SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Prediction of behavior and support requirements during the entire life cycle of a system enables accurate cost estimates by using the Monte Carlo simulation by computer. The system reduces the ultimate cost to the procuring agency because it takes into consideration the costs of initial procurement, operation, and maintenance.
This report describes initial efforts to model the endlinking reaction of phenylethynyl-terminated oligomers. Several different molecular weights were simulated using the Bond Fluctuation Monte Carlo technique on a 20 x 20 x 20 unit lattice with periodic boundary conditions. After a monodisperse "melt" was equilibrated, chain ends were linked whenever they came within the allowed bond distance. Ends remained reactive throughout, so that multiple links were permitted. Even under these very liberal crosslinking assumptions, geometrical factors limited the degree of crosslinking. Average crosslink functionalities were 2.3 to 2.6; surprisingly, they did not depend strongly on the chain length. These results agreed well with the degrees of crosslinking inferred from experiment in a cured phenylethynyl-terminated polyimide oligomer.
The incorporation of a number of additional capabilities into an existing Weibull analysis computer program and the results of Monte Carlo computer simulation study to evaluate the usefulness of the Weibull methods using samples with a very small number of failures and extensive censoring are discussed. Since the censoring mechanism inherent in the Space Shuttle Main Engine (SSME) data is hard to analyze, it was decided to use a random censoring model, generating censoring times from a uniform probability distribution. Some of the statistical techniques and computer programs that are used in the SSME Weibull analysis are described. The methods documented in were supplemented by adding computer calculations of approximate (using iteractive methods) confidence intervals for several parameters of interest. These calculations are based on a likelihood ratio statistic which is asymptotically a chisquared statistic with one degree of freedom. The assumptions built into the computer simulations are described. The simulation program and the techniques used in it are described there also. Simulation results are tabulated for various combinations of Weibull shape parameters and the numbers of failures in the samples.
The authors present calculated first and second escape peak efficiencies for a variety of n-type coaxial Ge detectors using the Monte Carlo method. The results are given for right-circular cylindrical geometries of size ranging from 3-cm diameter x 3-cm thick to 8-cm diameter x 8-cm thick. For completeness, the intrinsic interaction and photopeak efficiencies for energies ranging from 20 keV to 20 MeV are listed. The calculations have been tested against experimental measurement and found to be in agreement to within the quoted errors (typically 10 percent). It is found that the ratio of the second escape peak efficiency to the first escape peak efficiency, R, is approximately independent of energy for small detector volumes but has a weak power law energy dependence for large volumes. It is shown that R also varies as an inverse power law of the active volume.
A novel method is presented to estimate contaminant levels around spacecraft and satellites of arbitrarily complex geometry. The method uses a three-dimensional direct simulation Monte Carlo algorithm to characterize the contaminant cloud surrounding the space platform, and a computer-assisted design preprocessor to define the space-platform geometry. The method is applied to the Upper Atmosphere Research Satellite to estimate the contaminant flux incident on the optics of the halogen occultation experiment (HALOE) telescope. Results are presented in terms of contaminant cloud structure, molecular velocity distribution at HALOE aperture, and code performance.
There are many flows fields that span a wide range of length scales where regions of both rarefied and continuum flow exist and neither direct simulation Monte Carlo (DSMC) nor computational fluid dynamics (CFD) provide the appropriate solution everywhere. Recently, a new viscous collision limited (VCL) DSMC technique was proposed to incorporate effects of physical diffusion into collision limiter calculations to make the low Knudsen number regime normally limited to CFD more tractable for an all-particle technique. This original work had been derived for a single species gas. The current work extends the VCL-DSMC technique to gases with multiple species. Similar derivations were performed to equate numerical and physical transport coefficients. However, a more rigorous treatment of determining the mixture viscosity is applied. In the original work, consideration was given to internal energy non-equilibrium, and this is also extended in the current work to chemical non-equilibrium.
Verification of DOT-SPACETRAN transport calculations of a lithium hydride and tungsten shield for a SNAP reactor was performed using the MORSE (Monte Carlo) code. Transport of both neutrons and gamma rays was considered. Importance sampling was utilized in the MORSE calculations. Several quantities internal to the shield, as well as dose at several points outside of the configuration, were in satisfactory agreement with the DOT calculations of the same.
The mathematical derivations of various methods employed in the Monte Carlo particle-trajectory model (MCPTM) are presented, and the application of the MCPTM to the calculation of the photochemical heating of the inner coma through the partial thermalization of cometary hydrogen atoms produced by the photodissociation of water is discussed. This model is then used to explain the observed morphology of the spatially extended Ly-alpha comas of comets. The rocket and Skylab images of the Ly-alpha coma of Comet Kohoutek are examined.
In this paper we discuss the methods developed for the production of the INTEGRAL/SPI instrument response. The response files were produced using a suite of Monte Carlo simulation software developed at NASA/GSFC based on the GEANT-3 package available from CERN. The production of the INTEGRAL/SPI instrument response also required the development of a detailed computer mass model for SPI. We discuss our extensive investigations into methods to reduce both the computation time and storage requirements for the SPI response. We also discuss corrections to the simulated response based on our comparison of ground and inflight calibration data with MGEANT simulation.
In this paper we discuss the methods developed for the production of the INTEGRAL/SPI instrument response. The response files were produced using a suite of Monte Carlo simulation software developed at NASA/GSFC based on the GEANT-3 package available from CERN. The production of the INTEGRAL/SPI instrument response also required the development of a detailed computer mass model for SPI. We discuss ow extensive investigations into methods to reduce both the computation time and storage requirements for the SPI response. We also discuss corrections to the simulated response based on our comparison of ground and infiight Calibration data with MGEANT simulations.
