Search NASA⌕ Search

SEARCH · Search NASA

Results for “strains effect”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1996

Temperature and Strain-Rate Effects on Low-Cycle Fatigue Behavior of Alloy 800H

The effects of strain rate (4 x 10(exp -6) to 4 x 10(exp -3)/s) and temperature on the Low-Cycle Fatigue (LCF) behavior of alloy 800H have been evaluated in the range 750 C to 950 C. Total axial strain controlled LCF tests were conducted in air at a strain amplitude of +/- 0.30 pct. LCF life decreased with decreasing strain rate and increasing temperature. The cyclic stress response behavior showed a marked variation with temperature and strain rate. The time- and temperature- dependent processes which influence the cyclic stress response and life have been identified and their relative importance assessed. Dynamic strain aging, time-dependent deformation, precipitation of parallel platelets of M(23)C6 on grain boundaries and incoherent ledges of twins, and oxidation were found to operate depending on the test conditions. The largest effect on life was shown by oxidation processes.

Rao, K. Bhanu Sankara↗
NASA NTRS1972

An investigation of strain cycling behavior of 7075-T6 aluminum under combined state of strain: The effects of out-of-phase, biaxial strain cycling on low cycle fatigue

The effect of out-of-phase strain cycling on the low cycle fatigue of biaxially loaded specimens is discussed. A method to apply phase angles between two strains imposed in two different directions was developed. The data and the proposed theoretical analysis are part of a research program on biaxial strain cycling effect on fatigue life of structural materials.

Zamrik, S. Y.↗
NASA NTRS1994

The Effect of Strain on the Base Resistance and Transit Time of Ungraded and Compositional-Graded SiGe HBTs

A theoretical study of the effects of the strain on the base properties of ungraded and compositional-graded n-p-n SiGe Heterojunction Bipolar Transistors (HBT) is presented. The dependencies of the transverse hole mobility and longitudinal electron mobility upon strain, composition and doping, are formulated using published Monte-Carlo data and, consequently, the base resistance and transit time are modeled and calculated. The results are compared to results obtained using common formulas that ignore these dependencies. The differences between the two sets of results are shown. The paper's conclusion is that for the design, analysis and optimization of high frequency SiGe HBTs the strain effects on the base properties cannot be ignored.

Rosenfeld, D.↗
DOE OSTI2025

Coexisting Phases in NaNbO 3 Thin Films Influenced by Epitaxial Strain and Size Effects

Coherently strained NaNbO 3 thin films are synthesized across a range of thicknesses, enabling the study of size effects under epitaxial strain in antiferroelectric thin films without relaxation. Competing antiferroelectric‐ferroelectric phases are observed, leading to the stabilization of phase coexistence, multistate switching with strong retention and fatigue performance, and potential avenues to boost energy storage properties.

antiferroelectrics↗
DOE OSTI2023

Synergistic effects of mixing and strain in high entropy spinel oxides for oxygen evolution reaction

Developing stable and efficient electrocatalysts is vital for boosting oxygen evolution reaction (OER) rates in sustainable hydrogen production. High-entropy oxides (HEOs) consist of five or more metal cations, providing opportunities to tune their catalytic properties toward high OER efficiency. This work combines theoretical and experimental studies to scrutinize the OER activity and stability for spinel-type HEOs. Density functional theory confirms that randomly mixed metal sites show thermodynamic stability, with intermediate adsorption energies displaying wider distributions due to mixing-induced equatorial strain in active metal-oxygen bonds. The rapid sol-flame method is employed to synthesize HEO, comprising five 3d-transition metal cations, which exhibits superior OER activity and durability under alkaline conditions, outperforming lower-entropy oxides, even with partial surface oxidations. The study highlights that the enhanced activity of HEO is primarily attributed to the mixing of multiple elements, leading to strain effects near the active site, as well as surface composition and coverage.

08 HYDROGEN↗
DOE OSTI2020

Effect of strain on the reactivity of graphene films

The effect of strain on the adsorption of atomic species (Cl, H, N, and O) on pristine and nitrogen-doped graphene is studied using density functional theory. Expansive strain increases surface reactivity by destabilizing graphene π orbitals, which is similar to the shift in the d-band center observed on stretched metal surfaces. However, compressive strain leads to the formation of nanoripples that strongly bind atomic species at ridge sites, which is fundamentally different from adsorption on compressed metal surfaces. Furthermore, our findings suggest that strain can be used as an effective means of manipulating graphene’s reactivity, which is explicitly shown here for the oxygen reduction reaction.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS1982

Environmental and high strain rate effects on composites for engine applications

The complex environmental and loading conditions experienced by many turbine engine components impose severe durability and damage tolerance requirements for component materials. Programs are being conducted to establish the structural performance of composite materials under anticipated engine operating environments. A description is presented of the results obtained in connection with several of these programs. A comparison of predicted and measured hygrothermal effects is considered along with hygrothermal effects on defect growth, high strain rate effects on composite mechanical properties, dynamic stress intensity factors for composites, and the indentation laws for composite impact analysis.

