Search NASA⌕ Search

SEARCH · Search NASA

Results for “output”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

An adaptive observer for single-input single-output linear systems.

A full order adaptive observer is described for observing the state of a single-input single-output observable continuous differential system with unknown parameters. Convergence of the observer states to those of the system is accomplished by directly changing the parameters of the observer using an adaptive law based upon Lyapunov stability theory. Observer eigenvalues may be freely chosen. Some restriction is placed upon the system input in that it must be sufficiently rich in frequencies in order to insure convergence.

Carroll, R. L.↗
NASA NTRS1973

Measurement and analysis of force-time outputs of pyrotechnic nuts

The dynamic loadings produced by two standard pyrotechnic nuts were compared with loadings produced by four recently developed low-shock nuts. The nuts were manufactured by separate contractors. Each nut was given a number designation, the number having no special significance. The results show that the use of the Hopkinson bar to measure force-time outputs of the nuts at stud and housing sides aided greatly in understanding the events occurring in the nuts. Acceleration data appear to be dependable, for the most part, but of more limited value. The low-shock designs show considerable improvement over the standard designs above 4,000 Hz when the results are plotted in shock spectrum form. They involve some penalties with regard to weight and cost.

Neubert, V. H.↗
NASA NTRS1974

Uncertainties in predicting solar panel power output

The problem of calculating solar panel power output at launch and during a space mission is considered. The major sources of uncertainty and error in predicting the post launch electrical performance of the panel are considered. A general discussion of error analysis is given. Examples of uncertainty calculations are included. A general method of calculating the effect on the panel of various degrading environments is presented, with references supplied for specific methods. A technique for sizing a solar panel for a required mission power profile is developed.

Anspaugh, B.↗
NASA NTRS1973

Pole-placement with constant gain output feedback

Davison (1970) has demonstrated that it is possible to assign max (m, p) poles of a linear time-invariant controllable and observable multivariable system arbitrarily close to desired locations by using constant gain output feedback. A new proof of Davison's theorem on pole placement is developed, and a system design procedure is described which offers some advantages over Davison's method. It is shown that in some cases more than max (m, p) poles can be assigned arbitrarily, and a least square design procedure is proposed to approximate the desired pole locations when it is not possible to place all the poles.

Sridhar, B.↗
NASA NTRS1973

Three-dimensional evaluation of energy extraction in output cavities of klystron amplifiers

Description of an accurate three-dimensional mathematical model and computer program for calculating electronic interaction, electron trajectories, beam interception, and efficiency in the output cavity of a klystron amplifier. The highest computed efficiency for an optimally bunched beam was 80.3% with 6% ideal interception. Efficiency is shown to increase initially with interception.

Kosmahl, H. G.↗
NASA NTRS1974

Optimal filter design subject to output sidelobe constraints - Theoretical considerations

The design of filters for detection and estimation in radar and communications systems is considered, with inequality constraints on the maximum output sidelobe levels. A constrained optimization problem in Hilbert space is formulated, incorporating the sidelobe constraints via a partial ordering of continuous functions. Generalized versions (in Hilbert space) of the Kuhn-Tucker and duality theorems allow the reduction of this problem to an unconstrained one in the dual space of regular Borel measures.

Fortmann, T. E.↗
NASA NTRS1975

Transmitter switch for high-power microwave output

Combiner system can be used for combining output powers of two transmitters or for switching from one to the other. This can be done when pair of transmitters operate on same frequency and carriers are phase coherent as by excitation from single exciter.

Wiggins, C. P.↗
NASA NTRS1974

Investigation of rank 2 and higher output feedback for pole placement

A common feature of several pole placement techniques is discussed and the use of a dyadic feedback matrix is presented. The limitation of this design is examined and a design involving output feedback matrices of Rank greater than one is developed as a logical extension of the dyadic feedback design. An example is presented to illustrate the design procedure.

Sridhar, B.↗
NASA NTRS1974

Output orientation in R and D: A better approach?

Research and development management is examined as it might be performed under an output-oriented approach in which the company's needs for innovations in various product and production areas were identified. It is shown that a company's R and D program is the aggregate of its needs in various areas of its business. The planning, programming and budgeting approach is applied to R and D. The state of theory on R and D decision making in economics is summarized. Abstracts of articles concerning R and D in industry are included.

