Search NASA⌕ Search

SEARCH · Search NASA

Results for “Aircraft Stability”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 433 records · Page 24
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Eigenstructure assignment for the control of highly augmented aircraft

Eigenstructure assignment is utilized to design flight control laws for aircraft with many control effectors. It is shown that a previous eigenstructure design for the flight propulsion control coupling (FPCC) aircraft lateral dynamics with three control surfaces exhibits a lack of stability robustness because the control distribution matrix is nearly rank-deficient. A method is mapped back, reducing the control space to two dimensions by using the singular value decomposition. After the design is complete, the controller is mapped back to the original three-dimensional control space. This design approach yields a controller with both smaller gains and improved multivariable stability margins at the aircraft inputs. An interesting characteristics of the control mapping, as applied to the given example, is that the most effective inputs have the larger gains while the less effective inputs have smaller gains.

Sobel, Kenneth M.↗
NASA NTRS1989

Impact cratering in low-gravity environments - Results of reconnaissance experimentation on the NASA KC-135A reduced-gravity aircraft

A program of flight experimentation was performed on the NASA KC-135A reduced-gravity aircraft to evaluate the potential for conducting impact experiments in reduced-gravity environments and to collect impact-cratering data at gravity levels below 1 g. Lead pellets were launched into coarse-grained sand at velocities of about 65-130 m/sec while the gravitational acceleration was maintained at 0.59-0.05 g. A total of 64 craters were studied and, after allowance is made for the atmospheric pressure over the target (0.83 atm), their diameters are found to have been consistent with scaling predictions made on the basis of ground-based experimentation. Formation times were also obtained for 33 of these craters and constitute a distribution that is somewhat different from that described by the ground-based data. Nevertheless, the KC-135 data set as a whole falls on the trend formed by the ground-based results. The overall agreement between the two data sets attests to the stability of the aircraft as a platform for impact experimentation.

Cintala, M. J.↗
NASA NTRS1994

Spectral control of an alexandrite laser for an airborne water-vapor differential absorption lidar system

A narrow-linewidth pulsed alexandrite laser has been greatly modified for improved spectral stability in an aircraft environment, and its operation has been evaluated in the laboratory for making water-vapor differential absorption lidar measurements. An alignment technique is described to achieve the optimum free spectral range ratio for the two etalons inserted in the alexandrite laser cavity, and the sensitivity of this ratio is analyzed. This technique drastically decreases the occurrence of mode hopping, which is commonly observed in a tunable, two-intracavity-etalon laser system. High spectral purity (greater than 99.85%) at 730 nm is demonstrated by the use of a water-vapor absorption line as a notch filter. The effective cross sections of 760-nm oxygen and 730-nm water-vapor absorption lines are measured at different pressures by using this laser, which has a finite linewidth of 0.02 cm(exp -1) (FWHM). It is found that for water-vapor absorption linewidths greater than 0.04 cm(exp -1) (HWHM), or for altitudes below 10 km, the laser line can be considered monochromatic because the measured effective absorption cross section is within 1% of the calculated monochromatic cross section. An analysis of the environmental sensitivity of the two intracavity etalons is presented, and a closed-loop computer control for active stabilization of the two intracavity etalons in the alexandrite laser is described. Using a water-vapor absorption line as a wavelength reference, we measure a long-term frequency drift (approximately 1.5 h) of less than 0.7 pm in the laboratory.

Ponsardin, Patrick↗
NASA NTRS1994

Techniques to improve maneuver stability characteristics of a nonlinear wide-body transport airplane in cruise flight

The maneuver control stability characteristics of an aircraft are a flying qualities parameter of critical importance, to ensure structural protection as well as adequate predictability to the pilot. Currently, however, maneuver stability characteristics are not uniquely addressed in the Federal Aviation Regulations (FAR) Part 25, for transport aircraft. In past transport category certification programs, the Federal Aviation Administration (FAA) has used a combination of requirements (longitudinal control, vibration and buffeting, high-speed characteristics, and out-of-trim characteristics) to ensure safe and controllable maneuver stability characteristics over a range of flight conditions and airplane configurations. Controversies exist regarding each of these regulations, however, and considerable expenditures in terms of design studies and testing time have resulted from the requirements. It is also recognized that additional engineering guidance is needed for identifying acceptable nonlinear maneuver stability characteristics, particularly as they relate to relaxed stability, highly augmented transport configurations. The current trend in large aircraft design is toward relaxed, or even negative, static margins for improved fuel efficiency. The advanced flight control systems developed for these aircraft, in many instances, have rendered current aforementioned maneuver stability criteria either too stringent or of little practical use. Current design requirements do not account for these advanced designs. The objective was to evaluate a broad spectrum of linear and nonlinear longitudinal stability characteristics to generate data for defining satisfactory and unacceptable maneuver characteristics, as defined by pilot opinion. Primary emphasis was placed on two techniques of varying column force per normal acceleration. This study was a joint venture with four pilots participating; one from NASA, one from the FAA, and two from industry.

Grantham, William D.↗
NASA NTRS1974

Analysis of a flare-director concept for an externally blown flap STOL aircraft

A flare-director concept involving a thrust-required flare-guidance equation was developed and tested on a moving-base simulator. The equation gives a signal to command thrust as a linear function of the errors between the variables thrust, altitude, and altitude rate and corresponding values on a desired reference flare trajectory. During the simulator landing tests this signal drove either the horizontal command bar of the aircraft's flight director or a thrust-command dot on a head-up virtual-image display of a flare director. It was also used as the input to a simple autoflare system. An externally blown flap STOL (short take-off and landing) aircraft (with considerable stability and control augmentation) was modeled for the landing tests. The pilots considered the flare director a valuable guide for executing a proper flare-thrust program under instrument-landing conditions, but were reluctant to make any use of the head-up display when they were performing the landings visually.

