SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The latest RF front end built by Burhans (Mini-L-82) was successfully interfaced to the Ohio University LORAN-C receiver. In order for the front end to operate optimally, modifications were made to existing automatic gain control (AGC) circuitry already developed for the Ohio University LORAN-C receiver. The hardware modifications to the AGC and other interface circuitry, as well as some preliminary results are discussed.
Silicon nitride and hafnium nitride coatings were deposited by reactive RF sputtering on oxidized and unoxidized 440C stainless steel substrates. Sputtering was done in mixtures of argon and nitrogen gases from pressed powder silicon nitride and from hafnium metal targets. Depositions were at two background pressures, 8 and 20 mtorr, and at two different fractions (f) of nitrogen in argon, 0.25 and 0.60, for hafnium nitride and at f = 0.25 for silicon nitride. The coatings and the interface between the coating and substrates were investigated by X-ray diffractometry, scanning electron microscopy, energy dispersive X-ray analysis and Auger electron spectroscopy. A Knoop microhardness of 1650 + or - 100 kg/sq mm was measured for hafnium nitride and 3900 + or - 500 kg/sq mm for silicon nitride. The friction coefficients between a 440C rider and the coatings were measured under lubricated conditions. Scratch test results demonstrate that the adhesion of hafnium nitride to both oxidized and unoxidized 440C is superior to that of silicon nitride. Oxidized 440C is found to have increased adhesion, to both nitrides, over that of unoxidized 440C.
During the Storm Hazards Experiment 1982, the Goddard Space Flight Center monitored radiation from lightning from a site at the Wallops Flight Facility, Wallops Island, VA. Measurements were made while the NASA F106 penetrated thunderstorms to obtain data on lightning strikes to the aircraft. The objective of the ground-based measurements was to help determine if the events recorded by the F106 were part of lightning discharges. During the experiment, 53 cases were obtained in which events were recorded aboard the aircraft while reliable quality RF radiation was recorded on the ground. These cases came from 12 different storms occurring from June through August 1982. The data confirms that the aircraft was measuring events which were part of lightning and indicates that the events recorded on the aircraft tend to occur early in the flash.
The Networks Consolidation Program (NCP) will utilize 34-meter shaped dual-reflector Cassegrain antennas. The shaping calculations, the X/S-band feedhorn to be used, and the predicted RF performance of this antenna system are discussed.
AES depth profiling data are presented for thin films of BaTiO3 deposited on silicon by RF sputtering. By profiling the sputtered BaTiO3/silicon structures, it was possible to study the chemical composition and the interface characteristics of thin films deposited on silicon at different substrate temperatures. All the films showed that external surface layers were present, up to a few tens of angstroms thick, the chemical composition of which differed from that of the main layer. The main layer had stable composition, whereas the intermediate film-substrate interface consisted of reduced TiO(2-x) oxides. The thickness of this intermediate layer was a function of substrate temperature. All the films showed an excess of barium at the interface. These results are important in the context of ferroelectric phenomena observed in BaTiO3 thin films.
Circuit has high reverse isolation and wide bandwidth. Wideband isolation amplifier has low intermodulation distortion and high reverse isolation. Circuit does not require selected or matched components or directional coupling device. Circuit used in applications requiring high reverse isolation such as receiver intermediate-frequency (IF) strips and frequency distribution systems. Also applicable in RF and video signaling.
Preliminary results indicate that the new front end automatic gain control (AGC) combination perform satisfactorily. Side by side bench tests with Trimble 10A and Texas Instruments 9900 LORAN-C receivers have proven that the proper time differences are being obtained. Further optimization of the AGC circuit will occur as software to track all of the stations in a LORAN-C chain is developed. The AGC circuit was designed to sample up to six separate LORAN-C stations. Along with expanded station tracking software, a more sophisticated search routine is also under development. A printed circuit board for the AGC is planned and will be enclosed with the RF front end in a sealed enclosure to reduce interference from the other digital circuits of the microcomputer.
The ion-molecule and the radical-molecule mechanisms are responsible for the dissociation of hydrocarbons, and chlorosilane monomers and the formation of polymerized species, respectively, in the plasma state of a RF discharge. In the plasma, of a mixture of monomer with Ar, the rate determining step for both dissociation and polymerization is governed by an ion-molecular type interaction. Additions of H2 or NH3 to the monomer Ar(+) mixture transforms the rate determining step from an ion-molecular interaction to a radical-molecule type interaction for both monomer dissociation and polymerization processes.
The combination of the finite conductivity of the Earth plus the propagation of the return stroke current up the channel which results in an apparent time delay between the fast field changes and RF radiation for distant observers is shown. The time delay predicted from model return strokes is on the order of 20 micro and the received signal has the characteristics of the data observed in Virginia and Florida. A piecewise linear model for the return stroke channel and a transmission line model for current propagation on each segment was used. Radiation from each segment is calculated over a flat Earth with finite conductivity using asymptotics approximations for the Sommerfeld integrals. The radiation at the observer is processed by a model AM radio receiver. The output voltage was calculated for several frequencies between HF-UHF assuming a system bandwidth (300 kHz) characteristic of the system used to collect data in Florida and Virginia. Comparison with the theoretical fast field changes indicates a time delay of 20 microns.
