Search NASA⌕ Search

SEARCH · Search NASA

Results for “short-circuit”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2

Damage and recovery characteristics of lithium-containing solar cells.

Damage and recovery characteristics were measured on lithium-containing solar cells irradiated by 1-MeV electrons. Empirical expressions for cell recovery time, diffusion-length damage coefficient immediately after irradiation, and diffusion-length damage coefficient after recovery were derived using results of short-circuit current, diffusion-length, and reverse-bias capacitance measurements. The damage coefficients were expressed in terms of a single lithium density parameter, the lithium gradient. A fluence dependence was also established, this dependence being the same for both the immediate-post-irradiation and post-recovery cases. Cell recovery rates were found to increase linearly with lithium gradient.

Faith, T. J.↗

Research on rechargeable oxygen electrodes.

A research program is described which consisted of studying the effects of electrode cycling in very pure KOH solutions, with and without controlled additions of impurities, on oxide formation, oxygen evolution kinetics, oxygen reduction kinetics (including hydrogen peroxide formation), and changes in electrode structure. Bright platinum, platinized platinum, and Teflon-bonded platinum black electrodes were studied. Three main problem areas are identified: the buildup of a refractory anodic layer on prolonged cycling, which leads to a degradation of performance; the dissolution and subsequent deposition of dendritic platinum in the separator, leading to short-circuit ing and loss of electrocatalyst; and the disruptive effect of bubbling during gas evolution on charge. Each of these problem areas is analyzed, and remedial solutions are proposed.

Giner, J.↗

Parametric performance characteristics and treatment of temperature coefficients of silicon solar cells for space application

The electrical performance characteristics of 2 and 10 ohms-cm N/P-type silicon solar cells were measured at simulated solar intensities of 5, 50, 100, 140, 250, 400, 550, 700, and 850 mW/sq cm. At each intensity, the temperature was varied in increments of 20 deg between extremes of +160 and -160 C. Short-circuit current, open-circuit voltage, and maximum power are presented in graphical format. Also described are three methods for predicting solar cell electrical performance as a function of temperature and intensity. Two of the methods are suitable for use at extreme temperature-intensity conditions. These methods were used sucessfully to predict the performance of the transducer on board the Mariner Mars 1971 spacecraft.

Patterson, R. E.↗

Heat treatment effects in Cu2S-CdS heterojunction photovoltaic cells

The optical and electronic properties of single crystal Cu2S-CdS photovoltaic cells were investigated. In these cells trapped charge near the interface which is manifested by a persistent increase in junction capacitance (the photocapacitance) plays a significant role in determining the carrier transport properties. It was found that the severe degradation in short-circuit current observed in heat-treated cells can be separated into two components: (1) a relatively small thermal component occurring on heat-treatment in the dark, and (2) a much larger degradation caused by exposure to light at room temperature. By a short additional heat-treatment above approximately 100 C the cell can be completely restored to its condition before the optically caused degradation with no effect on the depletion layer width.

Fahrenbruch, A. L.↗

Breakdown phenomena in reverse biased silicon solar cells.

Solar cell reverse current-voltage characteristics have been found to vary widely and to be generally unstable. At reverse voltages greater than approximately 20 V and at cell power dissipations of more than 4 W, the probability of permanent breakdown, resulting in cell short-circuit failure, was found to increase with increasing voltage and exposure time. Shorted cells showed evidence of cell contact material and silicon melting in very localized areas with lava-like flow patterns and channels bridging the p and n contacts.

Rauschenbach, H. S.↗

Voltage and power relationships in lithium-containing solar cells.

Photovoltaic characteristics have been measured on a large number of crucible-grown lithium-containing solar cells irradiated by 1-MeV electrons to fluences ranging from 3 x 10 to the 13th power to 3 x 10 to the 15th power electrons per sq cm. These measurements have established empirical relationships between cell photovoltaic parameters and lithium donor density gradient. Short-circuit current and maximum power measured immediately after irradiation decrease logarithmically with lithium gradient. Open-circuit voltage increases logarithmically with lithium gradient both immediately after irradiation and after recovery, the degree of recovery being strongly gradient-dependent at high fluence. As a result, the maximum power and the power at 0.43 V after recovery from 3 x 10 to the 15th power electrons per sq cm increase with increasing lithium gradient.

