Search NASA⌕ Search

SEARCH · Search NASA

Results for “SIMULATED ALTITUDE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 415 records · Page 23

Results of a space shuttle pulme impingement investigation at stage separation in the NASA-MSFC impulse base flow facility

Results are presented for an experimental space shuttle stage separation plume impingement program conducted in the NASA-Marshall Space Flight Center's impulse base flow facility (IBFF). Major objectives of the investigation were to: (1)determine the degree of dual engine exhaust plume simulation obtained using the equivalent engine; (2) determine the applicability of the analytical techniques; and (3) obtain data applicable for use in full-scale studies. The IBFF tests determined the orbiter rocket motor plume impingement loads, both pressure and heating, on a 3 percent General Dynamics B-15B booster configuration in a quiescent environment simulating a nominal staging altitude of 73.2 km (240,00 ft). The data included plume surveys of two 3 percent scale orbiter nozzles, and a 4.242 percent scaled equivalent nozzle - equivalent in the sense that it was designed to have the same nozzle-throat-to-area ratio as the two 3 percent nozzles and, within the tolerances assigned for machining the hardware, this was accomplished.

Mccanna, R. W.↗

Specimen mass measurement

The Skylab specimen mass measurement device was operated throughout the altitude test in close simulation of the 56-day Skylab mission. It performed operational specimen measurements well until it was passed out of the chamber for replacement of the specimen hold-down and was autoclaved prior to return. Fecal measurements were typically made with less than one percent error.

Thornton, W. E.↗

Effects of steady-state pressure distortion on the stall margin of a J85-21 turbojet engine

The effects of the inlet pressure distortions, induced by five screen patterns, on the performance of a J85-21 turbojet engine was conducted at the NASA Lewis Research Center. Testing was in support of the HiMAT RPRV program at Dryden Flight Research Center. Distortion patterns were chosen based on anticipated application of test results of the HiMAT installation. Tests were conducted at a simulated Mach number and altitude condition of 0.9 and 10 973 meters. Results are presented in terms of distortion levels and standard compressor performance parameters.

Bobula, G. A.↗

The chemistry of excited NO/+/ in an aurora

The six most significant production and seven most significant loss mechanisms are identified for NO(+)(a3 Sigma) in the aurora. Rate constants are given for these reactions as well as for the 14 most important reactions competing with the production of NO(+)(a). Using available data and certain crucial deductions on chemical reaction rates to simulate a number of altitude profiles, it is concluded that the two predominant sources of NO(+)(a3 Sigma) are probably N(+) + O2 yields NO(+)(a) + O and N2(+) + NO yields NO(+)(a) + N2. Radiative decay is not the primary loss mechanism but can dominate above 150 km. Destruction via charge exchange with N2 and O are most important below 150 km.

Young, E. R.↗

Radiometric observations of the 752.033-GHz rotational absorption line of H2O from a laboratory jet

With the aid of a high-resolution two-stage heterodyne radiometer, spectral absorption measurements of the 752.033 GHz line of water vapor were carried out, using a blackbody continuum as a background radiation source for investigating the absorptive properties of the H2O content of high altitude rocket plumes. To simulate this physical situation in a laboratory environment, a small steam jet was operated within a large high-vacuum chamber, with the H2O jet plume traversing the radiometer line of sight. The experiments verified that this rotational line is optically thick, with excitation temperatures below 100 K, in the downstream part of the plume, as predicted by theoretical modelling.

Dionne, G. F.↗

High-response measurements of a turbofan engine during nonrecoverable stall

High response measurements of a Pratt and Whitney F100(3) turbofan engine at a simulated Mach number and altitude of 1.2 and 3000 m (10,000 ft) respectively were recorded during a nonrecoverable stall. The nonrecoverable stall occurred as a result of incorrect scheduling of the high compressor variable vanes (RCVV) during an experimental engine control investigation. Recorded data indicates rotating stall originating in the high pressure compressor. From this region the disturbance propagates upstream into the fan and downstream throughout the core compressor. The rotating stall remained in the core compressor until the engine was shutdown. The fan exhibited some rotating stall, but the amplitude of the pressure oscillations were less severe. Data indicates that the fan was able to recover from the stall. Fan turbine inlet temperature (FTIT) had been decreasing until stall developed in the high-pressure compressor. From this time, FTIT increased towards its maximum temperature limit. The rising FTIT during nonrecoverable stall may be the result of incomplete combustion in the combustor and additional combustion occurring through the turbine.

