Search NASA⌕ Search

SEARCH · Search NASA

Results for “LUNAR PHASE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Moessbauer search for ferric oxide phases in lunar materials and simulated lunar materials

Moessbauer studies were carried out on lunar fines and on simulated lunar glasses containing magnetic-like precipitates with the primary objective of determining how much, if any, ferric oxide is present in the lunar soils. Although unambiguous evidence of lunar Fe(3+) phases was not obtained, an upper limit was estimated from different portions of the Moessbauer spectra to be between 0.1 and 0.4 wt.% (as Fe3O4). A smaller than 62 microns fraction of 15021,118 showed 0.5 wt.% ferromagnetic iron at 300 K in as-returned condition. After heating to 650 C in an evacuated, sealed quartz tube for 1400 hours, the same sample exhibited 1 wt.% ferromagnetic iron at room temperature. An accompanying decrease in excess absorption area near zero velocity was noted. Thus, the result of the vacuum heat treatment was to convert fine grained iron to larger particles, apparently without the oxidation effects commonly reported.

Forester, D. W.↗
NASA NTRS2006

Trajectory Design of the Lunar Impactor Mission Concept

The National Aeronautics and Space Administration (NASA) solicited proposals in 2006 for an opportunity to include a small secondary payload with the launch of the Lunar Reconnaissance Orbiter (LRO) scheduled for October 2008. The cost cap of the proposal was between $50 and $80M, and the mass cap was 1,000 kilograms. JPL proposed a Lunar Impactor (LI) concept for this solicitation. The mission objective of LI was to impact the permanently shadowed region of a South polar crater ultimately to detect the presence of water. The detection of water ice would prove to be an important factor on future lunar exploration. NASA Ames Research Center also proposed a similar concept, the Lunar Crater observation and Sensing Satellite (LCROSS), which was selected by NASA for the mission. However, in this paper, the trajectory design of the LI proposed by JPL is considered. Since the LI spacecraft was to be launched on the LRO launch vehicle as a secondary payload, its initial trajectory must be diverted at some later time from the LRO trans-lunar trajectory for the subsequent impact. Several such trajectories have been considered, where each trajectory option fields some specific values for the mission parameters. The mission parameters include the availability of LRO instruments at the time of impact for the observation by LRO, the mission duration, the impact velocity, the impact angle, etc. It is possible for the LI to be deflected with a relatively low delta-V to impact a South polar crater at a reasonable impact velocity and impact angle directly with no delay. However, the instruments on-board LRO may not be ready for observation. Thus, several delayed trajectory options have been considered further. The lunar phase at the time of impact may also play an important factor for observation, especially from Earth. Several lunar flyby trajectory maneuvers have been identified to arrive at the Moon for impact at the desired lunar phase. By using a combination of these successive lunar flyby maneuvers, the impact lunar phase may be adjusted to the desired location. A few such trajectories have been suggested. Also, some attempts have been made to maximize the impact velocity by converting the impact trajectory into a retrograde orbit with respect to Earth. Since these types of trajectories take advantage of the Sun-Earth three-body region to minimize the delta-V, the mission duration is relatively long. A few such trajectories are suggested. Also, an attempt has been made to adjust the lunar impact within a desired time period for the optimum Earth observation for the above trajectories. The mission parameters resulting from each trajectory option above are considered and weighed against the cost and robustness of the mission in a brief summary.

trajectory design↗
NASA NTRS1992

Artemis common lunar lander. Phase 2: Study results for external review

The purpose of the Artemis Program is to gather vital reconnaissance data by conducting robotic exploration missions to the lunar surface both prior to and concurrent with human exploration missions. The Artemis Program includes rapid, near-term development of a variety of small experimental and operational payloads, provides a low-cost capability to deliver these payloads to any location on the lunar surface, and supports the analysis of the data returned. The Artemis Program will improve the understanding of lunar geosciences, demonstrate the Moon's unique capability as an astronomical platform to study the universe, and to conduct scientific and technology development experiments, and will prepare for, enhance, and complement human mission The Artemis Common Lunar Lander Phase 2 Study results for external review are included.

Source record↗
NASA NTRS1978

Characterization of lunar ferromagnetic phases by the effective linewidth method

The effective line-width technique, first developed to study the physics of microwave relaxation in ferrites, has been successfully applied to lunar matter. Effective line-width measurements have been made on two selected samples containing disperse spherical metallic iron particles below 40 microns in diam. The data were obtained for fields from 7 to 12 kOe and a temperature range 125 - 300 K. The effective line width was field-independent and temperature-independent at 650 - 750 Oe. The high-field tails of the ferromagnetic resonance absorption were highly Lorentzian. From the relatively large and temperature-independent high-field effective line widths, it appears that (1) the metallic iron phases in lunar soil are rather impure; (2) the impurities are passive, in that there is no evidence for a temperature peak process; and (3) these samples contain no appreciable magnetite.

