Search NASA⌕ Search

SEARCH · Search NASA

Results for “Doppler Frequency”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2

Automated preprocessing of spaceborne SAR data

An efficient algorithm has been developed for estimation of the echo phase delay in spaceborne synthetic aperture radar (SAR) data. This algorithm utilizes the spacecraft ephemeris data and the radar echo data to produce estimates of two parameters: (1) the centroid of the Doppler frequency spectrum f(d) and (2) the Doppler frequency rate. Results are presented from tests conducted with Seasat SAR data. The test data indicates that estimation accuracies of 3 Hz for f(d) and 0.3 Hz/sec for the Doppler frequency rate are attainable. The clutterlock and autofocus techniques used for estimation of f(d) and the Doppler frequency rate, respectively are discussed and the algorithm developed for optimal implementation of these techniques is presented.

Curlander, J. C.↗

Signal statistics of the radar echoes: Angle-of-arrival statistics, part 2.2A

The Doppler spectra, measured with a vertical antenna beam, are characterized by essentially two different kinds of distributions, one has a very narrow and the other a broad spectral width. The former is accepted as due to reflection whereas the latter is due to scattering. It can happen that both kinds of spectra are observed simultaneously. Superimposed on a fairly broad Gaussian signal spectrum, very narrow signal spikes are evident. Because some spikes occur at different Doppler frequencies, the subreflections have to be assumed to move with different radial velocities. To experimentally verify this reasonable assumption, it is proposed to measure the angle of arrival of the different signal returns. One can here make use of the essential advantage that the spikes can be filtered in frequency (called Doppler sortening or sharpening). By means of the cross spectrum analysis with the interferometer technique (measuring phase differences between spaced antennas), their angle of arrival can be measured. This will allow determination of the distribution of the angles of arrival.

Rottger, J.↗

A search for sinusoidal gravitational radiation in the period range 30-2000 seconds

Since condensed massive objects in binary systems should generate observable periodic gravitational radiation, a large fraction of which may appear in one harmonic of the orbital frequency, monochromatic Doppler frequency perturbations were searched for at about 9000 discrete frequencies in the 0.0005-0.0333-Hz band using predetection data taken with the Pioneer 11 spacecraft. The results of the search are presented, and formal sensitivities for the possible signals are discussed. The results are interpreted as observational thresholds for possible incident gravitational wave trains having polarization states and propagation directions that are a priori unknown.

Armstrong, J. W.↗

Mesospheric wind measurements using a medium-frequency imaging Doppler interferometer

Wind results from a medium-frequency radar operated as an imaging Doppler interferometer are presented. Ten independent antennas, together with mesospheric wind motions, were used to Doppler-sort and then echo-locate individual scattering points. The three-dimensional location and radial velocity of each discrete scattering point was determined. Mean winds were then determined by a least squares fit to the radial velocities of the ensemble of scatterers.

Adams, G. W.↗

Designing clutter rejection filters with complex coefficients for airborne pulsed Doppler weather radar

Ground clutter interference is a major problem for airborne pulse Doppler radar operating at low altitudes in a look-down mode. With Doppler zero set at the aircraft ground speed, ground clutter rejection filtering is typically accomplished using a high-pass filter with real valued coefficients and a stopband notch centered at zero Doppler. Clutter spectra from the NASA Wind Shear Flight Experiments of l991-1992 show that the dominant clutter mode can be located away from zero Doppler, particularly at short ranges dominated by sidelobe returns. Use of digital notch filters with complex valued coefficients so that the stopband notch can be located at any Doppler frequency is investigated. Several clutter mode tracking algorithms are considered to estimate the Doppler frequency location of the dominant clutter mode. From the examination of night data, when a dominant clutter mode away from zero Doppler is present, complex filtering is able to significantly increase clutter rejection over use of a notch filter centered at zero Doppler.

Jamora, Dennis A.↗

RAWS: The spaceborne radar wind sounder

The concept of the Radar Wind Sounder (RAWS) is discussed. The goals of the RAWS is to estimate the following three qualities: the echo power, to determine rain rate and surface wind velocity; the mean Doppler frequency, to determine the wind velocity in hydrometers; and the spread of the Doppler frequency, to determine the turbulent spread of the wind velocity. Researchers made significant progress during the first year. The feasibility of the concept seems certain. Studies indicate that a reasonably sized system can measure in the presence of ice clouds and dense water clouds. No sensitivity problems exist in rainy environments. More research is needed on the application of the radar to the measurement of rain rates and winds at the sea surface.

Moore, Richard K.↗

Techniques for measurement of vertical and horizontal velocities: Monostatic versus bistatic measurements

Three techniques of direct measurement are presented from which velocities may be obtained: (1) Doppler frequency shift, (2) spaced antenna drift, (3) spatially modulated transverse beam measurements. Emphasis is placed on the Doppler frequency measurement approach. It will compare bistatic with monostatic configurations as regards received power (or sensitivity), spatial resolution, Doppler shift and avoidance of ground clutter.