The effect of binding energy on the growth of clusters on a two-dimensional square lattice was studied by a means of a Monte Carlo simulation. The results indicate that for binding energies higher than 0.5kT, clusters grow relative to the initial random distribution, while for binding energies lower than 0.5 kT, clusters decompose. It was also found that at low binding energies the equilibrium percentage of atoms that are bound in clusters is linearly dependent on the binding energy. The cluster density behaved in a similar manner. This similarity reflects the fact that at low binding energies the growth proceeds mainly by the formation of new clusters rather than by an increase in the size of existing ones.
The flow of carbon dioxide through a small conical nozzle is computed using two different numerical approaches. The first of these is the direct simulation Monte Carlo method in which the physical phenomena are modeled at the molecular level. The second technique solves the Navier-Stokes equations of fluid flow. The purpose of the paper is to compare the solutions generated by these two methods for the conditions prevailing in a small, low density nozzle. The comparison between the two sets of solutions reveals only small differences. However, the flow properties in the thick viscous layer close to the nozzle at the exit plane show important deviations which have implications for the subsequent determination of the plume backflow.
Computations are presented for the relaxation zone behind strong, 1D shock waves in nitrogen. The analysis is performed with the direct simulation Monte Carlo method (DSMC). The DSMC code is vectorized for efficient use on a supercomputer. The code simulates translational, rotational and vibrational energy exchange and dissociative and recombinative chemical reactions. A model is proposed for the treatment of three body-recombination collisions in the DSMC technique which usually simulates binary collision events. The model improves previous models because it can be employed with a large range of chemical-rate data, does not introduce into the flow field troublesome pairs of atoms which may recombine upon further collision (pseudoparticles) and is compatible with the vectorized code. The computational results are compared with existing experimental data. It is shown that the derivation of chemical-rate coefficients must account for the degree of vibrational nonequilibrium in the flow. A nonequilibrium-chemistry model is employed together with equilibrium-rate data to compute the flow in several different nitrogen shock waves.
The current-voltage characteristics of graded Al(x)Ga(1-x)As heterojunction barriers were investigated using a self-consistent ensemble Monte Carlo method. Results are presented for barriers with two doping levels (10 to the 15th/cu cm and 10 to the 17th/cu cm) and two barrier heights (100 and 265 meV). It was found that the lower barrier structure exhibited little rectification at room temperature at both doping levels, while the higher barrier exhibited considerable rectification. The structures with the lower doping value exhibited a smaller current in both forward and reverse regions, due to space-charge effect. The results of studies of the energy and momentum distribution functions along the barrier indicate that the assumption of drifted Maxwellian distribution used in energy-momentum models is not justified for Gamma valley electrons.
While hydrocarbon combustion and gas-surface interactions have been simulated for a variety of applications in continuum solvers, such processes have been rarely investigated in Direct Simulation Monte Carlo (DSMC). Thus Variable Hard/Soft Sphere (VHS/VSS)collision parameters are not available for most molecules of interest in the decomposition of methane, a significant pyrolysis gas product and potential atmospheric species for Titan re-entries. As these properties are essential for accurate modeling of gas transport and thermochemical effects, a method must be devised to compute them for use in DSMC. In this study, the methodology outlined in Stephani et al is utilized to compute the VHS/VSS parameters by fitting the Ω(1,1)and Ω(2,2) collision integrals [1]. These collision integrals are typically computed from intermolecular potentials and are used in CFD simulations to calculate transport properties such as viscosity, thermal conductivity, and diffusion. This approach ensures consistency between micro-scale collisions and macro-scale transport properties. To produce the necessary collision integrals needed for the fitting routine, we utilize the method described by Laricchiuta et al, where collision integrals are computed based on the constituent particles’ polarizability and effective electron number [2].Preliminary computations of pure-species Ω(1,1)and Ω(2,2)collision integrals produced from the coupled approach of Stephani et al and Laricchiuta et al for methane show good agreement with those computed via available ab-initio Potential Energy Surface Computations, as seen in Figure 1. Above 300K, no more than 12% deviation is observed between the two results over the temperature range of the fitted PES data [3].Current results of this study include full collision-specificVSS transport properties for a complex-species mixture involving major byproducts of pure methane decomposition. Targeted final results will include a comprehensive list of VSS parameters relevant toDSMC simulations of Titan atmospheric entry, based on the reduced kinetic model of Savajano et al [4].
Cold wall and multibody collision effects on reflection of imploding shock waves using Monte Carlo method and molecular dynamics
A model of rarefied gas flow in tubes was developed which combines a lobular distribution with diffuse reflection at the wall. The model with Monte Carlo techniques was used to explain previously observed deviations in the free molecular thermal transpiration ratio which suggest molecules can have a greater tube transmission probability in a hot-to-cold direction than in a cold-to-hot direction. The model yields correct magnitudes of transmission probability ratios for helium in Pyrex tubing (1.09 to 1.14), and some effects of wall-temperature distribution, tube surface roughness, tube dimensions, gas temperature, and gas molecular mass.
The results of ground laboratory and in-space exposure of polymeric materials to atomic oxygen has enabled the development of a Monte Carlo computational model which simulates the oxidation processes of both environments. The cost effective projection of long-term low-Earth-orbital durability of protected polymeric materials such as SiO(x)-coated polyimide Kapton photovoltaic array blankets will require ground-based testing to assure power system reliability. Although silicon dioxide thin film protective coatings can greatly extend the useful life of polymeric materials in ground-based testing, the projection of in-space durability based on these results can be made more reliable through the use of modeling which simulates the mechanistic properties of atomic oxygen interaction, and replicates test results in both environments. Techniques to project long-term performance of protected materials, such as the Space Station Freedom solar array blankets, are developed based on ground laboratory experiments, in-space experiments, and computational modeling.