Search NASA⌕ Search

SEARCH · Search NASA

Results for “flight simulation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Real time flight simulation methodology

An example sensitivity study is presented to demonstrate how a digital autopilot designer could make a decision on minimum sampling rate for computer specification. It consists of comparing the simulated step response of an existing analog autopilot and its associated aircraft dynamics to the digital version operating at various sampling frequencies and specifying a sampling frequency that results in an acceptable change in relative stability. In general, the zero order hold introduces phase lag which will increase overshoot and settling time. It should be noted that this solution is for substituting a digital autopilot for a continuous autopilot. A complete redesign could result in results which more closely resemble the continuous results or which conform better to original design goals.

Parrish, E. A.↗
NASA NTRS1976

Flight simulation study to determine MLS lateral course width requirements on final approach for general aviation

An investigation of the effects of various lateral course widths and runway lengths for manual CAT I Microwave Landing System instrument approaches was carried out with instrument rated pilots in a General Aviation simulator. Data are presented on the lateral dispersion at the touchdown zone, and the middle and outer markers, for approaches to 3,000, 8,000 (and trial 12,000 foot) runway lengths with full scale angular lateral course widths of + or - 1.19 deg, + or - 2.35 deg, and + or - 3.63 deg. The distance from touchdown where the localizer deviation went to full scale was also recorded. Pilot acceptance was measured according to the Cooper-Harper rating system.

Crumrine, R. J.↗
NASA NTRS1977

Real time flight simulation methodology

Substitutional methods for digitization, input signal-dependent integrator approximations, and digital autopilot design were developed. The software framework of a simulator design package is described. Included are subroutines for iterative designs of simulation models and a rudimentary graphics package.

Parrish, E. A.↗
NASA NTRS1977

Research on integration of visual and motion cues for flight simulation and ride quality investigation

Vestibular perception and integration of several sensory inputs in simulation were studied. The relationship between tilt sensation induced by moving fields and those produced by actual body tilt is discussed. Linearvection studies were included and the application of the vestibular model for perception of orientation based on motion cues is presented. Other areas of examination includes visual cues in approach to landing, and a comparison of linear and nonlinear wash out filters using a model of the human vestibular system is given.

Young, L. R.↗
NASA NTRS1977

An experimental study of transmission, reflection and scattering of sound in a free-jet flight simulation facility and comparison with theory

Acoustic time delays across a free-jet shear layer are measured and compared with predictions based on (1) ray paths refracted abruptly across a cylindrical vortex sheet and (2) ray paths traced through a more realistic diverging flow model. The close agreement between measurement and theory confirms that Snell's law provides an accurate prediction of wavefront refraction or angle changes across a diverging shear layer. Microphones are placed on calculated ray paths to determine the coherent transmission and internal reflection characteristics of the shear layer and also the scattering of sound by the shear-layer turbulence. The transmission data essentially verify the proposed, theoretical calibration factor which forms part of a computational procedure that is being developed to convert model jet data from a free-jet facility to inflight conditions.

Ahuja, K. K.↗
NASA NTRS1977

Effectiveness of an inlet flow turbulence control device to simulate flight noise fan in an anechoic chamber

A hemispherical inlet flow control device was tested on a 50.8 cm. (20-inch) diameter fan stage in the NASA-Lewis anechoic chamber. The control device used honeycomb and wire mesh to reduce turbulence intensities entering the fan. Far field acoustic power level results show about a 5 db reduction in blade passing tone and about 10 dB reduction in multiple pure tone sound power at 90% design fan speed with the inlet device in place. Hot film cross probes were inserted in the inlet to obtain data for two components of the turbulence at 65 and 90% design fan speed. Without the flow control device, the axial intensities were below 1.0%, while the circumferential intensities were almost twice this value. The inflow control device significantly reduced the circumferential turbulence intensities and also reduced the axial length scale.

Woodward, R. P.↗
NASA NTRS1978

Expansion of flight simulator capability for study and solution of aircraft directional control problems on runways, appendixes

The models used to implement the DC-9-10 aircraft simulation for the Runway Direction Control study are presented. The study was done on the Douglas Aircraft six-degree-of-freedom motion simulator. Documentation of the models was in algebraic form, to the extent possible. Effort was directed toward presenting what was actually done rather than general forms.

Mcgowan, J. A.↗
NASA NTRS1977

Wind models for flight simulator certification of landing and approach guidance and control systems

The definition of a model suitable for certification was the main objective of this report. The model was designed to simplify and reduce the wind model parameters to enable evaluation of a large number of aircraft and control system design parameters. Analytical descriptions of wind phenomena were presented. For those parameters defying analytic description, probabilistic descriptions were sought. A brief analysis of the effects of wind on aircraft motion was conducted. The axes transformations required between wind and turbulence components in their inherent axis system and in the airplane's axis system were shown. Techniques of providing a random process on computers for the representation of turbulence were presented. A simulation model was presented that combines all the foregoing components.

