Results for “Path” — Page 22

NASA NTRSDate not supplied

Nonnormality of Sonic Boom Loudness Metrics in the Turbulent Atmospheric Boundary Layer at Large Lateral Distances from the Flight Path

Atmospheric boundary layer (ABL) turbulence causes variability of the sonic boom waveform at the ground. Recent numerical investigations of sonic boom propagation through kinematic velocity fluctuations indicate that loudness metric distributions are positively skewed relative to a normal distribution. This skewness depends on the propagation distance and turbulence intensity. Propagation simulations of N-waves and shaped booms through inhomogeneous ABL turbulence are presented. Meteorological conditions are varied to examine different daytime ABL conditions and their effect on sonic boom loudness distributions. Two outcomes are observed: 1) the loudness metric distributions become increasingly positively skewed as the propagation distance through the ABL increases, and 2) the distributions become increasingly positively skewed at the same lateral distance from the flight path as the convection level of the daytime ABL is increased. Thus, results indicate that ground level measurements of sonic boom loudness from flight tests performed at large lateral distances from the flight path may not be normally distributed, due to turbulence present in the ABL. (This research is supported by the Commercial Supersonic Technology Project of the National Aeronautics and Space Administration under Grant No. 80NSSC19K1685.)

sonic boom↗

NASA NTRS2022

Towards Finding Energy Efficient Paths for Hybrid Airships in the Atmosphere of Venus

This paper presents a solution to the motion planning problem for an autonomous airship under superrotation winds of the Venusian atmosphere. The airship uses both buoyancy and aerodynamic lift to control its altitude. In addition, solar panels distributed over the aircraft provide energy to the propellers and allow for battery recharging. Our approach uses a sampling-based planner that relies on Dubins’ Airplane paths deformed under the influence of the winds to create a tree of kinematically feasible trajectories. We use the battery state to prune energetically unfeasible trajectories and we propose a cost function that accounts for the energy expenditure of the propulsive system and that considers battery charging by using the Economics notion of opportunity cost. The method is illustrated through a series of simulations that show how the vehicle takes longer and high-altitude paths to minimize the use of energy and favor battery recharge. Our results also show that naive trajectories are not feasible in terms of energy, justifying the need for more efficient solutions.

Bernardo Martinez R. Jr↗

NASA NTRSDate not supplied

Formal Verification, Distributed Computing, and Path Planning Algorithms

The safety- and mission-critical nature of much of the work done at NASA requires algorithms and software to be exceedingly reliable. Formal methods techniques are one way of ensuring this high level of robustness. This talk will discuss the development and formal verification of autonomous aircraft path planning algorithms related to the Bellman-Ford shortest path algorithm, including consideration of distributed computation of the algorithm.

Formal Methods↗

NASA NTRS2024

Flight Path Control Error Analysis for the Helioswarm Observatory

The HelioSwarm Observatory requires specific geometries be formed by the nine satellites in the swarm to resolve different scales of solar wind turbulence. Maneuver execution and state estimation drive flight path control errors that could disrupt the swarm geometry. Using a Monte-Carlo analysis, flight path control errors for dispersed trajectories were generated and the impact to science performance and other mission constraints evaluated. The results highlight the unique aspects of swarm-type multi-satellite missions in terms of maneuver planning and error tolerance.

Stephen West↗

NASA NTRS1963

COMMON PATH INTERFEROMETER USING FRESNEL ZONE PLATES

Common path interferometer using two fresnel zone plates for diffraction beam splitting, is applied to the testing of unit magnification optics

OPTICAL PATH↗

NASA NTRSDate not supplied

Designing a Flight Test of a Flight Path Management System for Advanced Air Mobility Research

