Search NASA⌕ Search

SEARCH · Search NASA

Results for “large”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 415 records · Page 23

Longitudinal Aerodynamic Characteristics to Large Angles of Attack of a Cruciform Missile Configuration at a Mach Number of 2

The lift, pitching-moment, and drag characteristics of a missile configuration having a body of fineness ratio 9.33 and a cruciform triangular wing and tail of aspect ratio 4 were measured at a Mach number of 1.99 and a Reynolds number of 6.0 million, based on the body length. The tests were performed through an angle-of-attack range of -5 deg to 28 deg to investigate the effects on the aerodynamic characteristics of roll angle, wing-tail interdigitation, wing deflection, and interference among the components (body, wing, and tail). Theoretical lift and moment characteristics of the configuration and its components were calculated by the use of existing theoretical methods which have been modified for application to high angles of attack, and these characteristics are compared with experiment. The lift and drag characteristics of all combinations of the body, wing, and tail were independent of roll angle throughout the angle-of-attack range. The pitching-moment characteristics of the body-wing and body-wing-tail combinations, however, were influenced significantly by the roll angle at large angles of attack (greater than 10 deg). A roll from 0 deg (one pair of wing panels horizontal) to 45 deg caused a forward shift in the center of pressure which was of the same magnitude for both of these combinations, indicating that this shift originated from body-wing interference effects. A favorable lift-interference effect (lift of the combination greater than the sum of the lifts of the components) and a rearward shift in the center of pressure from a position corresponding to that for the components occurred at small angles of attack when the body was combined with either the exposed wing or tail surfaces. These lift and center-of-pressure interference effects were gradually reduced to zero as the angle of attack was increased to large values. The effect of wing-tail interference, which influenced primarily the pitching-moment characteristics, is dependent on the distance between the wing trailing vortex wake and the tail surfaces and thus was a function of angle of attack, angle of roll, and wing-tail interdigitation. Although the configuration at zero roll with the wing and tail in line exhibited the least center-of-pressure travel, the configuration with the wing and tail interdigitated had the least change in wing-tail interference over the angle-of-attack range. The lift effectiveness of the variable-incidence wing was reduced by more than 70 percent as a result of an increase in the combined angle of attack and wing incidence from 0 deg to 40 deg. The wing-tail interference (effective downwash at the tail) due to wing deflection was nearly zero as a result of a region of negative vorticity shed from the inboard portion of the wing. The lift characteristics of the configuration and its components were satisfactorily predicted by the calculated results, but the pitching moments at large angles of attack were not because of the influence of factors for which no adequate theory is available, such as the variation of the crossflow drag coefficient along the body and the effect of the wing downwash field on the afterbody loading.

Spahr, J. R.↗

Finite element analysis of large transient elastic-plastic deformations of simple structures, with application to the engine rotor fragment containment/deflection problem

Assumed-displacement versions of the finite-element method are developed to predict large-deformation elastic-plastic transient deformations of structures. Both the conventional and a new improved finite-element variational formulation are derived. These formulations are then developed in detail for straight-beam and curved-beam elements undergoing (1) Bernoulli-Euler-Kirchhoff or (2) Timoshenko deformation behavior, in one plane. For each of these categories, several types of assumed-displacement finite elements are developed, and transient response predictions are compared with available exact solutions for small-deflection, linear-elastic transient responses. The present finite-element predictions for large-deflection elastic-plastic transient responses are evaluated via several beam and ring examples for which experimental measurements of transient strains and large transient deformations and independent finite-difference predictions are available.

Wu, R. W.↗

A bibliographical surveys of large-scale systems

A limited, partly annotated bibliography was prepared on the subject of large-scale system control. Approximately 400 references are divided into thirteen application areas, such as large societal systems and large communication systems. A first-author index is provided.

Corliss, W. R.↗

Applications of symbolic computing methods to the dynamic analysis of large systems

Since the symbolic computing language is very well suited to the operations with algebraic equations, techniques use the transfer function concept as a tool for the analysis of large linear dynamic systems. Techniques were coded in the experimental symbolic computer language FORMAC. The first of these approaches, REDUCE 1, establishes the techniques and a computer program to symbolically reduce arbitrary block diagrams associated with large systems for desired transfer functions. Symbolic closed form solutions are determined in several forms including an expanded form in terms of the driving frequencies and system constants. Programs are also written to numerically evaluate the symbolic solutions. A second computer program, REDUCE 2, is also based on the use of symbolic computing methods and was written to accommodate large engineering systems.

