Search NASA⌕ Search

SEARCH · Search NASA

Results for “Airborne transmission”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
DOE OSTI2021

A missing layer in COVID-19 studies: Transmission of enveloped viruses in mucus-rich droplets

Here we evaluate the influence of mucus layers on the evaporation time and transport of enveloped viruses, including SARS-CoV-2. Enveloped viruses must remain moist to be fully infective. Yet, the Wells model based on water droplets divides respiratory droplets into either quickly evaporated aerosolized particles termed droplet nuclei (<10 s) or liquid droplets that fall to the nearest surface, leaving no physical mechanism for airborne transmission of fully infective enveloped viruses over large distances (greater than a few meters). Yet, the role of mucus layers on evaporation times has not been considered even though the formation of mucus shells around liquid cores of respiratory droplets has been shown experimentally. Here we show that mucus shells increase the drying time by orders of magnitude so that enveloped virions may remain well hydrated and, thus, fully infective at substantial distances. Further, this provides a mechanism by which infective enveloped virus particles can transmit as aerosols within buildings and between buildings over extended distances. This analysis is important because public health agencies typically follow the Wells model to establish health policies including social/physical distancing guidelines.

60 APPLIED LIFE SCIENCES↗
DOE OSTI2023

Size-Resolved Elemental Composition of Respiratory Particles in Three Healthy Subjects

The chemical composition of respiratory particles is of interest because the viability of any viruses and bacteria in the particles has been shown to depend on this factor. Here, using computer controlled scanning electron microscopy/energy dispersive X-ray spectroscopy (CCSEM/EDX), we analyzed the size-resolved chemical composition of greater than 35,000 individual respiratory particles collected from three healthy human subjects, quantitatively at nanometer-scale spatial resolution. The desiccated particles ranged in size from 0.05 to 4.4 μm, and the mode of the size distribution was approximately 0.1 μm. Particles were heterogeneous in composition, with approximately 42% of them containing a carbon atomic percentage greater than 95% and approximately 53% of them containing a Na + P + K + Cl percentage greater than 5%. Based on the particles’ elemental composition, we classified them into five categories: 48%–56% of the total number were carbonaceous, mostly organic; 40%–50% Na-rich salt; 0.3%–0.5% P-rich salt; 0.1–0.8% K-rich salt; and 1%–2.5% mixed salt. The number ratio of Na-rich salt particles to carbonaceous particles increased with increasing particle size; particles larger than approximately 2 μm were dominated by Na-rich salt. Size-dependent differences in the chemical composition of respiratory particles may have important implications for the efficiency of airborne transmission of respiratory pathogens.

60 APPLIED LIFE SCIENCES↗
DOE OSTI2020

Decontamination of SARS-CoV-2 and Other RNA Viruses from N95 Level Meltblown Polypropylene Fabric Using Heat under Different Humidities

In March of 2020, the World Health Organization declared a pandemic of coronavirus disease 2019 (COVID-19), caused by the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). The pandemic led to a shortage of N95-grade filtering facepiece respirators (FFRs), especially surgical-grade N95 FFRs for protection of healthcare professionals against airborne transmission of SARS-CoV-2. We and others have previously reported promising decontamination methods that may be applied to the recycling and reuse of FFRs. In this study we tested disinfection of three viruses, including SARS-CoV-2, dried on a piece of meltblown fabric, the principal component responsible for filtering of fine particles in N95-level FFRs, under a range of temperatures (60–95 °C) at ambient or 100% relative humidity (RH) in conjunction with filtration efficiency testing. We found that heat treatments of 75 °C for 30 min or 85 °C for 20 min at 100% RH resulted in efficient decontamination from the fabric of SARS-CoV-2, human coronavirus NL63 (HCoV-NL63), and another enveloped RNA virus, chikungunya virus vaccine strain 181/25 (CHIKV-181/25), without lowering the meltblown fabric’s filtration efficiency.

60 APPLIED LIFE SCIENCES↗
DOE OSTI2021

Shaping the Future of Science: COVID‐19 Highlighting the Importance of GeoHealth

Abstract From the heated debates over the airborne transmission of the novel coronavirus to the abrupt Earth system changes caused by the sudden lockdowns, the dire circumstances resulting from the coronavirus disease 2019 (COVID‐19) pandemic have brought the field of GeoHealth to the forefront of visibility in science and policy. The pandemic has inadvertently provided an opportunity to study how human response has impacted the Earth system, how the Earth system may impact the pandemic, and the capacity of GeoHealth to inform real‐time policy. The lessons learned throughout our responses to the COVID‐19 pandemic are shaping the future of GeoHealth.

