Redundancy optimization for series k-out-of-n systems
Redundancy optimization for series-parallel systems and serially connected k-out-of-n type subsystems, with cost constraints and reliability considerations
Bien, D. D.↗
SEARCH · Search NASA
Results for “serialization”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Fabrication and evaluation of large-area ultrasoft X-ray detectors suitable for spacecraft application
The modifications to the Houston/MSC design of the gas proportional counter flight electronics system are discussed. The following modifications are described: charge amplifier bandwidth improvements, power converter redesign, serial data output buffer, second differentiator, and risetime discriminator. In addition, the redesign of the stellar aspect camera is discussed along with developments in thin film fabrication.
Bowyer, S.↗
Spread spectrum communication link using surface wave devices
A fast lock-up, 8-MHz bandwidth 8,000 bit per second data rate spread spectrum communication link breadboard is described that is implemented using surface wave devices as the primary signal generators and signal processing elements. It uses surface wave tapped delay lines in the transmitter to generate the signals and in the receiver to detect them. The breadboard provides a measured processing gain for Gaussian noise of 31.5 dB which is within one dB of the theoretical optimum. This development demonstrates that spread spectrum receivers implemented with surface wave devices have sensitivities and complexities comparable to those of serial correlation receivers, but synchronization search times which are two to three orders of magnitude smaller.
Hunsinger, B. J.↗
Data compression/error correction digital test system. Appendix 2: Theory of operation
An overall block diagram of the DC/EC digital system test is shown. The system is divided into two major units: the transmitter and the receiver. In operation, the transmitter and receiver are connected only by a real or simulated transmission link. The system inputs consist of: (1) standard format TV video, (2) two channels of analog voice, and (3) one serial PCM bit stream.
Source record↗
Applications of ERTS-A Data Collection System (DCS) in the Arizona Regional Ecological Test Site (ARETS)
The author has identified the following significant results. Preliminary analysis of DCS data from the USGS Verde River stream flow measuring site indicates the DCS system is furnishing high quality data more frequently than had been expected. During the 43-day period between Nov. 3, and Dec. 15, 1972, 552 DCS transmissions were received during 193 data passes. The amount of data received far exceeded the single high quality transmission per 12-hour period expected from the DCS system. The digital-parallel ERTS-1 data has furnished sufficient to accurately compute mean daily gage heights. These in turn, are used to compute average daily streamflow rates during periods of stable or slowly changing flow conditions. The digital-parallel data has also furnished useful information during peak flow periods. However, the serial-digital DCS capability, currently under development for transmitting streamflow data, should provide data of greater utility for determining times of flood peaks.
Schumann, H. H.↗
Optimum allocation of redundancy among subsystems connected in series
This analysis considers the optimum allocation of redundancy in a system of serially connected subsystems in which each subsystem is of the k-out-of-n type. Redundancy is optimally allocated when: (1) reliability is maximized for given costs; or (2) costs are minimized for given reliability. Several techniques are presented for achieving optimum allocation and their relative merits are discussed. Approximate solutions in closed form were attainable only for the special case of series-parallel systems and the efficacy of these approximations is discussed.
Bien, D. D.↗
GEOS-2 C-band radar system project. Spectral analysis as related to C-band radar data analysis
Work performed on spectral analysis of data from the C-band radars tracking GEOS-2 and on the development of a data compaction method for the GEOS-2 C-band radar data is described. The purposes of the spectral analysis study were to determine the optimum data recording and sampling rates for C-band radar data and to determine the optimum method of filtering and smoothing the data. The optimum data recording and sampling rate is defined as the rate which includes an optimum compromise between serial correlation and the effects of frequency folding. The goal in development of a data compaction method was to reduce to a minimum the amount of data stored, while maintaining all of the statistical information content of the non-compacted data. A digital computer program for computing estimates of the power spectral density function of sampled data was used to perform the spectral analysis study.
Source record↗
Parasitic suppressing circuit
A circuit for suppressing parasitic oscillations across an inductor operating in a resonant mode is described. The circuit includes a switch means and resistive means connected serially across the inductor. A unidirectional resistive-capacitive network is also connected across the inductor and to the switch means to automatically render the switch means conducting when inductive current through the inductor ceases to flow.
Fowler, J. T.↗
Evaluating the efficiency of man-machine systems
Efficiency and the degree of adaptability of a system to cope with problems presented to it, are evaluated. Also evaluated are serial production, possible modernization approaches, and operational procedures. The link between system efficiency and cost criteria are included.
Korolev, B. A.↗
The mammalian response to lunar particulates.
The response of germfree mice to subcutaneous and intraperitoneal injection of aqueous suspensions of lunar fine material (LFM) was evaluated. Both uninjected mice and mice injected with dry heat sterilized LFM were included as controls. After injection, the majority of mice were subjected to serial sacrifice to assess the time course of the tissue response. A smaller group of animals were held for lifespan studies. The observations suggest that LFM is relatively insoluble in tissue and that, while acting as a low grade irritant, it has little tendency to evoke reactive fibrosis.
Holland, J. M.↗
Investigation of mounting discrete chip components for hybrid microelectronic applications.
