SEARCH · Search NASA

Results for “RECEIVER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20

All sources NASA NTRS DOE OSTI

NASA NTRS1985

Optical Quantum Receiver For Binary Signals

In quantum optical receiver, both amplitude and phase of received optical signal measured to extract as much information as possible, thereby reducing error probability. Phase-modulated received signal mixed with equal amplitude replica of optical carrier generated in phase locked loop. Two signals interfere with each other at photomultiplier cathode. Probability of error with this scheme close to theoretical minimum and implemented with current technology.

Vilnrotter, V. A.↗

NASA NTRS1983

The 30 GHz communications satellite low noise receiver

A Ka-band low noise front end in proof of concept (POC) model form for ultimate spaceborne communications receiver deployment was developed. The low noise receiver consists of a 27.5 to 30.0 GHz image enhanced mixer integrated with a 3.7 to 6.2 GHz FET low noise IF amplifier and driven by a self contained 23.8 GHz phase locked local oscillator source. The measured level of receiver performance over the 27.3 to 30.0 GHz RF/3.7 to 6.2 GHz IF band includes 5.5 to 6.5 dB (typ) SSB noise figure, 20.5 + or - 1.5 dB conversion gain and +23 dBm minimum third order two tone intermodulation output intercept point.

Steffek, L. J.↗

NASA NTRS1984

Test results for 27.5- to 30-GHz communications satellite receivers

Five proof of concept receivers are tested. The receivers operate in the 27.5 to 30 GHz uplink band for communications satellites and produce an output at C band. Receiver requirements and test results are given. Test methods are discussed and results are compared with the contractor's test results.

Conroy, M. J.↗

NASA NTRS1984

Autonomous Integrated Receive System (AIRS) requirements definition. Volume 2: Design and development

Functional requirements and specifications are defined for an autonomous integrated receive system (AIRS) to be used as an improvement in the current tracking and data relay satellite system (TDRSS), and as a receiving system in the future tracking and data acquisition system (TDAS). The AIRS provides improved acquisition, tracking, bit error rate (BER), RFI mitigation techniques, and data operations performance compared to the current TDRSS ground segment receive system. A computer model of the AIRS is used to provide simulation results predicting the performance of AIRS. Cost and technology assessments are included.

Chie, C. M.↗

NASA NTRS1985

TDRSS S-shuttle unique receiver equipment

Beginning with STS-9, the Tracking and Date Relay Satellite system (TDRSS) will start providing S- and Ku-band communications and tracking support to the Space Shuttle and its payloads. The most significant element of this support takes place at the TDRSS White Sands Ground Terminal, which processes the Shuttle return link S- and Ku-band signals. While Ku-band hardware available to other TDRSS users is also applied to Ku-Shuttle, stringent S-Shuttle link margins have precluded the application of the standard TDRSS S-band processing equipment to S-Shuttle. It was therfore found necessary to develop a unique S-Shuttle Receiver that embodies state-of-the-art digital technology and processing techniques. This receiver, developed by Motorola, Inc., enhances link margins by 1.5 dB relative to the standard S-band equipment and its bit error rate performance is within a few tenths of a dB of theory. An overview description of the Space Shuttle Receiver Equipment (SSRE) is presented which includes the presentation of block diagrams and salient design features. Selected, measured performance results are also presented.

Weinberg, A.↗

NASA NTRS1986

High dynamic global positioning system receiver

A Global Positioning System (GPS) receiver having a number of channels, receives an aggregate of pseudorange code time division modulated signals. The aggregate is converted to baseband and then to digital form for separate processing in the separate channels. A fast fourier transform processor computes the signal energy as a function of Doppler frequency for each correlation lag, and a range and frequency estimator computes estimates of pseudorange, and frequency. Raw estimates from all channels are used to estimate receiver position, velocity, clock offset and clock rate offset in a conventional navigation and control unit, and based on the unit that computes smoothed estimates for the next measurement interval.

