SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A comparison of total system cost is made between solar photovoltaic and laser/receiver systems. The laser systems assume either a solar-pumped CO2 blackbody transfer laser with MHD receiver or a solar pumped liquid neodymium laser with a photovoltaic receiver. Total system costs are less for the laser systems below 300 km where drag is significant. System costs are highly dependent on altitude.
A simple technique for long-pulse (0.2-2 microsec) generation with neodymium lasers has been demonstrated. Under the proper conditions, a normal-mode oscillator, operated in a single transverse mode, produces well-defined relaxation oscillations from which a single subpulse can be isolated for amplification. The characteristic subpulse temporal profile is ideal for saturated amplification without pulse shortening. Data are presented for a Nd:YLF system consisting of an oscillator followed by a 64-nm-long amplifier. Pulse energies in excess of 100 mJ were achieved with a small-signal gain of 630.
Energy levels and spectral broadening of neodymium ions in laser glass from fluorescence and absorption spectra
Laser oscillations and optical spectra of neodymium doped calcium fluorophosphate crystals
Development, fabrication, and evaluation of neodymium doped YAG laser rods
Preliminary results of an experimental study conducted to investigate the dynamic behavior of flames in explosive gases are presented. The medium was an equimolar acetylene-oxygen mixture maintained initially at a pressure of 110 torr. and room temperature in an experimental vessel 9 cm in internal diameter. Ignition was performed by means of a neodymium laser beam focused on a 0.3 mm diameter steel wire. Experimental observations were performed by the use of a stroboscopic laser-schlieren system yielding a set of photographic records of wave phenomena at a frequency of 200,000 per second. The records reveal the existence of a number of shocks which by a thorough analysis of the blast wave generated by the ignition process, are shown to be due entirely to the flame generated flow field. The capability of a flame to form blast waves in an expanding spherical geometry is thus established, providing an experimental demonstration of the significance the dynamic effects of combustion can achieve.
The results of experimental measurements of the coherent anti-Stokes Raman spectra of water vapor in flames are reported. A pulsed, frequency-doubled neodymium laser was used to supply the pump beam and to pump a dye laser to provide a broadband Stokes beam at 6600 A. Spectra were obtained in the postflame region of a premixed methane-air flame in the Raman frequency shift region of the symmetric stretch mode (3651.7 kaysers) at an approximate temperature of 1675 K. A theoretical calculation of the coherent anti-Stokes Raman spectrum of water vapor at this temperature was made, taking into account only isotropic Q-branch transitions, and using the energy level data of Floud et al. (1976). The theoretical prediction is shown essentially to reproduce all qualitative features of the experimental spectrum, and to exhibit a strong temperature dependence.
The insulating properties of thermal barrier coatings (TBCs) provide highly beneficial thermal protection to turbine engine components by reducing the temperature sustained by those components. Therefore, measuring the temperature beneath the TBC is critical for determining whether the TBC is performing its insulating function. Currently, noncontact temperature measurements are performed by infrared pyrometry, which unfortunately measures the TBC surface temperature rather than the temperature of the underlying component. To remedy this problem, the NASA Glenn Research Center, under the Information Rich Test Instrumentation Project, developed a technique to measure the temperature beneath the TBC by incorporating a thin phosphor layer beneath the TBC. By performing fluorescence decay-time measurements on light emission from this phosphor layer, Glenn successfully measured temperatures from the phosphor layer up to 1100 C. This is the first successful demonstration of temperature measurements that penetrate beneath the TBC. Thermographic phosphors have a history of providing noncontact surface temperature measurements. Conventionally, a thermographic phosphor is applied to the material surface and temperature measurements are performed by exciting the phosphor with ultraviolet light and then measuring the temperature-dependent decay time of the phosphor emission at a longer wavelength. The innovative feature of the new approach is to take advantage of the relative transparency of the TBC (composed of yttria-stabilized zirconia) in order to excite and measure the phosphor emission beneath the TBC. The primary obstacle to achieving depth-penetrating temperature measurements is that the TBCs are completely opaque to the ultraviolet light usually employed to excite the phosphor. The strategy that Glenn pursued was to select a thermographic phosphor that could be excited and emit