Search NASA⌕ Search

SEARCH · Search NASA

Results for “DESCENT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20

A flight investigation of the ultra-deep-stall descent and spin recovery characteristics of a 1/6 scale radiocontrolled model of the Piper PA38 Tomahawk

Ultradeep stall descent and spin recovery characteristics of a 1/6 scale radio controlled model of the Piper PA38 Tomahawk aircraft was investigated. It was shown that the full scale PA38 is a suitable aircraft for conducting ultradeep stall research. Spin recovery was accomplished satisfactorily by entry to the ultradeep stall mode, followed by the exit from the ultradeep stall mode. It is concluded that since the PA38 has excellent spin recovery characteristics using normal recovery techniques (opposite rudder and forward control colum pressure), recovery using ultradeep stall would be beneficial only if the pilot suffered from disorientation.

Blanchard, W. S., Jr.↗

Research study: STS-1 Orbiter Descent

The conversion of STS-1 orbiter descent data from AVE-SESAME contact programs to the REEDA system and the reduction of raw radiosonde data is summarized. A first difference program, contact data program, plot data program, and 30 second data program were developed. Six radiosonde soundings were taken. An example of the outputs of each of the programs is presented.

Hickey, J. S.↗

Modeling of the aircraft in-trail-following task during profile descent

The cockpit display of traffic information (CDTI) system concepts enable the pilot to observe the surrounding air traffic pattern. The impact of such a system is far reaching in terms of improved safety, pilot and controller workload, and aircraft fuel efficiency. One direct payoff is the ability to distribute the ATC workload to the pilot in such tasks as merging and spacing. The CDTI application of spacing approach aircraft in the terminal area is addressed. In-trail-following/CDTI experiments were performed using realistic cockpit simulators and profile descent approach scenarios. Based on collected experimental simulator data, pilot models were developed which include state estimation, decision making and flight control aspects. These models were coupled with models of aircraft and CDTI equipment to study the dynamic phenomena and stability of strings of aircraft along various approach patterns.

Goka, T.↗

Space Shuttle Orbiter descent navigation

The entry operational sequence (OPS 3) begins approximately 2 hours prior to the deorbit maneuver and continues through atmospheric entry, terminal area energy management (TAEM), approach and landing, and rollout. During this flight phase, the navigation state vector is estimated by the Space Shuttle Orbiter onboard navigation system. This estimate is computed using a six-element sequential Kalman filter, which blends inertial measurement unit (IMU) delta-velocity data with external navaid data. The external navaids available to the filter are tactical air navigation (TACAN), barometric altimeter, and microwave scan beam landing system (MSBLS). Attention is given to the functional design of the Orbiter navigation system, the descent navigation sensors and measurement processing, predicted Kalman gains, correlation coefficients, and current flights navigation performance.

Montez, M. N.↗

In-trail following during profile descents with a cockpit display of traffic information

Four line pilots performed simulator flights of 747s on different air routes in conditions of following other aircraft while maintaining a specified temporal flight interval separation. The flights were made in the heading-select mode of the autopilot, and the pitch wheel or altitude select/hold mode with the throttle on manual. A cockpit display of traffic information (CDTI) on a CRT was presented in front of the throttles. A VOR radial with dotted centerlines and sidebands representing 3 km intervals was displayed, along with scales of distance depending on altitude. Traffic information was updated every four seconds. Simulated flights began at cruise and followed a standard profile descent, and traffic following intervals of 60, 80, 120, and 140 seconds were presented in different trials. Results indicated that a CDTI was sufficient instrumentation for trailing other aircraft, with low error rates up to the point of landing preparations.

Chappell, S. L.↗

Strong refraction near the Venus surface - Effects observed by descent probes

The telemetry signals from Pioneer Venus probes indicated the strong downward refraction of radio waves. As the probes descended, the strength of the direct signal decreased because of absorption and refractive defocusing. During the last 30 km of descent there was a second measured component in addition to the direct signal. Strong atmospheric reaction is important in strengthening echoes that are scattered toward the earth. Such surface-reflected signals are good indicators of horizontal winds.

Croft, T. A.↗

Transitions and transversions in evolutionary descent - An approach to understanding

A quantitative theoretical groundwork is presented for determining the proportions of the possible types of base substitutions observed between 12 genes sharing a common ancestor and isolated from extant species. Three methods (direct count, regression, and informational entropy maximization) are described by which conditional base substitution probabilities that determine evolutionary descent can be estimated from experimental data. These methods are utilized to study the ratio of transversions to transitions during gene divergence. The limiting ratio is directly calculated from a knowledge of the 12 conditional probabilities for each type of base substitution and from a knowledge of the equilibrium base composition of the DNAs compared. An expression is developed for this calculation. It is concluded that multiple substitutions per se do not lead to a decrease in transition differences with increasing evolutionary divergence.

