Search NASA⌕ Search

SEARCH · Search NASA

Results for “Exotics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 469 records · Page 26

Interstellar carbon in meteorites

The Murchison and Allende chondrites contain up to 5 parts per million carbon that is enriched in carbon-13 by up to +1100 per mil (the ratio of carbon-12 to carbon-13 is approximately 42, compared to 88 to 93 for terrestrial carbon). This 'heavy' carbon is associated with neon-22 and with anomalous krypton and xenon showing the signature of the s-process (neutron capture on a slow time scale). It apparently represents interstellar grains ejected from late-type stars. A second anomalous xenon component ('CCFXe') is associated with a distinctive, light carbon (depleted in carbon-13 by 38 per mil), which, however, falls within the terrestrial range and hence may be of either local or exotic origin.

Swart, P. K.↗

Saturn's electrostatic discharges - Could lightning be the cause?

It is proposed that Saturn's electrostatic discharges (SED) might be generated in the planet's equatorial atmosphere, perhaps as lightning from a storm system. The 10-h-10-min periodicity of the signal envelope duplicates that of Saturn's equatorial jet. The rings shield the atmosphere from solar EUV photons, and thereby substantially reduce the local ionospheric cutoff frequency to allow low-frequency SED to leak out. Many of the unusual properties of SED could be explained in terms of changes in the storm system, the relative spacecraft position in the beaming pattern of the source, local refraction of the signal by the highly disturbed ionosphere, and the influence of the ring particles on the highest frequency component of SED. A comparison of SED with planetary lightning on other planets shows that the two are similar in general character and some time behavior; the power output of SED may be higher than most planetary lightning, but that is unclear because of uncertainties in the measurements and variations in the signal's spectrum. It is suggested that lightning could be a viable source for SED and that exotic ring mechanisms are not necessarily required.

Burns, J. A.↗

An analysis of propulsion options for transport of lunar materials to earth orbit

This paper describes the results of analyses of space-based transportation systems for the transport of extraterrestrial materials from their point of origin on the lunar surface to final delivery point in earth orbit and transport of equipment and supplies for extraterrestrial processing to the operational site. The emphasis has been on the use of near-term (pre-year 2000) propulsion systems, such as advanced chemical (H2, O2) and nuclear-electric systems. More exotic systems (mass drivers, nuclear-thermal rockets, etc.) were also considered to evaluate the potential to be gained by use of post-year 2000 technologies. Finally, the effects of using extraterrestrial propellants (e.g., H2 from lunar polar water-ice for chemical systems) were compared to those of propulsion systems deriving all or part of their propellants from the earth.

Frisbee, R. H.↗

Laser-modified electron scattering from a slowly ionising atom

When an electron scatters from an atom in the presence of a laser field which is resonant with an atomic transition, off-shell effects enter into the cross section. These only become significant at higher laser intensities where the atom may also be ionised by the laser. Cross-sections are obtained for electron-atom scattering in which these off-shell effects appear and in which the slow ionisation of the atom by the laser is included. Experiments are suggested in which simplifications can occur and which still retain these 'exotic' effects.

Fiordilino, E.↗

Linking numbers, spin, and statistics of solitons

The spin and statistics of solitons in the (2 + 1)- and (3 + 1)-dimensional nonlinear sigma models is considered. For the (2 + 1)-dimensional case, there is the possibility of fractional spin and exotic statistics; for 3 + 1 dimensions, the usual spin-statistics relation is demonstrated. The linking-number interpretation of the Hopf invariant and the use of suspension considerably simplify the analysis.

Wilczek, F.↗

A non-catastrophist explanation for the iridium anomaly at the Cretaceous/Tertiary boundary

The iridium (Ir) anomaly at the Cretaceous/Tertiary (C/T) boundary can be explained by dissolution of normal pelagic limestones producing an insoluble clay residue containing Ir-rich meteoritic material. Further concentration of Ir and other trace metals in the clay can be explained by deposition under reducing conditions. Clay-mineral analyses indicate that the boundary clay is similar to locally derived clays in the limestones above and below the boundary, and contains no detectable exotic components. This supports a terrestrial origin for the boundary clay. The genesis of the boundary clay is attributed to changes in ocean chemistry (pH and oxygenation), leading to an interval of widespread dissolution of carbonate sequences in the oceans, and culminating in the development of submarine pyritic hardgrounds and a disconformity of global extent.