at wavelengths that could be transmitted through the TBC. The phosphor that was selected was yttria doped with europia (Y2O3:Eu), which has a minor excitation peak at 532 nm (green) and an emission peak at 611 nm (red)--both are wavelengths that exhibit significant transmission through the TBC. The measurements were performed on specimens consisting of a 25- m-thick phosphor layer beneath a 100- m-thick TBC. The 532-nm (green) excitation light was provided by a frequency-doubled YAG:Nd (yttrium-aluminum-garnet:neodymium) laser, and the fluorescence decay time measurements were acquired with a modified Raman microscope. The preceding graph compares the intensity of the phosphor emission of the phosphor layer above the TBC versus that of the phosphor layer beneath the TBC. Although there was considerable attenuation of the phosphor signal (a factor of 30), the phosphor emission at the reduced intensity was more than sufficient to perform fluorescence decay time measurements. The following graph shows the fluorescence lifetime temperature dependency for the Y2O3:Eu phosphor layers both above and below the TBC. These curves show an excellent match and indicate that, despite the attenuation due to the overlying TBC, the phosphor layer beneath the TBC still functions as an effective temperature indicator.
Preliminary results are presented of the efficient diode-pumped operation of a neodymium yttrium aluminum borate (NYAB) laser at 531.5 nm using two 1-W diode-laser arrays for the pump. With 1380 mW of CW power incident on the crystal, as much as 51 mW of 532.5-nm laser radiation was obtained with the unoptimized cavity. The corresponding optical-to-optical conversion efficiency was 3.7 percent. A plot of the output 531.5 nm vs incident 807 nm pump power is shown. The crystal output power was critically dependent on the rotational and translational adjustment of the NYAB crystal inside the cavity. It is suggested that a crystal cut at the exact phase matching angle, placed in a cavity with proper optimal reflection and transmission mirror coatings, and pumped at proper wavelength can result in higher output power. Thus, the NYAB output power approaches that of a CW intracavity frequency doubled Nd:YAG laser.
Amplification and thermally induced phase distortions in a cw pumped laser head with an active element in the form of a thin Yb : YAG slab are experimentally studied. Lasing characteristics of an emitter based on this laser head are examined. Laser radiation is obtained with an average power of 32 W and a slope efficiency with respect to the absorbed pump power η = 68 %. (paper)
The emission spectra of krypton plasma in the range of 8 – 14 nm upon excitation of a pulsed gas jet by 1.06-mm Nd : YAG laser radiation with a pulse energy of 0.85 J, pulse duration of 5.2 ns, and repetition rate of 10 Hz are investigated. The krypton emission spectrum is a wide (8 – 14 nm) band, peaking at 10.3 nm, which is formed by a series of much narrower lines. The observed lines are identified, and the fraction of laser pulse energy converted into the (8 – 14)-nm emission band and emitted into half-space (2π sr) is determined. The maximum conversion efficiency is found to be 21 %. The expected throughputs of lithographic systems with sources based on Sn, Xe, and Kr ions for different wavelengths, corresponding to the emission peaks of ions of these materials, are compared. (paper)
Different modifications of acousto-optic modulators (AOMs) based on KG(WO{sub 4}){sub 2} (KGW) and KY(WO{sub 4}){sub 2} (KYW) crystals, designed for Q switching of high-power pulsed lasers, is developed and investigated. It is shown that AOMs based on these crystals are universal, can be combined with different lasers in the wavelength range of 1 – 3 μm, and have a high radiation resistance in the absence of antireflection coatings and light input at Brewster’s angle. The operation efficiency of KGW-based AOMs is experimentally demonstrated. Solid-state lasers based on Cr : Er : YSGG (λ = 2.78 μm), Cr : Yb : Ho : YSGG (λ = 2.87 μm), Cr : Tm : Ho : YSGG (λ = 2.09 μm), and Nd : YAG (λ = 1.064 μm) crystals with active acousto-optic Q switching, operating in the repetitively pulsed regime with a high beam quality and without surface destruction, are investigated. Lasing pulses (30 – 60)-ns long with energy up to 32 mJ at a repetition rate from 1 to 1000 Hz are obtained. (paper)
Optical parametric chirped-pulse amplification (OPCPA) using high-energy Nd:glass lasers has the potential to produce ultra-intense pulses (>10 23 W/cm 2 ). We report on the performance of the final high-efficiency amplifier in an OPCPA system based on large-aperture (63 x 63-mm 2 ) partially deuterated potassium dihydrogen phosphate (DKDP) crystals. Here, the seed beam (170 nm, 240 mJ) was provided by the preceding OPCPA stages. The maximum pump-to-signal conversion efficiency of 37% was achieved with a 52-mm-long DKDP crystal and 40-J pump energy at 527 nm due to the flattop super-Gaussian pump beam profile and flat-in-time pulse shape. The 11.8-J output signal was compressed to 19 fs.
