SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
In accomplishing the Gemini Program objectives, an onboard digital computer system, an inertial platform reference system, a radar system, and control systems using hypergolic bipropellant propulsion have been developed and successfully demonstrated.
Gyroless Solar Pointing Aerobee Rocket Control System /SPARCS/ using no inertial platform and having solid state circuitry
Gyroless Solar Pointing Aerobee Rocket Control System /SPARCS/ using no inertial platform and having solid state circuitry
Fourth angle driving law for different four gimbal systems used for simulation display and inertial platform isolation
An analysis of the principles of strapdown inertial platforms is presented, and the advantages of the strapdown system as compared to other stabilized systems are discussed. The application of the rebalance loop to continuously restore the position of sensor output axes is described. The attitude logarithms and the rebalance electronics which are required for accurate navigation are examined.
The attitude algorithms applied to strapdown inertial platforms are discussed. A review of six attitude transformation algorithms and the realizations of these algorithms by digital differential analyzers are presented. The number of digital differential analyzers for each algorithm is either smaller than or equal to that obtained by others.
The paper describes two self-test procedures applied to the problem of estimating the biases in accelerometers and gyroscopes on an inertial platform. The first technique is the weighted sum-squared residual (WSSR) test, with which accelerator bias jumps are easily isolated, but gyro bias jumps are difficult to isolate. The WSSR method does not take full advantage of the knowledge of system dynamics. The other technique is a multiple hypothesis method developed by Buxbaum and Haddad (1969). It has the advantage of directly providing jump isolation information, but suffers from computational problems. It might be possible to use the WSSR to detect state jumps and then switch to the BH system for jump isolation and estimate compensation.
An attitude control system is described in which angular rate signals are generated by rate gyros mounted closely adjacent to gimbaled engines at the rear of a vehicle. Error signals representative of a commanded change in vehicle angle or attitude are obtained from a precision inertial platform located in the nose region of the vehicle. The rate gyro derived signals dominate at high frequencies where dynamic effects become significant, and platform signals dominate at low frequencies where precision signals are required for a steady vehicle attitude. The blended signals are applied in a conventional manner to control the gimbaling of vehicle engines about control axes.
A flight instrumentation system for the acquisition of atmospheric turbulence data is described. Airflow direction transducers and an impact pressure transducer are the primary instruments for measuring vertical and lateral gust velocity, and a sensitive incremental pressure transducer is used to measure longitudinal gust velocity. Airplane motions, sensed by an inertial platform, are subtracted from the primary measurements during postflight data reduction to yield true gust velocity time histories. Salient engineering features of the instrumentation are discussed, and a complete description of the instrumentation is presented.
A technique is described for precise registration of two images of the same area, taken under different conditions. The technique, called AUTO-MATCH, involves digital preprocessing of the images to extract edge contours, followed by a correlation of corresponding edge end points. The availability of an array of endpoints makes possible subpixed registration accuracy. The technique is applied to a system for assessment of geometric image quality, to be installed at NASA-Goddard. This system measures the registration vectors over an array of window pairs from LANDSAT images, so as to determine the distortion between them. Similar measurements could be used to infer relative positioning of the spacecraft. The technique is considered for updating the inertial navigation systems of missiles or aircraft. Scene matching between an image obtained aboard the vehicle and a stored reference can eliminate the drift of an inertial platform in order to demonstrate this capability in real time. A laboratory demonstration of AUTO-MATCH is described.
The results of a six degree of freedom (6-DOF) nonlinear Monte Carlo dispersion analysis for the latest glide return to landing site (GRTLS) abort trajectory for the Space Transportation System 1 Flight are presented. For this GRTLS, the number two main engine fails at 262.5 seconds ground elapsed time. Fifty randomly selected simulations, initialized at external tank separation, are analyzed. The initial covariance matrix is a 20 x 20 matrix and includes navigation errors and dispersions in position and velocity, time, accelerometer bias, and inertial platform misalinements. In all 50 samples, speedbrake, rudder, elevon, and body flap hinge moments are acceptable. Transitions to autoland begin before 9,000 feet and there are no tailscrapes. Navigation derived dynamic pressure accuracies exceed the flight control system constraints above Mach 2.5. Three out of 50 landings exceeded tire specification limit speed of 222 knots. Pilot manual landings are expected to reduce landing speed by landing farther downrange.
