Search NASA⌕ Search

SEARCH · Search NASA

Results for “Surface Comparison”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1960

Subsonic Kernel-Function Flutter Analysis of a Highly Tapered Tail Surface and Comparison with Experimental Results

A flutter analysis employing the kernel function for three-dimensional, subsonic, compressible flow is applied to a flutter-tested tail surface which has an aspect ratio of 3.5, a taper ratio of 0.15, and a leading-edge sweep of 30 deg. Theoretical and experimental results are compared at Mach numbers from 0.75 to 0.98. Good agreement between theoretical and experimental flutter dynamic pressures and frequencies is achieved at Mach numbers to 0.92. At Mach numbers from 0.92 to 0.98, however, a second solution to the flutter determinant results in a spurious theoretical flutter boundary which is at a much lower dynamic pressure and at a much higher frequency than the experimental boundary.

Walberg, Gerald D.↗
NASA NTRS2012

Comparison of Surface Elevation Changes of the Greenland and Antarctic Ice Sheets from Radar and Laser Altimetry

A primary purpose of satellite altimeter measurements is determination of the mass balances of the Greenland and Antarctic ice sheets and changes with time by measurement of changes in the surface elevations. Since the early 1990's, important measurements for this purpose have been made by radar altimeters on ERS-l and 2, Envisat, and CryoSat and a laser altimeter on ICESat. One principal factor limiting direct comparisons between radar and laser measurements is the variable penetration depth of the radar signal and the corresponding location of the effective depth of the radar-measured elevation beneath the surface, in contrast to the laser-measured surface elevation. Although the radar penetration depth varies significantly both spatially and temporally, empirical corrections have been developed to account for this effect. Another limiting factor in direct comparisons is caused by differences in the size of the laser and radar footprints and their respective horizontal locations on the surface. Nevertheless, derived changes in elevation, dHldt, and time-series of elevation, H(t), have been shown to be comparable. For comparisons at different times, corrections for elevation changes caused by variations in the rate offrrn compaction have also been developed. Comparisons between the H(t) and the average dH/dt at some specific locations, such as the Vostok region of East Antarctic, show good agreement among results from ERS-l and 2, Envisat, and ICESat. However, Greenland maps of dHidt from Envisat and ICESat for the same time periods (2003-2008) show some areas of significant differences as well as areas of good agreement. Possible causes of residual differences are investigated and described.

Zwally, H. Jay↗
NASA NTRS2019

Remote Sensing of Sea Surface Salinity: Comparison of Satellite and In Situ Observations and Impact of Retrieval Parameters

Since 2009, three low frequency microwave sensors have been launched into space with the capability of global monitoring of sea surface salinity (SSS). The European Space Agency's (ESA's) Microwave Imaging Radiometer using Aperture Synthesis (MIRAS), onboard the Soil Moisture and Ocean Salinity mission (SMOS), and National Aeronautics and Space Administration's (NASA's) Aquarius and Soil Moisture Active Passive mission (SMAP) use L-band radiometry to measure SSS. There are notable differences in the instrumental approaches, as well as in the retrieval algorithms. We compare the salinity retrieved from these three spaceborne sensors to in situ observations from theArgo network of drifting floats, and we analyze some possible causes for the differences. We present comparisons of the long-term global spatial distribution, the temporal variability for a set of regions of interest and statistical distributions. We analyze some of the possible causes for the differences between the various satellite SSS products by reprocessing the retrievals from Aquarius brightness temperatures changing the model for the sea water dielectric constant and the ancillary product for the sea surface temperature. We quantify the impact of these changes on the differences in SSS between Aquarius and SMOS.We also identify the impact of the corrections for atmospheric effectsrecently modified in the Aquarius SSS retrievals. All three satellites exhibit SSS errors with a strong dependence on sea surface temperature, but this dependence varies significantly with the sensor. We show that these differences are first and foremost due to the dielectric constant model, then to atmospheric corrections and to a lesser extent to the ancillary product of the sea surface temperature.

SSS↗
NASA NTRS1986

Satellite scatterometer comparisons with surface measurements: Techniques and Seasat results

A method by which satellite and surface measurements can be compared in order to validate satellite wind observations is presented. The regression method requires knowledge of the expected differences (due to atmospheric variability and differing averaging) between perfect satellite and perfect buoy measurements. A model for estimating these differences is described. The regression method is applied to comparisons between Seasat Scatterometer (SASS) and U.S. National Data Buoy Office buoy data. Comparisons indicating a dependence of SASS accuracy on sea-surface temperature are summarized.

