SEARCH · Search NASA

Results for “SET”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 433 records · Page 24

All sources NASA NTRS DOE OSTI

NASA NTRS1976

Compressor blade setting angle accuracy study, volume 1

The aerodynamic test of a small, single stage, highly loaded, axial flow transonic compressor is covered. The stage was modified by fabricating a 24 blade rotor with mis-set blades in a repeating pattern - two degrees closed from nominal, two degrees open from nominal and nominal. The unit was instrumented to determine overall performance and average blade element data. High-response, dynamic pressure probes were installed to record pressure patterns at selected points in the flowpath. Testing was conducted at speeds from 70 to 94% of design equivalent speed with a conventional casing and also with circumferential grooves over the rotor tip. Testing indicated severe performance penalties were incurred as a result of the mis-set blading. Lower flow, pressure ratio, and efficiency were observed for the stage with or without casing treatment. Periodic pressure variations were detected at every location where high response pressure sensors were located and were directly related to blading geometry.

Holman, F. F.↗

NASA NTRS1977

Pseudo noise test set operation manual

Pseudonoise (PN) test set was designed to provide a reliable, operationally simple unit which allows the previously mentioned analog rms end-to-end error measurement of most communication systems to be easily performed. It also provides a band-limited pseudorandom noise as input, thereby escaping the disadvantages of most deterministic signals while retaining the advantages of using true-band-limited noise. In addition, the PN test set has the capability to be used as a means with which the autocorrelation function and impulse response may be determined for certain systems.

Weathers, G.↗

NASA NTRS1977

A computerized traffic control algorithm to determine optimal traffic signal settings

An algorithm was developed to optimally control the traffic signals at each intersection using a discrete time traffic model applicable to heavy or peak traffic. Off line optimization procedures were applied to compute the cycle splits required to minimize the lengths of the vehicle queues and delay at each intersection. The method was applied to an extensive traffic network in Toledo, Ohio. Results obtained with the derived optimal settings are compared with the control settings presently in use.

Seldner, K.↗

NASA NTRS1977

AOIPS data base management systems support for GARP data sets

A data base management system is identified, developed to provide flexible access to data sets produced by GARP during its data systems tests. The content and coverage of the data base are defined and a computer-aided, interactive information storage and retrieval system, implemented to facilitate access to user specified data subsets, is described. The computer programs developed to provide the capability were implemented on the highly interactive, minicomputer-based AOIPS and are referred to as the data retrieval system (DRS). Implemented as a user interactive but menu guided system, the DRS permits users to inventory the data tape library and create duplicate or subset data sets based on a user selected window defined by time and latitude/longitude boundaries. The DRS permits users to select, display, or produce formatted hard copy of individual data items contained within the data records.

Gary, J. P.↗

NASA NTRS1979

LS47: A DSN station location set compatible with JPL development ephemeris DE108

An updated Deep Space Network station location set, LS47, is presented which is compatible with JPL Development Ephemeris DE108. Analytic procedures for linearly correcting station spin axis and longitude estimates for an ephemeris update based on Brouwer-Clemence Set III parameters are briefly discussed. The validity of this technique is demonstrated by a comparison of a linearly corrected solution with one explicitly determined by reprocessing the data. A mission data base, including Viking 1 and 2 encounter data, is first used to obtain an updated DE96 compatible station location solution, LS46, which in turn is adjusted to form the DE108 solution, LS47. Improved station Z-heights are estimated by using available very long baseline interferometry data. Spin axis differences between LS46 and LS47 are relatively insignificant; however, the ephemeris change introduces a -0.8 x 10 to the -5 power degree rotation in the DE96 longitude ephemeris.

Ellis, J.↗

NASA NTRS1977

Set-point control of nonlinear systems

A method of nonlinear stochastic control is applied to the problem of providing set-point control. The procedure is illustrated for a nonlinear second-order plant. The controller design uses a variation of the 'multiple-model adaptive control' approach. Specific problems related to the design are investigated, including learning time and set-point accuracy dependence on the number of approximating models, chord versus tangent approximations, and the a priori Markov switching parameter values. Simulations are provided for different situations under various levels of measurement noise.