Lee, D.↗

Analysis of the charging of the SCATHA (P78-2) satellite

The charging of a large object in polar Earth orbit was investigated in order to obtain a preliminary indication of the response of the shuttle orbiter to such an environment. Two NASCAP (NASA Charging Analyzer Program) models of SCATHA (Satellite Charging at High Altitudes) were used in simulations of charging events. The properties of the satellite's constituent materials were compiled and representations of the experimentally observed plasma spectra were constructed. Actual charging events, as well as those using test environments, were simulated. Numerical models for the simulation of particle emitters and detectors were used to analyze the operation of these devices onboard SCATHA. The effect of highly charged surface regions on the charging conductivity within a photosheath was used to interpret results from the onboard electric field experiment. Shadowing calculations were carried out for the satellite and a table of effective illuminated areas was compiled.

Stannard, P. R.↗

Generation and propagation of an electromagnetic pulse in the Trigger experiment and its possible role in electron acceleration

Instruments onboard the Trigger payload detected a large-amplitude, low-frequency, electric field pulse which was observed with a time delay consistent only with an electromagnetic wave. A model for this perturbation is constructed, and the associated field-aligned current is calculated as a function of altitude. This experiment may simulate the acceleration mechanism which results in the formation of auroral arcs, and possibly even other events in cosmic plasmas.

Kelley, M. C.↗

Remote sensing of surface mines - A comparative study of sensor systems

The application of remote sensing to the inventory of coal surface mines and to the monitoring of mine reclamation in the eastern United States was investigated. Data were acquired during spring and autumn by several sensor systems over study areas located within the bituminous coal fields of Pennsylvania. Data sources were the Landsat MSS, an airborne multispectral scanner (Daedalus DS-1260), the airborne Thematic Mapper Simulator, and high-altitude color and color infrared aerial photography. A comparison of the data sets was conducted by a quantitative assessment of area measurement accuracy. Landsat data were found most suitable for a synoptic inventory of mines on a regional basis. High-altitude aerial photography was considered the best source of the detailed information required for reclamation monitoring. Nine channels of data from the airborne scanner were evaluated to select the most useful spectral bands for discriminating among the land cover types associated with surface mines. Four bands were selected in the following order by a stepwise linear discriminant procedure: 0.60-0.65 micron, 0.92-1.10 microns, 0.80-0.89 micron, and 8-14 microns. The data corresponding to these four bands were used for the thematic mapping of land cover.

Irons, J. R.↗

Lidar measurements of tropospheric gases

Measurements of pollutants and water vapor in the troposphere using the differential absorption lidar (DIAL) technique are described. Measurements are made of sulfur dioxide in power plant plumes with a mobile DIAL system operated near 300 nm. Comparisons of sulfur dioxide concentrations determined with the DIAL system and in-stack monitors are found to be in agreement to within 18%. Vertical water vapor profiles with a ground-based lidar system are measured using the water vapor absorption line at 724.3 nm. Rawinsonde and DIAL water vapor profile data are shown to agree within 10% to an altitude of 2.5 km. Simulations are discussed for airborne DIAL measurements of sulfur dioxide, water vapor, and nitrogen dioxide.

Browell, E. V.↗

The organic aerosols of Titan

The optical properties and chemical composition of thiolin, an organic solid synthesized by high-energy-electron irradiation in a plasma discharge (Sagan et al., 1984) to simulate the high-altitude aerosols of Titan, are investigated experimentally using monochromators, ellipsometers, and spectrometers (on thin films deposited by continuous dc discharge) and sequential and nonsequential pyrolytic gas chromatography/mass spectrometry (of the volatile component), respectively. The results are presented in tables and graphs and characterized. The real and imaginary elements of the complex refractive index in the visible are estimated as 1.65 and 0.004-0.08, respectively, in agreement with observations of Titan, and the IR absorption features include the nitrile band at 4.6 microns. The molecules identified in the volatile part of thiolin include complex species considered important in theoretical models of the origin of life on earth.