60 APPLIED LIFE SCIENCES↗
DOE OSTI2024

Existence of a Nonzero Worst‐Case ACH for Short‐Term Exposure in Ventilated Indoor Spaces

A well‐ventilated room is essential to reduce the risk of airborne transmission. As such, the scientific community sets minimum limits on ventilation with the idea that increased ventilation reduces pathogen concentration and thus reduces the risk of transmission. In contrast, the upper limit on ventilation is usually determined by human comfort and the need to reduce energy consumption. While average pathogen concentration decreases with increased ventilation, local concentration depends on multiple factors and may not follow the same trend, especially within short exposure times over large separation distances. Here, we show through experiments and high‐fidelity simulations the existence of a worst‐case ventilation where local pathogen concentration increases near the receiving host. This occurs during the type of meetings that were recommended during the pandemic (and in some cases solely authorized) with reduced occupancy adhering to social distancing and short exposure times below 20 minutes. We maintain that for cases of high occupancy and long exposure time, increased ventilation remains necessary.

Construction & Building Technology↗
NASA NTRS2018

Autonomous Inspection of Electrical Transmission Structures with Airborne UV Sensors and Automated Air Traffic Management

This report details test and measurement flights to demonstrate autonomous UAV (Unmanned Aerial Vehicle) inspection of high-voltage electrical transmission structures. A UAV built with commercial, off-the-shelf hardware and software, supplemented with custom sensors and logging software, measured ultraviolet (UV) emissions from a test generator placed on a low-altitude substation and a medium-altitude switching tower. Since corona discharge precedes catastrophic electrical faults on high-voltage structures, detection and geolocation of ultraviolet emissions is needed to develop a UAV-based self-diagnosing power grid. Signal readings from an onboard ultraviolet sensor were validated during flight with a commercial corona camera. Geolocation was accomplished with onboard GPS; the UAV position was logged to a local ground station and transmitted in real time to a NASA server for tracking in the national airspace. The method has practicality and relevance but not adequacy; either improved UAV position determination technology or increased sensor range is needed to enable broad deployment of this method.

Moore, Andrew J.↗
NASA NTRS2017

Autonomous Inspection of Electrical Transmission Structures with Airborne UV Sensors - NASA Report on Dominion Virginia Power Flights of November 2016

The report details test and measurement flights to demonstrate autonomous UAV inspection of high voltage electrical transmission structures. A UAV built with commercial, off-the-shelf hardware and software, supplemented with custom sensor logging software, measured ultraviolet emissions from a test generator placed on a low-altitude substation and a medium-altitude switching tower. Since corona discharge precedes catastrophic electrical faults on high-voltage structures, detection and geolocation of ultraviolet emissions is needed to develop a UAV-based self-diagnosing power grid. Signal readings from an onboard ultraviolet sensor were validated during flight with a commercial corona camera. Geolocation was accomplished with onboard GPS; the UAV position was logged to a local ground station and transmitted in real time to a NASA server for tracking in the national airspace.

Moore, Andrew J.↗
DOE OSTI2021

Modeling airborne pathogen transport and transmission risks of SARS-CoV-2

An integrated modeling approach has been developed to better understand the relative impacts of different expiratory and environmental factors on airborne pathogen transport and transmission, motivated by the recent COVID-19 pandemic. Computational fluid dynamics (CFD) modeling was used to simulate spatial-temporal aerosol concentrations and quantified risks of exposure as a function of separation distance, exposure duration, environmental conditions (e.g., airflow/ventilation), and face coverings. The CFD results were combined with infectivity models to determine probability of infection, which is a function of the spatial-temporal aerosol concentrations, viral load, infectivity rate, viral viability, lung-deposition probability, and inhalation rate. Uncertainty distributions were determined for these parameters from the literature. Probabilistic analyses were performed to determine cumulative distributions of infection probabilities and to determine the most important parameters impacting transmission. This modeling approach has relevance to both pathogen and pollutant dispersion from expelled aerosol plumes.

60 APPLIED LIFE SCIENCES↗
NASA NTRS1978

Effect of longitudinal stringers on sound transmission into a thin cylindrical shell

In the context of the transmission of airborne noise into an aircraft fuselage, a mathematical model is presented for the transmission of airborne noise into a stiffened cylindrical shell. The stiffeners are longitudinal stringers and are modeled as discrete structural elements. The numerical cases examined were typical of a narrow-bodied jet transport fuselage. The stringers appeared to raise the cylinder transmission loss in the mass-controlled region, although they produced dips at the stringer resonances. The ring-frequency dip in transmission loss, which is characteristic of monocoque shells, was found to still be present. There appeared to be a small increase in transmission loss as the number of stringers was increased. The effect of high damping was also investigated.

Koval, L. R.↗