Freilich, Michael H.↗
NASA NTRS2005

Mars Surface Mobility: Comparison of Past, Present, and Future Rover Systems

The future robotic and human exploration of Mars will rely heavily on mobile system to meet exploration objectives. In particular, the next decade of exploration (2009-2020) will utilize rovers and other mobile surface platforms to conduct a wide variety of tasks, including in the search for water and life, characterization of terrain and its geology, and conduct precursor measurements prepare for future human exploration.

Wilson, G. R.↗
NASA NTRS1984

A comparison of surface temperature derived from HCMM infrared measurements with field data

The satellite for the Heat Capacity Mapping Mission (HCMM) was launched on April 26, 1978. The HCMM had the objective to collect data in support of studies concerned with the feasibility of using infrared temperature data to compute the thermal inertia from the earth's surface. The HCMM radiometer had a channel for reflected radiation in the 0.5 to 1.1 micron waveband, and a channel for the infrared radiation in the 10.5 to 12.5 micron band. However, difficulties developed in connection with changes in the characteristics of the radiometer. The present investigation is concerned with a comparison of HCMM infrared temperatures with in situ data from the Mississippi River in the St. Louis, Missouri, area and with sea-surface temperatures collected in the Nantucket Shoals and Gulf of Mexico regions. It was found that, on the average, the difference between satellite in situ data was -4.6 C.

Vukovich, F. M.↗
NASA NTRS1983

An evaluation of Space Shuttle Orbiter forward fuselage surface pressures - Comparison with wind tunnel and theoretical predictions

In order for ground-based pressure distribution techniques to be verified by the actual performance of the Space Shuttle Orbiter in flight, a comparative study of flight pressure data and both wind tunnel and computational data is presented. The flight pressure data, obtained from measurements on the Orbiter's surface during atmospheric reentry, are part of the overall Orbiter flight data system designated Development Flight Instrumentation. Also given is an analysis of the Orbiter pressure data system, including its transducers, their behavior, and their calibration. The two analyses are the bases of an error assessment calculation for the flight data, as well as an explanation of any discrepancies between flight and ground-based data.

Bradley, P. F.↗
NASA NTRS1980

Comparison of surface wind stress measurements - Airborne radar scatterometer versus sonic anemometer

Sea surface wind stress measurements recorded by a sonic anemometer are correlated with airborne scatterometer measurements of ocean roughness (cross section of radar backscatter) to establish the accuracy of remotely sensed data and assist in the definition of geophysical algorithms for the scatterometer sensor aboard Seasat A. Results of this investigation are as follows: Comparison of scatterometer and sonic anemometer wind stress measurements are good for the majority of cases; however, a tendency exists for scatterometer wind stress to be somewhat high for higher wind conditions experienced in this experiment (6-9 m/s). The scatterometer wind speed algorithm tends to overcompute the higher wind speeds by approximately 0.5 m/s. This is a direct result of the scatterometer overestimate of wind stress from which wind speeds are derived. Algorithmic derivations of wind speed and direction are, in most comparisons, within accuracies defined by Seasat A scatterometer sensor specifications.

Brucks, J. T.↗
NASA NTRS1992

Gaspra's shape and surface features: Comparison to small satellites

The several thousand asteroids constitute the second largest population of substantial solid objects in the solar system (there are probably more comets), and have been studied from the Earth for nearly two centuries. Asteroids are important members of the solar system for several reasons, among them: (1) they contain the materials that reflect the processes going on early in the time of planet formation; (2) their impacts have been the major external influences on the surface of some terrestrial planets; and (3) their impacts on Earth have probably had major effects on biologic evolution. This paper examines and describes the asteroid Gaspra, and compares it to small satellites.

Thomas, P. C.↗
NASA NTRS2009

A Comparison of Surface Acoustic Wave Modeling Methods

Surface Acoustic Wave (SAW) technology is low cost, rugged, lightweight, extremely low power and can be used to develop passive wireless sensors. For these reasons, NASA is investigating the use of SAW technology for Integrated Vehicle Health Monitoring (IVHM) of aerospace structures. To facilitate rapid prototyping of passive SAW sensors for aerospace applications, SAW models have been developed. This paper reports on the comparison of three methods of modeling SAWs. The three models are the Impulse Response Method a first order model, and two second order matrix methods; the conventional matrix approach, and a modified matrix approach that is extended to include internal finger reflections. The second order models are based upon matrices that were originally developed for analyzing microwave circuits using transmission line theory. Results from the models are presented with measured data from devices.

