Search NASA⌕ Search

SEARCH · Search NASA

Results for “acoustic source”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

Application of the complex cepstrum to the location of acoustic sources near reflective surfaces

The complex cepstrum is used to correct bearing estimations of acoustic sources in the presence of a reflective surface. An automated liftering procedure is used which zeros out a block portion of the cepstrum including the echo information. The problem of the resulting distortion is alleviated by applying a coherence criterion to the recovered direct signals at each microphone. Thus to a large degree the interactive nature of cepstral processing is overcome for this application. For the test signals and geometries considered the cepstrum is shown to accurately correct for bearing errors in acoustic signals contaminated with reflections from nearby surfaces.

Fuller, C. R.↗
NASA NTRS1977

Acoustic source location in a jet-blown flap using a cross-correlation technique

The acoustic source strength distribution in a turbulent flow field was measured for two far field microphones at 45 deg above and below the plane of the flap surface. A processed signal from an inclined hot-film anemometry probe was cross correlated with the signal from the appropriate far field microphone. The contribution made by the sources associated with the fluctuating pressure on the flap surface to the sound received at far field microphone was estimated by cross correlating the processed signals of microphones which were embedded in the flap surface with the far field microphone signals. In addition, detailed fluid dynamic measurements were made in the flow field of the jet flap using dual sensor hot-film anemometry probes.

Becker, R. S.↗
NASA NTRS1980

Transmitted sound field due to an impulsive line acoustic source bounded by a plate followed by a vortex sheet

The propagation of sound due to a line acoustic source in the moving stream across a semiinfinite vortex sheet which trails from a rigid plate is examined in a linear theory for the subsonic case. A solution for the transmitted sound field is obtained with the aid of multiple integral transforms and the Wiener-Hopf technique for both the steady state (time harmonic) and initial value (impulsive source) situations. The contour of inverse transform and hence the decomposition of the functions are determined through causality and radiation conditions. The solution obtained satisfies causality and the full Kutta conditions. The transmitted sound field is composed of two waves in both the stady state and initial value problems. One is the wave scattered from the edge of the plate which is associated with the bow wave and the instability wave. These waves exist in the downstream sectors. The other is the wave transmitted through the vortex sheet which is also associated with the instability wave. Regional divisions of the transmitted sound field are identified.

Miura, T.↗
NASA NTRS1990

Identification of aerospace acoustic sources using sparse distributed associative memory

A pattern recognition system has been developed to classify five different aerospace acoustic sources. In this paper the performance of two new classifiers, an associative memory classifier and a neural network classifier, is compared to the performance of a previously designed system. Sources are classified using features calculated from the time and frequency domain. Each classifier undergoes a training period where it learns to classify sources correctly based on a set of known sources. After training the classifier is tested with unknown sources. Results show that over 96 percent of sources were identified correctly with the new associative memory classifier. The neural network classifier identified over 81 percent of the sources correctly.

Scott, E. A.↗
NASA NTRS1989

A smart pattern recognition system for the automatic identification of aerospace acoustic sources

An intelligent air-noise recognition system is described that uses pattern recognition techniques to distinguish noise signatures of five different types of acoustic sources, including jet planes, propeller planes, a helicopter, train, and wind turbine. Information for classification is calculated using the power spectral density and autocorrelation taken from the output of a single microphone. Using this system, as many as 90 percent of test recordings were correctly identified, indicating that the linear discriminant functions developed can be used for aerospace source identification.

Cabell, R. H.↗
NASA NTRS1972

The estimation of nonstationary spectra from moving acoustic source distributions.

It is shown that the Blackman-Tukey estimation procedure provides a natural estimate of a nonstationary spectrum defined in terms of the acoustic sources. The pressure field from the moving source distribution is discussed together with the estimation procedure. The spectrum can be considered as a time-dependent partition of the variance of the pressure field over a Doppler shifted continuum of frequencies. It is found that the effect of nonstationarity on the bias and variance of the estimate is small in cases of practical interest, provided sources directionality is excluded.

Mcdaid, E.↗
NASA NTRS1992

Simulation Of Static And Moving Acoustical Sources

Sounds in headphones changed according to movements of listener's head. Signal processor generates three-dimensional sound cues for headphones. Provides up to four independent acoustical sources simultaneously and simulates movements of each source in real time. Used to enhance presentations of data in cockpits of airplanes, in air-traffic-control towers, for training people whose hearing is impaired, for monitoring telerobots in hazardous situations, and for visualizing multidimensional scientific data, among many possible applications.

