Multi-parameter optimum in linear dynamical systems.
Multiparameter optimum damping for harmonically excited linear stable strictly dissipative n degrees of freedom system, locating multivariable saddle points
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Multiparameter optimum damping for harmonically excited linear stable strictly dissipative n degrees of freedom system, locating multivariable saddle points
The performance of a novel multistage estimator when applied to the estimation of the position, velocity, and acceleration of high dynamic Global Positioning System (GPS) receivers is discussed. For the present application, a two-stage specialization of the more general estimation scheme is considered, wherein the first-stage algorithm is selected to be a modified least-squares algorithm operating upon the differential signal model and referred to as differential least-squares (DLS) and the second stage is simply an extended Kalman filter (EKF). In terms of the threshold on received carrier power-to-noise power spectral density ratio (CNR), when compared to the single-stage EKF algorithm, the DLS-EKF algorithm is about 1.5-2.0 dB better in terms of threshold and outperforms the crossproduct AFC (automatic frequency control) loop by 2-5 dB. For the case when data modulation is present, the proposed scheme provides an improvement of about 6 dB in terms of CNR compared to an earlier approximate MLE (maximum likelihood estimation) scheme. There are also very significant improvements in terms of other performance measures.
Head-on beam-beam compensation is adopted to compensate the large beam-beam tune spread from the protonproton interactions at IP6 and IP8 in the Relativistic Heavy Ion Collider (RHIC). Two e-lenses are being built and to be in stalled near IP10 in the end of 2011. In this article we perform numeric simulation to investigate the effect of the electron beam parameters on the proton dynamics. The electron beam parameters include its transverse profile, size, current, offset and random errors in them. In this article we studied the effect of the electron beam parameters on the proton dynamics. The electron beam parameters include its transverse shape, size, current, offset and their random errors. From the study, we require that the electron beam size can not be smaller than the proton beam's. And the random noise in the electron current should be better than 0.1%. The offset of electron beam w.r.t. the proton beam center is crucial to head-on beam-beam compensation. Its random errors should be below {+-}8{micro}m.
Abstract not provided.
Plasma parameters and dynamics in capacitively coupled oxygen plasmas are investigated for different surface conditions. Metastable species concentration, electronegativity, spatial distribution of particle densities as well as the ionization dynamics are significantly influenced by the surface loss probability of metastable singlet delta oxygen (SDO). Simulated surface conditions are compared to experiments in the plasma-surface interface region using phase resolved optical emission spectroscopy. It is demonstrated how in-situ measurements of excitation features can be used to determine SDO surface loss probabilities for different surface materials.
This paper is concerned with the problem of computing real parameter margins for stabilized, structural dynamic systems with the masses, spring constants, and damping constants as uncertain parameters. Numerical algorithms for uncertain systems with multilinear parameters are investigated. It is shown that for a certain class of structural dynamic systems with small passive damping (e.g., flexible structures in space), the computational complexity of the problem can be avoided by modeling the system as a conservative plant, without loss of any practical significance.
Generalized nonlinear response theory is presented for stochastic dynamical systems. Experiments in which multiple measurements of dynamical quantities are used along with multiple perturbations of parameters of dynamical systems are described by generalized response functions (GRFs). These constitute a new type of multidimensional measures of stochastic dynamics either in the time or the frequency domains. Closed expressions for GRFs in stochastic dynamical systems are derived and compared with numerical non-equilibrium simulations. Several types of perturbations are considered: impulsive and periodic perturbations of temperature and impulsive perturbations of coordinates. The present approach can be used to study various types of stochastic processes ranging from single-molecule conformational dynamics to chemical kinetics of finite-size reactors such as biocells.
For applying linear parameter varying (LPV) control synthesis and analysis to a nonlinear system, it is required that a nonlinear system be represented in the form of an LPV model. In this paper, a new representation method is developed to construct an LPV model from a nonlinear mathematical model without the restriction that an operating point must be in the neighborhood of equilibrium points. An LPV model constructed by the new method preserves local stabilities of the original nonlinear system at "frozen" scheduling parameters and also represents the original nonlinear dynamics of a system over a non-trim region. An LPV model of the motion of FASER (Free-flying Aircraft for Subscale Experimental Research) is constructed by the new method.