In the assembly of hybrid microcircuits, passive and active discrete chip components are attached by epoxy cements and by solders. This study was initiated to determine the integrity of such attachments. Alumina substrates were subjected to a group of thermal and mechanical test environments defined by test methods in MIL-STD-883. Lot samples of substrates with assembly variations were subjected to separately applied testing and to serial testing. These test methods were applied sequentially to the same lot of substrates. Epoxy cements were generally satisfactory with respect to separate tests, although sequential tests severely degraded epoxy bond strengths of all types. Bond strengths to unglazed substrates were slightly superior to those of the same components on glazed types. Solder joints were vulnerable to catastrophic failure in several environments, especially temperature cycling and thermal shock. Vibration and impact shock also produced solder joint failures.
Caruso, S. V.↗
Performance testing of a Transit generator at JPL.
A Transit type thermoelectric generator, serial number QM-III, assembled with lightweight Isotec type thermoelectric panels, has been placed on test at the Jet Propulsion Laboratory. In its exterior appearance and main constructive features, generator QM-III is similar to the generator which was flown on the Transit satellite, launched into circular polar orbit on Sept. 2, 1972. The main difference between the flight generator and QM-III is that the flight hardware is heated by radioisotope decay, while QM-III is an ETG and is assembled with three different types of thermoelectric panels. The paper describes the generator and test equipment used and presents the results of the tests performed to date.
Rouklove, P.↗
A variable-data-rate, multimode quadriphase modem.
This paper describes the design and performance of a highly versatile modulator and demodulator recently developed to facilitate the evaluation of various digital communications links. The modem is capable of either PSK or QPSK operation and can accommodate a very wide range of continuously tunable data rates (1 kbps to 30 Mbps in each of two channels). In the QPSK mode, operation is possible using either a single serial data stream (single channel operation) or using two mutually independent, unrelated, and asynchronous data streams (dual-channel operation). Integrate and dump detectors are used at the demodulator for regeneration of the data stream(s). Measurements indicate that the performance of the overall system (including the bit detectors) is within 2 dB of the theoretically optimum performance of either PSK or QPSK at any rate within the range of rates provided by the modem, and is within 1 dB of theoretical over most of the range of rates.
Allen, R. W.↗
A parallel variable metric optimization algorithm
An algorithm, designed to exploit the parallel computing or vector streaming (pipeline) capabilities of computers is presented. When p is the degree of parallelism, then one cycle of the parallel variable metric algorithm is defined as follows: first, the function and its gradient are computed in parallel at p different values of the independent variable; then the metric is modified by p rank-one corrections; and finally, a single univariant minimization is carried out in the Newton-like direction. Several properties of this algorithm are established. The convergence of the iterates to the solution is proved for a quadratic functional on a real separable Hilbert space. For a finite-dimensional space the convergence is in one cycle when p equals the dimension of the space. Results of numerical experiments indicate that the new algorithm will exploit parallel or pipeline computing capabilities to effect faster convergence than serial techniques.
Straeter, T. A.↗
The vestibular system of the owl
Five owls were given vestibular examinations, and two of them were sacrificed to provide serial histological sections of the temporal bones. The owls exhibited a curious variability in the postrotatory head nystagmus following abrupt deceleration; sometimes a brisk nystagnus with direction opposite to that appropriate to the stimulus would occur promptly after deceleration. It was found also that owls can exhibit a remarkable head stability during angular movement of the body about any axis passing through the skull. The vestibular apparatus in the owl is larger than in man, and a prominent crista neglecta is present. The tectorial membrane, the cupula, and the otolithic membranes of the utricle, saccule, and lagena are all attached to surfaces in addition to the surfaces hearing hair cells. These attachments are very substantial in the utricular otolithic membrane and in the cupula.
Money, K. E.↗
An analysis of the circuitry of the visual pathway of the lateral eye of limullus
The methodology is discussed for three-dimensional analysis of the nervous system on the basis of electron micrographs of serial sections. An analysis is presented of a part of the circuitry of the rabbit retina. In addition, some exploratory work is reported with respect to the visual cortex of the cat brain. A proper technique for preservation of the visual cortex was worked out and a technique to localize microelectrode tips in the tissue in connection with electron microscopy was partially worked out.
Sjoestrand, F. S.↗
Data bus system development program
Two data bus systems were designed fabricated, Data Bus System I and Data Bus System II. The technical features of the delivered hardware include the following: (1) 5 MHz selfclocking data bus; (2) bidirectional communications utilizing Manchester Code at data rates in excess of 20,000 words per second; (3) utilization of MSI COS/MOS technology (4) probability of accepting an erroneous data bit less than 1 in 10 to the 25th power (5) low power consumption (50 to 1 reduction in quiescent current over P/MOS) (6) compatibility with projected high density packaging. Three distinct types of data bus remote terminals were developed: the subsystem interface unit, the combination of an electronic interface unit and a standard interface unit-serial, and an SIU/Preprocessor.
Harrison, J. S. J.↗
Vectorization on the star computer of several numerical methods for a fluid flow problem
A reexamination of some numerical methods is considered in light of the new class of computers which use vector streaming to achieve high computation rates. A study has been made of the effect on the relative efficiency of several numerical methods applied to a particular fluid flow problem when they are implemented on a vector computer. The method of Brailovskaya, the alternating direction implicit method, a fully implicit method, and a new method called partial implicitization have been applied to the problem of determining the steady state solution of the two-dimensional flow of a viscous imcompressible fluid in a square cavity driven by a sliding wall. Results are obtained for three mesh sizes and a comparison is made of the methods for serial computation.
Lambiotte, J. J., Jr.↗