Black, G.↗
NASA NTRS1974

Continuous-output terminal-shock-position sensor for mixed-compression inlets evaluated in wind tunnel tests of YF-12 aircraft inlet

An electronic sensor was built to measure the position of the terminal shock in a supersonic inlet. The sensor uses several static-pressure taps in the inlet wall. The sensor output is continuously proportional to shock position. When the sensor was installed in a YF-12 aircraft flight inlet during wind tunnel tests, it indicated shock position within + or - 5 percent of the total distance covered by the static-pressure-tap region. The maximum error caused by an angle of attack change of 4 deg was less than 25 percent. In the region of normal inlet operation, the angle of attack error is negligible. Frequency-response tests show the amplitude ratio is constant out to 60 Hz, and decreases to about 50 percent at 100 Hz, with a phase lag of 50 deg.

Dustin, M. O.↗
NASA NTRS1975

Scanning NASTRAN output data for maximum and minimum values

A computer program called NASCAN (NASTRAN scan) is described. NASCAN enables users to scan lengthy NASTRAN output files for maximum and minimum values in easy user oriented categories. Areas of high stress or deflections in any of the NASTRAN rigid formats are quickly detected and listed out for project documentations. The NASTRAN model is then revised if necessary by updating an input file tape which is processed through the NASTRAN program.

Walker, D. C.↗
NASA NTRS1974

Linear system identification - The application of Lion's identification scheme to a third order system with noisy input-output measurements

A linear system identification technique developed by Lion is adapted for use on a third-order system with six unknown parameters and noisy input-output measurements. A digital computer is employed so that rapid identification takes place with only two state variable filters. Bias in the parameter estimates is partially eliminated by a signal-to-noise ratio testing procedure.

Brown, C. M., Jr.↗
NASA NTRS1975

Continuous cardiac output measurement - Aspects of Doppler frequency analysis

From the suprasternal notch blood flow velocity in the aorta can be measured non-invasively by a Doppler probe. Integration over systole after frequency analysis gives a measure of stroke volume if a separate diameter observation is incorporated. Frequency analysis by a zero crossing counter or by a set of parallel phaselock loops was less effective than a set of bandpass filters. Observations on dogs, baboons and humans before and after exercise or surgery suggest the indications to be useful. Application to judging heart failure by the effect of introducing a volume load is indicated. Changes in output also are measured in freely moving subjects.

Mackay, R. S.↗
NASA NTRS1975

Example of input-output analysis

The thirty sectors included in the ECASTAR energy input-output model were listed. Five of these belong to energy producing sectors, fifteen to manufacturing industries, two to residential and commercial sectors, and eight to service industries. The model is capable of tracing impacts of an action in three dimensions: dollars, BTU's of energy, and labor. Four conservation actions considered were listed and then discussed separately, dealing with the following areas: increase in fuel efficiency, reduction in fuel used by the transportation and warehousing group, manufacturing of smaller automobiles, and a communications/transportation trade-off.

Source record↗
NASA NTRS1975

Input-output analysis of some sector actions

Selected energy conservation actions previously discussed in depth but separately in the areas of the energy industry, the industry sector, the transportation sector, and the residential and commercial sector, were brought together and assessed as a group. Particular emphasis was devoted to identifying secondary or indirect impacts and multiple interactions. Preliminary results obtained from the ECASTAR energy input-output model suggest that the impacts of energy conservation actions can be grossly misrepresented if secondary impacts are not included in the assessment. A methodology which stresses the importance of secondary and multiple interactions permeates the underlying philosophy of this discussion.

Source record↗
NASA NTRS1976

Computer program for single input-output, single-loop feedback systems

Additional work is reported on a completely automatic computer program for the design of single input/output, single loop feedback systems with parameter uncertainly, to satisfy time domain bounds on the system response to step commands and disturbances. The inputs to the program are basically the specified time-domain response bounds, the form of the constrained plant transfer function and the ranges of the uncertain parameters of the plant. The program output consists of the transfer functions of the two free compensation networks, in the form of the coefficients of the numerator and denominator polynomials, and the data on the prescribed bounds and the extremes actually obtained for the system response to commands and disturbances.

Source record↗
NASA NTRS1976

Digital plus analog output encoder

The disclosed encoder is adapted to produce both digital and analog output signals corresponding to the angular position of a rotary shaft, or the position of any other movable member. The digital signals comprise a series of binary signals constituting a multidigit code word which defines the angular position of the shaft with a degree of resolution which depends upon the number of digits in the code word. The basic binary signals are produced by photocells actuated by a series of binary tracks on a code disc or member. The analog signals are in the form of a series of ramp signals which are related in length to the least significant bit of the digital code word. The analog signals are derived from sine and cosine tracks on the code disc.

Hafle, R. S.↗