Search NASA⌕ Search

SEARCH · Search NASA

Results for “effective turbulence”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 343 records · Page 19
All sourcesNASA NTRSDOE OSTI
NASA NTRSDate not supplied

Modeling Autogenous Pressurization and Draining of a Cryogenic Storage Tank in Normal Gravity

A two-phase CFD model for autogenous pressurization and draining of a cryogenic storage tank is presented using both the Sharp Interface and Volume-Of-Fluid (VOF) approaches for capturing the front and the associated interfacial heat, mass and momentum transfer between the liquid and vapor regions. Both models are validated against data provided by the Cryogenic Propellant Storage and Transfer (CPST) Engineering Development Unit (EDU) experiment1. The results of the autogenous pressurization are presented first, focusing on the phase change and turbulence effects on the tank pressure and temperature predictions. Both the Sharp Interface (SI-CFD) and VOF (VOF-CFD) multiphase models predict tank pressure during pressurization within 3% of the measured values. The sensitivity of key physical and numerical parameters of the problem are tested using the Sharp Interface model. Effects of the accommodation coefficient (AC), and the computational grid structure are studied. The second part of this paper is devoted to validating the SI-VOF model, with an enhanced capability of moving the liquid-vapor interface, against the draining segment of the EDU experiment. The VOF-CFD model was also used to simulate tank draining and its results were compared with the results of the Sharp Interface model with the moving interface. Both models predict tank pressure during draining within 3.5% of the measured values. Pressure decrease rate is underpredicted by both models during the first 100 seconds of draining but matches the experimental rate for the rest of the simulation.

Computational Fluid Dynamics↗
NASA NTRSDate not supplied

Toward High-Quality X-59 Sonic Thump Measurements

Brigham Young University has been investigating best practices for recommendation to NASA in upcoming X-59 sonic thump measurements. This preparatory work has focused both on obtaining high-fidelity data and standardizing signal analysis techniques for sonic thumps. Included in the research are topics such as whether to use a ground-based or elevated microphone, how to use low-noise microphones and still recover high-fidelity data at low frequencies, and estimating the uncertainty in a given measurement due to local atmospheric turbulence effects. Also included is a study of windowing techniques, zero padding, and the removal of high-frequency ambient noise contamination.

sonic boom↗
NASA NTRS2024

Sonic Boom Analyses in Support of Improved X-59 Community Noise Testing

informing measurement planning and analysis of quiet supersonic aircraft community testing. The report is divided into three main sections: (1) investigations on the impacts of contaminating noise on sonic boom community noise metrics; (2) investigations into sonic boom variability, including turbulence effects on metrics of interest and development of a data-driven boom variability analysis framework; (3) other studies that support developing improved methodologies for community testing and analysis.

community noise↗
NASA NTRSDate not supplied

Lidar and UAS Measurements of Winds for the NASA Advanced Air Mobility Mission

The envisioned future of Advanced Air Mobility involves low-altitude operation of a new class of air vehicles. The low altitudes of the flight paths would have these vehicles spending most of their operation in conditions where unpredictable wind and turbulence effects may occur. Wind measurements will hence be critical to ensure safe and efficient operations for AAM. Such wind measurement could be used as a monitoring system for warning of hazardous wind events, as data input to forecasting models, or as a research tool to understand wind effects in complex environments. To meet this need NASA is evaluating wind sensing technologies with a capability to probe the atmospheric boundary layer. Doppler lidar is a leading candidate ground-based sensor, as shown by the decades-long history of being an effective tool for many wind studies. However, there is a need to re-assess the Doppler wind lidars for the AAM application which involves evaluating wind effects as vehicles operate in and out of vertiports, notably regarding spatial resolution. Meeting the needs for spatial resolution may involve the use of dual-Doppler techniques, rather than just single Doppler lidar. The study was furthermore motivated by looking toward the future of AAM, in which the air vehicles involved can also provide wind measurements. Airborne wind measurements, obtained directly from vehicle-mounted anemometers or indirectly from vehicle navigation data, offer a means to compare remotely sensed wind lidar with in-situ measurements. The following sections report on results of wind measurements obtained using lidar and the small uninhabited aircraft systems (sUAS’s) operating in the same volume of air.

Adam Medina↗
NASA NTRS1992

The effect of a turbulent wake on the stagnation point. II - Heat transfer results

A phenomenological model is proposed which relates the effects of freestream turbulence to the increase in stagnation point heat transfer. The model requires both turbulence intensity and energy spectra as inputs to the unsteady velocity at the edge of the boundary layer. The form of the edge velocity contains both a pulsation of the incoming flow and an oscillation of the streamlines. The incompressible unsteady and time-averaged boundary layer response is determined by solving the momentum and energy equations. The model allows for arbitary two-dimensional geometry, however, results are given only for a circular cylinder. The time-averaged Nusselt number is determined theoretically and compared to existing experimental data.

