Search NASA⌕ Search

SEARCH · Search NASA

Results for “Lift to Drag Ratio”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 469 records · Page 26
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Earth return aerocapture for manned Mars missions

Lift to drag ratio (L/D) requirements and stagnation point heating have been examined for a variety of probable entry conditions and vehicle configurations. It is found that vehicles with an L/D of 0.5 or more provide a corridor width of at least 0.7 degrees while keeping the peak deceleration load below 5 g for approach velocities up to 14.5 km/s. It is shown that stagnation point peak heating rates and integrated heat load critically depend on both entry velocity and ballistic coefficient. For the most severe cases under consideration, peak heating and integrated heat load are five times greater than those encountered by Apollo but within the range of experience for unmanned vehicles.

Tauber, M. E.↗
NASA NTRS1991

Interplanetary trajectory optimization of Mars aerobraking missions with constrained atmospheric entry velocities

Many current manned Mars mission studies are using low lift-to-drag ratio (L/D) vehicles to aerobrake at both Mars and earth. The use of these low L/D vehicles imposes constraints on the allowable velocity at the atmospheric interface. This paper will demonstrate that if these entry velocity constraints are incorporated into the interplanetary analysis, more opportunities can be achieved for a small increase in initial LEO mass. These additional opportunities result from varying the initial launch date, the encounter dates, and possibly using a powered Venus swingby on either the inbound or outbound transfer. This paper presents results for three atmospheric entry velocity ranges at Mars arrival and one velocity limitation upon Earth return. The results indicate that by carefully selecting the interplanetary trajectory, an optimum initial LEO mass mission can be found for even highly restrictive entry velocity missions in practically all of the 15 years studied.

Striepe, Scott A.↗
NASA NTRS1991

On a global aerodynamic optimization of a civil transport aircraft

An aerodynamic optimization procedure developed to minimize the drag to lift ratio of an aircraft configuration: wing - body - tail, in accordance with engineering restrictions, is described. An algorithm developed to search a hypersurface with 18 dimensions, which define an aircraft configuration, is discussed. The results, when considered from the aerodynamic point of view, indicate the optimal configuration is one that combines a lifting fuselage with a canard.

Savu, G.↗
NASA NTRS1992

The HL-20 Personnel Launch System

A lifting-body approach to the design of a personnel launch system spacecraft for Space Station crew rotation missions is presented. Recent study findings in the areas of wind tunnel tests, landing dynamics, handling qualities, and abort are summarized. HL-20, which is designed for safe and reliable operations, has improved operability, maintainability, and affordability as compared to current manned transportation operations. The high lift-to-drag ratio of the HL-20 provides significant advantages in reduced g-loads during entry, high crossrange capability, ability to fly to landing sites over an extensive part of the earth, and multiple landing opportunities per day at specific landing sites. Pilot ratings of the flying qualities are at level 1 on the Cooper-Harper scale. Attention is also given to a streamlined management approach to HL-20 PLS development and operations which are presently under study.

Talay, Theodore A.↗
NASA NTRS1990

A review of computational/experimental methodology developments in aeroacoustics

A number of studies in the area of propeller design and advanced configuration performance/acoustics are reviewed. Various designs are analyzed in the area of propeller efficiency, lift-to-drag ratio, and differential thrust and power coefficients. Predictions are compared to experiment and the numerical analyses are examined for restrictions and potential enhancements.

Eagleson, L. A.↗
NASA NTRS1992

Practical design optimization of wing/body configurations using the Euler equations

The development of a practical method for the aerodynamic design of isolated wing and wing/body configurations is achieved through the coupling of existing computational fluid dynamics (CFD) analysis codes and a quasi-Newton numerical optimization method. The direct design method is generalized to treat three-dimensional aerodynamic optimization problems subject to inviscid, rotational, compressible flow conditions imposed by the Euler equations. The method couples either the FLO57 or the TEAM flow solver with a modified version of the QNMDIF numerical optimization algorithm. The method is applied, but is not limited, to supersonic design problems. A case study is presented illustrating the method's effectiveness in maximizing the lift-to-drag ratio, subject to a variety of constraints, of selected supersonic configurations at cruise conditions.