Patton, C. E.↗
NASA NTRS1972

Temperature-time relationships from lunar two phase metallic particles /14310, 14163, 14003/.

Electron-microprobe and metallographic techniques are applied in an analysis of individual phases in two-phase metallic alpha + gamma particles and phosphide-metal particles separated magnetically or mechanically from three lunar soil samples. The interface equilibrium temperatures of the two-phase particles during their lunar residence are inferred from experimental Fe-Ni and Fe-Ni-P equilibrium diagrams. Times of equilibration are determined in some cases.

Axon, H. J.↗
NASA NTRS2012

In Situ Chemical Characterization of Mineral Phases in Lunar Granulite Meteorite Northwest Africa 5744

Northwest Africa (NWA) 5744 meteorite is a granulitic and troctolitic lunar breccia which may represent nearly pristine lunar crust (Fig. 1). NWA 5744 is unusually magnesian compared to other lunar breccias, with bulk [Mg/(Mg+Fe)] ~ 0.79 [1, 2]. Inspection shows impactor content is likely to be very minor, with low Ni content and a lack of metal grains. Some terrestrial contamination is present, evidenced by calcite within cracks. NWA 5744 has notably low concentrations of incompatible trace elements (ITEs) [2]. The goal of this study is to attempt to classify this lunar granulite through analyses of in situ phases.

Kent, J. J.↗
NASA NTRS2020

Improved Lunar Irradiance Model Using Multiyear MODIS Lunar Observations

The Moderate Resolution Imaging Spectroradiometer (MODIS) instruments on board the Terra and Aqua spacecrafts were launched on December 18, 1999, and May 4, 2002, respectively. One of the features of the MODIS instruments is the ability to perform observations of the lunar surface from its space view (SV) port. This event is scheduled approximately once a month via a spacecraft roll maneuver, which enables the lunar phase to be confined to within 1° for each instrument. The Moon is considered to be an extremely stable reference to monitor the long-term radiometric stability of the reflective solar bands (RSB). Each MODIS instrument can also view the Moon for about four months in a year without a roll maneuver. This is caused by the intrusion of the Moon in the SV. The lunar phase angles of these unscheduled lunar observations are distributed over a wide range varying from approximately 50° to 80° for Terra MODIS and from about -80° to -50° for Aqua MODIS, where the positive phase angle refers to a waning Moon, while the negative phase angle corresponds to a waxing Moon. Together, the scheduled and unscheduled lunar observations are used to monitor the long-term radiometric stability of the RSB. Of the several challenges involved in the modeling of the lunar optical properties, such as its absolute brightness, a number of optical and view geometry effects need to be considered. These effects are much easier to characterize for the scheduled observations due to confinement of the lunar phase angles compared to those for the unscheduled intrusions of the Moon in the SV. Nevertheless, it is still a challenge to remove the view geometry effect in the calibration coefficients derived from the scheduled lunar observations and even more challenging for the unscheduled lunar intrusions. In this work, the lunar absolute irradiance is modeled using known attributes and from the lunar observations by the two MODIS instruments from the time period between the years 2005 and 2012.

Calibration↗
NASA NTRSDate not supplied

Overview of NASA’s Break the Ice Lunar Challenge Phase 1

As NASA works to extend human exploration of the solar system, a sustained presence on the Moon will be critical for developing and testing the technologies and systems needed for future missions to Mars and beyond. In situ resource utilization (ISRU)—the use of lunar materials for life support, fuel, energy, manufacturing, and construction—is necessary to limit the delivery of supplies from Earth. One of the most important of these resources is water. Water supports all life on Earth and will be critical to supporting human exploration beyond Earth. On the Moon, water is trapped in icy regolith at the lunar poles, including inside permanently dark and cold craters. Novel approaches are needed to excavate the icy regolith and transport it for processing in support of permanent human missions on the Moon. To accelerate the development of such approaches and to seek diverse ideas, NASA’s Centennial Challenges launched the Break the Ice Lunar Challenge in November 2020. Phase 1 of the challenge was focused on stimulating innovative approaches for excavating icy regolith and delivering water in extreme lunar environmental conditions. The challenge sought to incentivize solutions for maximizing water delivery while minimizing energy use and the mass of equipment required to be transported to the lunar surface. Submissions for phase 1 of the challenge were due in June 2021 and winners were announced in August 2021. This paper provides details about the execution of the challenge, solutions received, criteria used to select winning solutions, and status of the phase 2 of the challenge.

Naveen Vetcha↗
NASA NTRS1973

Melting behavior and phase relations in the lunar interior

Phase equilibrium experiments at both high and low pressures on lunar samples and synthetic compositions are reported as well as related petrographic studies of lunar rock samples. The objectives were to trace the origins of rocks found on the lunar surface, to characterize the nature of the lunar interior and to locate and identify the sources of lunar magmas.

Hays, J. F.↗