Holmquist, R.↗

Descent vehicles

The creation of descent vehicles marked a new stage in the development of cosmonautics, involving the beginning of manned space flight and substantial progress in space research on the distant bodies of the Solar System. This booklet describes these vehicles and their structures, systems, and purposes. It is intended for the general public interested in modern problems of space technology.

Popov, Y. I.↗

Feedback control for fuel-optimal descents using singular perturbation techniques

In response to rising fuel costs and reduced profit margins for the airline companies, the optimization of the paths flown by transport aircraft has been considered. It was found that application of optimal control theory to the considered problem can result in savings in fuel, time, and direct operating costs. The best solution to the aircraft trajectory problem is an onboard real-time feedback control law. The present paper presents a technique which shows promise of becoming a part of a complete solution. The application of singular perturbation techniques to the problem is discussed, taking into account the benefits and some problems associated with them. A different technique for handling the descent part of a trajectory is also discussed.

Price, D. B.↗

Design requirements and development of an airborne descent path definition algorithm for time navigation

The design requirements for a 4D path definition algorithm are described. These requirements were developed for the NASA ATOPS as an extension of the Local Flow Management/Profile Descent algorithm. They specify the processing flow, functional and data architectures, and system input requirements, and recommended the addition of a broad path revision (reinitialization) function capability. The document also summarizes algorithm design enhancements and the implementation status of the algorithm on an in-house PDP-11/70 computer. Finally, the requirements for the pilot-computer interfaces, the lateral path processor, and guidance and steering function are described.

Izumi, K. H.↗

Impact of mismodeled idle engine performance on calculation and tracking of optimal 4-D descent trajectories

Advanced flight management systems are being developed which are capable of calculating optimal 3-D and 4-D flight trajectories for arbitrary fuel and time costs. These systems require mathematical models of airplane performance in order to compute the optimal profiles. Mismodeled idle engine characteristics can result in descent trajectories requiring excessive throttle and/or speedbrake activity in order to achieve the desired end conditions. This paper evaluates the cost and fuel penalties, trajectory variations, and flight control requirements associated with typical idle engine modeling errors for a twin-jet transport airplane. Variations in idle power setting, thrust, fuel flow, and surge bleed operation were evaluated for a cruise/descent flight segment. The results of this analysis provide insight into the penalties associated with uncertainties in idle engine performance and suggest methods of modeling which minimize these penalties.

Williams, D. H.↗

A comparison of the ground effects measured with and without rate-of-descent modeling on the F-15 S/MTD configuration

The effect of descent rate (DR) on the approach aerodynamics of the F-15 S/MTD aircraft is investigated experimentally using a moving model in the NASA Langley Vortex Research Facility. A 0.083-scale low-speed rotary-balance model equipped with a thrust-reverser simulator and with grit strips to assure turbulent flow was tested in an approach configuration at forward speed 60 ft/sec, corresponding to DR = 4.19 ft/sec. The results are presented in extensive graphs and compared with wind-tunnel data on the same configuration at DR = 0. Significant differences are attributed to the DR in the present experiments and the presence of a ground boundary layer in the wind-tunnel tests. It is predicted that safe approaches could be made with the lower thrust reverser vectored up to 80 deg, or even 110 deg if the DR were not arrested near the ground.

Kemmerly, Guy T.↗

STS-40 descent BET products: Development and results

Descent Best Estimate Trajectory (BET) Data were generated for the final Orbiter Experiments Flight, STS-40. This report discusses the actual development of these post-flight products: the inertial BET, the Extended BET, and the Aerodynamic BET. Summary results are also included. The inertial BET was determined based on processing Tracking and Data Relay Satellite (TDRSS) coherent Doppler data in conjunction with observations from eleven C-band stations, to include data from the Kwajalein Atoll and the usual California coastal radars, as well as data from five cinetheodolite cameras in the vicinity of the runways at EAFB. The anchor epoch utilized for the trajectory reconstruction was 53,904 Greenwich Mean Time (GMT) seconds which corresponds to an altitude at epoch of approximately 708 kft. Atmospheric data to enable development of an Extended BET for this mission were upsurped from the JSC operational post-flight BET. These data were evaluated based on Space Shuttle-derived considerations as well as model comparisons. The Aerodynamic BET includes configuration information, final mass properties, and both flight-determined and predicted aerodynamic performance estimates. The predicted data were based on the final pre-operational databook, updated to include flight determined incrementals based on an earlier ensemble of flights. Aerodynamic performance comparisons are presented and correlated versus statistical results based on twenty-two previous missions.