Reuther, J.↗
NASA NTRS1992

Propulsion requirements for the HL-20 personnel launch system

A lifting-body approach to the design of an HL-20 personnel launch system spacecraft for SSF crew rotation missions is presented. The high hypersonic lift-to-drag ratio of the HL-20 provides significant advantages in reduced g-loads during entry, high crossrange capability, ability to fly to landing sites over an extensive part of the earth, and multiple landing opportunities per day at specific landing sites. The HL-20 is capable of performing a return-to-launch-site runaway landing anytime during the first minute of launch following activation of an enhanced launch escape system.

Talay, Theodore A.↗
NASA NTRS1992

Supersonic airplane design optimization method for aerodynamic performance and low sonic boom

This paper presents a new methodology for the optimization of supersonic airplane designs to meet the dual design objectives of low sonic boom and high aerodynamic performance. Two sets of design parameters are used on an existing High Speed Civil Transport (HSCT) configuration to maximize the aerodynamic performance and minimize the sonic boom under the flight track. One set of the parameters perturbs the camber line of the wing sections to maximize the lift-over-drag ratio (L/D). A preliminary optimization run yielded a 3.75 percent improvement in L/D over a baseline low-boom configuration. The other set of parameters modifies the fuselage area to achieve a target F-function. Starting from an initial configuration with strong bow, wing, and tail shocks, a modified design with a flat-top signature is obtained. The methods presented can easily incorporate other design variables and objective functions. Extensions to the present capability in progress are described.

Cheung, Samson H.↗
NASA NTRS1993

Analysis of a hypersonic waverider research vehicle with a hydrocarbon scramjet engine

The results of a feasibility study of a hypersonic waverider research vehicle with a hydrocarbon scramjet engine are presented. The integrated waverider/scramjet geometry is first optimized with a vehicle synthesis code to produce a maximum product of the lift-to-drag ratio and the cycle specific impulse, hence cruise range. Computational fluid dynamics (CFD) is then employed to provide a nose-to-tail analysis of the system at the on-design conditions. Some differences are noted between the results of the two analysis techniques. A comparison of experimental, engineering analysis and CFD results on a waverider forebody are also included for validation.

Molvik, Gregory A.↗
NASA NTRS1993

Influence of interplanetary trajectory selection on Earth atmospheric entry velocity of Mars missions

Many current manned Mars mission studies are using low lift-to-drag ratio vehicles to aerobrake at both Mars and Earth. This paper will demonstrate that if entry velocity constraints are incorporated into the interplanetary analysis of aerobraking Mars missions, more opportunities can be achieved for only a small increase in initial mass in low-Earth orbit (IMLEO). These additional opportunities result from varying the initial launch date and the encounter dates and possibly using a powered Venus swingby on either the inbound or outbound transfer. This paper not only presents unconstrained entry velocity missions but also includes results for entry velocities below 12.5 and 14 km/s on Earth return and between 6.0-8.5 km/s at Mars arrival. The results indicate that, regardless of the Mars entry velocity range selected, an Earth entry velocity below 14 km/s is easily attainable for a minimal IMLEO increase. Although there are fewer 12.5 km/s Earth entry velocity missions possible, both Mars entry velocity constraint cases have over 50 percent of their missions requiring a negligible IMLEO increase.

Striepe, Scott A.↗
NASA NTRS1993

Influence of interplanetary trajectory selection on Mars atmospheric entry velocity

Many current manned Mars mission studies are using low lift-to-drag ratio (L/D) vehicles to aerobrake at both Mars and Earth. The use of these low L/D vehicles could limit the allowable velocity at the atmospheric interface. This paper will demonstrate that if entry velocity constraints are incorporated into the interplanetary analysis of aerobraking Mars missions, many opportunities can be achieved for a small increase in initial mass in low-Earth orbit (IMLEO). These opportunities result from varying the initial launch date and the encounter dates and possibly using a powered Venus swingby on either the inbound or outbound transfer. This paper demonstrates this technique by using three atmospheric entry velocity ranges at Mars arrival (6.0-8.5, 6.4-8.1, and 7.2-7.3 km/s), unconstrained Mars entry velocities, and an Earth return entry velocity below 14 km/s. The results indicate that, by carefully selecting the interplanetary trajectory, an optimum IMLEO mission can be found for even highly restrictive entry velocity missions in practically all of the 15 yr studied.

