Demodulation of amplitude modulated RF waves in plasma at resonance.
Audio waves from radio stations detected by rockets, using technique applicable to plasma diagnostics
Kawashima, N.↗
SEARCH · Search NASA
Results for “plasma diagnostic techniques”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
High temperature UF6 RF plasma experiments applicable to uranium plasma core reactors
An investigation was conducted using a 1.2 MW RF induction heater facility to aid in developing the technology necessary for designing a self critical fissioning uranium plasma core reactor. Pure, high temperature uranium hexafluoride (UF6) was injected into an argon fluid mechanically confined, steady state, RF heated plasma while employing different exhaust systems and diagnostic techniques to simulate and investigate some potential characteristics of uranium plasma core nuclear reactors. The development of techniques and equipment for fluid mechanical confinement of RF heated uranium plasmas with a high density of uranium vapor within the plasma, while simultaneously minimizing deposition of uranium and uranium compounds on the test chamber peripheral wall, endwall surfaces, and primary exhaust ducts, is discussed. The material tests and handling techniques suitable for use with high temperature, high pressure, gaseous UF6 are described and the development of complementary diagnostic instrumentation and measurement techniques to characterize the uranium plasma, effluent exhaust gases, and residue deposited on the test chamber and exhaust system components is reported.
Roman, W. C.↗
Experimental measurements of the plasma sheath around pinhole defects in a simulated high-voltage solar array
An emissive Langmuir probe was used to measure the potentials within the plasma sheath developed around a hole in a simulated solar array at voltages between 50 and 450 V. The hole sizes were larger than actual pinhole defects; the plasma density was in the 10,000 per cu cm range, which is considerably lower than the density of 1,000,000 per cu cm found at low-earth-orbit altitudes. Despite these inadequacies in the simulation, the experiments indicate that this type of probe is a useful diagnostic technique for investigating the plasma sheaths developing around pinhole defects.
Gabriel, S. B.↗
A fluctuation-induced plasma transport diagnostic based upon fast-Fourier transform spectral analysis
A diagnostic, based on fast Fourier-transform spectral analysis techniques, that provides experimental insight into the relationship between the experimentally observable spectral characteristics of the fluctuations and the fluctuation-induced plasma transport is described. The model upon which the diagnostic technique is based and its experimental implementation is discussed. Some characteristic results obtained during the course of an experimental study of fluctuation-induced transport in the electric field dominated NASA Lewis bumpy torus plasma are presented.
Powers, E. J.↗
Plasma erosion rate diagnostics using laser-induced fluorescence
An optical technique for measuring the sputtering rate of a molybdenum surface immersed in a xenon plasma has been developed and demonstrated. This approach, which may be useful in real-time wear diagnostics for ion thrusters, relies on laser-induced fluorescence to determine the density of sputtered molybdenum atoms.
Gaeta, C. J.↗
Langmuir Probe Measurements of Inductively Coupled Plasmas in CF4/Ar/O2 Mixtures
Fluorocarbon gases, such as CF4, and their mixtures are widely used in contemporary low-pressure and high-density plasma processing techniques. In such plasmas Langmuir probe is one of the most commonly employed diagnostic techniques to obtain electron number density (ne), electron temperature (Te), electron energy distribution function (EEDF), mean electron energy (Ee), ion number density (ni), and plasma potential (Vp). In this paper we report probe data for planar inductively coupled plasmas in CF4/O2/Ar mixtures. By varying the relative concentrations in the mixture, radial profiles of ne, ni, Te, Ee, Vp, EEDF were measured in the mid-plane of the plasma at 10 mTorr and 20 mTorr of gas pressures, and 200 W and 300 W of RF powers. Data show that ne and ni decrease with increase of CF4 content and decrease of gas-pressure but they increase with increase of RF-power, whereas Vp increases with decrease of gas-pressure and remains independent of RF-power. However, they all peak at the center of the plasma and decrease towards the edge while Te follows the other way and increases a little with increase of power. The measured EEDFs exhibit Druyvesteyn-like distribution at all pressures and powers. Data are analyzed and will be presented.
Rao, M. V. V. S.↗
The LeRC rail accelerators: Test designs and diagnostic techniques
The feasibility of using rail accelerators for various in-space and to-space propulsion applications was investigated. A 1 meter, 24 sq mm bore accelerator was designed with the goal of demonstrating projectile velocities of 15 km/sec using a peak current of 200 kA. A second rail accelerator, 1 meter long with a 156.25 sq mm bore, was designed with clear polycarbonate sidewalls to permit visual observation of the plasma arc. A study of available diagnostic techniques and their application to the rail accelerator is presented. Specific topics of discussion include the use of interferometry and spectroscopy to examine the plasma armature as well as the use of optical sensors to measure rail displacement during acceleration. Standard diagnostics such as current and voltage measurements are also discussed.
