Search NASA⌕ Search

SEARCH · Search NASA

Results for “TAIL SURFACES, HORIZONTAL - CHAR”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1921

The Pressure Distribution over the Horizontal Tail Surfaces of an Airplane II

This investigation was undertaken to determine whether the results obtained upon model tail surfaces can be used to accurately predict loads upon the full-sized tail; and also to find the distribution of load when large elevator angles are used, as the loads from such angles can not be obtained readily in free flight. The method consisted in using a metal horizontal tail surface inside of which small air passages, connecting with a series of holes in the surface, led the pressure off from the tail in rubber tubes. In this way the pressure at each of these holes was measured by a manometer at several angles of attack and several to the loading under similar conditions in the full-sized airplane and the manner of distribution is quite similar in the two cases when there is no slip stream.

Norton, F H↗
NASA NTRS1950

Investigation of the Model ME 210 in the Spin Wind Tunnel of the DVL: Model with Long Fuselage and with a VEE Tail - Report 4

After conclusion of the spin investigation of the model Me 210 with elongated fuselage and central vertical tail surfaces (model condition III; reference 3), tests were performed on the same model with a vee tail (model condition IV). Here the entire tail surfaces consist of only one surface with pronounced dihedral. Since the blanketing of the vertical tail surfaces by the horizontal tail surfaces, which may occur in case of standard tail surfaces, does not occur here, one could expect for this type of tail surface favorable spin characteristics, particularly with respect to rudder effectiveness for spin recovery. However, the test results did not confirm these expectations. The steady spin was shown to be very irregular; regarding rudder effectiveness the vee tail surfaces proved to be inferior even to standard tail surfaces, thus they represent the most unfavorable of the four fuselage and tail-surface combinations investigated so far.

Huffschmid, A↗