The National Aeronautics and Space Administration (NASA) has completed a flight test to evaluate the performance of an onboard prototype automation system operating in future high density urban airspace. The test was part of a research investigation of the Urban Air Mobility (UAM) concept, with a focus on a future environment having hundreds of simultaneous operations over a metropolitan area. The complexity of this future UAM airspace may require automation capable of replanning an aircraft’s path in the presence of traffic and other changing constraints. A live-virtual-constructive (LVC) approach was used to conduct the test. Prototype automation technology was integrated into one of the two live aircraft, which were combined with virtual traffic to create a mixed reality environment at the target airspace density. In-flight evaluation enabled verification of the automation’s functions and discovery of any unexpected behaviors resulting from its operation in an actual flight environment. The in-flight evaluation also provided data for validation of air traffic simulations. This paper discusses the design, methodology, and challenges overcome to conduct a successful flight test. Remaining challenges, future work, and recommendations to improve the flight test capability are also discussed.

Advanced Air Mobility↗

NASA NTRSDate not supplied

An Experimental System for Strategic Flight Path Management in Advanced Air Mobility

In the concept envisioned for Urban Air Mobility (UAM) operations, fleets of electric vertical takeoff and landing (eVTOL) vehicles would operate between vertiports distributed within a densely populated area. These operations would be largely independent from the existing air traffic control system and would place the responsibility for flight planning and aircraft separation on fleet operators. The fourth major level on the UAM Maturity Level scale, UML-4, relies on “collaborative and responsible” automation to enable operations in non-visual conditions with medium traffic density (hundreds of aircraft in one metropolitan region) and medium complexity. This level of service places many requirements on automation systems to assist the operators of these aircraft. NASA has developed the Autonomous Operations Planner (AOP), a reference prototype Flight Path Management automation system, and has modified AOP to support research of anticipated UML-4 operations. AOP creates a four-dimensional flight plan conforming to the constraints of these operations, evaluates and modifies the flight plan during flight as conditions and constraints evolve, and coordinates the flight plan with other airspace users and with service providers. This version of AOP has been integrated into the Sikorsky Autonomy Research Aircraft and used in a flight test activity. In this paper we discuss anticipated characteristics of UAM operations, modifications that were made to AOP to adapt to that environment or to support the flight test, and observations of software and aircraft performance during the flight test. The aircraft achieved four-dimensional conformance with the flight plan and AOP provided adequate planning in almost all cases. We discuss improvements that could be made to AOP to address deficiencies that were observed.

Autonomous Operations Planner↗

NASA NTRSDate not supplied

An Experimental System for Strategic Flight Path Management in Advanced Air Mobility

In the concept envisioned for Urban Air Mobility (UAM) operations, fleets of electric vertical takeoff and landing (eVTOL) vehicles would operate between vertiports distributed within a densely populated area. These operations would be largely independent from the existing air traffic control system and would place the responsibility for flight planning and aircraft separation on fleet operators. The fourth major level on the UAM Maturity Level scale, UML-4, relies on “collaborative and responsible” automation to enable operations in non-visual conditions with medium traffic density (hundreds of aircraft in one metropolitan region) and medium complexity. This level of service places many requirements on automation systems to assist the operators of these aircraft. NASA has developed the Autonomous Operations Planner (AOP), a reference prototype Flight Path Management automation system, and has modified AOP to support research of anticipated UML-4 operations. AOP creates a four-dimensional flight plan conforming to the constraints of these operations, evaluates and modifies the flight plan during flight as conditions and constraints evolve, and coordinates the flight plan with other airspace users and with service providers. This version of AOP has been integrated into the Sikorsky Autonomy Research Aircraft and used in a flight test activity. In this paper we discuss anticipated characteristics of UAM operations, modifications that were made to AOP to adapt to that environment or to support the flight test, and observations of software and aircraft performance during the flight test. The aircraft achieved four-dimensional conformance with the flight plan and AOP provided adequate planning in almost all cases. We discuss improvements that could be made to AOP to address deficiencies that were observed.

Autonomous Operations Planner↗

NASA NTRS1962