Rampino, M. R.↗

The case for antiparticles in the extragalactic cosmic radiation

The presence of an excess of low-energy antiprotons in the primary cosmic radiation has given rise to several possible explanations, some of which involve exotic processes such as mini-black holes and extragalactic antiparticles. The latter possibility is considered, and it is shown that there are interesting implications for the cosmic radiation at higher energies. Indeed, it may be possible to account for a previously puzzling feature of the cosmic ray spectrum (a 'bump' in the range between 10 to the 14th and 10 to the 15th eV) by hypothesizing a primary extragalactic origin for the bulk of the observed cosmic ray antiprotons, although such an explanation is not unique. In this model, most of the cosmic rays above 10 to the 15th eV are extragalactic. A method of testing this hypothesis experimentally is described.

Stecker, F. W.↗

Identification of the SiCC radical toward IC +10216 - The first molecular ring in an astronomical source

In the radio spectrum of the envelope of the evolved carbon star IRC +10216, the fraction of lines from exotic molecules seldom or never observed in the terrestrial laboratory is exceptionally high. At least 20 lines have not been identified, and it is not known whether one, two, or a number of new molecules are involved. It is shown in the present investigation that nine of the previously unidentified lines in IRC +10216 are produced by SiCC, a radical long known to exist in stellar atmospheres. The true ground-state geometry of this radical has only been obtained recently on the basis of an elegant two-photon ionization experiment in a supersonic molecular beam. Information regarding the molecular geometry and lower rotational levels of SiCC is presented in a graph. The intensities of the SiCC lines confirm the assignments, yield new data on the temperature and density in the envelope of IRC +10216, and indicate that the amount of SiCC there is substantial.

Thaddeus, P.↗

Human factors in cockpit automation

The rapid advance in microprocessor technology has made it possible to automate many functions that were previously performed manually. Several research areas have been identified which are basic to the question of the implementation of automation in the cockpit. One of the identified areas deserving further research is warning and alerting systems. Modern transport aircraft have had one after another warning and alerting systems added, and computer-based cockpit systems make it possible to add even more. Three major areas of concern are: input methods (including voice, keyboard, touch panel, etc.), output methods and displays (from traditional instruments to CRTs, to exotic displays including the human voice), and training for automation. Training for operating highly automatic systems requires considerably more attention than it has been given in the past. Training methods have not kept pace with the advent of flight-deck automation.

Wiener, E. L.↗

SSME lifetime prediction and verification, integrating environments, structures, materials: The challenge

The planned missions for the space shuttle dictated a unique and technology-extending rocket engine. The high specific impulse requirements in conjunction with a 55-mission lifetime, plus volume and weight constraints, produced unique structural design, manufacturing, and verification requirements. Operations from Earth to orbit produce severe dynamic environments, which couple with the extreme pressure and thermal environments associated with the high performance, creating large low cycle loads and high alternating stresses above endurance limit which result in high sensitivity to alternating stresses. Combining all of these effects resulted in the requirements for exotic materials, which are more susceptible to manufacturing problems, and the use of an all-welded structure. The challenge of integrating environments, dynamics, structures, and materials into a verified SSME structure is discussed. The verification program and developmental flight results are included. The first six shuttle flights had engine performance as predicted with no failures. The engine system has met the basic design challenges.

Ryan, R. S.↗

Hibonite: Crystal Chemistry and Origin of Blue Coloration in Meteoritic Assemblages

The blue color and optical spectra of hibonite, a common constituent of refractory inclusions in carbonaceous chondrites, are discussed. Because they may be manifestations of exotic cation species stabilized in unusual coordination sites in the hibonite crystalstructure. Hibonite, ideally CaAl12O19, is conducive to atomic substitution of host Ca2+ and Al3+ ions by a variety of lanthanide and first series transition elements. The latter cations are responsible for the colors of many rock-forming minerals as a result of intraelectronic or intervalence transitions. The visible-region spectra of most oxide and silicate minerals are generally well understood. Assignments of absorption bands in meteoritic hibonite optical spectra due to uncertainties of cation valencies and complexities in the crystal structure are examined. The crystal chemistry of hibonite is reviewed, Mossbauer spectral measurements of iron-bearing hibonite and electronic transitions that may be responsible for the blue coloration of meteoritic hibonites are discussed.

Burns, R. G.↗

Planetary perspective. Report of Working Group Number 4

The study of global megageomorphology from a planetary perspective requires that, philosophically, we view the Earth as a planet like any other; one among a number of bodies of varied size and composition which, together with the Sun, form the Solar System. A first step in the study of the Earth from the planetary perspective is the development of global distribution maps of surface factors as landforms, tectonics, and of key processes operating on Earth. Data of other types, such as gravity and magnetism, should also be included and, so far as possible, multiple data sets should be developed. The compilation of maps would serve as a catalyst for research and a basis for interpretation. They could be used scientifically to document changes such as glacial variations and their relationships to climate, volcanic eruptions and their effects, and coastal alterations. Slow and rapid changes should be studied together with the relationships between scale and the rapidity of change. A study of the relationship of geomorphology (i.e., surficial processes) to lithology and structure is needed. The planetary perspective can also help in the identification and investigation of exotic features such as suspect terrains.