Here we present a theoretical framework for the dynamic calibration of the higher eigenmode parameters (stiffness and optical lever inverse responsivity) of a cantilever. The method is based on the tip–surface force reconstruction technique and does not require any prior knowledge of the eigenmode shape or the particular form of the tip–surface interaction. The calibration method proposed requires a single-point force measurement by using a multimodal drive and its accuracy is independent of the unknown physical amplitude of a higher eigenmode.
ABSTRACT In this paper, we use all available baryon acoustic oscillation, Hubble parameter, and quasar angular size data to constrain six dark energy cosmological models, both spatially flat and non-flat. Depending on the model and data combination considered, these data mildly favour closed spatial hypersurfaces (by as much as 1.7σ) and dark energy dynamics (up to a little over 2σ) over a cosmological constant Λ. The data also favour, at 1.8σ to 3.4σ, depending on the model and data combination, a lower Hubble constant than what is measured from the local expansion rate.
This paper is focused on the development and validation of a dynamic model for an MEA-based CO 2 capture unit. Starting with a rigorous steady-state process model, the dynamic model is developed in Aspen Plus Dynamics ® using a modified Murphree-efficiency approach and is validated using dynamic data collected from the National Carbon Capture Center (NCCC) in Wilsonville, Alabama. The dynamic test runs were designed with due consideration of process excitation and process nonlinearities constrained by the available time to conduct the test runs and implement the experimental designs in the plant control system. The experimental data include solvent composition and loading. Since the experimental data were found to violate mass and energy balances, filtering algorithms coupled with dynamic data reconciliation techniques were used. Without adjusting any model parameters, the dynamic model satisfactorily predicted dynamic response of CO 2 capture due to step changes in the solvent flowrate, flue gas flowrate, and steam flowrates. Transient studies show that the process gain and time constants can considerably change depending on the direction of the disturbance or manipulated variables, indicating process nonlinearities. Due to a storage tank between the absorber and stripper, the time constant of the full plant can be considerably longer than the time constants of the absorber or stripper individually. Furthermore, impact of the control system on the process efficiency while following an optimal CO 2 capture schedule was also studied.
A wind-tunnel test of a 1/10th-scale Atlas-Centaur I large payload fairing launch vehicle model was conducted in the NASA Langley Transonic Dynamics Tunnel. The wind tunnel model was an aeroelastically-scaled version of the flight vehicle and was capable of simulating either of the first two bending vibration modes of the full-scale vehicle by a partial mode technique. The primary purpose of the test was to gather data concerning buffet response which could be used to clear the vehicle for flight. Additionally, angle-of-attack studies were conducted and several payload fairing configurations were tested to assess the buffet response and dynamic stability of off-design flight conditions and geometric parameters. No dynamic instabilities were found for any of the configurations tested. The buffet response data for the nominal flight configuration indicate that the unsteady buffet loads represent 5 to 10 percent of the total design load; therefore, the buffet loads are not a large factor affecting the overall vehicle design. Payload fairing length-to-diameter ratio variations were found to have small effects on the buffet response of the model, except in the case of the smallest length-to-diameter models for the second bending mode simulation. The effects of angle of attack on buffet response were found to be small. The model was more sensitive to Mach number changes than to angle of attack. The buffet response results from this wind tunnel test were influenced by the tunnel facility vibration levels. An attempt was made to experimentally reduce the effect of the facility mechanical vibration for the nominal flight configuration by testing with vertical rods used to stiffen the sting support. The first flight of the Atlas-Centaur I vehicle successfully occurred on July 25, 1990, and a comparison of flight measurements with wind tunnel data is presented. The flight data was found to be well within the 3 sigma level of the wind tunnel data.