Middleton, D. B.↗
NASA NTRS1975

Introduction to the aerodynamics of flight

General concepts of the aerodynamics of flight are discussed. Topics considered include: the atmosphere; fluid flow; subsonic flow effects; transonic flow; supersonic flow; aircraft performance; and stability and control.

Talay, T. A.↗
NASA NTRS1976

Wind tunnel tests of the dynamic characteristics of the fluidic rudder

The fourth phase is given of a continuing program to develop the means to stabilize and control aircraft without moving parts or a separate source of power. Previous phases have demonstrated the feasibility of (1) generating adequate control forces on a standard airfoil, (2) controlling those forces with a fluidic amplifier and (3) cascading non-vented fluidic amplifiers operating on ram air supply pressure. The foremost objectives of the fourth phase covered under Part I of this report were to demonstrate a complete force-control system in a wind tunnel environment and to measure its static and dynamic control characteristics. Secondary objectives, covered under Part II, were to evaluate alternate configurations for lift control. The results demonstrate an overall response time of 150 msec, confirming this technology as a viable means for implementing low-cost reliable flight control systems.

Belsterling, C. A.↗
NASA NTRS1982

An in-flight investigation of pilot-induced oscillation suppression filters during the fighter approach and landing task

An investigation of pilot-induced oscillation suppression (PIOS) filters was performed using the USAF/Flight Dynamics Laboratory variable stability NT-33 aircraft, modified and operated by Calspan. This program examined the effects of PIOS filtering on the longitudinal flying qualities of fighter aircraft during the visual approach and landing task. Forty evaluations were flown to test the effects of different PIOS filters. Although detailed analyses were not undertaken, the results indicate that PIOS filtering can improve the flying qualities of an otherwise unacceptable aircraft configuration (Level 3 flying qualities). However, the ability of the filters to suppress pilot-induced oscillations appears to be dependent upon the aircraft configuration characteristics. Further, the data show that the filters can adversely affect landing flying qualities if improperly designed. The data provide an excellent foundation from which detail analyses can be performed.

Bailey, R. E.↗
NASA NTRS1982

An in-flight investigation of pilot-induced oscillation suppression filters during the fighter approach and landing task

An investigation of pilot-induced oscillation suppression (PIOS) filters was performed using the USAF/Flight Dynamics Laboratory variable stability NT-33 aircraft, modified and operated by Calspan. This program examined the effects of PIOS filtering on the longitudinal flying qualities of fighter aircraft during the visual approach and landing task. Forty evaluations were flown to test the effects of different PIOS filters. Although detailed analyses were not undertaken, the results indicate that PIOS filtering can improve the flying qualities of an otherwise unacceptable aircraft configuration (Level 3 flying qualities). However, the ability of the filters to suppress pilot-induced oscillations appears to be dependent upon the aircraft configuration characteristics. Further, the data show that the filters can adversely affect landing flying qualities if improperly designed. The data provide an excellent foundation from which detail analyses can be performed.

Bailey, R. E.↗
NASA NTRS1983

Flutter prediction for a wing with active aileron control

A method for predicting the vibrational stability of an aircraft with an analog active aileron flutter suppression system (FSS) is expained. Active aileron refers to the use of an active control system connected to the aileron to damp vibrations. Wing vibrations are sensed by accelerometers and the information is used to deflect the aileron. Aerodynamic force caused by the aileron deflection oppose wing vibrations and effectively add additional damping to the system.

Penning, K.↗
NASA NTRS1989

Unsteady aerodynamics and aeroelastic research at AFWAL

An efficient and accurate transonic unsteady aerodynamic method is needed for predicting flight loads, flutter and aeroelastic stability for advanced aircraft. There have been new developments and many improvements to older codes. XTRAN3S was improved and is a useful code for the near term. However, to predict the unsteady aerodynamics for high performance maneuvering aircraft, the Euler/Navier-Stokes codes must be extended and improved for complex 3-D configurations. The long term goal is development of Euler/Navier-Stokes unsteady aerodynamic methods for aeroelastic analysis.

Huttsell, L. J.↗
NASA NTRS1989

Aeroservoelastic wind-tunnel investigations using the Active Flexible Wing Model: Status and recent accomplishments

The status of the joint NASA/Rockwell Active Flexible Wing Wind-Tunnel Test Program is described. The objectives are to develop and validate the analysis, design, and test methodologies required to apply multifunction active control technology for improving aircraft performance and stability. Major tasks include designing digital multi-input/multi-output flutter-suppression and rolling-maneuver-load alleviation concepts for a flexible full-span wind-tunnel model, obtaining an experimental data base for the basic model and each control concept and providing comparisons between experimental and analytical results to validate the methodologies. The opportunity is provided to improve real-time simulation techniques and to gain practical experience with digital control law implementation procedures.

Noll, Thomas E.↗
NASA NTRS1989

Results of an A109 simulation validation and handling qualities study

The results for the validation of a mathematical model of the Agusta A109 helicopter, and subsequent use of the model as the baseline for a handling qualities study of cockpit centerstick requirements, are described. The technical approach included flight test, non-realtime analysis, and realtime piloted simulation. Results of the validation illustrate a time- and frequency-domain approach to the model and simulator issues. The final A109 model correlates well with the actual aircraft with the Stability Augmentation System (SAS) engaged, but is unacceptable without the SAS because of instability and response coupling at low speeds. Results of the centerstick study support the current U.S. Army handling qualities requirements for centerstick characteristics.

Eshow, Michelle M.↗