Hurd, W. J.↗

NASA NTRS1985

A heterodyne receiver for the submillimeter wavelength region based on cyclotron resonance in InSb at low temperatures

A heterodyne receiver has been developed for observation of interstellar atomic and molecular lines in the submillimeter wavelength region. The main detection mechanism of the device is cyclotron resonance in bulk n-InSb due to a quantized magnetic field. Measurements were carried out between 492 and 812 GHz in order to determine the sensitivity of the device for astrophysical applications. Double sideband receiver noise temperatures of 250 K at 492 GHz; 350 K at 625 GHz; and 510 K at 812 GHz were obtained. The magnetic induction for the laboratory tests was about 2.5 KG and the mixer operating temperature was about 1.6 K. It is shown that the receiver is sensitive enough to identify the narrow rotation lines of diatomic hydrides in dark-cloud regions of the interstellar medium.

Brown, E. R.↗

NASA NTRS1987

DSN advanced receiver: Breadboard description and test results

A breadboard Advanced Receiver for use in the Deep Space Network was designed, built, and tested in the laboratory. Field testing was also performed during Voyager Uranus encounter at DSS-13. The development of the breadboard is intended to lead towards implementation of the new receiver throughout the network. The receiver is described on a functional level and then in terms of more specific hardware and software architecture. The results of performance tests in the laboratory and in the field are given. Finally, there is a discussion of suggested improvements for the next phase of development.

Brown, D. H.↗

NASA NTRS1988

Advanced Receiver tracking of Voyager 2 near solar conjunction

The Advanced Receiver (ARX) was used to track the Voyager 2 spacecraft at low Sun-Earth-Probe (SEP) angles near solar conjunction in December of 1987. The received carrier signal exhibited strong fluctuations in both phase and amplitude. The ARX used spectral estimation and mathematical modeling of the phase and receiver noise processes to set an optimum carrier tracking bandwidth. This minimized the mean square phase error in tracking carrier phase and thus minimized the loss in the telemetry signal-to-noise ratio due to the carrier loop. Recovered symbol SNRs and errors in decoded engineering data for the ARX are compared with those for the current Block 3 telemetry stream. Optimum bandwidths are plotted against SEP angle. Measurements of the power spectral density of the solar phase and amplitude fluctuations are also given.

Brown, D. H.↗

NASA NTRS1987

High dynamic GPS receiver using maximum likelihood estimation and frequency tracking

A new high dynamic global positioning system (GPS) receiver is presented and its performance characterized by analysis, simulation, and demonstration. The demonstration receiver is a breadboard model capable of tracking a single simulated satellite signal in pseudorange and range rate. Pseudorange and range rate estimates are made once every 20 ms, using a maximum likelihood estimator, and are tracked by means of a third-order fading memory filter in a feedback configuration. The receiver tracks pseudorange with rms errors of under 1 m when subjected to simulated 50 g, 40 g/s circular trajectories. The tracking threshold is approximately 28 dB-Hz, which provides 12 dB margin relative to the minimum specified signal strength, assuming 3.5 dB system noise figure and 0 dBi antenna gain.

Hurd, W. J.↗

NASA NTRS1987

30-micron heterodyne receiver

Advantages and constraints of remote measurements using heterodyne spectroscopy near 30 microns are discussed. The state of the art of wideband HgCdTe photomixers and PbSnSe diode-laser local oscillators being developed for FIR heterodyne receivers is described. The first compact 30-micron heterodyne radiometer was built, and initial results at 28-microns show about 2-percent mixer efficiency for a 500-MHz-bandwidth receiver. Factors limiting receiver performance are discussed, along with the projected sensitivity of new interdigitated-electrode HgCdTe photoconductor mixers being developed for operation up to 200 microns.

Kostiuk, Theodor↗

NASA NTRS1988

Solar dynamic heat receiver thermal characteristics in low earth orbit

A simplified system model is under development for evaluating the thermal characteristics and thermal performance of a solar dynamic spacecraft energy system's heat receiver. Results based on baseline orbit, power system configuration, and operational conditions, are generated for three basic receiver concepts and three concentrator surface slope errors. Receiver thermal characteristics and thermal behavior in LEO conditions are presented. The configuration in which heat is directly transferred to the working fluid is noted to generate the best system and thermal characteristics. as well as the lowest performance degradation with increasing slope error.

