Search NASA⌕ Search

SEARCH · Search NASA

Results for “DIFFUSION EFFECT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 469 records · Page 26
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Inlet total pressure loss due to acoustic wall treatment

Experimental determination of the effect of diffuser wall acoustic treatment on inlet total pressure loss. Data were obtained by testing an inlet model with 10 different acoustically treated diffusers differing only in the design of the Helmholtz resonator acoustic treatment. Tests were conducted in a wind tunnel at forward velocities to 41 meters per second for inlet throat Mach numbers of .5 to .8 and angles of attack as high as 50 degrees. Results indicate a pressure loss penalty due to acoustic treatment that increases linearly with the porosity of the acoustic facing sheet. For a surface porosity of 14% the total pressure loss was 21% greater than that for an untreated inlet. The penalty resulting from treatment increased for average throat Mach numbers above approximately .7 where local regions of sonic or supersonic surface flow were encountered. Pressure loss over the treatment was not affected by the presence of noise.

Miller, B. A.↗
NASA NTRS1978

Effects of wave-induced diffusion on thermospheric acoustic-gravity waves

When wave-induced diffusion is included in the equations governing acoustic-gravity wave propagation in an atmosphere in diffusive equilibrium, it is found that phase and amplitude relationships between the density fluctuations of individual atmospheric constituents agree with AE-C satellite observations of wavelike structure only over a narrow range of wave periods. For a 400-km horizotal wavelength, the observations are consistent with internal gravity waves of periods 11.5-22 minutes propagating at phase speeds 300-600 m/sec.

Del Genio, A. D.↗
NASA NTRS1979

Laser-zone Growth in a Ribbon-to-ribbon (RTR) Process Silicon Sheet Growth Development for the Large Area Silicon Sheet Task of the Low Cost Solar Array Project

A technique for growing limited-length ribbons continually was demonstrated. This Rigid Edge technique can be used to recrystallize about 95% of the polyribbon feedstock. A major advantage of this method is that only a single, constant length silicon ribbon is handled throughout the entire process sequence; this may be accomplished using cassettes similar to those presently in use for processing Czochralski waters. Thus a transition from Cz to ribbon technology can be smoothly affected. The maximum size being considered, 3 inches x 24 inches, is half a square foot, and will generate 6 watts for 12% efficiency at 1 sun. Silicon dioxide has been demonstrated as an effective, practical diffusion barrier for use during the polyribbon formation.

Baghdadi, A.↗
NASA NTRS1979

Performance of a V/STOL tilt nacelle inlet with blowing boundary layer control

A scale model of a V/STOL tilt nacelle fitted to a 0.508 m single stage fan was tested in the NASA Lewis 9x15 ft low speed wind tunnel to determine the effect of diffuser blowing on the inlet aerodynamics and aeromechanical performance. The test was conducted over a range of freestream speeds (up to 120 knots) and angles of attack (up to 120 deg). Diffuser blowing had a beneficial affect on all performance parameters. The angle of attack range for separation free flow substantially increased, and the fan face distortion significantly reduced with a corresponding increase in total pressure recovery. Discrete narrow band blade stress peaks which were common to the nonblowing (baseline) configuration were eradicated with diffuser blowing.

Johns, A. L.↗
NASA NTRS1979

Performance of a V/STOL tilt nacelle inlet with blowing boundary layer control

A scale model of a V/STOL tilt nacelle fitted to a 0.508 m single stage fan was tested in the NASA Lewis low speed wind tunnel to determine the effect of diffuser blowing on the inlet aerodynamics and aeromechanical performance. The test was conducted over a range of freestream speeds (up to 120 knots) and angles-of attack (up to 120 deg). In general, diffuser blowing had a beneficial affect on all performance parameters. The angle-of-attack range for a separation-free flow substantially increased, and the fan face distortion reduced with a corresponding increase in total pressure recovery. Discrete narrow band blade stress peaks which were common to the nonblowing (baseline) configuration were eradicated with diffuser blowing.

Johns, A. L.↗
NASA NTRS1980

Study of radiation induced deep-level defects in proton irradiated AlGaAs-GaAs solar cells

Radiation induced deep-level defects (both electron and hole traps) in proton irradiated AlGaAs-GaAs p-n junction solar cells are investigated along with the correlation between the measured defect parameters and the solar cell performance parameters. The range of proton energies studied was from 50 KeV to 10 MeV and the proton fluence was varied from 10 to the 10th power to 10 to the 13th power P/sq cm. Experimental tools employed include deep-level transient spectroscopy, capacitance-voltage, current voltage, and SEM-EBIC methods. Defect and recombination parameters such as defect density and energy level, capture cross section, carrier lifetimes and effective hole diffusion lengths in n-GaAs LPE layers were determined from these measurements.