Khare, B. N.↗

Reactivation study for NASA Lewis Research Center's hypersonic tunnel facility

The Hypersonic Tunnel Facility (HTF) at NASA Lewis Research Center's Plum Brook Station is a blowdown, free-jet, nonvitiated propulsion facility capable of Mach 5, 6, and 7 with true temperature, altitude, and air composition simulation. The facility has been in a deactivated status for 13 years. Discussed are the capabilities of HTF, and the results of a deactivation study recently conducted to determine the cost, schedule, and technical effort required to restore HTF to its original design operating capabilities are summarized.

Haas, Jeffrey E.↗

Reactivation study for NASA Lewis Research Center's Hypersonic Tunnel Facility

The Hypersonic Tunnel Facility (HTF) at NASA Lewis Research Center's Plum Brook Station is a blowdown, free-jet, nonvitiated propulsion facility capable of Mach 5, 6, and 7 with true temperature, altitude, and air composition simulation. The facility has been in a deactivated status for 13 years. Discussed are the capabilities of HTF, and the results of a deactivation study recently conducted to determine the cost, schedule, and technical effort required to restore HTF to its original design operating capabilities are summarized.

Haas, Jeffrey E.↗

Transient performance of fan engine with water ingestion

In a continuing investigation on effects of rain-water ingestion into bypass fan engines, it is shown that the performance of axial-flow compressors and fans is fundamentally time-dependent during ingestion of water. A code named WINCOF-I has been developed for establishing the performance of axial-flow turbomachinery operating with air-water vapor-water droplet-water film mixture, Illustrative examples of predictions and effects are provided for the case of the air-compression system of a generic bypass fan engine. Utilizing performance maps so-generated, the effects of water ingestion into the generic engine have been determined under test cell conditions simulating ingestion, flight operation (altitude and flight Mach number), and power-demand setting.

Murthy, S. N. B.↗

Advanced nozzle and engine components test facility

A test facility for conducting scaled advanced nozzle and engine component research is described. The CE-22 test facility, located in the Engine Research Building of the NASA Lewis Research Center, contains many systems for the economical testing of advanced scale-model nozzles and engine components. The combustion air and altitude exhaust systems are described. Combustion air can be supplied to a model up to 40 psig for primary air flow, and 40, 125, and 450 psig for secondary air flow. Altitude exhaust can be simulated up to 48,000 ft, or the exhaust can be atmospheric. Descriptions of the multiaxis thrust stand, a color schlieren flow visualization system used for qualitative flow analysis, a labyrinth flow measurement system, a data acquisition system, and auxiliary systems are discussed. Model recommended design information and temperature and pressure instrumentation recommendations are included.

Beltran, Luis R.↗

Advanced nozzle and engine components test facility

A test facility for conducting scaled advanced nozzle and engine component research is described. The CE-22 test facility, located in the Engine Research Building of the NASA Lewis Research Center, contains many systems for the economical testing of advanced scale-model nozzles and engine components. The combustion air and altitude exhaust systems are described. Combustion air can be supplied to a model up to 40 psig for primary air flow, and 40, 125, and 450 psig for secondary air flow. Altitude exhaust can be simulated up to 48,000 ft, or the exhaust can be atmospheric. Descriptions of the multiaxis thrust stand, a color schlieren flow visualization system used for qualitative flow analysis, a labyrinth flow measurement system, a data acquisition system, and auxiliary systems are discussed. Model recommeded design information and temperature and pressure instrumentation recommendations are included.

Beltran, Luis R.↗

Dynamic Stability and Control Problems of Piloted Reentry from Lunar Missions

A fixed-base simulator investigation has been made of stability and control problems during piloted reentry from lunar missions. Reentries were made within constraints of acceleration and skipping, in which the pilot was given simulated navigation tasks of altitude and heading angle commands. Vehicles considered included a blunt-face, high-drag capsule, and a low-drag lifting cone, each of which had a trim lift-drag ratio of 0.5. With the provision of three-axis automatic damping, both vehicles were easily controlled through reentry after a brief pilot-training period. With all dampers out, safe reentries could be made and both vehicles were rated satisfactory for emergency operation. In damper-failure conditions resulting in inadequate Dutch roll damping, the lifting-cone vehicle exhibited control problems due to excessive dihedral effect and oscillatory acceleration effects.

Moul, Martin T.↗