Search NASA⌕ Search

SEARCH · Search NASA

Results for “electronic transitions”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 433 records · Page 24

Transition radiation in astrophysics.

Transition radiation produced by relativistic electrons traversing cosmic grains is investigated as a possible source of celestial X rays. The detailed theory of transition radiation including the formation-zone effect is used to calculate the X-ray emissivity in interstellar space. It is found that the largest contribution of transition radiation to the observed X-ray emission from the galactic disk is at about 2 keV, where less than about 0.3% of the observed emissivity is due to transition radiation. At higher energies transition radiation is strongly suppressed by the formation-zone effect, while at lower energies the observed emissivity increases much faster with decreasing energy than does transition radiation. Transition radiation is also compared with bremsstrahlung, synchrotron emission, and Compton scattering. The comparison with synchrotron emission and bremsstrahlung relates X-ray production by transition radiation to radio emission and to approximately 100-MeV gamma-ray production, respectively.

Yodh, G. B.↗

Measurement of the transition probability of the C III 190.9 nanometer intersystem line

A radio-frequency ion trap has been used to store C(2+) ions created by electron bombardment of CO. The transition probability for the 2s2p 3Po1-2s2 1S0 intersystem line of C m has been measured by recording the radiative decay at 190.9 nm. The measured A-value is 121 +/- 7/s and agrees, within mutual uncertainty limits, with that of Laughlin et al. (1978), but is 20 percent larger than that of Nussbaumer and Storey (1978). The effective collision mixing rate coefficient among the fine structure levels of 3Po and the combined quenching and charge transfer rate coefficients out of the 3Po1 level with the CO source gas have also been measured.

Kwong, Victor H. S.↗

Fine structure and resonance transitions in C(+)

Significant features in the collision strengths for electron-impact excitation of the fine-structure transition 2P0 1/2 - 2P0 3/2 and the resonance transition 2P0 - 2D in C(+) are discussed based on improved calculations. The former transition gives rise to a well-known (2,3) line in the infrared spectra of many astrophysical sources.

Blum, Robert D.↗

Resonance transition radiation X-ray laser

A free electron laser is proposed using a periodic dielectric and helical magnetic field. Periodic synchronism between the electrons and the optical wave is obtained at the period of the dielectric and not at the period of the helical magnetic field. The synchronism condition and the gain of the new device are derived. The effects on the gain from dephasing and beam expansion due to elastic scattering of the electrons in the periodic medium are included in the gain calculation. Examples of the resonance transition radiation laser and klystron are given. Operation at photon energies between 2.5 and 3.5 keV with net gain up to 12 percent is feasible using high electron-beam energies of 3 and 5 GeV. Moderate (300-MeV) beam energy allows operation between 80 to 110 eV with up to 57 percent net gain using a klystron design. In both cases, rapid foil heating may limit operation to a single electron-beam pulse.

Reid, Max B.↗

A Hot-electron Direct Detector for Radioastronomy

A new approach is proposed to improve the sensitivity of direct-detection bolometers. The idea is to adjust a speed of the thermal relaxation of hot-electrons in a nanometer size normal metal or superconductive transition edge bolometer by controlling the elastic electron mean free path. If the bolometer contacts are made of a superconductor with high critical temperature then the thermal diffusion into the contacts is absent because of the Andreev's reflection and the electron-phonon relaxation is the only mechanism for heat removal. The relaxation rate should behave as 7(exp 4)l at subkelvin temperatures (l is the electron elastic mean free path) and can be reduced by factor of 10 - 100 by decreasing l. Then an antenna- or waveguide-coupled bolometer with a time constant approx. 10(exp -3) to 10(exp -5) S at T approx. = 0.1 - 0.3 K will exhibit photon-noise limited performance in millimeter and subn-millimeter range. The bolometer will have a figure-of-merit NEk square root of tau approx. = 10(exp -22) 10(exp -21) W/Hz at 100 mK which is 10(exp 3) times smaller than that of a state-of-the-art bolometer. This will allow for a tremendous increase in speed which will have a significant impact for observational mapping applications. Alternatively, the bolometer could operate at higher temperature with still superior sensitivity This research was performed by the Center for Space Microelectronics Technology, JPL, California Institute of Technology, under the contract for NASA.

Karasik, B. S.↗

The Near-Earth Space Radiation for Electronics Environment

The earth's space radiation environment is described in terms of: a) charged particles as relevant to effects on spacecraft electronics, b) the nature and distribution of trapped and transiting radiation, and c) their effect on electronic components.

Stassinopoulos, E. G.↗

On the problem of density diagnostics for the EUV spectrum of the solar transition zone

Spectral-line ratios that may be used to determine the electron temperature and density in the solar transition zone and corona are identified. The problem of interpreting the intensity ratios of C III lines observed in Skylab EUV limb spectra is considered. It is shown that the intensity distribution with height above the solar limb of the 1176-A C III lines is different from that of the 1909-A C III lines in the Skylab spectra, suggesting that model atmospheres must be folded into the C III calculations for proper interpretation of the data. Possible reasons for the differences in the intensity distributions and widths of the 1176-A and 1909-A lines are discussed along with an application to the analogous lines of Si III.