Li, S. S.↗
NASA NTRS1982

Seasonal dependence of the distribution of large-scale plasma depletions in the low-latitude F region

From several years of Atmosphere Explorer data, it is shown that large-scale plasma density depletions (horizontal scale greater than 1000km) in the nocturnal F region occur mainly during the first half of the night. The geomagnetic latitude of these depletions depends on season: at solstice periods the occurrence is mainly in the summer hemisphere and at equinoxes mainly on the geomagnetic equator. Large-scale depletions occur most often at longitudes characterized by a large magnetic declination. The large-scale plasma depletions are interpreted to be a consequence of imposed upward drift which raises the F region above the satellite trajectory. This interpretation is tested by calculating the vertical ion drift velocity imposed by zonal and meridional winds and electrostatic fields, with allowance for the effects of diffusion. The calculations reveal a correspondence between the locations of maxima in the calculated vertical ion drift velocity and the large-scale plasma depletions.

Dachev, T. P.↗
NASA NTRS1983

A multi-spacecraft study of the coronal and interplanetary transport of solar cosmic rays. I, II

The analysis and interpretation of the multiple-spacecraft observations of a collection of flare events in six energy bands between 3 and 60 MeV/nucleon are presented. The longitudinal and radial dependence of the times of maximum flux, the relative maximum fluxes, and the decay constants, are determined; and the propagation model is compared with a simplified single-spacecraft model. The analytical model developed accounts for the effects of diffusion, convection, adiabatic deceleration, and corotation. The intensity time profiles are calculated for hypothetical spacecraft spaced at 60-deg longitude intervals between -120 and 120 deg. It is concluded that the large value of k(IP) (greater than or equal to 6 x 10 to the 21st sq cm/s) indicates the nonnegligibility of focused diffusion in the interplanetary modeling of these events.

Mcguire, R. E.↗
NASA NTRS1984

Axisymmetric circulations forced by heat and momentum sources - A simple model applicable to the Venus atmosphere

A simple mechanistic model of a zonally averaged circulation forced by heat and momentum sources is developed and applied to the Venus atmosphere in the light of recent data. Basic equations for a steady-state axisymmetric circulation are discussed, and the parametric dependence of a nearly inviscid Hadley circulation in the absence of eddy forcing is examined and extended to a wide range of thermal Rossby numbers. The effect of diffusion is considered and found to be small for the Venus cloud region. The zonally averaged eddy sources and sinks required to support the zonal superrotation on Venus are determined.

Hou, A. Y.↗
NASA NTRS1987

Field calibration of reference reflectance panels

A procedure for calibrating reference reflectance panels using the sun as the radiation source and a pressed-polytetrafluoroethylene powder standard is described. The directional/directional reflectance factor and the directional/hemispheric reflectance factor are examined. Directional/directional voltage responses for pressed-halon are analyzed. Three painted BaSO4 and one painted halon were calibrated using the proposed procedure. The effects of diffuse irradiance on reflectance-factor measurements are investigated. It is determined that the method has an accuracy on the order of 1 percent. The advantages and disadvantages of this method are discussed.

Jackson, Ray D.↗
NASA NTRS1988

Model structure of a cosmic-ray mediated stellar or solar wind

An idealized hydrodynamic model is presented for the mediation of a free-streaming stellar wind by galactic cosmic rays or energetic particles accelerated at the stellar wind termination shock. The spherically-symmetric stellar wind is taken to be cold; the only body force is the cosmic ray pressure gradient. The cosmic rays are treated as a massless fluid with an effective mean diffusion coefficient k proportional to radial distance r. The structure of the governing equations is investigated both analytically and numerically. Solutions for a range of values of k are presented which describe the deceleration of the stellar wind and a transition to nearly incompressible flow and constant cosmic ray pressure at large r. In the limit of small k the transition steepens to a strong stellar wind termination shock. For large k the stellar wind is decelerated gradually with no shock transition. It is argued that the solutions provide a simple model for the mediation of the solar wind by interstellar ions as both pickup ions and the cosmic ray anomalous component which together dominate the pressure of the solar wind at large r.