Oakes, Kevin F.↗

Final STS-35 Columbia descent BET products and results for LaRC OEX investigations

Final STS-35 'Columbia' descent Best Estimate Trajectory (BET) products have been developed for Langley Research Center (LaRC) Orbiter Experiments (OEX) investigations. Included are the reconstructed inertial trajectory profile; the Extended BET, which combines the inertial data and, in this instance, the National Weather Service atmospheric information obtained via Johnson Space Center; and the Aerodynamic BET. The inertial BET utilized Inertial Measurement Unit 1 (IMU1) dynamic measurements for deterministic propagation during the ENTREE estimation process. The final estimate was based on the considerable ground based C-band tracking coverage available as well as Tracking Data and Relay Satellite System (TDRSS) Doppler data, a unique use of the latter for endo-atmospheric flight determinations. The actual estimate required simultaneous solutions for the spacecraft position and velocity, spacecraft attitude, and six IMU parameters - three gyro biases and three accelerometer scale factor correction terms. The anchor epoch for this analysis was 19,200 Greenwich Mean Time (GMT) seconds which corresponds to an initial Shuttle altitude of approximately 513 kft. The atmospheric data incorporated were evaluated based on Shuttle derived considerations as well as comparisons with other models. The AEROBET was developed based on the Extended BET, the measured spacecraft configuration information, final mass properties, and the final Orbiter preoperation databook. The latter was updated based on aerodynamic consensus incrementals derived by the latest published FAD. The rectified predictions were compared versus the flight computed values and the resultant differences were correlated versus ensemble results for twenty-two previous STS entry flights.

Oakes, Kevin F.↗

Descent advisor preliminary field test

A field test of the Descent Advisor (DA) automation tool was conducted at the Denver Air Route Traffic Control Center in September 1994. DA is being developed to assist Center controllers in the efficient management and control of arrival traffic. DA generates advisories, based on trajectory predictions, to achieve accurate meter-fix arrival times in a fuel efficient manner while assisting the controller with the prediction and resolution of potential conflicts. The test objectives were to evaluate the accuracy of DA trajectory predictions for conventional- and flight-management-system-equipped jet transports, to identify significant sources of trajectory prediction error, and to investigate procedural and training issues (both air and ground) associated with DA operations. Various commercial aircraft (97 flights total) and a Boeing 737-100 research aircraft participated in the test. Preliminary results from the primary test set of 24 commercial flights indicate a mean DA arrival time prediction error of 2.4 sec late with a standard deviation of 13.1 sec. This paper describes the field test and presents preliminary results for the commercial flights.

Green, Steven M.↗

Descent Advisor Preliminary Field Test

A field test of the Descent Advisor (DA) automation tool was conducted at the Denver Air Route Traffic Control Center in September 1994. DA is being developed to assist Center controllers in the efficient management and control of arrival traffic. DA generates advisories, based on trajectory predictions, to achieve accurate meter-fix arrival times in a fuel efficient manner while assisting the controller with the prediction and resolution of potential conflicts. The test objectives were: (1) to evaluate the accuracy of DA trajectory predictions for conventional and flight-management system equipped jet transports, (2) to identify significant sources of trajectory prediction error, and (3) to investigate procedural and training issues (both air and ground) associated with DA operations. Various commercial aircraft (97 flights total) and a Boeing 737-100 research aircraft participated in the test. Preliminary results from the primary test set of 24 commercial flights indicate a mean DA arrival time prediction error of 2.4 seconds late with a standard deviation of 13.1 seconds. This paper describes the field test and presents preliminary results for the commercial flights.

Green, Steven M.↗

Nonlinear Performance Seeking Control using Fuzzy Model Reference Learning Control and the Method of Steepest Descent

Performance Seeking Control (PSC) attempts to find and control the process at the operating condition that will generate maximum performance. In this paper a nonlinear multivariable PSC methodology will be developed, utilizing the Fuzzy Model Reference Learning Control (FMRLC) and the method of Steepest Descent or Gradient (SDG). This PSC control methodology employs the SDG method to find the operating condition that will generate maximum performance. This operating condition is in turn passed to the FMRLC controller as a set point for the control of the process. The conventional SDG algorithm is modified in this paper in order for convergence to occur monotonically. For the FMRLC control, the conventional fuzzy model reference learning control methodology is utilized, with guidelines generated here for effective tuning of the FMRLC controller.

Kopasakis, George↗