Azimuth Track Level Compensation to Reduce Blind Pointing Errors of the Deep Space Network Antennas
The Beam wave-guide antennas of the NASA Deep Space Network are -wheel and track- antennas.
Antenna↗
SEARCH · Search NASA
Results for “tracking errors”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A sampled-data pursuit tracking model.
Sampled data pursuit hand-tracking model for human operator
TRACKING STUDY↗
Navigation and guidance analysis for a Mars mission Interim study report
Error propagation program simulating earth based tracking for navigation and guidance analysis of Mars mission
SPACECRAFT TRACKING↗
Soft-error generation due to heavy-ion tracks in bipolar integrated circuits
Both bipolar and MOS integrated circuits have been empirically demonstrated to be susceptible to single-particle soft-error generation, commonly referred to as single-event upset (SEU), which is manifested in a bit-flip in a latch-circuit construction. Here, the intrinsic characteristics of SEU in bipolar (static) RAM's are demonstrated through results obtained from the modeling of this effect using computer circuit-simulation techniques. It is shown that as the dimensions of the devices decrease, the critical charge required to cause SEU decreases in proportion to the device cross-section. The overall results of the simulations are applicable to most integrated circuit designs.
Zoutendyk, J. A.↗
Preliminary Error Characterization and Parametric Error Model for the Automatic Dependent Surveillance - Contract Extended Projected Profile Message
A critical component of Trajectory-Based Operations (TBO) is the ability for a consistent and accurate 4-dimensional trajectory (4DT) to be shared and synchronized between airborne and ground systems as well as amongst various ground automation systems. The Aeronautical Telecommunication Network—Baseline 2 (ATN-B2) standard defines the Extended Projected Profile (EPP) trajectory that can be sent via Automatic Dependent Surveillance-Contract (ADS-C) from an aircraft to ground automation. The EPP trajectory message contains a representation of the reference trajectory from an aircraft’s Flight Management System (FMS). In this work, a set of scenarios were run in a high-fidelity aircraft and FMS simulation to perform an initial characterization of EPP trajectory errors under a given set of conditions. The parameters investigated were the route length, route type, wind magnitude error, wind direction error, and with and without a required time-of-arrival (RTA) constraint. In addition, linear regression was used to identify a set of EPP error models for the cross-track, vertical, and time errors.
Guerreiro, Nelson M.↗
Orbit determination for low-thrust spacecraft: Concepts and analysis
Earth-based orbit determination capability for SEP spacecraft in multistation tracking and in thrust subsystem error modeling is described. Five different tracking strategies are applied to a 15 day segment of an Encke rendezvous mission. Both optimal and suboptimal orbit determination performance are determined for a wide range of process noise parameter values. The multi-station tracking techniques are found to be extremely effective, reducing orbit determination errors by orders of magnitude over that obtained with conventional single-station tracking. Explicitly differenced multistation data (QVLBI) is found to be least sensitive to gross modeling errors, but if a reasonably good process noise model is available, explicit differencing is not required.
Mcdanell, J. P.↗
Harmonic drive gear error: Characterization and compensation for precision pointing and tracking
Imperfections and geometry effects in harmonic drive gear reducers cause a cyclic gear error, which at a systems level, results in high frequency torque fluctuations. To address this problem, gear error testing was performed on a wide variety of sizes and types of harmonic drives. It was found that although all harmonic drives exhibit a significant first harmonic, higher harmonics varied greatly with each unit. From life tests, small changes were found in harmonic content, phase shift, and error magnitude (on the order of .008 deg peak-to-peak maximum) occurred for drives with many millions of degrees of output travel. Temperature variations also influenced gear error. Over a spread of approximately 56 C (100 F), the error varied in magnitude approximately 20 percent but changes in a repeatable and predictable manner. Concentricity and parallelness tests of harmonic drive parts resulted in showing alignment influence gear error amplitude. Tests on dedoidaled harmonic drives showed little effect on gear error; surprisingly, in one case for a small drive, gear error actually improved. Electronic compensation of gear error in harmonic drives was shown to be substantially effective for units that are first harmonic dominant.