Wenzel, Elizabeth M.↗
DOE OSTI2026

Seismic Recovery of Acoustic Source Height During the OSIRIS-REx Sample Return Capsule Re-Entry

Controlled hypersonic reentries with well‐constrained trajectories are exceedingly rare, yet they provide valuable reference cases for validating geophysical source characterization methods applicable to bolides and space debris. The 24 September 2023 re‐entry of the OSIRIS‐REx Sample Return Capsule, the first interplanetary capsule to return over the contiguous United States in nearly two decades, presented such an opportunity. Here, we present seismic observations of this event recorded at 16 stations across three sites at ground distances of 7–20 km from the trajectory. Using eigenray tracing through ground‐to‐space atmospheric specifications, we invert picked acoustic‐to‐seismic travel times for effective shock‐generated acoustic source altitudes along the known trajectory. The method recovers source heights of 57.9–59.5 km with travel‐time residuals <1 s across all stations. The seismic‐derived source heights, when compared at their along‐track positions, fall within the range of previously published infrasound‐derived heights for the corresponding trajectory segment, with intermethod differences comparable with the timing‐based uncertainty. These results suggest that air‐to‐ground coupling does not introduce a resolvable systematic timing bias in the picked near‐field seismic arrivals, supporting seismic observations as a complementary tool for altitude estimation of bolides, re‐entry vehicles, and other hypersonic atmospheric sources.

Silber, Elizabeth Allaryce [Sandia National Labora↗
NASA NTRS1980

Some effects of motion and plane reflecting surfaces on the radiation from acoustic sources

The effects of translatory and rotational motion and of the proximity of ground surface on the radiation from acoustic monopole and dipole sources are discussed together with the key equations. It is shown that interference patterns are produced by reflection and absorption at a plane surface and that consequently, the far-field directivity of an acoustic source near the ground can be substantially altered from its free-field value. The kinematic effects discussed include the beaming of sound in the direction of source motion and the shifting of the observer source frequency in a directionally dependent manner. The effects are illustrated by experimental data.

Lansing, D. L.↗
NASA NTRS1978

Theory on acoustic sources

A theory is described for the radiation emission emission from acoustic multipole sources. The sources can be stationary or moving at speeds including supersonic and experience stationary or moving disturbances. The effect of finite source distributions and disturbances is investigated as well as the manner in which they interact. Distinction is made between source distributions that responsed as a function of time and those that respond as a function of space.

Wright, S. E.↗
NASA NTRS1984

Recovery of burner acoustic source structure from far-field sound spectra

A method is presented that permits the thermal-acoustic efficiency spectrum in a long turbulent burner to be recovered from the corresponding far-field sound spectrum. An acoustic source/propagation model is used based on the perturbation solution of the equations describing the unsteady one-dimensional flow of an inviscid ideal gas with a distributed heat source. The technique is applied to a long cylindrical hydrogen-flame burner operating over power levels of 4.5-22.3 kW. The results show that the thermal-acoustic efficiency at a given frequency, defined as the fraction of the total burner power converted to acoustic energy at that frequency, is rather insensitive to burner power, having a maximum value on the order of 10 to the -4th at 150 Hz and rolling off steeply with increasing frequency. Evidence is presented that acoustic agitation of the flame at low frequencies enhances the mixing of the unburned fuel and air with the hot products of combustion. The paper establishes the potential of the technique as a useful tool for characterizing the acoustic source structure in any burner, such as a gas turbine combustor, for which a reasonable acoustic propagation model can be postulated.

Mahan, J. R.↗
NASA NTRS1987

Effects of acoustic sources

An experiment was conducted to determine the effect of acoustics on the laminar flow on the side of a nacelle. A flight test was designed to meet this goal and a brief review of the purpose is given. A nacelle with a significant length of laminar flow was mounted on the wing of NASA OV-1. Two noise sources are also mounted on the wing: one in the center body of the nacelle; the second in a wing mounted pod outboard of the nacelle. These two noise sources allow for a limited study of the effect of source direction in addition to control of the acoustic level and frequency. To determine the range of Tollmien-Schlichting frequencies, a stability analysis using the pressure coefficient distribution along the side of the nacelle was performed. Then by applying these frequencies and varying the acoustic level, a study of the receptivity of the boundary layer to the acoustic signal, as determined by the shortening of the length of laminar flow, was conducted. Results are briefly discussed.

Schoenster, James A.↗
NASA NTRS2005

Acoustic Source Modeling for High Speed Air Jets

The far field acoustic spectra at 90deg to the downstream axis of some typical high speed jets are calculated from two different forms of Lilley s equation combined with some recent measurements of the relevant turbulent source function. These measurements, which were limited to a single point in a low Mach number flow, were extended to other conditions with the aid of a highly developed RANS calculation. The results are compared with experimental data over a range of Mach numbers. Both forms of the analogy lead to predictions that are in excellent agreement with the experimental data at subsonic Mach numbers. The agreement is also fairly good at supersonic speeds, but the data appears to be slightly contaminated by shock-associated noise in this case.