Vanlandingham, H. F.↗

NASA NTRS1981

SRB dewatering set

The system components and operation of the space shuttle solid rocket booster (SRB) dewatering set are described. The SRB dewatering set consists of a nozzle plug, control console, remote control unit, power distribution unit, umbilical cable, interconnect cables, and various handling and storage items. The nozzle plug (NP) is a remotely controlled, tethered underwater vehicle that is launched from the retrieval vessel (RV) by a crane, descends down the side of the SRB, and is positioned below the SRB nozzle. A TV camera mounted at the top of the NP central core is used by the control console operator to visually guide the NP during descent and docking. The NP is then driven up and locked into the nozzle. Compressed air is passed through the umbilical from the RV, through the NP and into the SRB motor. The water inside the SRB is expelled causing the SRB to rotate to a near horizontal attitude on the surface of the water.

Wickham, R. E.↗

NASA NTRS1981

An algorithm for minimum-cost set-point ordering in a cryogenic wind tunnel

An algorithm for minimum cost ordering of set points in a cryogenic wind tunnel is developed. The procedure generates a matrix of dynamic state transition costs, which is evaluated by means of a single-volume lumped model of the cryogenic wind tunnel and the use of some idealized minimum-costs, which is evaluated by means of a single-volume lumped model of the cryogenic wind tunnel and the use of some idealized minimum-cost state-transition control strategies. A branch and bound algorithm is employed to determine the least costly sequence of state transitions from the transition-cost matrix. Some numerical results based on data for the National Transonic Facility are presented which show a strong preference for state transitions that consume to coolant. Results also show that the choice of the terminal set point in an open odering can produce a wide variation in total cost.

Tripp, J. S.↗

NASA NTRS1981

Recommended data sets, corn segments and spring wheat segments, for use in program development

The sets of Large Area Crop Inventory Experiment sites, crop year 1978, which are recommended for use in the development and evaluation of classification techniques based on LANDSAT spectral data are presented. For each site, the following exists: (1) accuracy assessment digitized ground truth; (2) a minimum of 5 percent of the scene ground truth identified as corn or spring wheat; and (3) at least four acquisitions of acceptable data quality during the growing season of the crop of interest. The recommended data sets consist of 41 corn/soybean sites and 17 spring wheat sites.

Austin, W. W.↗

NASA NTRS1982

The containment set approach to upsets in digital systems

An approach to the fault analysis of digital systems is proposed which combines faults, hardware, and software into one overall model. The model is useful for the consideration of intermittent/transient faults, and supports a new method, based on the concept of a containment set, for realizing transient fault tolerance without massive redundancy. The model also serves as the basis for a new approach to system fault tolerance evaluation and validation using a transition matrix defined in terms of the containment set. The application of upset theory to the design of transient fault-tolerant microprocessor controllers is discussed.

Glaser, R. E.↗

NASA NTRS1983

Argentina spectral-agronomic multitemporal data set

A multitemporal LANDSAT spectral data set was created. The data set is over five 5 nm-by-6 nm areas over Argentina and contains by field, the spectral data, vegetation type and cloud cover information.

Helmer, D.↗

NASA NTRS1983

Structure of the Saint Francois Mountains and surrounding lead belt, south east Missouri: Inferences from thermal IR and other data sets

Several digital data sets were registered to a common base map for southern Missouri. These registered data sets were examined in an attempt to improve our understanding of the crustal structure and the relationships between structure and Pb-Zn-Cu, Fe, Mn, and Ba ores in the area. Data included land station reading of gravity, geologic data, and Heat Capacity Mapping Mission (HCMM) images. The HCMM day infrared (IR) images of Missouri displayed linear features, which parallel a newly discovered NW-SE trending Bouguer gravity low. The structural pattern over the gravity low suggests vertical uplift of the low density crust via isostatic readjustment and consequent fracturing of the Paleozoic sedimentary cover. The presence of a gravity low is interesting because rifts are often sites of extensive mineralization. The HCMM thermal data were also examined in conjunction with digital topography, land use, and LANDSAT MSS data to understand the phenomena that produce linears on the HCMM day IR images. Finally, the kinds of information that can be extracted from day-night IR pairs are discussed.