Doschek, G. A.↗

A theoretical study of the excited states of Ag3

Recently there was considerable interest in the properties and reactivities of small metal clusters. However, for the transition metal trimers, gas phase spectroscopy exists only for Cu3. Calculations are reported for the excited states of the Ag3 molecule. The excitation energies, geometries, derived harmonic frequencies, and transition moments are presented. The electronic structure of these states is very similar to the analogous states of Cu3. From the VCI wave functions transition moments were calculated between each of the Rydberg excited states and the ground state for an equilateral triangle geometry with R sub Ag-Ag = 5.3 a sub 0. One state was computed for the configuration 4d29 5sa sup prime 2 sub 1 5se sup prime 1 sub x 5se sup prime 1 sub y. This configuration was considered since the corresponding configuration for Cu3 is low-lying. Calculations were carried out for a quartet wavefunction in which the 4d hole was localized on the central Ag atom. The spectrum for Ag3 is expected to be simpler than for Cu3 since the 5s2 4d9 states are shifted to higher energy.

Walch, Stephen P.↗

Ordering Effects in NbC and TaC

By means of transmission electron microscopy and electron diffraction, evidence has been obtained for the existence of long range carbon atom ordering in single-crystal niobium carbide that has a carbon-to-metal ratio close to the integral composition Nb6C5. The ordering, which gives rise to superlattice and domain structures similar to those observed in V6C5, appears, however, only in samples that have been cooled slowly through the order-disorder temperature of 1025 C. In TaC of similar composition, the ordering, although present, remains very imperfect even after the crystals are subjected to the same thermal treatment. The results are interpreted in terms of the electronic structure of the transition metal carbides as it is currently understood, and their relevance to the mechanical properties of NbC and TaC are discussed.

Venables, J. D.↗

Deformed Brueckner-Hartree-Fock calculations

The renormalized Brueckner-Hartree-Fock (RBHF) theory for many-body nuclear systems is generalized to permit calculations for intrinsic states having permanent deformation. Both Hartree-Fock and Brueckner self-consistencies are satisfied, and details of the numerical techniques are discussed. The Hamada-Johnston interaction is used in a study of deformations, binding, size, and separation energies for several nuclei. Electromagnetic transition rates, moments, and electron scattering form factors are calculated using nuclear wave functions obtained by angular momentum projection. Comparison is made to experiment as well as to predictions of ordinary and density-dependent Hartree-Fock Theory.

Ford, W. F.↗

Deactivation of N2 A/super 3/Sigma/sub u/+ molecules in the aurora.

Recent rocket observations of the molecular nitrogen Vegard-Kaplan system in the aurora have been reinterpreted using an atmospheric model based on mass spectrometer measurements in an aurora of similar intensity at the same time of year. It is found that the population rates of the considered levels in the aurora are accurately determined by radiative cascade from two other states excited by direct electron impact. In some bright auroras the role of NO in quenching the lower vibrational levels of the A state is significant. The conclusions are based on a number of relevant auroral observations in combination with calculations using electron cross section and transition probability measurements by Shemansky and Broadfoot (1971).

Shemansky, D. E.↗

Deformed Brueckner-Hartree-Fock calculations.

The renormalized Brueckner-Hartree-Fock (RBHF) theory for many-body nuclear systems has been generalized to permit calculations for intrinsic states having permanent deformation. Both Hartree-Fock and Brueckner self-consistencies are satisfied, and details of the numerical techniques are discussed. The Hamada-Johnston interaction is used in a study of deformations, binding, size, and separation energies for several nuclei. Electromagnetic transition rates, moments, and electron scattering form factors are calculated using nuclear wave functions obtained by angular momentum projection. Comparison is made to experiment as well as to predictions of ordinary and density-dependent Hartree-Fock theory.

Ford, W. F.↗

Excitation and dissipation of Pc-1 micropulsations

A theoretical model based on hydromagnetic instabilities (including Alfven firehose and magnetoacoustic mirror instabilities), in the region where the electrons are in the transition from collisional to collisionless and ions are in the collisionless region, is proposed as a possible wave emission mechanism for Pc-1 pulsations. The model is compared with recent observations with good agreement between the theory and observations, especially for an emission source located at a distance L less than 5. Furthermore, a suggestion is made that the hydromagnetic instabilities could be relevant to the night and early morning hours emissions while the ion cyclotron instabilities could be responsible for the daytime emission of Pc-1 pulsations.

Hung, R. J.↗

Work function determination of promising electrode materials for thermionic energy converters

The work function determinations of candidate materials for low temperature (1400 K) thermionics through vacuum emission tests are discussed. Two systems, a vacuum emission test vehicle and a thermionic emission microscope are used for emission measurements. Some nickel and cobalt based super alloys were preliminarily examined. High temperature physical properties and corrosion behavior of some super alloy candidates are presented. The corrosion behavior of sodium is of particular interest since topping cycles might use sodium heat transfer loops. A Marchuk tube was designed for plasma discharge studies with the carbide and possibly some super alloy samples. A series of metal carbides and other alloys were fabricated and tested in a special high temperature mass spectrometer. This information coupled with work function determinations was evaluated in an attempt to learn how electron bonding occurs in transition alloys.

Jacobson, D.↗

Measurement of the fundamental vibration-rotation spectrum of ClO

The ClO fundamental absorption band near 850/cm is observed, with a tunable PbSnTe diode laser used as a source of monochromatic radiation. The chlorine monoxide concentration in the absorption tube was measured indirectly via a UV transmission technique. Frequencies and assignments for the ClO lines, and band centers and rotational constants for the ClO fundamental vibration, are tabulated. Diatomic vibration-rotation transitions within and between electronic substates are discussed. The tunable diode laser is valuable for studying the hyperfine structure. The IR spectroscopic technique is developed in order to monitor chlorine monoxide concentration in the stratosphere, since the short-lived ClO is a crucial intermediate participant in reactions involving destruction of stratospheric ozone.

Menzies, R. T.↗