Zana, L. M.↗
LeRC rail accelerators - Test designs and diagnostic techniques
The feasibility of using rail accelerators for various in-space and to-space propulsion applications was investigated. A 1 meter, 24 sq mm bore accelerator was designed with the goal of demonstrating projectile velocities of 15 km/sec using a peak current of 200 kA. A second rail accelerator, 1 meter long with a 156.25 sq mm bore, was designed with clear polycarbonate sidewalls to permit visual observation of the plasma arc. A study of available diagnostic techniques and their application to the rail accelerator is presented. Specific topics of discussion include the use of interferometry and spectroscopy to examine the plasma armature as well as the use of optical sensors to measure rail displacement during acceleration. Standard diagnostics such as current and voltage measurements are also discussed. Previously announced in STAR as N83-35053
Zana, L. M.↗
Standard Practices for Usage of Inductive Magnetic Field Probes with Application to Electric Propulsion Testing
Inductive magnetic field probes (also known as B-dot probes and sometimes as B-probes or magnetic probes) are useful for performing measurements in electric space thrusters and various plasma accelerator applications where a time-varying magnetic field is present. Magnetic field probes have proven to be a mainstay in diagnosing plasma thrusters where changes occur rapidly with respect to time, providing the means to measure the magnetic fields produced by time-varying currents and even an indirect measure of the plasma current density through the application of Ampère's law. Examples of applications where this measurement technique has been employed include pulsed plasma thrusters and quasi-steady magnetoplasmadynamic thrusters. The Electric Propulsion Technical Committee (EPTC) of the American Institute of Aeronautics and Astronautics (AIAA) was asked to assemble a Committee on Standards (CoS) for Electric Propulsion Testing. The assembled CoS was tasked with developing Standards and Recommended Practices for various diagnostic techniques used in the evaluation of plasma thrusters. These include measurements that can yield either global information related to a thruster and its performance or detailed, local data related to the specific physical processes occurring in the plasma. This paper presents a summary of the standard, describing the preferred methods for fabrication, calibration, and usage of inductive magnetic field probes for use in diagnosing plasma thrusters. Inductive magnetic field probes (also called B-dot probes throughout this document) are commonly used in electric propulsion (EP) research and testing to measure unsteady magnetic fields produced by time-varying currents. The B-dot probe is relatively simple in construction, and requires minimal cost, making it a low-cost technique that is readily accessible to most researchers. While relatively simple, the design of a B-dot probe is not trivial and there are many opportunities for errors in probe construction, calibration, and usage, and in the post-processing of data that is produced by the probe. There are typically several ways in which each of these steps can be approached, and different applications may require more or less vigorous attention to various issues.
Polzin, Kurt A.↗
EUV Diagnostics of Optically Thick Plasmas Using the 304 Å Channel
A fundamental limitation of current EUV diagnostic techniques is the need to neglect the He II emission contribution in the 304Å channel. This limits our ability to use strong observations available to us and increases uncertainties in the measurements made. A new EUV diagnostic technique is introduced that accounts for absorption as well as emission contributions from emitting channels such as 304 Å. This new technique can be equally applied to emitting and non-emitting channels, paving the way for more realistic discussion of the heating and energetics of transient plasmas using a wider range of observations. The diagnostic technique is used to compute the dynamics and energetics of a filament eruption observed in the high-cadence SDO/AIA and the associated ICME is observed by ACE/SWICS. The analysis gives us robust measurements of filament dynamics, energetics and its ionization history in the low solar corona. A comparison of these results with results calculated with techniques where He II emission in 304 Å is not considered allowed us to quantify the contribution from emission and comment on the robustness of our method.
EUV↗
Theoretical and experimental studies of the nature and characteristics of space-related plasma resonance phenomena Final report, 1 Jul. 1969 - 30 Jun. 1970
Space plasma experiments involving Alouette resonances and diagnostic techniques applied to electron density and temperature and local magnetic field strength measurement
Crawford, F. N.↗
Laboratory simulation of the structure of disturbed zones around bodies in space
Description of laboratory studies of certain aspects of the spacecraft/space plasma interaction regarding, in particular, the near and intermediate wake regions. The plasma wind tunnel facilities and the diagnostic techniques employed in these tests are described. Results are obtained which concern the variation of the normalized ion flux with normalized distance along the wake axis downstream from a conducting spherical body, the variation of the normalized width of the disturbed region with normalized distance downstream from the body center, and the location of the point of maximum ion current enhancement as a function of body potential.
