Search NASA⌕ Search

SEARCH · Search NASA

Results for “Cross-spectral density”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

24 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS2007

The Energy-Dependent X-Ray Timing Characteristics of the Narrow Line Seyfert 1 MKN 766

We present the energy-dependent power spectral density (PSD) and cross-spectral properties of Mkn 766, obtained from combining data obtained during an XMM-Newton observation spanning six revolutions in 2005 with data obtained from an XMM-Newton long-look in 2001. The PSD shapes and rms-flux relations are found to be consistent between the 2001 and 2005 observations, suggesting the 2005 observation is simply a low-flux extension of the 2001 observation and permitting us to combine the two data sets. The resulting PSD has the highest temporal frequency resolution for any AGN PSD measured to date. Applying a broken power-law model yields break frequencies which increase in temporal frequency with photon energy. Obtaining a good fit when assuming energy-independent break frequencies requires the presence of a Lorentzian at 4.6 +/- 0.4 x 10(exp -4)Hz whose strength increases with photon energy, a behavior seen in black hole X-ray binaries. The cross-spectral properties are measured; temporal frequency-dependent soft-to-hard time lags are detected in this object for the first time. Cross-spectral results are consistent with those for other accreting black hole systems. The results are discussed in the context of several variability models, including those based on inwardly-propagating viscosity variations in the accretion disk.

Markowitz, A.↗
NASA NTRS1979

Case studies of gravity waves associated with isolated tornadic storms on January 13, 1976

Penetrative convection, thunderstorms, squall lines, etc., all generate atmospheric gravity waves which can be observed by a ground-based ionospheric Doppler sounder array. Sources of these waves can be determined from reverse ray tracing computations. Case studies of gravity waves associated with isolated tornadic storms on January 13, 1976 were summarized to establish the minimum data sampling time required for correct spectral analysis and ray tracing computations. It was concluded that the data sampling time can be reduced to two to three times the wave period while still obtaining a reasonably good power spectral density. It was also demonstrated that the data sampling time can be reduced to two to three times the time delay of the wave arrival between two station pairs while still obtaining a justifiably good cross-spectral analysis. Computed source locations of the observed gravity waves are compared with conventional and satellite meteorological data.

Hung, R. J.↗
DOE OSTI2024

The Simons Observatory: Combining cross-spectral foreground cleaning with multitracer B -mode delensing for improved constraints on inflation

The Simons Observatory (SO), due to start full science operations in early 2025, aims to set tight constraints on inflationary physics by inferring the tensor-to-scalar ratio r from measurements of cosmic microwave background (CMB) polarization B-modes. Its nominal design including three small-aperture telescopes (SATs) targets a precision σ⁡(r = 0) ≤ 0.003 without delensing. Achieving this goal and further reducing uncertainties requires a thorough understanding and mitigation of other large-scale B-mode sources such as Galactic foregrounds and weak gravitational lensing. We present an analysis pipeline aiming to estimate r by including delensing within a cross-spectral likelihood, and demonstrate it for the first time on SO-like simulations accounting for various levels of foreground complexity, inhomogeneous noise and partial sky coverage. As introduced in an earlier SO delensing paper, lensing B-modes are synthesized using internal CMB lensing reconstructions as well as Planck-like cosmic infrared background maps and LSST-like galaxy density maps. We then extend SO’s power-spectrum-based foreground-cleaning algorithm to include all auto- and cross-spectra between the lensing template and the SAT B-modes in the likelihood function. This allows us to constrain r and the parameters of our foreground model simultaneously. Within this framework, we demonstrate the equivalence of map-based and cross-spectral delensing and use it to motivate an optimized pixel-weighting scheme for power spectrum estimation. We start by validating our pipeline in the simplistic case of uniform foreground spectral energy distributions. In the absence of primordial B-modes, we find that the 1⁢σ statistical uncertainty on r, σ⁡(r), decreases by 37% as a result of delensing. Tensor modes at the level of r = 0.01 are successfully detected by our pipeline. Even when using more realistic foreground models including spatial variations in the dust and synchrotron spectral properties, we obtain unbiased estimates of r both with and without delensing by employing the moment-expansion method. In this case, uncertainties are increased due to the higher number of model parameters, and delensing-related improvements range between 27% and 31%. These results constitute the first realistic assessment of the delensing performance at SO’s nominal sensitivity level.

79 ASTRONOMY AND ASTROPHYSICS↗
NASA NTRS1979

Field measurement of penetrator seismic coupling in sediments and volcanic rocks

Field experiments were conducted to determine experimentally how well a seismometer installed using a penetrator would be coupled to the ground. A dry lake bed and a lava bed were chosen as test sites to represent geological environments of two widely different material properties. At each site, two half-scale penetrators were fired into the ground, a three-component geophone assembly was mounted to the aft end of each penetrator, and dummy penetrators were fired at various distances to generate seismic signals. The recorded signals were digitized, and cross-spectral analyses were performed to compare the observed signals in terms of power spectral density ratio, coherence and phase difference. The analyses indicate that seismometers deployed by penetrators will be as well coupled to the ground as are seismometers installed by conventional methods for the frequency range of interest in earthquake seismology, although some minor differences were observed at frequencies near the upper limit of the frequency band.

Nakamura, Y.↗
NASA NTRS1979

Field Measurements of Penetrator Seismic Coupling in Sediments and Volcanic Rocks

Field experiments were conducted to determine how well a seismometer installed using a penetrator would be coupled to the ground. A dry-lake bed and a lava bed were chosen as test sites to represent geological environments of two widely different material properties. At each site, two half-scale penetrators were fired into the ground, a three-component geophone assembly was mounted to the aft end of each penetrator, and dummy penetrators were at various distances to generate seismic signals. These signals were detected by the penetrator-mounted geophone assembly and by a reference geophone assembly buried or anchored to surface rock and 1-m from the penetrator. The recorded signals were digitized, and cross-spectral analyses were performed to compare the observed signals in terms of power spectral density ratio, coherence, and phase difference. The analyses indicate that seismometers deployed by penetrators will be as well coupled to the ground as are seismometers installed by conventional methods for the frequency range of interest in earthquake seismology.

Nakamura, Y.↗
NASA NTRS1981

Interpretation of phase velocity measurements of wind-generated surface waves

Differences in experimental results for surface gravity wave phase speeds obtained by cross spectra and slope-height spectra are compared. It is shown that, for a simple two-dimensional model containing both dispersive and non-dispersive waves, the observed differences can be explained readily. The slope-height technique measures a weighted average of the wavenumber squared; for frequencies sufficiently large compared with the dominant frequency, the computed phase-speed variation with frequency is representative of the wave having the larger wavenumber - the dispersive wave. For the cross-spectral method, it is shown that the small-probe-separation assumption usually employed is not valid for frequencies much larger than the dominant frequency, except at the singular point where both waves have exactly equal spectral densities and the phase function represents an average of the two modes. For all other cases, the phase function approaches that of the wave having the larger spectral density, and essentially ignores the presence of the other wave, even if both modes are relatively close in their contributions to the total spectral density.

Dudis, J. J.↗