Waterman, A. T.↗

Comparison of medium frequency pulsed radar interferometer and correlation analysis winds, part 1

In principle, the interferometer analysis determines the radial velocity and direction of single scatterers provided that each has a sufficiently different Doppler frequency to permit separation by spectral analysis. In fact, scatterers will not have constant radial velocity, and their Doppler frequencies as well as their directions will be modulated by their horizontal motion. Thus, there is a tradeoff between the poorer resolution but less smeared scatterers on shorter records and the higher resolution (longer) records. Three or more non-collinear scatterers are sufficient to determine the wind. It appears that the velocity found from the combined interferometer peaks agrees well with the apparent velocity from correlation methods, but the true velocity is a factor of 2 smaller. This difference might be resolved by searching for scatters showing regular movement between adjacent records.

Meek, C. E.↗

Ionospheric disturbances caused by long period sound waves generated by Saturn-Apollo launches

Wavelike disturbances were observed in the ionosphere following several nuclear explosions in early 1960's. Supersonic shock waves within the atmosphere generated by large rockets can cause ionospheric electron density perturbations. A CW phase path Doppler array in the New York area was operated during the Saturn-Apollo 12 and 13 launches and recorded Doppler frequency fluctuations due to rocket launchings. Cross correlation and power spectral analyses of the phase path-path Doppler frequency variation records showed that the phase velocities of the signal arrivals were from south of the array with 700 - 800 m/sec corresponding to periods in the range of 2 to 4 minutes. Ionograms taken every 60 seconds from Wallops Islands showed clearly ionospheric disturbances due to rockets. The group velocities were estimated to be of the order of 450 m/sec 1 obtained from the earliest visible disturbances seen on CW phase path Doppler records and ionograms together with the rocket trajectory data.

Rao, G. L.↗

Rough surface wavelength measurement through self mixing of Doppler microwave backscatter

A microwave backscatter technique is presented that has the ability to sense the dominant surface wavelength of a random rough surface. The purpose of this technique is to perform this measurement from an aircraft or spacecraft, wherein the horizontal velocity of the radar is an important parameter of the measurement system. Attention will be directed at water surface conditions for which a dominant wavelength can be defined, then the spatial variations of reflectivity will have a two dimensional spectrum that is sufficiently close to that of waves to be useful. The measurement concept is based on the relative motion between the water waves and a nadir looking radar, and the fact that while the instantaneous Doppler frequency at the receiver returned by any elementary group of scatterers on a water wave is monotonically changing, the difference in the Doppler frequency between any two scattering 'patches' stays approximately constant as these waves travel parallel to the major axis of an elliptical antenna footprint. The results of a theoretical analysis and a laboratory experiment with a continuous wave (CW) radar that encompasses several of the largest waves in the illuminated area show how the structure in the Doppler spectrum of the backscattered signal is related to the surface spectrum and its parameters in an especially direct and simple way when an incoherent envelope detector is the receiver.

Weissman, D. E.↗

Measurement capabilities of a one-dimensional LDV system

The capability is investigated of a single component laser Doppler velocimeter (LDV) system for the measurement of three dimensional mean and turbulent flow statistics. Sets of general equations defining the parameters measured by a single component LDV system are derived. Solutions to the equations for different configurations of a single forward scatter LDV system show that three-dimensional mean velocity measurements can be made with a minimum restriction on the precision for detecting the Doppler frequency. Measurements of the three-dimensional cross products and correlation parameters are shown to require a significantly higher precision in the Doppler frequency detection.

Cliff, W. C.↗

Multibeam single frequency synthetic aperture radar processor for imaging separate range swaths

A single-frequency multibeam synthetic aperture radar for large swath imaging is disclosed. Each beam illuminates a separate ""footprint'' (i.e., range and azimuth interval). The distinct azimuth intervals for the separate beams produce a distinct Doppler frequency spectrum for each beam. After range correlation of raw data, an optical processor develops image data for the different beams by spatially separating the beams to place each beam of different Doppler frequency spectrum in a different location in the frequency plane as well as the imaging plane of the optical processor. Selection of a beam for imaging may be made in the frequency plane by adjusting the position of an aperture, or in the image plane by adjusting the position of a slit. The raw data may also be processed in digital form in an analogous manner.

