Search NASA⌕ Search

SEARCH · Search NASA

Results for “transient behavior”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

The electrodynamic and hydrodynamic phenomena in magnetically-levitated molten droplets. II - Transient behavior and heat transfer considerations

Computed results are presented describing the transient evolution of the velocity and the temperature fields in a levitation-melted, electromagnetically-positioned metallic sample under microgravity, for conditions, when the heating current is switched off. Thus the calculations trace the evolution from one steady state corresponding to the simultaneous operation of both the heating and the positioning coils to that corresponding to the operation of the positioning coils only. The calculations have shown that the velocity field will decay much more rapidly than the temperature field, so that the cooling and subsequent undercooling and recalescence of the samples should take place from an essentially stagnant melt, meeting the original objectives of the experiment. The computed results for the velocity decay appear to agree with asymptotic calculations and also appear to follow the scaling laws.

Zong, Jin-Ho↗
NASA NTRS1949

Transient Behavior of Lumped-Constant Systems for Sensing Gas Pressures

The development of theoretical equations describing the behavior of a lumped-constant pressure-sensing system under transient operation Is presented with experimental data that show agreement with the equations. A pressure-sensing system 'consisting of a tube terminating in a reservoir is investigated for the transient relation between a presSure disturbance at the open end of the tube and the pressure response in the reservoir. Design parameters are presented that can be adjusted to achieve a desired performance fran such a system when the system is considered as a transfer member of a control loop.

INSTRUMENTS - PRESSURE↗
NASA NTRS1998

Long-Term Variability and Transient Behavior of some Galactic Hard X-Ray Sources as Observed with BATSE

The Burst and Transient Source Experiment (BATSE) experiment on the Compton Observatory has been providing continuous, all-sky monitoring of the hard X-ray sky for over seven years. A wide variety of transient and high-variability phenomena are observed for about sixty Galactic neutron star and black hole systems. A daily sensitivity level of approximately 75 mCrab is attained for sources observed by Earth occultation in un-crowded regions and approximately 20 mCrab for pulsars with known periods. This talk will qualitatively describe the types of variability that are observed from some of the brighter sources, including their duty-cycle and the various time-scales observed. Implications for the INTEGRAL mission will be discussed.

Fishman, Gerald J.↗
NASA NTRS1982

Transient behavior of an actively mode-locked semiconductor laser diode

Experimental investigation was carried out to study the transient regimes during the buildup and decay of the active mode-locked state in a laser diode. The mode locking was achieved through a sinusoidal modulation of the diode current with the laser in an external cavity. The pulse shape evolution and the time constants for the buildup and decay were determined.

Auyeung, J. C.↗
NASA NTRS1991

An analytic solution of the transient behavior of backscattering thermal protective coatings exposed to combined radiative and convective heating

An analytic solution of the material response to combined radiative and convective heating is presented. The solution includes the equations of radiative transfer (within the material), coupled to a transient energy equation which contains both radiative and convective terms. The analysis allows for unlimited spectral detail, but assumes that within the range of applicability, the various material properties do not vary significantly with temperature. Also, to facilitate development of the analytic solution, it is assumed that scattering within the material dominates absorption, and the material exposed surface does not ablate. The exposed surface boundary condition includes convective heating and spectral radiation, some of which is absorbed by the surface and some which penetrates the surface.

Cornelison, Charles J.↗
DOE OSTI2021

A Data Set for Intercomparing the Transient Behavior of Dynamical Model-Based Subseasonal to Decadal Climate Predictions

Climate predictions using coupled models in different time scales, from intraseasonal to decadal, are usually affected by initial shocks, drifts, and biases, which reduce the prediction skill. These arise from inconsistencies between different components of the coupled models and from the tendency of the model state to evolve from the prescribed initial conditions toward its own climatology over the course of the prediction. Aiming to provide tools and further insight into the mechanisms responsible for initial shocks, drifts, and biases, this paper presents a novel data set developed within the Long Range Forecast Transient Intercomparison Project, LRFTIP. This data set has been constructed by averaging hindcasts over available prediction years and ensemble members to form a hindcast climatology, that is a function of spatial variables and lead time, and thus results in a useful tool for characterizing and assessing the evolution of errors as well as the physical mechanisms responsible for them. A discussion on such errors at the different time scales is provided along with plausible ways forward in the field of climate predictions

54 ENVIRONMENTAL SCIENCES↗
NASA NTRS2011

Loop Heat Pipe Transient Behavior Using Heat Source Temperature for Set Point Control with Thermoelectric Converter on Reservoir

