Review of sonic boom theory
Sonic boom theory of geometric acoustics with nonlinear effects modification, emphasizing horizontally stratified atmospheric propagation, discussing failure near caustic
Hayes, W. D.↗
SEARCH · Search NASA
Results for “acoustical effects”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Amplification by wave distortion in unstable combustors
Pressure wave distortion effects on combustor acoustic mode instability based on model with burning rate related to Reynolds number
Heidmann, M. F.↗
The NASA/GE quiet engine 'A.'
The National Aeronautics and Space Administration and the General Electric Company are jointly developing two low noise propulsion technology demonstrators (Engine 'A' and 'C' incorporating respectively a low tip speed and high tip speed fan) under the Experimental Quiet Engine Program. The acoustic and aerodynamic performance characteristics of Engine 'C' which is currently on test will be reported at a later date. The present paper describes the design, component development and engine evaluation of the 'A' demonstrator. The aerodynamic and acoustic performance obtained on the fan component are discussed. The demonstrator engine acoustic test program is outlined. The effect of inlet geometry and duct acoustic treatment are presented. The static acoustic data are extrapolated to flight and compared with the FAA noise regulations.
Benzakein, M. J.↗
Concerns of the Institute of Transport Study and Research for reducing the sound level inside completely repaired buses
Sound level measurements on noise sources on buses are used to observe the effects of attenuating acoustic pressure levels inside the bus by sound-proofing during complete repair. A spectral analysis of the sound level as a function of motor speed, bus speed along the road, and the category of the road is reported.
Groza, A.↗
Noise transmission through flat rectangular panels into a closed cavity
Five panels backed by a closed cavity were studied experimentally and analytically to determine the noise transmission characteristics of the coupled panel-cavity system. The closed cavity was studied both with and without fiber-glass lining to provide either an absorbent or a reverberant acoustic space. The effects on noise reduction of cavity absorption, measurement location within the cavity, panel mass, and panel stiffness were examined. Results indicated that both measurement location and absorption in the cavity have significant effects on the noise reduction. Increasing panel mass improves the noise reduction at almost all frequencies, and increasing panel stiffness improves nose reduction below the fundamental resonance frequency. A simple, one dimensional analytical model was developed which provided good agreement with the experimental results.
Barton, C. K.↗
The coupling between flow instabilities and incident disturbances at a leading edge
It is now generally agreed that an external disturbance field, such as an incident acoustic wave, can effectively couple to instabilities of a flow past a trailing edge. One purpose of the present paper is to show that there are situations where a similar coupling can occur at a leading edge. The process is analyzed and the effects of experimentally controllable parameters are assessed. It is important to account for such phenomena when evaluating the effect of external disturbances on transition.
Goldstein, M. E.↗
STS-3 medical report
The medical operations report for STS-3, which includes a review of the health of the crew before, during, and immediately after the third Shuttle orbital flight is presented. Areas reviewed include: health evaluation, medical debriefing of crewmembers, health stabilization program, medical training, medical 'kit' carried in flight, tests and countermeasures for space motion sickness, cardiovascular profile, biochemistry and endocrinology results, hematology and immunology analyses, medical microbiology, food and nutrition, potable water, shuttle toxicology, radiological health, and cabin acoustic noise. Environmental effects of shuttle launch and landing medical information management, and management, planning, and implementation of the medical program are also dicussed.
Pool, S. L.↗
An experimental study of tone excited heated jets
The objective of this investigation was to obtain detailed experimental data on the effects of upstream acoustic excitation on the mixing of heated jets with the surrounding air. Based on the information gathered in the literature survey, a technical approach was developed to carry out a systematic set of mean flowfield measurements for a broad range of jet operating and acoustic excitation conditions. Most of the results were obtained at Mach numbers of 0.3 and 0.8 and total temperatures of up to 800 K. Some measurements were made also for the fully expanded supersonic jet of Mj = 1.15. The maximum level of excitation was Le equal to or less than 150 dB and a range of excitation frequencies up to fe = 4 kHz was used. The important results derived from this study can be summarized as follows: (1) the sensitivity of heated jets to upstream acoustic excitation varies strongly with the jet operating conditions, (2) the threshold excitation level increases with increasing jet temperature, and (3) the preferred Strouhal number does not change significantly with a change of the jet operating conditions.