Jain, A.↗

Coherent summation of spatially distorted Doppler lidar signals using a two-dimensional heterodyne detector array

We have investigated the improvement in the signal-to-noise ratio for a coherent Doppler lidar through the use of a multi-element heterodyne detector array. Such an array enables the spatial summation of atmospheric refractive turbulence induced speckles, and time varying target speckles. Our recent experiments have shown that the non-coherent summation of the lidar signals from a heterodyne detector array can enhance the heterodyne mixing efficiency and thus the signal-to-noise ratio. In this paper, we expand this work to include the coherent summation of array signals. The digitized heterodyne signals were stored in a personal computer. Fast Fourier transforms were performed on both the non-coherent and coherent summations of the detector array signals. It was found that the coherent summation greatly enhanced the accuracy in the Doppler frequency estimate. A theoretical analysis was performed and indicated good agreement with experimental results. We have also applied these results to the more general lidar applications including atmospheric wind sensing, and have found that in most lidar applications the Doppler frequency estimate is increased through the use of the heterodyne detector array.

Chan, Kin Pui↗

Experimental Validation of Pulse Phase Tracking for X-Ray Pulsar Based

Pulsars are a form of variable celestial source that have shown to be usable as aids for autonomous, deep space navigation. Particularly those sources emitting in the X-ray band are ideal for navigation due to smaller detector sizes. In this paper X-ray photons arriving from a pulsar are modeled as a non-homogeneous Poisson process. The method of pulse phase tracking is then investigated as a technique to measure the radial distance traveled by a spacecraft over an observation interval. A maximum-likelihood phase estimator (MLE) is used for the case where the observed frequency signal is constant. For the varying signal frequency case, an algorithm is used in which the observation window is broken up into smaller blocks over which an MLE is used. The outputs of this phase estimation process were then looped through a digital phase-locked loop (DPLL) in order to reduce the errors and produce estimates of the doppler frequency. These phase tracking algorithms were tested both in a computer simulation environment and using the NASA Goddard Space flight Center X-ray Navigation Laboratory Testbed (GXLT). This provided an experimental validation with photons being emitted by a modulated X-ray source and detected by a silicon-drift detector. Models of the Crab pulsar and the pulsar B1821-24 were used in order to generate test scenarios. Three different simulated detector trajectories were used to be tracked by the phase tracking algorithm: a stationary case, one with constant velocity, and one with constant acceleration. All three were performed in one-dimension along the line of sight to the pulsar. The first two had a constant signal frequency and the third had a time varying frequency. All of the constant frequency cases were processed using the MLE, and it was shown that they tracked the initial phase within 0.15% for the simulations and 2.5% in the experiments, based on an average of ten runs. The MLE-DPLL cascade version of the phase tracking algorithm was used in the varying frequency case. This resulted in tracking of the phase and frequency by the DPLL outputs in both the simulation and experimental environments. The crab pulsar was experimentally tested with a trajectory with a higher acceleration. In this case the phase error tended toward zero as the observation extended to 250 seconds and the doppler frequency error tended to zero in under 100 seconds.

Experimental↗

Method and System for Producing Images of an Object

A method and system are provided to produce images of an object. A receiving station is positioned in view of a range-coded signal emitting satellite and the object. The receiving station is sensitive to direct transmission of the range-coded signal and reflections of the range-coded signal from the object. Both range from the receiving station to the object and a Doppler frequency shift history between the receiving station and the object is determined using the direct transmission and reflections of the range-coded signal. An image is formed using the two-dimensional record provided by the range and the Doppler frequency shift history.

Katzberg, Stephen J.↗

Lowest-order average effect of turbulence on atmospheric profiles derived from radio occultation

Turbulence in planetary atmospheres and ionospheres causes changes in angles of refraction of radio waves used in occultation experiments. Atmospheric temperature and pressure profiles, and ionospheric electron concentration profiles, derived from radio occultation measurements of Doppler frequency contain errors due to such angular offsets. The lowest-order average errors are derived from a geometrical-optics treatment of the radio-wave phase advance caused by the addition of uniform turbulence to an initially homogeneous medium. It is concluded that the average profile errors are small and that precise Doppler frequency measurements at two or more wavelengths could be used to help determine characteristics of the turbulence, as well as accuracy limits and possible correction terms for the profiles. However, a more detailed study of both frequency and intensity characteristics in radio and optical occultation measurements of turbulent planetary atmospheres and ionospheres is required to realize the full potential of such measurements.

Eshleman, V. R.↗

Multipath induced errors in meteorological Doppler/interferometer location systems

One application of an RF interferometer aboard a low-orbiting spacecraft to determine the location of ground-based transmitters is in tracking high-altitude balloons for meteorological studies. A source of error in this application is reflection of the signal from the sea surface. Through propagating and signal analysis, the magnitude of the reflection-induced error in both Doppler frequency measurements and interferometer phase measurements was estimated. The theory of diffuse scattering from random surfaces was applied to obtain the power spectral density of the reflected signal. The processing of the combined direct and reflected signals was then analyzed to find the statistics of the measurement error. It was found that the error varies greatly during the satellite overpass and attains its maximum value at closest approach. The maximum values of interferometer phase error and Doppler frequency error found for the system configuration considered were comparable to thermal noise-induced error.

Wallace, R. G.↗