Goldstein, Marvin E.↗
NASA NTRS1985

The production of lightning-associated infrasonic acoustic sources in thunderclouds

Electrostatic production of low frequency (about 1 Hz) acoustic pulses associated with electrical discharges in thunderclouds has been theoretically described (e.g., Wilson, 1920; Dessler, 1973) and experimentally observed (e.g., Bohannon et al., 1977; Balachandran, 1983). The measured waveforms differ consistently with the theories in that the observed wave has an initial positive (or condensation) pulse followed by a negative (or rarefaction) pulse; whereas theories predicted only a negative pulse. The electrical heating of the air by positive streamer systems during the discharge is computed in this theoretical paper. This rapid (supersonic) electrical heating, although small (about 10 to the -6th T sub zero), produces a positive pressure perturbation (of about 10 to the -1st Pa), which when added to the negative electrostatic pressure perturbation generates an acoustic wave consistent with measured signals. A positive pulse always precedes the negative pulse in this model, and the positive pulse is always smaller in amplitude than the negative. The durations of the positive and negative pulses are similar. When more realistic models are employed, the observed signal can be related through theory to physical parameters in the thundercloud.

Few, A. A.↗
NASA NTRS1989

Acoustic design considerations: Review of rotor acoustic sources

It is not sufficient to optimize a rotor design in terms of a single noise level calculated for a single flight condition and a single measurement location. The various noise sources, their frequency content, amplitude, and directivity as a function of operating condition must be considered. A summary of the frequency ranges, directivity patterns and the most important operational and design parameters for major rotor noise sources is presented. It is difficult to generalize design requirements for rotor noise because the acoustic output varies so widely depending on the noise source, flight condition, measurement location, and frequency range. However, assuming the rotor must lift a fixed nominal payload and operate over a wide range of flight conditions, three general design guidelines can be stated: (1) minimize tip Mach number; (2) minimize blade thickness in the tip region; and (3) minimize gradients in the spanwise lift distribution in the tip region. Constraints on blade thickness, maximum values for hover tip Mach number, advancing tip Mach number and spanwise lift coefficient gradient will be specified during the aerodynamic, dynamic and structural optimization process. The rotor noise sources to be considered include the low frequency loading and thickness noise, and the higher frequency noise due to blade-vortex interactions (BVI). The analyses to be employed will include the comprehensive rotor analysis and design program CAMRAD and the rotor noise prediction program WOPWOP.

Martin, Ruth M.↗
NASA NTRS2018

Initial Calibrations and Wind Tunnel Test Results for an In-Flow Reference Array Using New In-Flow Acoustic Sources in Four Array Mount Configurations

This paper describes efforts to develop a small in-flow phased microphone array as a reference acoustic sensor and quantify its level-measurement accuracy with new in-flow calibration sources. The devices can be applied to a wide variety of in- and out-of-flow measurement applications and test facilities. Recent tests of the array and two calibration sources in the NASA Anechoic Chamber and Army 7- by 10-foot Wind Tunnel at NASA Ames Research Center demonstrated that the array was functional over a frequency range of 2 to 100 kilohertz for emission angles of 92 degrees, 108 degrees, and 120 degrees, and Mach numbers of 0, 0.15, and 0.25. The array and calibration sources were then used to assess the relative effects of array installation on background noise and level measurement accuracy by locating the array in the flow (strut- and wall-mounted) as well as outside the flow behind a porous wall screen and a free shear layer. The wind tunnel array measurements were compared with anechoic chamber measurements using discrete microphones at the same source distance and emission angles. At 92 degrees, the noise floor and attenuation spectra were comparable (within 5 decibels) for each installation from 2 to 30 kilohertz. At higher angles, the array installation behind the Kevlar screen had the lowest noise floor at M = 0.15 and 0.25. The array installation 10 inches (maximum available distance) behind a free shear layer had higher background noise that is typically reduced to a lower level by moving the array back further from the flow. For emission angles greater than 92 degrees, both the Kevlar and free shear layer installations exhibited stronger attenuations in measured level, beginning at lower frequencies than either the wall- or strut-mount configurations. Additional array and calibration source units of the same design are being tested at NASA’s Glenn Research Center and Langley Research Center in their aeroacoustic research facilities in an effort to improve measurement accuracy and repeatability.

Aeroacoustic Wind Tunnel Research↗
NASA NTRS2006

Acoustic Source Localization in Aircraft Interiors Using Microphone Array Technologies

Using three microphone array configurations at two aircraft body stations on a Boeing 777-300ER flight test, the acoustic radiation characteristics of the sidewall and outboard floor system are investigated by experimental measurement. Analysis of the experimental data is performed using sound intensity calculations for closely spaced microphones, PATCH Inverse Boundary Element Nearfield Acoustic Holography, and Spherical Nearfield Acoustic Holography. Each method is compared assessing strengths and weaknesses, evaluating source identification capability for both broadband and narrowband sources, evaluating sources during transient and steady-state conditions, and quantifying field reconstruction continuity using multiple array positions.

Sklanka, Bernard J.↗