The LHP operating temperature is governed by the saturation temperature of its reservoir. Controlling the reservoir saturation temperature is commonly done by cold biasing the reservoir and using electrical heaters to provide the required control power. With this method, the loop operating temperature can be controlled within 0.5K or better. However, because the thermal resistance that exists between the heat source and the LHP evaporator, the heat source temperature will vary with its heat output even if the LHP operating temperature is kept constant. Since maintaining a constant heat source temperature is of most interest, a question often raised is whether the heat source temperature can be used for LHP set point temperature control. A test program with a miniature LHP was carried out to investigate the effects on the LHP operation when the control temperature sensor was placed on the heat source instead of the reservoir. In these tests, the LHP reservoir was cold-biased and was heated by a control heater. Test results show that it was feasible to use the heat source temperature for feedback control of the LHP operation. In particular, when a thermoelectric converter was used as the reservoir control heater, the heat source temperature could be maintained within a tight range using a proportional-integral-derivative or on/off control algorithm. Moreover, because the TEC could provide both heating and cooling to the reservoir, temperature oscillations during fast transients such as loop startup could be eliminated or substantially reduced when compared to using an electrical heater as the control heater.

Ku, Jentung↗
NASA NTRS1986

Analysis of the transient behavior of rubbing components

Finite element equations are developed for studying deformations and temperatures resulting from frictional heating in sliding system. The formulation is done for linear steady state motion in two dimensions. The equations include the effect of the velocity on the moving components. This gives spurious oscillations in their solutions by Galerkin finite element methods. A method called streamline upwind scheme is used to try to deal with this deficiency. The finite element program is then used to investigate the friction of heating in gas path seal.

Quezdou, M. B.↗
NASA NTRS1952

Automatic control systems satisfying certain general criterions on transient behavior

An analytic method for the design of automatic controls is developed that starts from certain arbitrary criterions on the behavior of the controlled system and gives those physically realizable equations that the control system can follow in order to realize this behavior. The criterions used are developed in the form of certain time integrals. General results are shown for systems of second order and of any number of degrees of freedom. Detailed examples for several cases in the control of a turbojet engine are presented.

Boksenbom, Aaron S↗
NASA NTRS2000

Jovian Substorms: A Study of Processes Leading to Transient Behavior in the Jovian Magnetosphere

Solar system magnetospheres can be divided into two groups: induced and intrinsic. The induced magnetospheres are produced in the solar wind interaction of the magnetized solar wind with planetary obstacles. Examples of these magnetospheres are those of comets, Venus and Mars. Intrinsic magnetospheres are the cavities formed in the solar wind by the magnetic fields produced by dynamo current systems inside the planets: Mercury, Earth, Jupiter, Saturn, Uranus and Neptune are known to have intrinsic magnetospheres. Intrinsic magnetospheres can be further subdivided as to how the circulating plasma is driven by external or internal processes. The magnetospheres of Mercury and Earth are driven by the solar wind. The magnetospheres of Jupiter and possibly of Saturn are principally driven by internal processes. These processes provide the energy for the powerful jovian radio signals that can be detected easily on the surface of the Earth.

Russell, C. T.↗
DOE OSTI2023

Comparative Study of Nonlinear Black-Box Modeling for Power Electronics Converters

With the increasing penetration level of renewable sources and power electronics loads in modern power systems, accurate and computationally efficient models are needed. Black-box model (BBM) could be a useful method in such systems. However, not very extensive research efforts have been made for power electronics BBM so far, and existing works mostly focus on steady-state operation, neglecting the important transient behaviors such as load transients, voltage transients, and faults. This paper presents a comparative study of three commonly used nonlinear BBM approaches for transient behaviors of power electronics converters. Comparison methods are proposed, and the evaluations are conducted under different transients using a grid-connected single-phase photovoltaic inverter. The findings of this study provide valuable references for further feasibility investigations on implementing BBMs in large-scale power electronics-rich power systems.

Qiao, Liang↗
DOE OSTI2023

Aggregation of Leslie matrix models with application to ten diverse animal species

Some grouping is necessary when constructing a Leslie matrix model because it involves discretizing a continuous process of births and deaths. Here, the level of grouping is determined by the number of age classes and frequency of sampling. It is largely unknown what is lost or gained by using fewer age classes, and I address this question using aggregation theory. I derive an aggregator for a Leslie matrix model using weighted least squares, determine what properties an aggregated matrix inherits from the original matrix, evaluate aggregation error, and measure the influence of aggregation on asymptotic and transient behaviors. To gauge transient dynamics, I employ reactivity of the standardized Leslie matrix. I apply the aggregator to 10 Leslie models developed for animal populations drawn from a diverse set of species. Several properties are inherited by the aggregated matrix: (a) it is a Leslie matrix; (b) it is irreducible whenever the original matrix is irreducible; (c) it is primitive whenever the original matrix is primitive; and (d) its stable population growth rate and stable age distribution are consistent with those of the original matrix if the least squares weights are equal to the original stable age distribution. In the application, depending on the population modeled, when the least squares weights do not follow the stable age distribution, the stable population growth rate of the aggregated matrix may or may not be approximately consistent with that of the original matrix. Transient behavior is lost with high aggregation.

54 ENVIRONMENTAL SCIENCES↗