Lepicovsky, J.↗
Spacelab 3 drop dynamics experiments
Positioning techniques using the effects of acoustic-radiation pressure were used during the Spacelab 3 flight to carry out classical fluid dynamics experiments on liquid drops freely suspended in microgravity. Quantitative results dealing with the equilibrium shapes of acoustically rotated drops, with the response to the radiation pressure forces, and finally with the experimental measurement of surface tension have been obtained.
Trinh, E. H.↗
Shuttle environment database
The proceedings of a workshop on the development of a data base for the Space Shuttle environment are summarized. The data base is intended for use by experimenters in designing scientific payloads for Shuttle missions. The status of currently available data on the Shuttle environment is reviewed, with emphasis given to ten specific topics which are believed to be of concern to Shuttle experiment designers. These topics include: flight dynamics, vibration and acoustics, orbiter motion effects, EMI, and thermal and humidity effects. Attention is also given to: the Shuttle particulate environment; surface interactions inside and on the exterior of the spacecraft, and the natural Shuttle environment. Recent experimental results concerning Vehicle Glow on the spacecraft surface material are discussed in detail. A schematic diagram describing the functional organization of computer hardware for the Shuttle environment data base is provided.
Lauriente, M.↗
Added noise due to the effect of an upstream wake on a propeller
An analytical/computational study has been conducted to predict the effect of an upstream wing or pylon on the noise of an operating propeller. The wing trailing edge was placed at variable distances (0.1 and 0.3 chord) upstream of a scaled model propeller (SR-2). The wake was modeled using a similarity formulation. The instantaneous pressure distribution on the propeller blades during the passage through the wake was formulated in terms of a time-dependent variation of each blade section's angle of attack and in terms of the shed vortices from the blade trailing edge. It was found that the final expressions for the unsteady loads considerably altered the radiated noise pattern. Predicted noise for various observer positions, rotational speeds, and propeller/pylon distances were computed and are presented in terms of the pressure time history, harmonics of the Fourier analysis, and overall sound pressure levels (OASPL). The addition of the tangential stress due to skin friction was found to have a damping effect on the acoustic pressure time history and the resulting spectrum of the generated noise. It is shown that the positioning of a pylon upstream of a propeller indeed increases the overall noise.
Takallu, M. A.↗
Effects of velocity profile on boundary-layer shielding
A simple uniform flow boundary-layer model is used to study the effects on the acoustic field at the aircraft fuselage of placing Large Eddy Break Up devices in the boundary layer. The introduction of velocity defects into the boundary layer is shown to enhance boundary-layer shielding. Furthermore, shielding improvements are found to occur by moving the velocity defect further from the wall, by increasing its extent within the boundary layer, and by decreasing the minimum velocity in the defect.
Mcaninch, Gerry L.↗
Detecting Impacts Of Particles On Spacecraft
Report describes proposed network of acoustical sensors, in effect, miniature seismographic system, to detect impacts of particles on external panels of spacecraft. Inexpensive thin-film vibration sensors placed on insides of panels and connected to relatively-simple data-collection system. Meteoroid shields already planned for Space Station serves as panels on spacecraft. Describes tests of concept in which small spheres impinged on aluminum panels. Tests showed sensor data used to determine locations and characteristics of impacts and panels provide suitable medium for detecting low-probability impacts of interest.
Lempriere, Brian M.↗
Some Observations on Transitory Stall in Conical Diffusers
Results from an experimental investigation on the flow through conical diffusers are presented. The mean and fluctuating velocity fields are compared for three diffusers with total diffusion angles of 16, 20 and 24 degrees, in the throat Mach number (M sub t) range of 0.05 to 0.95. Each of the diffusers were 14 cm long and had a 5.08 cm inlet diameter, and the flow exited into the ambient. The boundary layer at the throat was thin with the throat diameter (D sub t) to momentum thickness (O) ratio being as high as 800 at M(sub t) = 0.4. While the 16 deg diffuser flow exited with a top-hat mean velocity profile, increasing losses due to increasing separation resulted in fuller profiles for the 20 and 24 degree cases. A detailed flow field study was conducted for the 16 deg. diffuser. The u'-spectrum, measured at the exit plane, exhibited a peak apparently due to the ensuing jet column instability throughout the M(sub t) range covered. In addition, a much lower frequency spectral peak also occurred in the M(sub t) range of 0.3 to 0.7. Both of the spectral peaks were due to axisymmetric flow fluctuations. A self-sustaining flow oscillation occurred in the M(sub t) range of 0.6 to 0.85, emitting a loud tone, when the jet column instability frequency matched the resonance frequency of the diffuser. Limited data showed that artificial acoustic excitation was effective in reducing the flow fluctuations, with a resultant increase in the pressure recovery, at low M(sub t).
