Search NASA⌕ Search

SEARCH · Search NASA

Results for “PROPELLER THRUST”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1952

An Investigation of the Effect of the WADC 30,000-Horsepower Whirl Rig Upon the Static Characteristics of a Propeller

Tests have been made at the Langley Aeronautical Laboratory on a 6000-horsepower propeller dynamometer installed at a ground test facility to determine the effect of a half-scale model of the Wright Aeronautical Development Center 30,000-horsepower whirl rig upon the aerodynamic characteristics of a three-blade NACA 10-(3)(062)-045 propeller. The model of the whirl rig was mounted in front of the 6000-horsepower propeller dynamometer. Static propeller tests were made for 0deg, 5deg, 10deg, 15deg, and 20deg blade angles over a range of rotational speeds from 600 to 2200 rpm in 100-rpm increments. Measurements were made of propeller thrust and torque, stresses in the propeller blades, and static and total pressures over the surface of the model. Propeller thrust and torque were increased up to 33 percent by the presence of the model of the whirl rig, but the average increase was from 5 to 10 percent. Blade vibratory stresses were small.

Salters, Leland B., Jr.↗
NASA NTRS1945

Effect of Propeller-Axis Angle of Attack on Thrust Distribution over the Propeller Disk in Relation to Wake-Survey Measurement of Thrust

Tests were made to investigate the variation of thrust distribution over the propeller disk with angle of pitch of the propeller thrust axis and to determine the disposition and the minimum number of rakes necessary to measure the propeller thrust. The tests were made at a low Mach number for a low and a high blade angle with the propeller operating at three small angles of pitch, and some of the tests were repeated at a higher Mach number. The data obtained show that, for small angles of pitch, large changes occur in the energy distribution in the wake which prohibit the use of a single survey rake for thrust measurement in flight tests and limit the use of a single rake in wind-tunnel tests. Under certain conditions, the energy distribution in the wake took on a symmetrical form and two diametrically opposed survey rakes were shown to be satisfactory for obtaining propeller thrust. (author)

Pendley, Robert E↗
NASA NTRS1988

Porous wind tunnel corrections for counterrotation propeller testing

Wind tunnel interference corrections have direct impact on measured propeller efficiency. A systematic series of wind tunnel tests was done in the porous-wall NASA Lewis 8- by 6-Foot Wind Tunnel to determine the wind tunnel interference corrections to the NASA Lewis counterrotation propeller test data. The test results were compared with calculations from a potential flow code to determine the interference corrections. At a Mach number of 0.8, the interference corrections resulted in a -0.008 Mach number correction which reduced the counterrotation propeller net efficiency data by 0.46 percent at the reduced Mach number. Additional wind tunnel tests were done to measure the effect of propeller thrust on wind tunnel wall interference. No wall interference corrections due to propeller thrust were found necessary for the high speed counterrotation propeller data obtained in the porous wall NASA Lewis 8- by 6-Foot Wind Tunnel.

Stefko, George L.↗
NASA NTRS1988

Porous wind tunnel corrections for counterrotation propeller testing

Wind tunnel interference corrections have direct impact on measured propeller efficiency. A systematic series of wind tunnel tests was done in the porous-wall NASA Lewis 8- by 6-Foot Wind Tunnel to determine the wind tunnel interference corrections to the NASA Lewis counterrotation propeller test data. The test results were compared with calculations from a potential flow code to determine the interference corrections. At a Mach number of 0.8, the interference corrections resulted in a -0.008 Mach number correction which reduced the counterrotation propeller net efficiency data by 0.46 percent at the reduced Mach number. Additional wind tunnel tests were done to measure the effect of propeller thrust on wind tunnel wall interference. No wall interference corrections due to propeller thrust were found necessary for the high speed counterrotation propeller data obtained in the porous wall NASA Lewis 8- by 6-Foot Wind Tunnel.

Stefko, George L.↗
NASA NTRS2002

Computational Predictions of the Performance Wright 'Bent End' Propellers

Computational analysis of two 1911 Wright brothers 'Bent End' wooden propeller reproductions have been performed and compared with experimental test results from the Langley Full Scale Wind Tunnel. The purpose of the analysis was to check the consistency of the experimental results and to validate the reliability of the tests. This report is one part of the project on the propeller performance research of the Wright 'Bent End' propellers, intend to document the Wright brothers' pioneering propeller design contributions. Two computer codes were used in the computational predictions. The FLO-MG Navier-Stokes code is a CFD (Computational Fluid Dynamics) code based on the Navier-Stokes Equations. It is mainly used to compute the lift coefficient and the drag coefficient at specified angles of attack at different radii. Those calculated data are the intermediate results of the computation and a part of the necessary input for the Propeller Design Analysis Code (based on Adkins and Libeck method), which is a propeller design code used to compute the propeller thrust coefficient, the propeller power coefficient and the propeller propulsive efficiency.