Chamis, C. C.↗
DOE OSTI2022

Study of the interplay between lower-order and higher-order energetic strain-gradient effects in polycrystal plasticity

in this report strain-gradient (SG) plasticity refers to a class of non-local theories in which gradients of plastic slip determine the storage of geometrically necessary dislocations, introducing a length-scale dependence in the mechanical behavior of crystalline materials, which is otherwise lacking in local theories. In this work, we incorporate lower-order (LO) and higher-order energetic (HOE) strain-gradient effects into a crystal plasticity fast Fourier transform (FFT)-based formulation to investigate the interplay of the length scale that each strain-gradient term introduces at the microscale, and the mechanical properties that result at the macroscale. For an applicable range of length scales, we consider two systems: a 1-D two-phase face centered cubic (FCC) laminate and a 3-D FCC polycrystal, and two uniaxial deformation modes: monotonic tension and cyclic tension–compression. We show that increases in the individual LO and HOE length scales increase the hardening rate and strength of the material, respectively. When combined, the strong LO hardening is less pronounced than the effect alone due to the lowering of the gradients due to the HOE microstress. We demonstrate that the LO and HOE hardening manifest as “isotropic” (yield surface expansion) and “kinematic” (yield surface shift) effects, respectively, consistent with their theoretical origins. We show that in cyclic loading, the Bauschinger effect emerges in both local and non-local calculations and link its origins and severity to the behavior in the strain field, slip-system rates, and the HOE microforce.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Decoupling indentation size and strain rate effects during nanoindentation: A case study in tungsten

Materials indented at small scales may simultaneously exhibit indentation size and strain rate effects which complicate the identification of the mechanisms that control deformation and strength. Here, in this work, we explore the possibility that indentation size and rate effects in some materials can be decoupled in a simple way. Nanoindentation tests with various load-time histories were carried out to measure the hardness of a tungsten single crystal over a wide range of indentation depths (~500–3600 nm) and indentation strain rates (~5 ×10 –5 –2 ×10 –1 s –1 ). Under these conditions, this material exhibits significant indentation size and rate effects, but the size effect is, to a good approximation, independent of strain rate. It is shown that this behavior can be understood by the Nix-Gao model for the indentation size effect modified to include the effects of a strain rate dependent friction stress. As a consequence, the size and rate dependencies of the hardness can be expressed as the sum of two independent terms: H($\dot{ε}$ i , h c )=H f ($\dot{ε}$ i ) + (H 0 – H f ) $\sqrt{1+ \frac{h^*}{h_c}}$, where H($\dot{ε}$ i , h c ) is the hardness at given indentation strain rate ($\dot{ε}$ i ) and contact depth (h c ), H f ($\dot{ε}$ i ) is the hardness contributed by the rate dependent friction stress, and (H 0 – H f ) and h* are size and rate independent constants that follow from the Nix-Gao analysis. This formula, together with an expression for the rate dependence of H f , was successfully applied to decouple the indentation size and rate effects observed in tungsten. In addition, the physics underlying the rate independence of indentation size effect is discussed, which provides guidance for application of the proposed approach to other materials.

42 ENGINEERING↗
DOE OSTI2020

Comprehensive Electrical Control of Metamagnetic Transition of a Quasi-2D Antiferromagnet by In Situ Anisotropic Strain

Effective nonmagnetic control of the spin structure is at the forefront of the study for functional quantum materials. This study demonstrates that, by applying an anisotropic strain up to only 0.05%, the metamagnetic transition field of spin–orbit-coupled Mott insulator Sr 2 IrO 4 can be in situ modulated by almost 300%. Simultaneous measurements of resonant X-ray scattering and transport reveal that this drastic response originates from the complete strain-tuning of the transition between the spin-flop and spin-flip limits, and is always accompanied by large elastoconductance and magnetoconductance. This enables electrically controllable and electronically detectable metamagnetic switching, despite the antiferromagnetic insulating state. The obtained strain-magnetic field phase diagram reveals that C 4 -symmetry-breaking anisotropy is introduced by strain via pseudospin-lattice coupling, directly demonstrating the pseudo-Jahn–Teller effect of spin–orbit-coupled complex oxides. The extracted coupling strength is much weaker than the superexchange interactions, yet crucial for the spontaneous symmetry-breaking, affording the remarkably efficient strain-control.

36 MATERIALS SCIENCE↗