Initial specifications for van and aircraft
Proposed testing program for strapdown inertial system containing platform gyros and pendulous gyros
Benson, D. O., Jr.↗
SEARCH · Search NASA
Results for “gyro”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The ST-224 - A redundant inertial measurement system
ST-224 redundant inertial measurement system, using conventional gimbaled platforms, each with three skewed single-degree-of-freedom control gyro and one caged gyro
Oconnor, B. J.↗
Determination of angles of attack and sideslip from radar data and a roll-stabilized platform
Equations for angles of attack and sideslip relative to both a rolling and nonrolling body axis system are derived for a flight vehicle for which radar and gyroscopic attitude data are available. The method is limited to application where a flat, nonrotating earth may be assumed. The gyro measures attitude relative to an inertial reference in an Euler angle sequence. In particular, a pitch, yaw, and roll sequence is used as an example in the derivation. Sample calculations based on flight data are presented to illustrate the method. Results obtained with the present gyro method are compared with another technique that uses onboard camera data.
Preisser, J. S.↗
Inertial navigation system using three TDF gyroscopic sensors not jointly mounted on a stable platform
An inertial navigation system is described and analyzed based on two two-degree-of-freedom Schuler-gyropendulums and one two-degree-of-freedom azimuth gyro. The three sensors, each base motion isolated about its two input axes, are mounted on a common base, strapped down to the vehicle. The up and down pointing spin vectors of the two properly tuned gyropendulums track the vertical and indicate physically their velocity with respect to inertial space. The spin vector of the azimuth gyro is pointing northerly parallel to the earth axis. The system can be made self-aligning on a stationary base. If external measurements for the north direction and the vertical are available, initial disturbance torques can be measured and easily biased out. The error analysis shows that the system is practicable with today's technology.
Stieler, B.↗
Improved navigation by combining VOR/DME information with air or inertial data
The improvement was determined in navigational accuracy obtainable by combining VOR/DME information (from one or two stations) with air data (airspeed and heading) or with data from an inertial navigation system (INS) by means of a maximum-likelihood filter. It was found that the addition of air data to the information from one VOR/DME station reduces the RMS position error by a factor of about 2, whereas the addition of inertial data from a low-quality INS reduces the RMS position error by a factor of about 3. The use of information from two VOR/DME stations with air or inertial data yields large factors of improvement in RMS position accuracy over the use of a single VOR/DME station, roughly 15 to 20 for the air-data case and 25 to 35 for the inertial-data case. As far as position accuracy is concerned, at most one VOR station need be used. When continuously updating an INS with VOR/DME information, the use of a high-quality INS (0.01 deg/hr gyro drift) instead of a low-quality INS (1.0 deg/hr gyro drift) does not substantially improve position accuracy.
Bobick, J. C.↗
Simulation of a flexible spinning vehicle
Results are presented of experimental investigation of the controlled and uncontrolled dynamical behavior of a rotating or artificial gravity space station including flexible body effects. A dynamically scaled model was supported by a spherical air bearing which provided a nearly moment free environment. Reaction jet system were provided for spin-up and spin-down and for damping of wobble motion. Two single-gimbal gyros were arranged as a control moment gyro wobble damping system. Remotely controllable movable masses were provided to simulate mass shift disturbances such as arise from crew motions. An active mass balance wobble damping system which acted to minimize the wobble motions induced by crew motions was also installed. Flexible body effects were provided by a pair of inertia augmentation booms. Inertia augmentation booms are contemplated for use on rotating space stations to cause the spin axis moment of inertia to be the largest of the three moments of inertia as is necessary to assure gyroscopic stability. Test runs were made with each of the control systems with the booms locked (rigid body) and unlocked (flexible body).
Baudry, W. A.↗
Updating inertial navigation systems with VOR/DME information.
Demonstration that updating an inertial navigation system (INS) with VOR/DME information (from one or two stations) by means of a maximum-likelihood filter results in substantial improvements in navigational accuracy over that obtained by the use of a single VOR/DME (current practice). When continuously updating, the use of a high-quality INS (0.01 deg/hr gyro drift) instead of a low-quality INS (1.0 deg/hr gyro drift) does not substantially improve position accuracy. In-flight alignment (or realignment) of an INS to an accuracy comparable to that of ground alignment can be accomplished by using two DMEs. Several reduced-order suboptimal filters were found to perform nearly optimally.