Lee, M. A.↗
NASA NTRS1988

Venus - Surface electromagnetic properties

Pioneer Venus high-angle radar imaging data are used here to correct values of the specular power reflection coefficient for the effects of diffusely scattering small-scale surface roughness. A value of 5.0 + or - 0.9 is found for the average dielectric permittivity of the rolling plains and lowlands, suggesting that most of the Venus surface is overlain by at most only a few cm of soil or dust. The unexpectedly high values of power reflection coefficient are confirmed by observations of correspondingly low values of radiothermal emission. Thus there can be little doubt that most of the highlands contain significant amounts of a conducting mineral near the surface.

Pettengill, Gordon H.↗
NASA NTRS1989

Magma zonation - Effects of chemical buoyancy and diffusion

Numerical simulations and scale analysis are used to assess the viability of the marginal box-filling mechanism for producing compositional zonation in magma bodies. Scale analysis and two-dimensional numerical experiments both show that box-filling occurs provided a critical ratio of compositional-to-thermal buoyancy is exceeded. This critical ratio depends on the ratio of thermal-to-chemical diffusivity; application of this result to magma bodies suggests that box-filling may occur for components with relatively high-chemical diffusivities such as water. However, box-filling will not produce significant zonation for components with small chemical diffusivities, such as silica, unless diffusive coupling increases silica diffusivity.

Spera, Frank J.↗
NASA NTRS1989

Correlations and alloy properties - Growth, vacancies, surface segregation

The aspects of bonding interaction mechanisms which have an impact on the correlation state of alloy semiconductors are demonstrated. The effect of the correlation state on liquidus and solidus curves, on surface segregation, and on vacancy densities is deduced. Vacancy energies for several alloys are presented, and tentative conclusions are drawn about their effects on diffusion, doping, and ion beam processing. Features of the theory of surface segregation in semiconductor alloys are then presented.

Sher, A.↗
NASA NTRS1991

Acousto-ultrasonics - Retrospective exhortation with bibliography

Major research on the acousto-ultrasonic (AU) technique (also known as the stress-wave-factor technique) encompassing aspects of acoustic emission and ultrasonic materials characterization methodology is reviewed. AU deals primarily with such factors as the assessment of the integrated effects of diffuse defect states, thermomechanical degradation, and population of subcritical flaws that influence AU measurements correlating with mechanical property variations. AU is used to evaluate fiber-reinforced composites, adhesive bonds, lumber, paper and wood products, cable and rope, and human bone. The AU technique has been demonstrated to be sensitive to interlaminar and adhesive bond strength variations and has been shown to be useful in assessing microporosity and microcracking produced by fatigue cycling. An extensive bibliography ranging from 1985 to 1991 is presented.

Vary, Alex↗
NASA NTRS1990

Acousto-ultrasonics

The theoretical development, methodology, and potential applications of acousto-ultrasonic nondestructive testing are set forth in an overview to assess the effectiveness of the technique. Stochastic wave propagation is utilized to isolate and describe defects in fiber-reinforced composites, particularly emphasizing the integrated effects of diffuse populations of subcritical flaws. The generation and nature of acousto-ultrasonic signals are described in detail, and stress-wave factor analysis of the signals is discussed. Applications of acousto-ultrasonics are listed including the prediction of failure sites, assessing fatique and impact damage, calculating ultimate tensile strength, and determining interlaminar bond strength. The method can identify subtle but important variations in fiber-reinforced composites, and development of the related instrumentation technology is emphasized.

Vary, Alex↗
NASA NTRS1992

Stability analysis of surface tension effects on a double-diffusive layer

The linear stability characteristics of a fluid layer with simultaneous temperature and concentration gradients in a reduced gravity field are examined. The surface tension of the fluid is assumed to be a linear function of temperature and concentration. It is concluded that a small amount of gravity may damp out oscillatory instability or may alter its dynamics so that instability appears as steady convection. The onset of salt-finger instability may be in the overstable mode due to the surface tension method. The Lewis and Prandtl numbers of the material have a strong influence on the stability boundaries and onset characteristics of the system.

Chen, C. F.↗
NASA NTRS1993

On the structure of gaseous confined laminar diffusion flames: Numerical investigation

The structure and characteristics of gaseous confined laminar diffusion flames are investigated by numerically solving the time-dependent two-dimensional axisymmetric conservation equations. The numerical model accounts for the important chemical and physical processes involved, including axial diffusion, viscous effects, radial convection, and finite-rate chemistry. The numerical results clearly show that the flame has a finite thickness and leakage of fuel vapor into the flame zone is possible. The effect of heat release is found to induce some radial flow. Predicted flame shape and dimensions are compared to the classical Burke-Schumann flame. The numerically calculated flame is observed to be about 15 percent taller and 5 percent narrower than that of the Burke-Schumann solution under the same conditions.

Mawid, M. A.↗