Arvidson, R. E.↗

NASA NTRS1982

The containment set approach to digital system tolerance of lightning-induced transient faults

A fault model and a system model are necessary to assess the tolerance or resilience of a digital system to lightning-induced transients. It is noted that these models are usually developed separately. A new approach is outlined here for this assessment problem which combines the fault and system models into an overall model. With this approach, referred to as the containment set approach, an assessment of the effects of lightning-induced transients can be made in terms of a state transition matrix. This matrix can be generated by means of fault injection experiments. In addition, certain nonredundancy-oriented design alternatives to the achievement of lightning-induced transient tolerance in digital systems are indicated by the containment set approach.

Masson, G. M.↗

NASA NTRS1984

Mars polar volatiles: Topographic and geologic setting

Progress on a project to elucidate the geological and topographic setting of the Martian polar volatiles is reported. The following accomplishments are enumerated: (1) all of the Mariner 9 imaging data sets available through JPL were acquired and copied; (2) Mariner 9 imagery was investigated in terms of the accuracy of the imaging footprints, dark current, and residual image; (3) the transfer functions of both vidicons were investigated; and (4) the magnitude of the atmospheric scattering was examined.

Murray, B.↗

NASA NTRS1984

The Use of Available Potential Energy to Evaluate Two GLAS FGGE Data Sets

Meteorological data derived from satellites provided an essential component of the FGGE data sets, especially in data sparse regions of the globe. The impact of satellite derived observations on objective analyses and numerical model predictions are investigated. The FGGE data sets and resulting numerical forecasts and the ability to define the available potential energy of the atmosphere, and its relationship to synoptic scale features such as extratropical cyclones are studied.

Horn, L. H.↗

NASA NTRS1985

Generated spiral bevel gears: Optimal machine-tool settings and tooth contact analysis

Geometry and kinematic errors were studied for Gleason generated spiral bevel gears. A new method was devised for choosing optimal machine settings. These settings provide zero kinematic errors and an improved bearing contact. The kinematic errors are a major source of noise and vibration in spiral bevel gears. The improved bearing contact gives improved conditions for lubrication. A computer program for tooth contact analysis was developed, and thereby the new generation process was confirmed. The new process is governed by the requirement that during the generation process there is directional constancy of the common normal of the contacting surfaces for generator and generated surfaces of pinion and gear.

Litvin, F. L.↗

NASA NTRS1984

Basis set limit geometries for ammonia at the SCF and MP2 levels of theory

The controversy over the Hartree-Fock bond angle of NH3 is resolved and the convergence of the geometry for the molecule as the basis set is systematically improved with both SCF and correlated MP2 wave functions. The results of the geometrical optimizations, carried out in four stages with a series of uncontracted bases sets, are shown. The obtained structure for NH3 supports the results of Radom and Rodwell (1980) that the Hartree-Fock limit angle is significantly greater than was previously believed.

Defrees, D. J.↗

NASA NTRS1985

A unique set of micromechanics equations for high temperature metal matrix composites

A unique set of micromechanic equations is presented for high temperature metal matrix composites. The set includes expressions to predict mechanical properties, thermal properties and constituent microstresses for the unidirectional fiber reinforced ply. The equations are derived based on a mechanics of materials formulation assuming a square array unit cell model of a single fiber, surrounding matrix and an interphase to account for the chemical reaction which commonly occurs between fiber and matrix. A three-dimensional finite element analysis was used to perform a preliminary validation of the equations. Excellent agreement between properties predicted using the micromechanics equations and properties simulated by the finite element analyses are demonstrated. Implementation of the micromechanics equations as part of an integrated computational capability for nonlinear structural analysis of high temperature multilayered fiber composites is illustrated.

Hopkins, D. A.↗