Hanford, Anthony J.↗
NASA NTRS2004

Effects of Freestream Turbulence on Turbine Blade Heat Transfer

Experiments have shown that moderate turbulence levels can nearly double turbine blade stagnation region heat transfer. Data have also shown that heat transfer is strongly affected by the scale of turbulence as well as its level. In addition to the stagnation region, turbulence is often seen to increase pressure surface heat transfer. This is especially evident at low to moderate Reynolds numbers. Vane and rotor stagnation region, and vane pressure surface heat transfer augmentation is often seen in a pre-transition environment. Accurate predictions of transition and relaminarization are critical to accurately predicting blade surface heat transfer. An approach is described which incorporates the effects of both turbulence level and scale into a CFD analysis. The model is derived from experimental data for cylindrical and elliptical leadng edges. Results using this model are compared to experimental data for both vane and rotor geometries. The comparisons are made to illustrate that using a model which includes the effects of turbulence length scale improves agreement with data, and to illustrate where improvements in the modeling are needed.

Boyle, Robert J.↗
NASA NTRS1989

Effects of very high turbulence on heat transfer

The effects of very high free stream turbulence on heat transfer were investigated experimentally by placing a flat plate, constant temperature heat transfer surface in a large diameter turbulent-free jet. The heat transfer rates measured were two to four times greater than those that would be predicted by accepted correlations for turbulent boundary layers. Thus, rather than establish a particular high turbulence flow field and then measure its effect on heat transfer, search for a flow field with very aggressive heat transfer characteristics and description of the aspects of the free stream turbulence associated with high levels of heat transfer is examined.

Maciejewski, Paul K.↗
NASA NTRS1975

The effect of thin turbulent shear layers on the optical quality of imaging systems

A modified C141 transport was outfitted with a 91.5-cm reflector telescope designed to view objects radiating outside the visible window in the infrared range from 1 micron to 1000 microns. The telescope is situated in a cavity which is operated open port. Spoilers were designed which reduce turbulence-induced excitation of the cavity. The aircraft was designed to operate at altitudes up to 15 km to significantly reduce the effect of the H2O and CO2. Furthermore, the optically degrading influence of the large-scale atmospheric turbulence on land-based telescopes is replaced by the effect of the turbulent shear layer resulting from the spoiler upstream of the cavity. A mathematical model was established to describe the effect of turbulent shear layers on imaging systems and to examine the parameters of interest relevant to potential wind-tunnel experimentation.

Steinmetz, W. J.↗
NASA NTRS1994

Effects of the computational time step on numerical solutions for turbulent flow

Effects of large computational time steps on the computed turbulence were investigated using a fully implicit method. In turbulent channel flow computations the largest computational time step in wall units which led to accurate prediction of turbulence statistics was determined. Turbulence fluctuations could not be sustained if the computational time step was near or larger than the Kolmogorov time scale.

Choi, Haecheon↗
NASA NTRS1985

The effect of hydrodynamic turbulence on Langmuir waves in a slightly ionized plasma

In the lower altitude regions of the ionosphere, the gas present is only slightly ionized, and it behaves as a fluid. It is expected that a turbulent wake will form behind a spacecraft. Information is to be obtained regarding the effect of this turbulence on plasma waves measured by the spacecraft. If the turbulence is two-dimensional (2-D) and carries enstrophy, a fluctuating magnetic field and electric fields are produced. The fields induce fluctuations in the electron population which correlate with the magnetic and electric fluctuations which produced them. This correlation causes diffusion which changes the electron distribution and heats the electrons. As a result, the Langmuir frequency increases, and the Landau damping of Langmuir waves in the plasma decreases. Details regarding these processes are discussed, taking into account the results of a mathematical analysis.

Parish, J. L.↗
NASA NTRS1998

Effect of Free Stream Turbulence on the Flow-Induced Background Noise of In-Flow Microphones