Faith, T. J.↗

A possible current system associated with the Sqp variation.

It is suggested that the quiet day daily magnetic variation in the polar cap region, Sqp, results partly from the short-circuit effect of the magnetotail current by the polar ionosphere. This implies that there is an inward field-aligned current from the dawnside magnetopause to the forenoon sector of the auroral oval (positively charged) and an outward field-aligned current to the duskside magnetopause from the afternoon sector of the oval (negatively charged), together with the ionospheric (Pedersen and Hall) currents. The distribution of the magnetic field vectors of both combined current systems agrees with the observed Sqp vector distribution. The space charges provide an electric field distribution which is similar to that which has been observed by polar orbiting satellites.

Kawasaki, K.↗

The drift field model applied to the lithium-containing silicon solar cell

The drift field model used by Wolf to calculate the short-circuit current was extended to permit calculations of the open-circuit voltage and the maximum power under conditions of illumination of either tungsten (2800 C) source or AMO sunlight. Voltages were calculated using an expression for the drift field diode saturation current derived here. The model, applied to the oxygen rich (C-13 group) lithium solar cells, was used to calculate the pre-and post-electron bombardment trends for lithium gradients in the range of 10 to the 18th power to 10 to the 19th power Li/cm to the 4th power. Published experimental data characterizing these cells were used to tailor the model. The calculated trends are in reasonable agreement with the empirical data of Faith. Diffusion length degradation and carrier removal effects were sufficient to predict the cell performance up to 3 x 10 to the 14th power e/sq cm. Beyond this fluence it was necessary to include drift field removal effects.

Godlewski, M. P.↗

Theoretical and experimental investigation of 'grating' type photovoltaic cells

The fabrication procedure and properties of 'grating' cells made by forming a fine grating pattern of aluminum alloyed into n-silicon wafers are described. The finest grating lines achieved in the cells described were 5 microns; the smallest spacing was about 15 microns. The best temperature for alloying was found to be about 600 C, a bit above the Si-Al eutectic temperature (576 C). The short-circuit current obtained from the best of these cells exposed to 100 mW/sq cm of (simulated air mass zero) illumination was at least equal to that obtained from conventional diffused cells, but their open-circuit voltage was lower. Their quantum yield was strongly blue-shifted; it was flat from 4000 to 8500 A.

Loferski, J. J.↗

Performance of epitaxial back surface field cells

Epitaxial back surface field structures were formed by depositing a 10 micron thick 10 ohm-cm epitaxial silicon layer onto substrates with resistivities of 0.01, 0.1, 1.0 and 10 ohm-cm. A correlation between cell open-circuit voltage and substrate resistivity was observed and was compared to theory. The cells were also irradiated with 1-MeV electrons to a fluence of 5 times 10 to the 15th electrons per sq cm. The decrease of cell open-circuit voltage was in excellent agreement with theoretical predictions and the measured short-circuit currents were within 2% of the prediction. Calculations are presented for optimum cell performance as functions of epitaxial layer thickness, radiation fluence, and substrate diffusion length.

Brandhorst, H. W., Jr.↗

The use of FEP Teflon in solar cell cover technology

FEP plastic film was used as a cover and as an adhesive to bond cover glasses to silicon solar cells. Various anti-reflective coatings were applied to cells and subsequently covered with FEP. Short-circuit currents were measured before and after application of the coating and of the FEP. FEP bonded to seven of the nine differently coated cells, with no change in the total short circuit current in four cases.

Broder, J. D.↗

The aurora and the magnetosphere - The Chapman Memorial Lecture

Review of recent progress in magnetospheric physics, in particular, in understanding the magnetospheric substorm. It is shown that a number of magnetospheric phenomena can now be understood by viewing the solar wind-magnetosphere interaction as an MHD dynamo; auroral phenomena are powered by the dynamo. Also, magnetospheric responses to variations of the north-south and east-west components of the interplanetary magnetic field have been identified. The magnetospheric substorm is entirely different from the responses of the magnetosphere to the southward component of the interplanetary magnetic field. It may be associated with the formation of a neutral line within the plasma sheet and with an enhanced reconnection along the line. A number of substorm-associated phenomena can be understood by noting that the new neutral line formation is caused by a short-circuiting of a part of the magnetotail current.