Nye, Ted W.↗
Ionospheric range-rate effects in satellite-to-satellite tracking
Ionospheric range and range rate corrections in satellite-to-satellite tracking were investigated and the magnitude of errors that have to be considered for communications between satellites and related experiments was defined. The major causes of the sudden and sometimes large variations apparent in the ionospheric range and range rate corrections along the satellite arc are the geometric effects of the raypath and the curved ionosphere, and the localized perturbations in electron density along the satellite-to-satellite line of sight. Ionospheric tracking errors are greatly effected by the following parameters, whose influence was thoroughly investigated: satellite height, height of maximum electron density, localized ionospheric perturbations and gradients, and electron density variations with diurnal, day-to-day, seasonal, and solar cycle patterns. The results point to the need of using a sophisticated modeling approach incorporating daily solar data, and where possible actual ionospheric measurements as update information. Simulations were performed for satellites at various heights: Apollo, Geos, and Nimbus tracked by ATS-6; and in two different geometric configurations: coplanar and perpendicular orbits.
Bent, R. B.↗
GPS vertical axis performance enhancement for helicopter precision landing approach
Several areas were investigated for improving vertical accuracy for a rotorcraft using the differential Global Positioning System (GPS) during a landing approach. Continuous deltaranging was studied and the potential improvement achieved by estimating acceleration was studied by comparing the performance on a constant acceleration turn and a rough landing profile of several filters: a position-velocity (PV) filter, a position-velocity-constant acceleration (PVAC) filter, and a position-velocity-turning acceleration (PVAT) filter. In overall statistics, the PVAC filter was found to be most efficient with the more complex PVAT performing equally well. Vertical performance was not significantly different among the filters. Satellite selection algorithms based on vertical errors only (vertical dilution of precision or VDOP) and even-weighted cross-track and vertical errors (XVDOP) were tested. The inclusion of an altimeter was studied by modifying the PVAC filter to include a baro bias estimate. Improved vertical accuracy during degraded DOP conditions resulted. Flight test results for raw differential results excluding filter effects indicated that the differential performance significantly improved overall navigation accuracy. A landing glidepath steering algorithm was devised which exploits the flexibility of GPS in determining precise relative position. A method for propagating the steering command over the GPS update interval was implemented.
Denaro, Robert P.↗
Real-Time Optimization Of Receiver Bandwidth
Estimates of signal and noise spectra enhance reception of weak signals. Carrier-tracking phase-locked loop represented by linear mathematical model at small rms phase errors. Loop continuously generates estimates of received phase. Bandwidth (in effect, scale of complex-frequency variable p) optimized to minimize rms phase error. Minimum signals tracked 5 to 15 dB below those tracked by current receivers. Improvement accomplished by use of bandwidths of 0.1 to 1.0 Hz, in contrast with 3-Hz bandwidth in current use. Principle of real-time optimization of bandwidth adapted to other situations to enhance reception of weak signals otherwise "buried" in noise.
Vilnrotter, V. A.↗
Optimizing the fine lock performance of the Hubble Space Telescope fine guidance sensors
This paper summarizes the on-orbit performance to date of the three Hubble Space Telescope Fine Guidance Sensors (FGS's) in Fine Lock mode, with respect to acquisition success rate, ability to maintain lock, and star brightness range. The process of optimizing Fine Lock performance, including the reasoning underlying the adjustment of uplink parameters, and the effects of optimization are described. The Fine Lock optimization process has combined theoretical and experimental approaches. Computer models of the FGS have improved understanding of the effects of uplink parameters and fine error averaging on the ability of the FGS to acquire stars and maintain lock. Empirical data have determined the variation of the interferometric error characteristics (so-called 's-curves') between FGS's and over each FGS field of view, identified binary stars, and quantified the systematic error in Coarse Track (the mode preceding Fine Lock). On the basis of these empirical data, the values of the uplink parameters can be selected more precisely. Since launch, optimization efforts have improved FGS Fine Lock performance, particularly acquisition, which now enjoys a nearly 100 percent success rate. More recent work has been directed towards improving FGS tolerance of two conditions that exceed its original design requirements. First, large amplitude spacecraft jitter is induced by solar panel vibrations following day/night transitions. This jitter is generally much greater than the FGS's were designed to track, and while the tracking ability of the FGS's has been shown to exceed design requirements, losses of Fine Lock after day/night transitions are frequent. Computer simulations have demonstrated a potential improvement in Fine Lock tracking of vehicle jitter near terminator crossings. Second, telescope spherical aberration degrades the interferometric error signal in Fine Lock, but use of the FGS two-thirds aperture stop restores the transfer function with a corresponding loss of throughput. This loss requires the minimum brightness of acquired stars to be about one magnitude brighter than originally planned.