In recent experiments, 80-mW CW power in a single mode has been achieved from a neodymium:yttrium aluminum garnet (Nd:YAG) laser with only 1 W of electrical power input to a single semiconductor laser array pump. This corresponds to an overall efficiency of 8 percent, the highest reported CW efficiency for a Nd:YAG laser. A tightly focused semiconductor laser end pump configuration is used to achieve high pumping intensities (on the order of 1 kW/sq cm), which in turn causes the photon to photon conversion efficiency to approach the quantum efficiency (76 percent for Nd:YAG at 1.06 microns pumped at 0.810 micron). This is achieved despite the dual-lobed nature of the pump. Through the use of simple beam-combining schemes (e.g., polarization coupling and multireflection point pumping), output powers over 1 W and overall electrical to optical efficiencies as high as 10 percent are expected.
The tunable nature of lasers provides for a wide range of applications. Most applications rely on finding available laser wavelengths to meet the needs of the research. This article presents the concept of compositional tuning, whereby the laser wavelength is designed by exploiting nonstoichiometry. For research where precise wavelengths are required, such as remote sensing, this is highly advantageous. A theoretical basis for the concept is presented and experimental results in spectroscopic measurements support the theoretical basis. Laser operation nicely demonstrates the validity of the concept of designer lasers.
The effect of laser generated stress waves on the microstructure, hardness, strength and stress corrosion resistance of 2024 and 7075 aluminum alloys was investigated. Pulsed CO2 and neodymium-glass lasers were used to determine the effect of wavelength and pulse duration on pressure generation and material property changes. No changes in material properties were observed with CO2 laser. The strength and hardness of 2024-T351 and the strength of 7075-T73 aluminum alloys were substantially improved by the stress wave environments generated with the neodymium-glass laser. The mechanical properties of 2024-T851 and 7075-T651 were unchanged by the laser treatment. The correlation of the laser shock data with published results of flyer plate experiments demonstrated that a threshold pressure needed to be exceeded before strengthening and hardening could occur. Peak pressures generated by the pulsed laser source were less than 7.0 GPa which was below the threshold pressure required to change the mechanical properties of 2024-T851 and 7075-T651. Corrosion studies indicated that laser shocking increased the resistance to local attack in 2024-T351 and 7075-T651.
Using pulses of multifrequency stimulated Raman scattering (SRS) in calcite, nonlinear photoluminescence in a stilbene molecular crystal is excited. When multifrequency SRS is excited by the radiation of a Nd{sup 3+} : YAG laser with a wavelength of 1064 nm, eleven anti-Stokes components are observed in the visible spectrum with an average frequency shift of 1086 cm{sup −1} between them. Using the second harmonic of the Nd {sup 3+} : YAG laser radiation allowed three anti-Stokes and four Stokes components to be recorded. The large spectral range of the frequency comb facilitated effective reduction in the duration and increase in the intensity of the radiation pulse of multifrequency SRS. (nonlinear optical phenomena)
Frequency and polarization selection of neodymium glass laser oscillators by directing secondary radiation into laser cavity and duplicating spectral properties