Search NASA⌕ Search

SEARCH · Search NASA

Results for “SUNLIGHT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 379 records · Page 21

Preliminary results on tritium in Surveyor 3 material

Painted aluminum samples taken from Surveyor 3 were examined for possible tritium implanted by the solar wind. There was found to be a correlation of tritium content with exposure to sunlight. The amount of tritium in sample 1011,2 nearly perpendicular to the lunar surface exceeded the amount expected from the tritium content of lunar rock 12002 by at least a factor of 3. It is concluded that if there is tritium implanted by solar wind on lunar rocks, it is not retained by them.

Fireman, E. L.↗

Spacecraft orientation and exposure to environment, Appendix A

Material removed from the spacecraft and returned to earth remained on the lunar surface for 31.9 lunations. None of the returned parts received the maximum 10,686 hours of exposure because of shadowing by the planar array antenna, solar panel, thermal control compartments, or other parts of the spacecraft. To determine the actual exposure of specific parts to sunlight, six series of photographs were taken. A one-fifth-scale model spacecraft was oriented to a collimated light source simulating the orientation of Surveyor with the sun. Three cameras were set up to view different parts of the spacecraft. The data obtained from these photographs permitted an evaluation of the effects of exposure to solar radiation on the camera and its parts, the surface sampling scoop, and the strut from the radar altimeter and Doppler velocity sensor.

Nickle, N. L.↗

Apollo 15 contamination photography

The problem of optical contamination in the form of particulates in the vicinity of a spacecraft has been a source of concern for any astronomical experiment that must be performed in sunlight. This concern prompted a photographic photometric experiment on Apollo 15 to measure the brightness of the residual contamination cloud as well as the cloud produced by dumping waste water overboard. An upper limit of 10 to the minus 12.3 power B (B designates the brightness of the solar disc) was placed on the residual cloud at a 90 deg sun angle, which is comparable to the zodiacal light. The brightness of the cloud produced by the waste dump was estimated to be 10 to the minus 9.2 power B. It was observed to decrease rapidly to 10 to the -11.6 power B in minutes, then fluctuate in brightness for at least 25 minutes as additional material left the spacecraft. The cloud was observed to consist of individually resolved particle tracks estimated to be particles ranging from millimeters to centimeters in diameter in addition to a background of unresolved particles with an average diameter of 10.5 microns. Most of the tracks proceeded in straight-line paths from the dump nozzle. Several tracks violated this direction, apparently having been scattered by collisions. A few tracks appeared to have definite curvatures, which are believed to be caused by charged particle interactions.

Naumann, R. J.↗

High intensity portable fluorescent light

Eight high intensity portable fluorescent lights were produced. Three prototype lights were also produced, two of which were subsequently updated to the physical and operational configuration of the qualification and flight units. Positioning of lamp apertures and reflectors in these lights is such that the light is concentrated and intensified in a specific pattern rather than widely diffused. Indium amalgam control of mercury vapor pressure in the lamp gives high output at lamp ambient temperatures up to 105 C. A small amount of amalgam applied to each electrode stem helps to obtain fast warm-up. Shrinking a Teflon sleeve on the tube and potting metal caps on each end of the lamp minimizes dispersion of mercury vapor and glass particles in the event of accidental lamp breakage. Operation at 20 kHz allows the lamps to consume more power than at low frequency, thus increasing their light output and raising their efficiency. When used to expose color photographic film, light from the lamps produces results approximately equal to sunlight.

Kendall, F. B.↗

Effects of skylight polarization, cloudiness, and view angle on the detection of oil on water.

Three passive radiometric techniques, which use the contrast of sunlight reflected and backscattered from oil and water in specific wavelength regions, have potential application for remote sensing of oil spills. These techniques consist of measuring (1) total radiance, (2) the polarization components (normal and parallel) of radiance, and (3) the difference between the normal and parallel components. In this paper, the best view directions for these techniques are evaluated, conclusions are drawn as to the most promising technique, and explanations are developed to describe why previous total-radiance measurements yielded highest contrast between oil and water under overcast skies. The technique based on measurement of only the normal polorization component appears to be the most promising. The differential technique should be further investigated because of its potential to reduce the component of backscattered light from below the surface of the water. Measurements should be made about 45 deg nadir view angle in the direction opposite the sun. Overcast sky conditions provide a higher intensity of skylight relative to clear sky conditions and a lower intensity of backscatter within the water relative to surface reflectance. These factors result in higher contrast between oil and water under overcast skies.

Millard, J. P.↗

Airborne optical detection of oil on water.

Airborne measurements were made over controlled oil-spill test sites to evaluate various techniques, utilizing reflected sunlight, for detecting oil on water. The results of these measurements show that (1) maximum contrast between oil and water is in the UV and red portions of the spectrum; (2) minimum contrast is in the blue-green; (3) differential polarization appears to be a very promising technique; (4) no characteristic absorption bands, which would permit one oil to be distinguished from another, were discovered in the spectral regions measured; (5) sky conditions greatly influence the contrast between oil and water; and (6) highest contrast was achieved under overcast sky conditions.

Millard, J. P.↗

Spacecraft charging at synchronous orbit.

Observation that ATS 5 can charge to potentials as high as 10,000 volts during eclipse, and as high as 200 volts in sunlight. This charging has been used to infer the presence of the plasmasphere at synchronous altitude in the midnight region, and its prompt disappearance when hot plasma is injected in association with substorms. Although injected plasma has a density of 1.0 per cu cm the remaining cold plasma (less than 50 eV) has a density of 0.01 per cu cm. A mathematical model of ATS 5 has been constructed that can be used to predict spacecraft potentials. In addition, parts of ATS 5 can charge to several hundred volts without affecting the overall spacecraft potential appreciably.