Eaton, David J.↗
Orbit determination requirements for TOPEX
The error sensitivity of orbit calculations in support of the NASA Ocean Surface Topography Mapping Experiment (TOPEX), which require an accuracy on the order of 5 cm, is investigated. The contributions of errors in the gravitational, atmospheric drag and solar radiation pressure models to the computed orbit are analyzed for the cases of an ideal data distribution and realistic laser ranging data coverage. It is found that the major contributor to radial orbital error is the error in the geopotential model, accounting for orbital errors of 30 to 70 cm, with the effects of solar radiation pressure, drag modeling, tracking station coordinate errors making lesser contributions. It is concluded that TOPEX accuracy goals cannot be met using ground-based laser ranging data without improving the geopotential model.
Tapley, B. D.↗
Improved Carrier Tracking by Smoothing Estimators
Smoothing as a way to improve the carrier phase estimation is proposed and analyzed. The performance of first and second order Kalman optimum smoothers are investigated. This performance is evaluated in terms of steady state covariance error computation, dynamic tracking, and noise response. It is shown that with practical amounts of memory, a second order smoother can have a position error due to an acceleration or jerk step input less than any prescribed maximum. As an example of importance to the NASA Deep Space Network, a second order smoother can be used to track the Voyager spacecraft at Uranus and Neptune encounters with significantly better performance than a second order phase locked loop.
Raez, C. A. P.↗
Improved carrier tracking by smoothing estimators
Smoothing as a way to improve the carrier phase estimation is proposed and analyzed. The performance of first and second order Kalman optimum smoothers are investigated. This performance is evaluated in terms of steady state covariance error computation, dynamic tracking, and noise response. It is shown that with practical amounts of memory, a second order smoother can have a position error due to an acceleration or jerk step input less than any prescribed maximum. As an example of importance to the NASA Deep Space Network, a second order smoother can be used to track the Voyager spacecraft at Uranus and Neptune encounters with significantly better performance than a second order phase locked loop.
Pomalaza-Raez, C. A.↗
C-band radar calibration using GEOS-3
The various methods of determining tracking radar measurement error parameters are described, along with the projected accuracy of results. Typical examples and results for calibration of radars tracking the GEOS-3 satellite are presented.
Krabill, W. B.↗
Compensatory tracking with visual and tactile displays.
Visual and tactile display for compensatory tracking, noting conditions for minimum error, mean square error, etc
SENSORY FEEDBACK↗
Spacecraft induced error sources
The attitude control and measurement systems aboard the LANDSAT 2 and D satellites are described and associated errors are discussed. Also, the ephemeris errors from various tracking systems are examined. Use of the Global Positioning System and improved attitude control instruments is expected to greatly reduce the errors in LANDSAT D in comparison with previous LANDSATS.
Heuberger, H. S.↗
Terminal area automatic navigation, guidance, and control research using the Microwave Landing System (MLS). Part 3: A comparison of waypoint guidance algorithms for RNAV/MLS transition
The results of an investigation carried out for the Langley Research Center Terminal Configured Vehicle Program are presented. The investigation generated and compared three path update algorithms designed to provide smooth transition for an aircraft guidance system from DME, VORTAC, and barometric navaids to the more precise MLS by modifying the desired 3-D flight path. The first, called the Zero Cross Track, eliminates the discontinuity in cross track and altitude error by designating the first valid MLS aircraft position as the desired first waypoint, while retaining all subsequent waypoints. The discontinuity in track angle is left unaltered. The second, called the Tangent Path also eliminates the discontinuity in cross track and altitude and choose a new desired heading to be tangent to the next oncoming circular arc turn. The third, called the Continued Track eliminates the discontinuity in cross track, altitude and track angle by accepting the current MLS position and track angle as the desired ones and recomputes the location of the next waypoint. A method is presented for providing a waypoint guidance path reconstruction which treats turns of less than, and greater than, 180 degrees in a uniform manner to construct the desired path.
Pines, S.↗