Bobick, J. C.↗
The correlation length for interplanetary magnetic field fluctuations
It is argued that it is appropriate to consider two correlation lengths for interplanetary magnetic field fluctuations. For particles with gyro-radii large enough to encounter and be scattered by large-scale tangential discontinuities in the field (particles with energies greater than or approximately equal to several GeV/nucleon) the appropriate correlation length is simply the mean spatial separation between the discontinuities, L approximately 2 x 10 to the 11th power. Particles with gyro-radii much less than this mean separation (energies less than or approximately equal to 100 MeV/nucleon) appear to be unaffected by the discontinuities and respond only to smaller-scale field fluctuations. For these particles the correlation length is shown to be L approximately 10 to the 10th power cm. With this system of two correlation lengths the cosmic-ray diffusion tensor may be altered from what was predicted by, for example, Jokipii and Coleman, and the objections raised recently by Klimas and Sandri to the diffusion analysis of Jokipii may apply only at relatively low energies (approximately 50 MeV/nucleon).
Fisk, L. A.↗
A comparison of CMG steering laws for High Energy Astronomy Observatories (HEAOs)
A comparison of six selected control moment gyro steering laws for use on the HEAO spacecraft is reported. Basic equations are developed to project the momentum and torque of four skewed, single gimbal CMGs into vehicle coordinates. In response to the spacecraft attitude error signal, six algorithms are derived for controlling the CMG gimbal movements. HEAO performance data are obtained using each steering law and compared on the basis of such factors as accuracy, complexity, singularities, gyro hang-up and failure adaption. Moreover, each law is simulated with and without a magnetic momentum management system. The performance of any steering law is enhanced by the magnetic system. Without magnetics, the gimbal angles get large and there are significant differences in steering law performances due to cross coupling and nonlinearities. The performance of the pseudo inverse law is recommended for HEAO.
Davis, B. G.↗
STRAP IV - High accuracy, low drift attitude control system.
The STRAP IV attitude control system was designed, tested, and successfully launched to provide stable high accuracy pointing at nontrackable X-ray sources. On its initial flight (May 19, 1972), the STRAP IV control system updated its high accuracy, rate integrating gyros on two successive stellar targets and then maneuvered the rocket body to point the experimental payload at two separate X-ray sources and an X-ray-free background location. The third axis, which remained under the control of a coarse free gyro, was updated by a technique of successive star-target coordinate transformation to ensure the correct fine-axis azimuth alignment for the high accuracy inertial maneuvers. Pointing accuracies of 4 arc min with limit cycle stability of less than 20 arc sec peak to peak were obtained on all targets.
Shrewsberry, D. J.↗
Automatic control of the Skylab Astronaut Maneuvering Research Vehicle.
The two automatic control modes of the Astronaut Maneuvering Research Vehicle (AMRV) are analyzed: the control moment gyro (CMG) and the rate gyro (RG). The AMRV is an autonomous maneuvering unit which translates and rotates the pilot by means of hand-controller input commands. The CMG normal operation, desaturation, and cage/lock dynamics are described in terms of a realistic AMRV mass property configuration. No propellant is used for normal operation in the CMG mode, and the maximum rotation rate is 5 deg/sec about each AMRV axis. The RG attitude maneuvering and limit cycle submode dynamic are described in terms of the same AMRV mass property configuration.
Murtagh, T. B.↗
Some optimal considerations in attitude control systems
The conventional six-engine reaction control jet relay attitude control law with deadband is shown to be a good linear approximation to a weighted time-fuel optimal control law. Techniques for evaluating the value of the relative weighting between time and fuel for a particular relay control law is studied along with techniques to interrelate other parameters for the two control laws. Vehicle attitude control laws employing control moment gyros are then investigated. Steering laws obtained from the expression for the reaction torque of the gyro configuration are compared to a total optimal attitude control law that is derived from optimal linear regulator theory. This total optimal attitude control law has computational disadvantages in the solving of the matrix Riccati equation. Several computational algorithms for solving the matrix Riccati equation are investigated with respect to accuracy, computational storage requirements, and computational speed.