Rossbacher, L. A.↗

Propagation and secondary production of low energy antiprotons in the atmosphere

Current theories, in which the observed antiproton component is attributed strictly to secondary production in high energy inelastic collisions of protons with the interstellar medium or the atmosphere, apparently fail to explain the relatively high p vertical intensities measured at mountain and balloon altitudes. Therefore, a more careful calculation of the theoretical secondary intensity spectra is required before more exotic sources for these excess p's can be explored. A one dimensional diffusion equation is used to calculate the expected vertical intensity of p's due only to secondary production in the atmosphere; any assumed primary p spectrum is also included. Two adjustable parameters, the inelasticity and charge exchange in nucleon-nucleus collisions, were included in the algorithm. In order to obtain an independent estimate of their values the proton vertical intensities in the atmosphere were calculated, adjusting the parameters until the curves fit the experimental proton data, and then assumed that these values were identical in antinucleon-nucleus collisions.

Bowen, T.↗

Search for anomalous C-jets in Chacaltaya emulsion chamber experiment

Anomalous C-jets were measured in Chacaltaya emulsion chamber No.17. Measurement of 150 C-jets nuclear interactions occured in the target layer in the chamber itself with total visible energy greater than 5 TeV was completed. they are recorded in area of 11 sq m, corresponding to 17.1 sq m year exposure. Among them, seven events have no pinaught and two events are peculiar in that three showers out of four show abnormal cascade development. Two show remarkable characteristics indicating that they are coming from exotic interactions in the target layer. Illustrations of these events are presented and the thresholds of this type of event are discussed.

Kumano, H.↗

Calibration and operation of the Faint Object Spectrograph

The design and basic performance characteristics of the Faint Object Spectrograph (FOS), one of five instruments built for use on the Space Telescope observatory, is summarized briefly. The results of the recently completed instrument-level calibration are presented with special emphasis on issues affecting plans for FOS astronomical observations. Examples include such fundamental characteristics as: limiting magnitudes (system sensitivity and noise figures), spectral coverage and resolution, scattered light properties, and instrumental polarization and modulation efficiencies. Also gated toward intended users, a rather detailed description of FOS operating modes is given. The discussion begins with the difficulties anticipated during target acquisition and their hoped-for resolution. Both the 'normal' spectroscopic operating modes of the FOS and its 'exotic' features (e.g. spectropolarimetric, time-tagged, and time-resolved modes) are presented. The paper concludes with an overview of the activities to assure proper alignment and operation of the FOS within the entire Space Telescope system (orbital and ground-based).

Harms, R.↗

Absolute isotopic abundances of Ti in meteorites

A general formalism is presented for determining possible isotope compositions of exotic Ti, and illustrated with results from Ti isotope abundances measured in Ca-Al-rich inclusions of the Allende and Leoville meteorites and samples of other meteorites. Previously identified correlations between Ti-50 and Ca-48 in FUN (isotope fractionation effects and unknown nucleosynthetic effects) inclusions is shown to hold true, thereby supporting contributions from a neutron-rich equilibrium or nucleosynthetic equilibrium during formation of the meteorites. Extension of the study to carbonaceous meteorites indicated that condensation, volatilization and recondensation occurred during formation, although the isotope fractionation observed cannot yet be explained.

Niederer, F. R.↗

Automatic orbital GTAW welding: Highest quality welds for tomorrow's high-performance systems

Automatic orbital gas tungsten arc welding (GTAW) or TIG welding is certain to play an increasingly prominent role in tomorrow's technology. The welds are of the highest quality and the repeatability of automatic weldings is vastly superior to that of manual welding. Since less heat is applied to the weld during automatic welding than manual welding, there is less change in the metallurgical properties of the parent material. The possibility of accurate control and the cleanliness of the automatic GTAW welding process make it highly suitable to the welding of the more exotic and expensive materials which are now widely used in the aerospace and hydrospace industries. Titanium, stainless steel, Inconel, and Incoloy, as well as, aluminum can all be welded to the highest quality specifications automatically. Automatic orbital GTAW equipment is available for the fusion butt welding of tube-to-tube, as well as, tube to autobuttweld fittings. The same equipment can also be used for the fusion butt welding of up to 6 inch pipe with a wall thickness of up to 0.154 inches.

Henon, B. K.↗