Schaeffer, D. R.↗
NASA NTRS1978

Ground-based and in-flight simulator studies of low-speed handling characteristics of two supersonic cruise transport concepts

Conventional and powered lift concepts for supersonic approach and landing tasks are considered. Results indicated that the transport concepts had unacceptable low-speed handling qualities with no augmentation, and that in order to achieve satisfactory handling qualities, considerable augmentation was required. The available roll-control power was acceptable for the powered-lift concept.

Grantham, W. D.↗
NASA NTRS1977

Effectiveness of an inlet flow turbulence control device to simulate flight fan noise in an anechoic chamber

A hemispherical inlet flow control device was tested on a 50.8 cm. (20-inch) diameter fan stage in the NASA-Lewis Anechoic Chamber. The control device used honeycomb and wire mesh to reduce turbulence intensities entering the fan. Far field acoustic power level results showed about a 5 dB reduction in blade passing tone and about 10 dB reduction in multiple pure tone sound power at 90% design fan speed with the inlet device in place. Hot film cross probes were inserted in the inlet to obtain data for two components of the turbulence at 65 and 90% design fan speed. Without the flow control device the axial intensities were below 1.0%, while the circumferential intensities were almost twice this value. The inflow control device significantly reduced the circumferential turbulence intensities and also reduced the axial length scale.

Woodward, R. P.↗
NASA NTRS1979

Experiments in sensing transient rotational acceleration cues on a flight simulator

Results are presented for two transient motion sensing experiments which were motivated by the identification of an anomalous roll cue (a 'jerk' attributed to an acceleration spike) in a prior investigation of realistic fighter motion simulation. The experimental results suggest the consideration of several issues for motion washout and challenge current sensory system modeling efforts. Although no sensory modeling effort is made it is argued that such models must incorporate the ability to handle transient inputs of short duration (some of which are less than the accepted latency times for sensing), and must represent separate channels for rotational acceleration and velocity sensing.

Parrish, R. V.↗
NASA NTRS1980

Changes in erythropoietin levels during space flight or space flight simulation

Two hundred and seventy samples from 24 subjects involved in 3 bedrest studies and from 3 subjects involved in Spacelab Mission Development Test 3 were assayed for erythropoietin (Ep), in an in vitro fetal mouse liver cell assay, and for ferritin using a commercially available immunoradiometric assay kit. No trends or significant changes in serum Ep were observed. Serum ferritin concentrations tended to increases slightly during the 'missions', reflecting a redirection of iron from the suppressed erythron into iron stores.

Dunn, C. D. R.↗
NASA NTRS1980

Time delays in flight simulator visual displays

It is pointed out that the effects of delays of less than 100 msec in visual displays on pilot dynamic response and system performance are of particular interest at this time because improvements in the latest computer-generated imagery (CGI) systems are expected to reduce CGI displays delays to this range. Attention is given to data which quantify the effects of display delays in the range of 0-100 msec on system stability and performance, and pilot dynamic response for a particular choice of aircraft dynamics, display, controller, and task. The conventional control system design methods are reviewed, the pilot response data presented, and data for long delays, all suggest lead filter compensation of display delay. Pilot-aircraft system crossover frequency information guides compensation filter specification.

Crane, D. F.↗
NASA NTRS1983

Compensation for time delay in flight simulator visual-display systems

A piloted aircraft can be viewed as a closed-loop, man-machine control system. When a simulator pilot is performing a precision maneuver, a delay in the visual display of aircraft response to pilot-control input decreases the stability of the pilot-aircraft system. The less stable system is more difficult to control precisely. Pilot dynamic response and performance change as the pilot attempts to compensate for the decrease in system stability, and these changes bias the simulation results by influencing the pilot's rating of the handling qualities of the simulated aircraft. Delay compensation, designed to restore pilot-aircraft system stability, was evaluated in several studies which are reported here. The studies range from single-axis, tracking-task experiments (with sufficient subjects and trials to establish statistical significance of the results) to a brief evaluation of compensation of a computer-generated-imagery (CGI) visual display system in a full six-degree-of-freedom simulation. The compensation was effective - improvements in pilot performance and workload or aircraft handling-qualities rating (HQR) were observed. Results from recent aircraft handling-qualities research literature which support the compensation design approach are also reviewed.

Crane, D. F.↗
NASA NTRS1984

A spatial model of wind shear and turbulence for flight simulation

A three dimensional model which combines measurements of wind shear in the real atmosphere with three dimensional Monte Carlo simulated turbulence was developed. The wind field over the body of an aircraft can be simulated and all aerodynamic loads and moments calculated.

Campbell, C. W.↗
NASA NTRS1984

An investigation of the existence of a surface water layer on aircraft radomes during simulated flight in heavy precipitation

An experiment to investigate the electromagnetic attenuation effects of an impacting water spray on an aircraft weather radome was conducted in Langley's 4 X 7 m. wind tunnel equipped with a water spray system. Results indicate no significant liquid water film formed at the stagnation point of the radome under the test conditions. However, a water sheath was observed standing away from the radome surface, which could possibly have significant attenuation properties of its own. Due to the lack of fidelity in modeling both the natural environment with the tunnel apparatus and the water sheath, it is recommended that further studies be undertaken to better define the water distribution in the vicinity of the radome and measure its effect on weather radar performance.

Branstetter, J. R.↗