Zaman, K. B. M. Q.↗
Some observations on transitory stall in conical diffusers
Results from an experimental investigation on the flow through conical diffusers are presented. The mean and fluctuating velocity fields are compared for three diffusers with total diffusion angles of 16, 20 and 24 degrees, in the throat Mach number (M sub t) range of 0.05 to 0.95. Each of the diffusers were 14 cm long and had a 5.08 cm inlet diameter, and the flow exited into the ambient. The boundary layer at the throat was thin with the throat diameter (D sub t) to momentum thickness (O) ratio being as high as 800 at M(sub t) = 0.4. While the 16 deg diffuser flow exited with a top-hat mean velocity profile, increasing losses due to increasing separation resulted in fuller profiles for the 20 and 24 degrees cases. A detailed flow field study was conducted for the 16 deg diffuser. The u'-spectrum, measured at the exit plane, exhibited a peak apparently due to the ensuing jet column instability throughout the M(sub t) range covered. In addition, a much lower frequency spectral peak also occurred in the M(sub t) range of 0.3 to 0.7. Both of the spectral peaks were due to axisymmetric flow fluctuations. A self-sustaining flow oscillation occurred in the M(sub t) range of 0.6 to 0.85, emitting a loud tone, when the jet column instability frequency matched the resonance frequency of the diffuser. Limited data showed that artificial acoustic excitation was effective in reducing the flow fluctuations, with a resultant increase in the pressure recovery, at low M(sub t).
Zaman, K. B. M. Q.↗
Plane-wave analysis of solar acoustic-gravity waves: A (slightly) new approach
The plane-wave decomposition of the acoustic-gravity wave effects observed in the photosphere provides a computationally efficient technique that probes the structure of the upper convective zone and boundary. In this region, the flat sun approximation is considered as being reasonably accurate. A technique to be used for the systematic plane-wave analysis of Michelson Doppler imager data, as part of the solar oscillations investigation, is described. Estimates of sensitivity are presented, and the effects of using different planar mappings are discussed. The technique is compared with previous approaches to the three dimensional plane-wave problem.
Bogart, Richard S.↗
Active Wave Propagation and Sensing in Plates
Health monitoring of aerospace structures can be done using an active interrogation approach with diagnostic Lamb waves. Piezoelectric patches are often used to generate the waves, and it is helpful to understand how these waves propagate through a structure. To give a basic understanding of the actual physical process of wave propagation, a model is developed to simulate asymmetric wave propagation in a panel and to produce a movie of the wave motion. The waves can be generated using piezoceramic patches of any size or shape. The propagation, reflection, and interference of the waves are represented in the model. Measuring the wave propagation is the second important aspect of damage detection. Continuous sensors are useful for measuring waves because of the distributed nature of the sensor and the wave. Two sensor designs are modeled, and their effectiveness in measuring acoustic waves is studied. The simulation model developed is useful to understand wave propagation and to optimize the type of sensors that might be used for health monitoring of plate-like structures.
Ghoshal, Anindya↗
The Airframe Noise Reduction Challenge
The NASA goal of reducing external aircraft noise by 10 dB in the near-term presents the acoustics community with an enormous challenge. This report identifies technologies with the greatest potential to reduce airframe noise. Acoustic and aerodynamic effects will be discussed, along with the likelihood of industry accepting and implementing the different technologies. We investigate the lower bound, defined as noise generated by an aircraft modified with a virtual retrofit capable of eliminating all noise associated with the high lift system and landing gear. However, the airframe noise of an aircraft in this 'clean' configuration would only be about 8 dB quieter on approach than current civil transports. To achieve the NASA goal of 10 dB noise reduction will require that additional noise sources be addressed. Research shows that energy in the turbulent boundary layer of a wing is scattered as it crosses trailing edge. Noise generated by scattering is the dominant noise mechanism on an aircraft flying in the clean configuration. Eliminating scattering would require changes to much of the aircraft, and practical reduction devices have yet to receive serious attention. Evidence suggests that to meet NASA goals in civil aviation noise reduction, we need to employ emerging technologies and improve landing procedures; modified landing patterns and zoning restrictions could help alleviate aircraft noise in communities close to airports.
Lockard, David P.↗