Wilson, W. c.↗
NASA NTRS1978

Comparison of surface and satellite gravity data

Satellite derived potential coefficients (GEM 9) are compared to terrestrial gravity data by degree in terms of coefficient differences and in terms of mean anomaly differences. The root mean square undulation difference (to degree 20) was 9 + or - m and the anomaly difference was + or - 7 mgals with GEM 9 commission errors of + or - 1.7 m and + or - 3.8 mgals. The standard deviations of the GEM 9 implied undulations increased from + or - 4 cm at degree 2 to + or - 53 cm at degree 20. The corresponding values implied by a recent (June 1978) terrestrial 5 deg field were + or - 2.53 m and + or - 0.38 m (at degree 20). Comparisons between Geos-3 altimeter derived anomalies and 1 deg X 1 Deg terrestrial data showed that + or - 6-8 mgals is a reasonable accuracy estimate for the altimeter derived anomalies. Anomalies derived from satellite to satellite tracking data indicate an accuracy of about + or - 6 mgals for the recovery of 5 deg equal area blocks.

Rapp, R. H.↗
NASA NTRS1990

An inter-comparison of surface energy flux measurement systems used during FIFE, 1987

During the first International Satellite Land Surface Climatology Program Field Experiment (FIFE-87), surface energy fluxes were measured at 22 flux sites by nine groups of scientists using different measuring systems. A rover Bowen ratio station was taken to nearly all the flux stations to serve as a reference for estimating the instrument related differences. The rover system was installed within a few meters from the host instrument of a site. Net radiation, Bowen ratio, and latent heat fluxes were compared between the rover and the host for the stations visited. Linear regression analysis was used to examine the relationship between rover measurements and host measurements. These inter-comparisons are needed to examine the influence of instrumentation on measurement uncertainty. Highly significant effects of instrument type were detected from these comparisons. Instruments of the same type showed average differences of less than 5 percent for net radiation, 10 percent for Bowen ratio, and 6 percent for latent heat flux. The corresponding average differences for different types of instruments can be up to 10, 30, and 20 percent respectively. The Didcot net radiometer gave higher net radiation while the Swissteco type showed lower values, as compared to the corrected REBS model. The 4-way components methed and the Thornswaite type give similar values to the REBS. The SERBS type Bowen ratio systems exhibit slightly lower Bowen ratios and thus higher latent heat fluxes, compared to the AZET systems. Eddy correlation systems showed slightly lower latent heat flux in comparison to the Bowen ratio systems.

Nie, D.↗
DOE OSTI2024

A global comparison of surface and subsurface microbiomes reveals large-scale biodiversity gradients, and a marine-terrestrial divide

Subsurface environments are among Earth’s largest habitats for microbial life. Yet, until recently, we lacked adequate data to accurately differentiate between globally distributed marine and terrestrial surface and subsurface microbiomes. Here, we analyzed 478 archaeal and 964 bacterial metabarcoding datasets and 147 metagenomes from diverse and widely distributed environments. Microbial diversity is similar in marine and terrestrial microbiomes at local to global scales. However, community composition greatly differs between sea and land, corroborating a phylogenetic divide that mirrors patterns in plant and animal diversity. In contrast, community composition overlaps between surface to subsurface environments supporting a diversity continuum rather than a discrete subsurface biosphere. Differences in microbial life thus seem greater between land and sea than between surface and subsurface. Diversity of terrestrial microbiomes decreases with depth, while marine subsurface diversity and phylogenetic distance to cultured isolates rivals or exceeds that of surface environments. We identify distinct microbial community compositions but similar microbial diversity for Earth’s subsurface and surface environments.

54 ENVIRONMENTAL SCIENCES↗
NASA NTRS1980

Phytoplankton pigments from the Nimbus-7 Coastal Zone Color Scanner - Comparisons with surface measurements

Algorithms are developed for removing aerosol effects in visual data from the Nimbus-7 Coastal Zone Color Scanner (CZCS). The corrected imagery reveals eddy-like ocean circulation patterns. Pigment concentrations from CZCS are compared with surface determinations. CZCS imagery estimates pigment concentration to within 0.5 log C, where C is the sum of the concentrations of chlorophyll a and phaeopigments a

Gordon, H. R.↗
NASA NTRS1990

Dependence of the microwave radar cross section on ocean surface variables - Comparison of measurements and theory using data from the Frontal Air-Sea Interaction Experiment

The purpose of this investigation was to study the ability of theoretical radar cross section (RCS) models to predict the absolute magnitude of the ocean radar cross section under a wide variety of sea and atmospheric conditions. The dependence of the RCS on wind stress (as opposed to wind speed) was also studied. An extensive amount of experimental data was acquired during the Frontal Air-Sea Interaction Experiment. Measurements across an ocean front demonstrated that the vertical polarization and horizontal polarization radar cross section were more strongly dependent on wind stress than on wind magnitude. Current theoretical models for the RCS, based on stress, were tested with this data. In situations where the Bragg scattering theory does not agree with the measured radar cross section (magnitude and angle dependence), revisions are hypothesized and evaluated.

Weissman, David E.↗