Stone, N. H.↗
Lyman alpha coronagraph research sounding rocket program
The ultraviolet light coronagraph was developed and successfully flown on three rocket flights on 13 April 1979, 16 February 1980 and 20 July 1982. During each of these flights, the Ultraviolet Light Coronagraph was flown jointly with the White Light Coronagraph provided by the High Altitude Observatory. Ultraviolet diagnostic techniques and instrumentation for determining the basic plasma parameters of solar wind acceleration regions in the extended corona were developed and verified and the understanding of the physics of the corona through the performance, analysis and interpretation of solar observations advanced. Valuable UV diagnostics can be performed in the absence of a natural solar eclipse.
Parkinson, W. H.↗
Scaling and applied field studies of MPD thrusters with laser diagnostics
The topics are presented in viewgraph form and include the following: self-field magnetoplasmadynamics; 1/4-scale applied-field MPD; scaling of arcs and MPD-arcs; magnetic nozzle studies; advanced diagnostic techniques needed for obtaining particle velocity, temperature, and current distributions in plasma thrusters; nonintrusive laser diagnostics for arcs and MPD-arcs; and schematic of multi-beam interferometer for electron density profile determination.
York, Thomas M.↗
Laboratory-scale uranium RF plasma confinement experiments
An experimental investigation was conducted using 80 kW and 1.2 MW RF induction heater facilities to aid in developing the technology necessary for designing a self-critical fissioning uranium plasma core reactor. Pure uranium hexafluoride (UF6) was injected into argon-confined, steady-state, RF-heated plasmas in different uranium plasma confinement tests to investigate the characteristics of plamas core nuclear reactors. The objectives were: (1) to confine as high a density of uranium vapor as possible within the plasma while simultaneously minimizing the uranium compound wall deposition; (2) to develop and test materials and handling techniques suitable for use with high-temperature, high-pressure gaseous UF6; and (3) to develop complementary diagnostic instrumentation and measurement techniques to characterize the uranium plasma and residue deposited on the test chamber components. In all tests, the plasma was a fluid-mechanically-confined vortex-type contained within a fused-silica cylindrical test chamber. The test chamber peripheral wall was 5.7 cm ID by 10 cm long.
Roman, W. C.↗
Verification of Loop Diagnostics
Many different techniques have been used to characterize the plasma in the solar corona: density-sensitive spectral line ratios are used to infer the density, the evolution of coronal structures in different passbands is used to infer the temperature evolution, and the simultaneous intensities measured in multiple passbands are used to determine the emission measure. All these analysis techniques assume that the intensity of the structures can be isolated through background subtraction. In this paper, we use simulated observations from a 3D hydrodynamic simulation of a coronal active region to verify these diagnostics. The density and temperature from the simulation are used to generate images in several passbands and spectral lines. We identify loop structures in the simulated images and calculate the loop background. We then determine the density, temperature and emission measure distribution as a function of time from the observations and compare with the true temperature and density of the loop. We find that the overall characteristics of the temperature, density, and emission measure are recovered by the analysis methods, but the details of the true temperature and density are not. For instance, the emission measure curves calculated from the simulated observations are much broader than the true emission measure distribution, though the average temperature evolution is similar. These differences are due, in part, to inadequate background subtraction, but also indicate a limitation of the analysis methods.
Winebarger, A.↗
The multiple applications of electrons in space
An electron source such as a simple cathode is a cheap and light device which can serve several technological and scientific purposes in space: (1) electrostatic charging of a spacecraft can be limited by releasing electrons accumulated on the conductive elements of their surface; (2) the erosion of conductive coatings and the ability of conductive paints to withstand the space environment can be evaluated by monitoring the flow of charged particles impinging on their surface; (3) measuring the current collected by the spacecraft surface as a function of its potential with respect to an emitter is a very sensitive diagnostic technique which can yield a number of plasma parameters, such as density and temperature; (4) it is possible to convert the thermal motion of space plasmas into electrical energy by collecting energetic electrons and returning them to the medium as cold particles; (5) a wave in a plasma is characterized by a conduction current density which gives rise to fluctuations of the current flowing to the surface.
Grard, R. J. L.↗
Observations of ion cyclotron waves near synchronous orbit and on the ground
Ion cyclotron waves (ICWs) generated in the magnetosphere by the ion cyclotron instability of 10-100 keV protons are now known to be the origin of short-period (0.1-5 Hz) electromagnetic field oscillations observed by synchronous spacecraft and on the earth's surface. Observations of the various wave characteristics, including spectral and polarization properties, that lead to the identification of generation and propagation mechaniisms, and regions in the magnetosphere are described with reference to ATS-6, GEOS, and ground-based wave data and interpreted using cold plasma propagation theory. The presence of heavy ions (O/+/, He/+/) dramatically modifies ICW magnetospheric propagation characteristics giving rise to spectral slots and polarization reversals. These properties may be used in plasma diagnostics. Finally satellite-ground correlations and techniques for determining the magnetospheric source position of ICWs not seen at synchronous orbit but observed on the ground as structured Pc1 pulsations are considered.
Fraser, B. J.↗