Lorenzo, C. F.↗

Stability of large-scale systems with stable and unstable subsystems.

The purpose of this paper is to develop new methods for constructing vector Liapunov functions and broaden the application of Liapunov's theory to stability analysis of large-scale dynamic systems. The application, so far limited by the assumption that the large-scale systems are composed of exponentially stable subsystems, is extended via the general concept of comparison functions to systems which can be decomposed into asymptotically stable subsystems. Asymptotic stability of the composite system is tested by a simple algebraic criterion. With minor technical adjustments, the same criterion can be used to determine connective asymptotic stability of large-scale systems subject to structural perturbations. By redefining the constraints imposed on the interconnections among the subsystems, the considered class of systems is broadened in an essential way to include composite systems with unstable subsystems. In this way, the theory is brought substantially closer to reality since stability of all subsystems is no longer a necessary assumption in establishing stability of the overall composite system.

Grujic, Lj. T.↗

Large-scale negative polarity magnetic fields on the sun and particle-emitting flares

Some observational facts about the large-scale patterns formed by solar negative polarity magnetic fields during the 19th and 20th cycles of solar activity are presented. The close relation of the position of occurrence of very large flares accompanied by cosmic ray and PCA events as well as other phenomena of solar activity during the declining part of the 19th cycle of the regularities in the internal structure of large scale negative polarity features are demonstrated.

Bumba, V.↗

Stability of large-scale systems under structural perturbations.

A large-scale system is considered as a system constituted of subsystems which may be connected or disconnected from each other during operation. A new concept of connective stability is introduced by which a large-scale system is regarded as stable if it remains stable (in the sense of Lyapunov) under structural perturbations produced by the on-off participation of the subsystems. Algebraic conditions are developed that guarantee exponential connective stability of large-scale systems which may be composed of linear and nonlinear time-varying subsystems coupled by linear or nonlinear connections.

Siljak, D. D.↗

On large-scale system stability.

A large-scale system is considered as a system constituted of subsystems which may be connected or disconnected from each other during operation. A new notion of connective stability is introduced by which a large-scale system is regarded as stable if it remains stable (in the sense of Liapunov) under structural perturbations produced by the on-off participation of the subsystems. Algebraic conditions are developed that guarantee exponential connective stability in large-scale systems which may be composed of linear and nonlinear subsystems coupled by linear or nonlinear connections.

Siljak, D. D.↗

Rotor dynamic considerations for large wind power generator systems

Successful large, reliable, low maintenance wind turbines must be designed with full consideration for minimizing dynamic response to aerodynamic, inertial, and gravitational forces. Much of existing helicopter rotor technology is applicable to this problem. Compared with helicopter rotors, large wind turbines are likely to be relatively less flexible with higher dimensionless natural frequencies. For very large wind turbines, low power output per unit weight and stresses due to gravitational forces are limiting factors. The need to reduce rotor complexity to a minimum favors the use of cantilevered (hingeless) rotor configurations where stresses are relieved by elastic deformations.

Ormiston, R. A.↗

Procedures for experimental measurement and theoretical analysis of large plastic deformations

Theoretical equations are derived and analytical procedures are presented for the interpretation of experimental measurements of large plastic strains in the surface of a plate. Orthogonal gage lengths established on the metal surface are measured before and after deformation. The change in orthogonality after deformation is also measured. Equations yield the principal strains, deviatoric stresses in the absence of surface friction forces, true stresses if the stress normal to the surface is known, and the orientation angle between the deformed gage line and the principal stress-strain axes. Errors in the measurement of nominal strains greater than 3 percent are within engineering accuracy. Applications suggested for this strain measurement system include the large-strain-stress analysis of impact test models, burst tests of spherical or cylindrical pressure vessels, and to augment small-strain instrumentation tests where large strains are anticipated.

Morris, R. E.↗

Finite element formulations for problems of large elastic-plastic deformation

An Eulerian finite element formulation is presented for problems of large elastic-plastic flow. The method is based on Hill's variational principle for incremental deformations, and is suited to isotropically hardening Prandtl-Reuss materials. The formulation is given in a manner which allows any conventional finite element program, for "small strain" elasticplastic analysis, to be simply and rigorously adapted to problems involving arbitrary amounts of deformation and arbitrary levels of stress in comparison to plastic deformation moduli. The method is applied to a necking bifurcation analysis of a bar in plane-strain tension. A unified general formulation of finite element equations, both Lagrangian and Eulerian, for large deformations, with arbitrary choice of the conjugate stress and strain measures, and a discussion is given of other proposed formulations for elastic-plastic finite element analysis at large strain.