Wu, Y. C.↗

NASA NTRS1988

A dual-frequency 183/380 GHz receiver for airborne applications

A complete dual-frequency cryogenic heterodyne receiver operating at 183 and 380 GHz is described. The cooled mixers are whisker-contacted GaAs Schottky diodes mounted in reduced-height fundamental-mode waveguide. The local oscillators are Gunn-oscillator-driven multipliers using GaAs varactor diodes as the harmonic generators. Quasi-optical techniques are used extensively for coupling the remote and local oscillator signals into the mixers. The overall system double side-band (DSB) noise temperature is 320 K for the 183-GHz receiver and 650 K for the 380 GHz receiver.

Batelaan, Paul D.↗

NASA NTRS1988

Development of an integrated heat pipe-thermal storage system for a solar receiver

An integrated heat pipe-thermal storage system was developed as part of the Organic Rankine Cycle Solar Dynamic Power System solar receiver for space station application. The solar receiver incorporates potassium heat pipe elements to absorb and transfer the solar energy within the receiver cavity. The heat pipes contain thermal energy storage (TES) canisters within the vapor space with a toluene heater tube used as the condenser region of the heat pipe. During the insolation period of the earth orbit, solar energy is delivered to the heat pipe. Part of this thermal energy is delivered to the heater tube and the balance is stored in the TES units. During the eclipse period of earth orbit, the stored energy in the TES units is transferred by the potassium vapor to the toluene heater tube. A developmental heat pipe element was constructed that contains axial arteries and a distribution wick connecting the toluene heater and the TES units to the solar insolation surface of the heat pipe. Tests were conducted to demonstrate the heat pipe, TES units, and the heater tube operation. The heat pipe element was operated at design input power of 4.8 kW. Thermal cycle tests were conducted to demonstrate the successful charge and discharge of the TES units. Axial power flux levels up to 15 watts/sq cm were demonstrated and transient tests were conducted on the heat pipe element. Details of the heat pipe development and test procedures are presented.

Keddy, E.↗

NASA NTRS1989

Automatic Frequency Control For DMSK Receiver

Report discusses performance of automatic frequency-control (AFC) subsystem of differential minimum-shift-keying receiver described in "DMSK Receiver for Moblile/Satellite Service," NPO-16659. Describes efforts to quantify behavior of system during acquisition of carrier signal; including theoretical analysis leading to numerical simulation, and measurements of performance of receiving equipment.

Davarian, Faramaz↗

NASA NTRS1989

Optical Receivers With Rough Reflectors

Receiver for optical communications uses rough reflector instead of diffraction-limited reflector customarily thought necessary for such systems. Rough reflector collects and focuses optical signal. Other receiver components include narrow-passband optical filter to reject out-of-band background radiation, spatial filter to limit receiver field of view, optical-detector array (typically two concentric detectors), and postdetection processor to reconstruct transmitted message.

Vilnrotter, Victor A.↗

NASA NTRS1988

Submillimeter heterodyne receiver for the CSO telescope

This task is to build a cryogenically cooled 620 to 700 GHz astronomical receiver that will be used as a facility instrument at the CalTech Submillimeter Observatory (CSO) on Mauna Kea, Hawaii. The receiver will have applications as a very high resolution spectrometer to investigate spectral lines in planetary and satellite atmospheres, and comets. The receiver will also be used to make continuum measurements of planets, satellites, and asteroids. During FY88, a scale model (200 GHz) SIS mixer radiometer was built and intrgrated into a cryostat designed for use on the CSO telescope. This system will serve as a model to guide the work on the higher frequency mixer. A solid state local oscillator source that covers two bands in the 600 to 700 GHz has been developed under contract JPL and will be delivered before the end of the year. Work has continued on the SIS materials needed for the 620 to 700 GHz mixer. Test hardware has been developed which allow the 1 to 5 curves for SIS material to be easily measured.

Gulkis, S.↗

NASA NTRS1988

Design and predicted performance of the GPS demonstration receiver for the NASA Topex satellite

NASA's Ocean Topography Experiment (Topex) satellite will perform topographic ocean mapping. Topex will carry an experimental tracking system based on the use of GPS (Global Positioning System). An onboard GPS Demonstration Receiver (GPSDR) will be used with a network of up to ten receivers at precisely known ground sites. Following a brief overview of the Topex mission and its derived accuracy requirements, the authors describe the design of the GPSDR. The major hardware and software components are reviewed and discussed. Projected receiver tracking and navigation performance measures are presented and discussed.

Carson, Lance↗