Striepe, Scott A.↗
NASA NTRS1993

Nonequilibrium effects on the aerothermodynamics of transatmospheric and aerobraking vehicles

A 3D CFD algorithm is used to study the effect of thermal and chemical nonequilibrium on slender and blunt body aerothermodynamics. Both perfect gas and reacting gas air models are used to compute the flow over a generic transatmospheric vehicle and a proposed lunar transfer vehicle. The reacting air is characterized by a translational-rotational temperature and a vibrational-electron-electronic temperature and includes eight chemical species. The effects of chemical reaction, vibrational excitation, and ionization on lift-to-drag ratio and trim angle are investigated. Results for the NASA Ames All-body Configuration show a significant difference in center of gravity location for a reacting gas flight case when compared to a perfect gas wind tunnel case at the same Mach number, Reynolds number, and angle of attack. For the same center of gravity location, the wind tunnel model trims at lower angle of attack than the full-scale flight case. Nonionized and ionized results for a proposed lunar transfer vehicle compare well to computational results obtained from a previously validated reacting gas algorithm. Under the conditions investigated, effects of weak ionization on the heat transfer and aerodynamic coefficients were minimal.

Hassan, Basil↗
NASA NTRS1993

Hypersonic aerodynamic characteristics for Langley Test Technique Demonstrator

Experimental longitudinal and lateral-directional aerodynamic characteristics were obtained for a generic transatmospheric vehicle concept referred to as the Langley Test Technique Demonstrator. The baseline configuration, without engine modules, was longitudinally and directionally unstable over the hypersonic Mach number range of the investigation and exhibited untrimmed (L/D)max levels between 2.6 and 2.8. Adding various engine modules to the baseline configuration produced mainly, degradations in lift-to-drag ratio. In general, longitudinal aerodynamic coefficients predicted with an engineering code referred to as Aerodynamic Preliminary Analysis System (APAS) were in qualitative, and often quantitative agreement with measurement.

Phillips, W. P.↗
NASA NTRS1993

Six-degree-of-freedom guidance and control-entry analysis of the HL-20

The ability of the HL-20 lifting body to fly has been evaluated for an automated entry from atmospheric interface to landing. This evaluation was required to demonstrate that not only successful touchdown conditions would be possible for this low lift-to-drag-ratio vehicle, but also the vehicle would not exceed its design dynamic pressure limit of 400 psf during entry. This dynamic pressure constraint limit, coupled with limited available pitch-control authority at low supersonic speeds, restricts the available maneuvering capability for the HL-20 to acquire the runway. One result of this analysis was that this restrictive maneuvering capability does not allow the use of a model-following atmospheric entry-guidance algorithm, such as that used by the Space Shuttle, but instead requires a more adaptable guidance algorithm. Therefore, for this analysis, a predictor-corrector guidance algorithm was developed that would provide successful touchdown conditions while not violating the dynamic pressure constraint. A flight-control system was designed and incorporated, along with the predictor-corrector guidance algorithm, into a six-DOF simulation. which showed that the HL-20 remained controllable and could reach the landing site and execute a successful landing under all off-nominal conditions simulated.

Powell, Richard W.↗
NASA NTRS1928

Windmills in the light of modern research

The chief contribution of modern research in the field of windmills is a better understanding of the phenomena and of the available means for the accomplishment of certain results, but also of the natural limits to their productive capacity.

WINDMILLS - RESEARCH↗
NASA NTRS1989

A hypersonic executive transport

Four teams of seven students each developed conceptual designs for a hypersonic executive transport. The specifications called for a 10-passenger jet that had a range of 6000 nm while cruising at a Mach number between M = 4 and M = 6 and was capable of operating from 10,000-ft runways. The configurations produced by the student design teams varied significantly in both planform and propulsion, but all met the mission requirements. A methane-fueled, variable-cycle turbofan-ramjet powered, double-delta transport was the most conventional design; a second aircraft having variable sweep canards utilized hydrogen-fueled turbofan-ramjet engines and laminar flow control on its delta wing. Two configurations were derived from waverider concepts, analytically shaped flying wings that exploit an M = 6 shock wave for efficient lift-to-drag ratios. One of the waveriders uses a liquid, noncryogenic fuel - methylcyclohexane - to power separate turbofan and ramjet engines. The second waverider initially operates its turbofan-ramjet engine with liquid JP-X for take-off and flight to M = 3, then switches to liquid hydrogen for the ramjet high Mach number cycle. The design studies include the effects of aerodynamic heating, environmental concerns, and operating and production costs of each hypersonic transport.

Debonis, J.↗