A method for calculating the increase in received telemetry signal power required to compensate for the use of a radio frequency interference (RFI) filter in front of the DSN receiving system low-noise amplifier is described. The telemetry system for which the degradation is calculated is an uncoded PCM/PM system in which the NRZ data directly modulates the carrier at a modulation level which leaves a discrete carrier. A phase-locked loop in the RF receiver tracks the discrete carrier and coherently demodulates the PCM data. The RFI filter may be a series of Butterworth, Tchebychev, or Bessel low-pass, high-pass, band-pass, or band-reject filters, each with arbitrary bandwidth, number of poles, and, for band-pass or band-reject filters, resonant frequency. The only restriction is that the RFI filter must have only simple poles. Numerical results are presented for the RFI filters the DSN plans to place in front of the S-band FET, S-band maser, and X-band maser low noise amplifiers. The main conclusion is that the filters will produce negligible degradation at data rates below 4 Mbps.
During Storm Hazards - 82, simultaneous measurements are made of radar echoes, fast and slow field changes and RF radiation from lightning. Radio frequency radiation and radar echoes are also obtained during periods when the research aircraft is struck by lightning. These data are presently used to better understand the electrical processes which occur during strikes to the aircraft. Preliminary conclusions verify that the events recorded aboard the aircraft occurred during lightning but also indicate that they occur with surprising frequency very early in the flash.
This report describes one of three study tasks related to the application of an RF interferometer aboard a low-orbiting spacecraft to determine the location of ground-based transmitters. Computer modeling was used to estimate the error in the measured signal angle-of-arrival caused by reflection and diffraction off the spacecraft. Existing computer codes (NEC-BSC) were modified and used to determine the perturbation, due to the spacecraft, in the phase difference between two interferometer antennas, suspended on either side of the spacecraft. This phase perturbation was found as a function of the angle-of-arrival of the signal from a far-field source. The spacecraft antennas were assumed to be circularly polarized with a cardioid pattern. It was found that the perturbation was as much 12.4 deg within the + or - 60 deg field-of-view. This suggests that phase calibration and correction of phase measurements are essential for precision position location using this technique.
This paper investigates the use of one type of GPS-signal derived measurement, the doubly differenced GPS RF Doppler, in the orbit determination of low-altitude earth satellites. This measurement is simple to make, is insensitive to clock errors and provides a continuous determination of the user satellite orbit. Analysis shows that, with a constellation of 18 GPS satellites and 13 ground stations, the 1300 km altitude of a user satellite (TOPEX) can be determined to 5 cm in 2 hours of tracking. Examination is made of the effects of employing fewer ground stations, of different solution strategies, and of introducing fictitious thrust parameters to alleviate the geopotential modeling error which is one of the major error sources.
Short, direct link between switch and filters reduces signal loss. New switch attaches directly to filter housing, eliminating cables and connectors. As result, losses in transmitter and receiver paths reduced by about 0.4 dB. Because connectors and cables are not used, RF path loss for selected signal through switch and filter is smaller than usual.
A test program to assess the capability of the peripheral vision horizon display (PVHD) to provide peripheral attitude cues to the pilot is described. The system was installed in the rear cockpit of a RF-4C aircraft, selected because its poor instrument crosscheck conditions. The PVHD test plan was designed to assess three primary areas: (1) ability of the system to reduce spatial disorientation; (2) ability of the system to aid the pilot in recovering from unusual attitudes; and (3) improvement in pilot performance during instrument landing system (ILS) approaches. Results of preliminary test flights are summarized. The major problem areas concern the distinction of the display itself and the capability of the display to provide pitch motion cues.
A communication system using a satellite with a 118 meter diameter quad aperture antenna to provide telephone service to mobile users remotely located from the large metropolitan areas where the telephone companies are presently implementing their cellular system is described. In this system, which is compatible with the cellular system, the mobile user communicates with the satellite at UHF frequencies. The satellite connects him at S-Band, to the existing telephone network via a base station. The results of the RF definition work for the quad aperture antenna are presented. The elements of the study requirements for the LMSS are summarized, followed by a beam topology plan which satisfies the mission requirements with a practical and realiable configuration. The geometry of the UHF antenna and its radiation characteristics are defined. The various feed alternatives, and the S-band aperture are described.
Silicon nitride and hafnium nitride coatings were deposited by reactive RF sputtering on oxidized and unoxidized 440C stainless steel substrates. Sputtering was done in mixtures of argon and nitrogen gases from pressed powder silicon nitride and from hafnium metal targets. Depositions were at two background pressures, 8 and 20 mtorr, and at two different fractions (f) of nitrogen in argon, 0.25 and 0.60, for hafnium nitride and at f = 0.25 for silicon nitride. The coatings and the interface between the coating and substrates were investigated by X-ray diffractometry, scanning electron microscopy, energy dispersive X-ray analysis and Auger electron spectroscopy. A Knoop microhardness of 1650 + or 100 kg/sq mm was measured for hafnium nitride and 3900 + or 500 kg/sq mm for silicon nitride. The friction coefficients between a 440C rider and the coatings were measured under lubricated conditions. Scratch test results demonstrate that the adhesion of hafnium nitride to both oxidized and unoxidized 440C is superior to that of silicon nitride. Oxidized 440C is found to have increased adhesion, to both nitrides, over that of unoxidized 440C.
Metal-carbon-metal structures were fabricated using either gold or aluminum evaporated electrodes and RF plasma (methane) deposited 'diamondlike' carbon films. Alternating-current conductance and capacitance versus voltage and frequency (10 Hz to 13 MHz) data were taken to determine the dielectric properties of these films. Conductance versus frequency data fit a generalized power law, consistent with both dc and hopping conduction components. The capacitance versus frequency data are well matched to the conductance versus frequency data, as predicted by a Kramers-Kronig analysis. The dielectric loss tangent is nearly constant at 0.5 to 1.0 percent over the frequency range from 1 to 100 kHz. The dc resistivity is above 10 to the 13th ohm cm, and the dc breakdown strength is above 8 x 10 to the 6th V/cm is properly prepared samples.