Akasofu, S.-I.↗

Interdiffusion in the Ni/TD-NiCr and Cr/TD-NiCr systems

The diffusion of Ni and Cr into TD-NiCr has been studied over the 900 to 1100 C temperature range. The diffusion couples were prepared by electroplating Cr and Ni on polished TD-NiCr wafers. Concentration profiles produced as a result of isothermal diffusion at 905, 1000, and 1100 C were determined by electron microprobe analysis. The Boltzmann-Matano analysis was used to determine concentration-dependent diffusion coefficients which were found to compare favorably with previously reported values. These data suggest that 2 vol % ThO2 distribution has no appreciable effect on the rates of diffusion in TD-NiCr with a large grain size. This supports the view that an inert dispersoid in an alloy matrix will not in itself lead to enhanced diffusion unless a short-circuit diffusion structure is stabilized.

Pawar, A. V.↗

Irradiation and measurements of fluorinated ethylene-propylene-A on silicon solar cells in vacuum

Silicon monoxide (SiO) coated silicon solar cells covered with fluorinated ethylene-propylene-A (FEP-A) were irradiated by 1-MeV electrons in vacuum. The effect of irradiation on the light transmittance of FEP-A was checked by measuring the short-circuit current of the cells while in vacuum after each dose increment, immediately after the irradiation, and again after a minimum elapsed time of 16 hr. The results indicated no apparent loss in transmission due to irradiation of FEP-A and no delamination from the SiO surface while the cells were in vacuum, but embrittlement of FEP-A occurred at the accumulated dose.

Marsik, S. J.↗

Results of the first 150 days of the NTS-1 solar cell experiments

Twelve solar cell experiments were on the Naval Research Laboratory NTS-1 satellite launched on 14 July 1974, into a 13,260 km circular orbit at an inclination of 125 deg. The experiment comprises: 2 ohm-cm n/p, lithium-diffused p/n, violet n/p, p(+) back surface field, and ultra-thin wrap around contact cells. The short-circuit current of the experiments ranged from 2 to 12 percent higher in space than under solar simulators. During the 5 year life of the satellite, the experiments will be exposed to radiation equivalent to 2 x 10 to the 15th power 1-MeV electron cm/2 and to nearly 5500 thermal cycles.

Statler, R. L.↗

Hydrogen diffusion and trapping in nickel

An analysis of hydrogen transport in pure polycrystalline nickel foils and rods at 300-550 K shows that both trapping and short-circuit diffusion are present and have small yet significant effects on permeation, evolution, and absorption. Both effects appear to be associated primarily with the dislocation substructure of nickel. Relations describing hydrogen transport in nickel are obtained using the data on deuterium permeation, tritium absorption, and outgassing in pure polycrystalline nickel together with earlier measurements of diffusivity and solubility of hydrogen isotopes.

Louthan, M. R., Jr.↗

Effect of electron irradiation in vacuum on FEP-A silicon solar cell covers

The effect of irradiation on the light transmittance of ethylene-propylene-A (FEP-A) was investigated by measuring the short-circuit current of the cells after each of several electron dose increments, immediately after total irradiation, and 16 hours after total irradiation. Results indicated no apparent overall loss in transmission due to irradiation of FEP-A. However, filter wheel measurements revealed a 'darkening' of the FEP-A at the blue end of the spectrum. Some embrittlement of the FEP-A occurred at an accumulated dose of 67,500,000 rads.

Marsik, S. J.↗

Space calibration of standard solar cells using high altitude sounding rockets

Four photovoltaic cells were space calibrated and successfully recovered from a NASA Aerobee rocket launched on Sept. 18, 1974, which reached a peak altitude of 251 km. The experiment was comprised of four 2 ohm-cm n/p cells, two of which are optically filtered with 0.6 to 0.9 micron bandpass filters. The short-circuit current agreed to within 4% of the laboratory calibration. The variation of cell output due to atmospheric attenuation between the altitude range 80 and 251 km was 0.4% for the unfiltered cells.

Thomas, N. L.↗