When making noise measurements of sound sources in flow using microphones immersed in an air stream or wind tunnel, the factor limiting the dynamic range of the measurement is, in many cases, the noise caused by the flow over the microphone. To lower this self-noise, and to protect the microphone diaphragm, an aerodynamic microphone forebody is usually mounted on the tip of the omnidirectional microphone. The microphone probe is then pointed into the wind stream. Even with a microphone forebody, however, the self-noise persists, prompting further research in the area of microphone forebody design for flow-induced self-noise reduction. The magnitude and frequency characteristics of in-flow microphone probe self-noise is dependent upon the exterior shape of the probe and on the level of turbulence in the onset flow, among other things. Several recent studies present new designs for microphone forebodies, some showing the forbodies' self-noise characteristics when used in a given facility. However, these self-noise characteristics may change when the probes are used in different facilities. The present paper will present results of an experimental investigation to determine an empirical relationship between flow turbulence and self-noise levels for several microphone forebody shapes as a function of frequency. As a result, the microphone probe self-noise for these probes will be known as a function of freestream turbulence, and knowing the freestream turbulence spectra for a given facility, the probe self-noise can be predicted. Flow-induced microphone self-noise is believed to be related to the freestream. turbulence by three separate mechanisms. The first mechanism is produced by large scale, as compared to the probe size, turbulence which appears to the probe as a variation in the angle of attack of the freestream. flow. This apparent angle of attack variation causes the pressure along the probe surface to fluctuate, and at the location of the sensor orifice this fluctuating surface pressure is sensed by the diaphragm as noise. The second mechanism is caused by the convection of smaller sized turbulence, on the order of the probe cross-section, which passes nearby or strikes the probe giving rise to a fluctuating pressure at the sensor orifice. And, the third mechanism is related to fine scale turbulence through its effects on boundary layer growth and transition to a turbulent boundary layer. The method for relating the probe self-noise to the freestream turbulence will be based on the method of K. J. Young5 from Boeing, who developed the technique and presented flow noise results for a Bruel & Kjaer Type 0385, 1/4 inch (6.35 mm) nose cone. The experimental set-up used in the present experiment is similar to that of Young and is described in the present paper. Finally, flow noise predictions are made using the empirical correlations. These predictions are then compared with actual flow noise measurements made in the National Full-Scale Aerodynamics Complex 40- by 80-Foot Wind Tunnel at NASA Ames Research Center.

Allen, Christopher S.↗
DOE OSTI2026

Effects of density turbulence on helicon wave propagation in the core plasmas

Radio frequency wave propagation can be significantly affected by density irregularities, such as filaments in the scrape-off layer or instabilities in the core plasma. In this study, we examine the impact of edge turbulence on helicon wave propagation using the Petra-M simulation tool. To analyze the effect of edge turbulence, we utilize a realistic background plasma derived from XGC simulations, which includes spatial density fluctuations at the edge. This focus is particularly relevant for the DIII-D configuration, characterized by edge density turbulence of the core plasmas in a wide pedestal QH-mode. We focus on helicon wave propagation in the core plasma since the slow mode cannot propagate into the core plasma when the density is higher than the lower hybrid resonance, where a wide pedestal QH-mode occurs. The simulation results indicate that edge density fluctuations have a substantial impact on helicon wave coupling due to scattering in the core. We specifically demonstrate that the toroidal mode number and the level of density fluctuations are significant factors influencing scattering. While we have minimized the excitation of slow modes from the antenna, we still observe mode-converted slow modes resulting from the incoming helicon waves. The insights derived from these simulations will inform upcoming tokamak experiments regarding helicon antenna coupling in long pulse scenarios.

Kim, Eun-Hwa [Princeton Plasma Physics Laboratory ↗
NASA NTRS1975

Parameter estimation of powered-lift STOL aircraft characteristics including turbulence and ground effects

Longitudinal aerodynamic coefficients are estimated from data recorded during flight tests of a powered-lift STOL aircraft. A comparison is made between the coefficient values determined by the regression and quasilinearization identification techniques from records taken during elevator pulse maneuvers. The results show that for these tests the regression method provides less scatter in coefficient estimates and provides better correlation with the predicted values. Special techniques are developed which allow identification of the coefficients from records taken during landing maneuvers in which the aircraft encounters turbulence while flying in ground effect. Flight test results are presented to illustrate the effects of air turbulence and ground proximity on the estimated coefficient values.

Wingrove, R. C.↗
NASA NTRS1974

Parameter estimation of powered-lift STOL aircraft characteristics including turbulence and ground effects

The estimation of longitudinal aerodynamic coefficients from data recorded during flight tests of a powered-lift STOL aircraft is considered. First, a comparison is made between the coefficient values determined by the regression and quasilinearization identification techniques from records taken during elevator pulse maneuvers. The results show that for these tests the regression method provides less scatter in coefficient estimates and provides better correlation with the predicted values. Special techniques are then developed which allow identification of the coefficients from records taken during landing maneuvers in which the aircraft encounters turbulence while flying in ground effect. Flight test results are presented to illustrate the effects of air turbulence and ground proximity on the estimated coefficient values.

Wingrove, R. C.↗
NASA NTRS1972

Resonant diffusion in strongly turbulent plasmas.

The effect of turbulent fluctuations on plasma particles is considered, and equations are derived which describe the evolution of macroscopic properties such as temperature and flow speed of the turbulent plasma. Initially, a diffusion equation for a single-particle distribution function averaged over an ensemble of plasmas is derived for an unmagnetized plasma. For the resonant diffusion in strongly turbulent plasmas, an ensemble of three-dimensional plasmas is considered with an approximately homogeneous and stationary distribution of random electromagnetic fluctuations. For each realization, the single-particle distribution function satisfies the Vlasov equation.

Birmingham, T. J.↗