Multi-Effect-Desalination (MED) may be exposed to fluctuations (disturbances) in input parameters during operation. Therefore, there is a requirement to analyze the transient behavior of such MED systems. In this work, a dynamic model is developed and used to examine the effect of abrupt and ramp changes in the main operational parameters on the plant behavior and performance. The results show that the disturbance intensity variation has a major role in the desalination plant behavior. For the current MED-TVC configuration, it is recommended to limit the reduction in the seawater cooling flow rate to under 12% of the designed steady-state value to avoid dry out in the evaporators. Here, a reduction in the motive steam flow rate and cooling seawater temperature of more than 20% and 35% of the nominal operating values, respectively, may lead to flooding in the evaporators and a complete plant shutdown. On the other hand, the disturbance period has a minimal effect on plant performance if it avoids the critical values of the disturbance intensity that can cause plant shutdown. Simultaneous combinations of two different disturbances with opposing effects result in a modest effect on the plant operation and they can be used to control and mitigate the flooding/drying effects of the disturbances. For simultaneous combinations of disturbances with similar effect, the plant needs an accurate control system to avoid an operational shutdown.
An assumption of smooth response to small parameter changes, of statistics or long-time averages of a chaotic system, is generally made in the field of sensitivity analysis, and the parametric derivatives of statistical quantities are critically used in science and engineering. In this paper, we propose a numerical procedure to assess the differentiability of statistics with respect to parameters in chaotic systems. Here, we numerically show that the existence of the derivative depends on the Lebesgue integrability of a certain density gradient function, which we define as the derivative of logarithmic SRB density along the unstable manifold. We develop a recursive formula for the density gradient that can be efficiently computed along trajectories, and demonstrate its use in determining the differentiability of statistics. Our numerical procedure is illustrated on low-dimensional chaotic systems whose statistics exhibit both smooth and rough regions in parameter space.
This paper considers control systems with a finite number of control parameters, i.e. dynamical polysystems. It is assumed that control switchings can occur only at certain discrete times. Statistical methods in number theory are used to investigate the controllability of these systems. Existence of control switching times is established through analysis of Diophantine equations. The values of control switching times are found through suitable numerical methods. Certain assertions on the controllability of the polysystems of the class under consideration are proved. Some examples are considered.
We apply the dynamical systems tools to study the asymptotic properties of a cosmological model based on a non-linear modification of General Relativity in which the standard Einstein-Hilbert action is replaced by one of Dirac-Born-Infeld type. It is shown that the dynamics of this model is extremely rich: there are found equilibrium points in the phase space that can be associated with matter-dominated, matter-curvature scaling, de Sitter, and even phantom-like solutions. Depending on the value of the overall parameters the dynamics in phase space can show multi-attractor structure into the future (multiple future attractors may co-exist). This is a consequence of bifurcations in control parameter space, showing strong dependence of the model's dynamical properties on the free parameters. Contrary to what is expected from non-linear modifications of general relativity of this kind, removal of the initial spacetime singularity is not a generic feature of the corresponding cosmological model. Instead, the starting point of the cosmic dynamics — the past attractor in the phase space — is a state of infinitely large value of the Hubble rate squared, usually associated with the big bang singularity.
A pulsed spallation target is subjected to very short (∼0.7μs) but intense loads (23.3 kJ) from repeated proton pulses, which knock away neutrons from the mercury atoms’ nuclei for a wide range application in physics, engineering, medicine, petroleum exploration, biology, chemistry, etc. The effect of this pulsed loading on the stainless-steel target module which contains the flowing mercury target material is difficult to predict not only due to its short but intense explosive-like physical reaction, but also the nonlinear material behavior of the liquid mercury in the structure. Injecting small helium bubbles in the mercury has been an efficient method of mitigating the pressure wave at high power level stage. However, prediction of the resultant loading on the target is more difficult when helium gas is intentionally injected into the mercury. A 2-phase material model that incorporates the Rayleigh-Plesset (R-P) model is expected to address this complex multi-physics dynamics problem by including the bubble dynamics in the liquid mercury. A parameter sensitivity study was firstly employed to understand their impact on the simulation strains. The investigated parameters included E, μ, γ, σ, n, VFgas, and gas cumulative volume curve control parameters a and b. Verification and validation results from sparse polynomial expansions (SPE) method and directional Gaussian smoothing (DGS) optimization show that the surrogate model had training error of ∼7% and validation error of ∼15%, indicating that machine learning methods and surrogate models can help optimize the uncertain parameters in the complex 2-phase material model. This approach is expected to fill the knowledge gap between unknown liquid-gas mixture material model and measured vessel strain responses.