This paper describes the development of a three-dimensional digital integrated automatic landing system (DIALS) for a small commercial jet transport. The system uses the Microwave Landing System (MLS), body-mounted accelerometers, as well as on-board sensors usually available on commercial aircraft, but does not require inertial platforms. The system development uses modern digital control techniques. The phases of flight considered are the localizer and glideslope capture, which may be performed simultaneously or sequentially, localizer and glideslope track (hold), crab/decrab, and flare to touchdown. The system captures, tracks and flares from steep glideslopes (2.5 - 5.5 deg) selected prior to glideslope capture. The results of a nonlinear simulation are presented.
The design and development of a 3-D Digital Integrated Automatic Landing System (DIALS) for the Terminal Configured Vehicle (TCV) Research Aircraft, a B-737-100 is described. The system was designed using sampled data Linear Quadratic Gaussian (LOG) methods, resulting in a direct digital design with a modern control structure which consists of a Kalman filter followed by a control gain matrix, all operating at 10 Hz. DIALS uses Microwave Landing System (MLS) position, body-mounted accelerometers, as well as on-board sensors usually available on commercial aircraft, but does not use inertial platforms. The phases of the final approach considered are the localizer and glideslope capture which may be performed simultaneously, localizer and steep glideslope track or hold, crab/decrab and flare to touchdown. DIALS captures, tracks and flares from steep glideslopes ranging from 2.5 deg to 5.5 deg, selected prior to glideslope capture. Digital Integrated Automatic Landing System is the first modern control design automatic landing system successfully flight tested. The results of an initial nonlinear simulation are presented here.
The application of extended Kalman filtering to estimating the Space Shuttle Propulsion performance, i.e., specific impulse, from flight data in a post-flight processing computer program is detailed. The flight data used include inertial platform acceleration, SRB head pressure, SSME chamber pressure and flow rates, and ground based radar tracking data. The key feature in this application is the model used for the SRB's, which is a nominal or reference quasi-static internal ballistics model normalized to the propellant burn depth. Dynamic states of mass overboard and propellant burn depth are included in the filter model to account for real-time deviations from the reference model used. Aerodynamic, plume, wind and main engine uncertainties are also included for an integrated system model. Assuming uncertainty within the propulsion system model and attempts to estimate its deviations represent a new application of parameter estimation for rocket powered vehicles. Illustrations from the results of applying this estimation approach to several missions show good quality propulsion estimates.
The aplication of extended Kalman filtering to estimating Space Shuttle Solid Rocket Booster (SRB) performance, specific impulse, from flight data in a post-flight processing computer program. The flight data used includes inertial platform acceleration, SRB head pressure, and ground based radar tracking data. The key feature in this application is the model used for the SRBs, which represents a reference quasi-static internal ballistics model normalized to the propellant burn depth. Dynamic states of mass overboard and propellant burn depth are included in the filter model to account for real-time deviations from the reference model used. Aerodynamic, plume, wind and main engine uncertainties are included.
The Rapid Geodetic Survey System (RGSS) is a system employing a high-accuracy gimbaled inertial platform. It provides a cost-effective capability for accurate direct measurement of the change in position, elevation, gravity intensity and deflection of the vertical from an initial point. The RGSS is an adaptation of the production version of the U.S. Army Position and Azimuth Determining System (PADS). Several hardware and software enhancements to improve the performance of the system, primarily for gravity vector survey, have occurred over the last few years. The basic principles for the control of error in the survey measurements due to noise and systematic error are discussed below. Actual acceptance test results for the RGSS which indicate an inherent capability of the system to measure change in the deflection of the vertical to a few-tenths of an arcsecond over survey periods of one to two hours using careful survey techniques are also presented. Finally a simple method to extend the capability of the system for longer duration surveys is indicated.
An inertial navigation system is described and analyzed based on two two-degree-of-freedom Schuler-gyropendulums and one two-degree-of-freedom azimuth gyro. The three sensors, each base motion isolated about its two input axes, are mounted on a common base, strapped down to the vehicle. The up and down pointing spin vectors of the two properly tuned gyropendulums track the vertical and indicate physically their velocity with respect to inertial space. The spin vector of the azimuth gyro is pointing northerly parallel to the earth axis. The system can be made self-aligning on a stationary base. If external measurements for the north direction and the vertical are available, initial disturbance torques can be measured and easily biased out. The error analysis shows that the system is practicable with today's technology.
Limitations on inertial sensor testing produced by test platform vibrations