Mcmeeking, R. M.↗

Asymptotic stability and instability of large-scale systems

The purpose of this paper is to develop new methods for constructing vector Lyapunov functions and broaden the application of Lyapunov's theory to stability analysis of large-scale dynamic systems. The application, so far limited by the assumption that the large-scale systems are composed of exponentially stable subsystems, is extended via the general concept of comparison functions to systems which can be decomposed into asymptotically stable subsystems. Asymptotic stability of the composite system is tested by a simple algebraic criterion. By redefining interconnection functions among the subsystems according to interconnection matrices, the same mathematical machinery can be used to determine connective asymptotic stability of large-scale systems under arbitrary structural perturbations.

Grujic, L. T.↗

Exponential stability of large-scale discrete systems

The concept of vector Liapunov functions is used to obtain conditions for the exponential stability of large-scale discrete systems which can be decomposed into a number of interconnected subsystems with the same stability property. Both the structurally invariant composite systems and the large-scale systems under structural perturbations are considered. Connective absolute stability of a large-scale system composed of the interconnected Lur'e-type subsystems is defined and resolved in this context, resulting in a computationally and conceptually attractive alternative to a straightforward stability analysis of the system by frequency-domain criteria.

Grujic, L. T.↗

A large area multi-element telescope for measuring the cosmic ray isotope composition

To measure the isotopic composition of cosmic rays up to Fe an instrument is needed with good isotopic resolution and a large exposure. The large geometry needed for a balloon-borne detector has been obtained with large mapped detectors and a trajectory determining spark chamber. The instrument achieves isotopic resolution only for stopping particles. For low charge particles where there is no Cerenkov response the detector works as a multiple dE/dx-Range-Energy detector. For higher charges where scintillator saturation becomes important it becomes a Cerenkov-range measurement.

Fisher, A. J.↗

Experimental feasibility study of the application of magnetic suspension techniques to large-scale aerodynamic test facilities

Based on the premises that (1) magnetic suspension techniques can play a useful role in large-scale aerodynamic testing and (2) superconductor technology offers the only practical hope for building large-scale magnetic suspensions, an all-superconductor three-component magnetic suspension and balance facility was built as a prototype and was tested successfully. Quantitative extrapolations of design and performance characteristics of this prototype system to larger systems compatible with existing and planned high Reynolds number facilities have been made and show that this experimental technique should be particularly attractive when used in conjunction with large cryogenic wind tunnels.

Zapata, R. N.↗

Large variable conductance heat pipe. Transverse header

The characteristics of gas-loaded, variable conductance heat pipes (VCHP) are discussed. The difficulties involved in developing a large VCHP header are analyzed. The construction of the large capacity VCHP is described. A research project to eliminate some of the problems involved in large capacity VCHP operation is explained.

Edelstein, F.↗

Some notions of decentralization and coordination in large-scale dynamic systems

Some notions of decentralization and coordination in the control of large-scale dynamic systems are discussed. Decentralization and coordination have always been important concepts in the study of large systems. Roughly speaking decentralization is the process of dividing a large problem into subproblems so that it can be handled more easily. Coordination is the manipulation of the subproblem so that the original problem is solved. The various types of decentralization and coordination that have been used to control dynamic systems are discussed. The emphasis was to distinguish between on-line and off-line operations to understand the results available by indicating the aspects of the problem which are decentralized.

Chong, C. Y.↗

Large area double scattering telescope for balloon-borne studies of neutrons and gamma rays

A large area double scattering telescope for balloon-borne research is described. It measures the flux, energy and direction of 2-100 MeV neutrons and 0.5-30 MeV gamma rays. These measurements are made using time-of-flight and pulse height analysis techniques with two large tanks of mineral oil liquid scintillator. Results from Monte Carlo calculations of the efficiency, energy resolution and angular resolution are presented and the electronics implementation for the processing of 80 photomultiplier tubes signals will be discussed. The detector weighs 800 kg with a large part of this weight being the liquid scintillator (320 kg). It will be flown at 3 mbars for flight durations up to 40 hours. The first flight is planned for Spring, 1975.

Zych, A. D.↗