Boland, J. S., III↗
Error modeling of precision orientation sensors in a fixed base simulation
Models of noise and dynamic characteristics of gyro and autocollimator for very small signal levels are presented. Measurements were evaluated using spectral techniques for identifying noise from base motion. The experiment was constructed to measure the precession, due to relativistic effects, of an extremely precise earth-orbiting gyroscope. The design goal for nonrelativistic gyro drift is 0.001 arcsec per year. An analogous fixed base simulator was used in developing methods of instrument error modeling and performance evaluation applicable to the relativity experiment sensors and other precision pointing instruments. Analysis of autocollimator spectra uncovered the presence of a platform gimbal resonance. The source of resonance was isolated to gimbal bearing elastic restraint properties most apparent at very small levels of motion. A model of these properties which include both elastic and coulomb friction characteristics is discussed, and a describing function developed.
Klinger, D. L.↗
Application of a parameter identification technique to a hingeless helicopter rotor
A mathematical model of a gyro-controlled, three-bladed hingeless helicopter rotor was developed and parameters of the model were estimated using a parameter identification technique. The flapping and feathering degrees of freedom of the blades were modeled. The equations of the model contain time-varying, periodic coefficients due to the forward speed of the rotor. A digital simulation of the analytical model was compared with wind-tunnel measurements to establish the validity of the model. Comparisons of steady-state and transient solutions of the analytical model with the tunnel measurements gave reasonably good matching of gyro angle but less satisfactory matching of hub moment measurements. Further improvements were obtained by use of a parameter identification technique to adjust as many as 10 parameters of the analytical model. The sensitivity of the blade response to small changes in the parameters was also calculated.
Kanning, G.↗
Gyroflex data transmittal and data acquisition system analysis
Data obtained from the evaluation of GYROFLEX gyro is presented herein, along with a description of the data acquisition system. In addition, the appendices contain an analysis of the voltmeter used for data collection, and the filtering technique employed. It is shown that the test setup is satisfactory for testing GYROFLEX gyros.
Peckham, C.↗
Effect of damping on excitability of high-order normal modes
The effect of localized structural damping on the excitability of higher-order large space telescope spacecraft modes is investigated. A preprocessor computer program is developed to incorporate Voigt structural joint damping models in a finite-element dynamic model. A postprocessor computer program is developed to select critical modes for low-frequency attitude control problems and for higher-frequency fine-stabilization problems. The selection is accomplished by ranking the flexible modes based on coefficients for rate gyro, position gyro, and optical sensor, and on image-plane motions due to sinusoidal or random PSD force and torque inputs.
Merchant, D. H.↗
The effects of localized damping on structural response
The effect of localized structural damping on the excitability of higher order normal modes of the large space telescope was investigated. A preprocessor computer program was developed to incorporate Voigt structural joint damping models in a NASTRAN finite-element dynamic model. A postprocessor computer program was developed to select critical modes for low-frequency attitude control problems and for higher frequency fine-stabilization problems. The mode selection is accomplished by ranking the flexible modes based on coefficients for rate gyro, position gyro, and optical sensors, and on image-plane motions due to sinusoidal or random power spectral density force and torque inputs.
Merchant, D. H.↗
On-orbit performance of the Skylab astronaut maneuvering research vehicle
The present work evaluates the results of flight tests of the Astronaut Maneuvering Research Vehicle (AMRV) conducted inside the Skylab Orbital Workshop. The vehicle is an autonomous mobility aid which allows the pilot to control his position and orientation in space without the necessity of reacting against the spacecraft. The purpose of the tests was to obtain operation experience and engineering/human performance data in a zero gravity environment, to correlate on-orbit data with simulation data, and to recommend a design configuration for future operational maneuvering units. Four different techniques for controlling AMRV dynamics were tested: hand-held maneuvering unit, direct, rate gyro, and control moment gyro operating modes.
Murtagh, T. B.↗