Wang, Xiang-Yu↗
NASA NTRS1977

A parametric investigation of an existing supersonic relative tip speed propeller noise model

A high tip speed turboprop is being considered as a future energy conservative airplane. The high tip speed of the propeller combined with the cruise speed of the airplane may result in supersonic relative flow on the propeller tips. These supersonic blade sections could generate noise that is a cabin environment problem. An existing supersonic propeller noise model was parametrically investigated to identify and evaluate the noise reduction variables. Both independent and interdependent parameter variations (constant propeller thrust) were performed. The noise reductions indicated by the independent investigation varied from sizable in the case of reducing Mach number to minimal for adjusting the thickness and loading distributions. The noise reduction possibilities of decreasing relative Mach number were further investigated during the interdependent variations. The interdependent investigation indicated that significant noise reductions could be achieved by increasing the propeller diameter and/or increasing the number of propeller blades while maintaining a constant propeller thrust.

Dittmar, J. H.↗
NASA NTRS1945

New Method of Determining the Polar Curve of an Airplane in Flight

A fundamental defect of existing methods for the determination of the polar of an airplane in flight is the impossibility of obtaining the thrust or the resistance of the propeller for any type airplane with any type engine. The new method is based on the premise that for zero propeller thrust the mean angle of attack of the blade is approximately the same for all propellers if this angle is reckoned from the aerodynamic chord of the profile section. This angle was determined from flight tests. Knowing the mean angle of the blade setting the angle of attack of the propeller blade at zero thrust can be found and the propeller speed in gliding obtained. The experimental check of the new method carried out on several airplanes gave positive results. The basic assumptions for the construction of the polars and the method of analyzing the flight data are given.

Yegorov, B. N.↗
NASA NTRS1986

Wing loads induced by a propeller wake

A wing located in the wake of a propeller sustains unsteady loading. This loading can generate components of structureborne noise which are transmitted to the interior of the aircraft. The vibration of the wing can also contribute to reradiation of propeller noise. An analysis system for the evaluation of wing unsteady loads is presented. The propeller wake is modeled as a potential helical tip vortex and unsteady airfoil theory is used to determine the wing response. The result is the forcing function for determining the structureborne noise. The wing response is evaluated as a function of propeller thrust coefficient, advance ratio, and propeller installation geometry. The system capabilities are demonstrated by application to three significantly different aircraft.

Weir, D. S.↗
NASA NTRS1949

An Electric Thrust Meter Suitable for Flight Investigation of Propellers

A lightweight instrument that utilizes resistance-wire electric strain gases to measure propeller-shaft thrust has been developed. A wind-tunnel investigation on a propeller installed, on a single-engine pursuit airplane showed that the instrument gave a reliable indication of propeller-shaft thrust to an accuracy of +/-2 percent within its calibrated range. No attempt was made to determine the relation of indicated shaft thrust to net propeller thrust.

Perkins, Porter J., Jr.↗
NASA NTRSDate not supplied

Static and Forced Oscillation Wind Tunnel Tests of A Tandem Propeller Configuration

A series of static and forced oscillation tests were conducted using a tandem propeller configuration in the NASA Langley 12-Foot Low-Speed Tunnel. The primary objectives were to quantify the effect of aerodynamic interactions on propeller thrust and identify conditions where the effect is most significant. A secondary objective was to obtain a preliminary data set from dynamic testing to assess the impact of angular rate on thrust performance. This paper presents analysis of the experimental data, which includes propeller performance measurements and qualitative flow visualization. The static results show that the rear propeller in the tandem configuration can experience thrust degradations greater than 30%. The extent of the wake interaction is a function of the hub separation distance and the advance ratio of the front propeller. Forced oscillation results showed that the front propeller exhibited primarily linear behavior across the conditions tested, whereas the rear propeller exhibited dynamic nonlinearity in the region of significant thrust degradation. These results are intended to support high-fidelity modeling research, particularly for flight dynamics simulation development to aid trajectory prediction, control design, and identification of hazardous conditions for multirotor vehicles.

Aerodynamic Interactions↗