Deforest, S. E.↗

Observing Venus near the sun.

Discussion of the special requirements posed by telescopic observing near the sun. The sky brightness in the image plane must be kept to a minimum. Sunlight scattered from dust in the atmosphere or on the optical surfaces is the main difficulty, particularly at red and infrared wavelengths where Rayleigh scattering by air molecules is weak. Atmospheric dust is less troublesome at high altitudes and in dry climates than at low, humid sites. Excellent seeing is required, especially to get the thin crescent of Venus at inferior conjunction into the narrow slit of a spectrograph. The spectroscopic phase effect of Venus is discussed, and the procedures used to carry out observations near the sun are described in detail.

Young, A. T.↗

The Lyman-alpha image of comet Tago-Sato-Kosaka /1969g/.

An f/2 objective-grating spectrograph aboard an Aerobee rocket recorded a faint image of Comet Tago-Sato-Kosaka (1969g) in L-alpha emission. Some sharpening of the image and reduction of film grain noise was accomplished by multiplying the picture's Fourier transform by an optimum filter function. After this processing, which was carried out digitally, the L-alpha comet image appeared as a nearly circularly symmetric diffuse glow approximately 800,000 km in diameter. There was also the suggestion of a faintly visible core of emission whose dimensions are less than 100,000 km. The sublimation of ice in the nucleus of the comet and the subsequent dissociation of the free water molecules by sunlight could produce a large cloud of hydrogen atoms around the comet. Resonant reradiation of solar L-alpha emission by this cloud is probably responsible for the most of the observed emission.

Jenkins, E. B.↗

Infrared heterodyne solar radiometry.

An infrared heterodyne radiometer has sufficient sensitivity for application to high resolution spectrometric studies of the sun and the absorption of sunlight in the atmosphere. In the 10-micron region, the resolution can typically range from less than .0067/cm to .067/cm. The minimum detectable signal can approach 10 to the -24th power W/Hz. The infrared heterodyne radiometer (IHR) can also be used for atmospheric propagation studies at the emission frequencies of the CO2 laser for the examination of the feasibility of space-to-ground laser communication links.

Mcelroy, J. H.↗

Tilting-filter measurements in dayglow rocket photometry.

A rocket-borne photometer containing two tilting-filter channels for the measurement of the forbidden OI 6300-A and 5577-A emission lines in the day airglow is described. The results of one flight substantiate the employment of tilting filters to determine accurate corrections for background continuum and provide reliable height profiles of emission intensity down to approximately 90 km. Discussions on the calibration of the instrument and its baffling against sunlight are also presented.

Schaeffer, R. C.↗

Optical detection of oil on water

Three radiometric techniques utilizing sunlight reflected and backscattered from water bodies have potential application for remote sensing of oil spills. Oil on water can be detected by viewing perpendicular polarization component of reflected light or difference between polarization components. Best detection is performed in ultraviolet or far-red portions of spectrum and in azimuth directions toward or opposite sun.

Millard, J. P.↗

The revised solar array synthesis computer program

The Revised Solar Array Synthesis Computer Program is described. It is a general-purpose program which computes solar array output characteristics while accounting for the effects of temperature, incidence angle, charged-particle irradiation, and other degradation effects on various solar array configurations in either circular or elliptical orbits. Array configurations may consist of up to 75 solar cell panels arranged in any series-parallel combination not exceeding three series-connected panels in a parallel string and no more than 25 parallel strings in an array. Up to 100 separate solar array current-voltage characteristics, corresponding to 100 equal-time increments during the sunlight illuminated portion of an orbit or any 100 user-specified combinations of incidence angle and temperature, can be computed and printed out during one complete computer execution. Individual panel incidence angles may be computed and printed out at the user's option.

Source record↗

Shape and Orientation of Nucleus

The shape and rate of rotation, as determined from brightness-time variations of reflected sunlight, for various asteroid nuclei are presented. The possible application of such a technique to the nucleus of comets is discussed.

Gehrels, T.↗

Results of the 1970 balloon flight solar cell standardization program

For the eighth consective year, high-altitude calibration of solar cells was accomplished with the aid of free-flight balloons. Flights were conducted to an altitude of 36,576 m which is above 99.5% of earth's atmosphere where all water vapor levels and significant ozone bands are absent. Solar cells calibrated in this manner are significant used as intensity references in solar simulators and in terrestrial sunlight. Discussed is the method employed for high altitude balloon flight solar cell calibration. Also presented are data collected on 52 standard solar cells on two flights conducted in 1970. Solar cells flown repeatedly on successive flights have shown correlation of better than + or - 1.0%.

Greenwood, R. F.↗

Studies relating to temperature control of a large scale telescope

Analytical methods are developed for estimating the circumferential and longitudinal temperature distributions in a large space telescope, idealized as a simple insulated tube with a flat mirror across one end. The effects of wall conduction, multilayer insulation, thermal coatings, heat pipes, and heated collars are analyzed, with numerical examples. For most of the study, the only thermal input to the tube was assumed to be from steady solar irradiation from one side, as in a geosynchronous orbit. Unsteady heat flow through the insulation, as in alternating sunlight and shadow of a low orbit, is briefly discussed.

Katzoff, S.↗

Remote soil moisture measurements

The degree of polarization of visible sunlight reflected from bare soils in agricultural test areas in the southwestern United States was measured by an airborne photopolarimeter. Surface soil specimens provided data concerning the surface moisture of the soil to which the polarization data were compared. The results indicate the feasibility of measuring soil surface moisture by airborne polarimeter instrumentation.

Stockhoff, E. H.↗