SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Polymeric materials in low earth orbit will be exposed to a harmful environment mainly due to atomic oxygen and ultraviolet radiation. In geosynchronous earth orbit, the major hazards to such materials are energetic charged particles and ultraviolet radiation. The progress of studies on the effects of these hazards on a polyetherimide, a polyimide, and an epoxy adhesive is presented.
A state-of-the-art literature review of the interactions between fibers and resin within graphite epoxy composite materials was performed. Emphasis centered on: adhesion theory; wetting characteristics of carbon fiber; load transfer mechanisms; methods to evaluate and measure interfacial bond strengths; environmental influence at the interface; and the effect of the interface/interphase on composite performance, with particular attention to impact toughness. In conjunction with the literature review, efforts were made to design experiments to study the wetting behavior of carbon fibers with various finish variants and their effect on adhesion joint strength. The properties of composites with various fiber finishes were measured and compared to the base-line properties of a control. It was shown that by tailoring the interphase properties, a 30% increase in impact toughness was achieved without loss of mechanical properties at both room and elevated temperatures.
In this paper we focus on the polymer-induced depletion attraction and its effect on colloidal sedimentation in colloid-polymer mixtures. We first report a small angle neutron scattering (SANS) study of the depletion effect in a mixture of hard-sphere-like colloid and non-adsorbing polymer. Then we present results of our recent sedimentation measurements in the same colloid-polymer mixture. A key parameter in controlling the sedimentation of heavy colloidal particles is the interparticle potential U(tau), which is the work required to bring two colloidal particles from infinity to a distance tau under a give solvent condition. This potential is known to affect the average settling velocity of the particles and experimentally one needs to have a way to continuously vary U(tau) in order to test the theory. The interaction potential U(tau) can be altered by adding polymer molecules into the colloidal suspension. In a mixture of colloid and non-adsorbing polymer, the potential U(tau) can develop an attractive well because of the depletion effect, in that the polymer chains are expelled from the region between two colloidal particles when their surface separation becomes smaller than the size of the polymer chains. The exclusion of polymer molecules from the space between the colloidal particles leads to an unbalanced osmotic pressure difference pushing the colloidal particles together, which results in an effective attraction between the two colloidal particles. The polymer-induced depletion attraction controls the phase stability of many colloid-polymer mixtures, which are directly of interest to industry.
This paper studies how the properties of large-scale convection affect the decay of plages. The plage decay, caused by the random-walk dispersion of flux tubes, is suggested to be severely affected by differences between the mean size of cellular openings within and around plages. The smaller cell size within a plage largely explains the smaller diffusion coefficient within plages as compared to that of the surrounding regions. The semipermeability of the plage periphery, together with the dependence of the diffusion coefficient on the flux-tube density, can explain the observed slow decay of plages (predicting a typical life time of about a month for a medium-sized plage), the existence of a well-defined plage periphery, and the observed characteristic mean magnetic flux density of about 100 G. One effect of the slowed decay of the plage by the semipermeability of the plage periphery is the increase of the fraction of the magnetic flux that can cancel with flux of the opposite polarity along the neutral line to as much as 80 percent as compared to at most 50 percent in the case of nonuniform diffusion. This may explain why only a small fraction of the magnetic flux is observed to escape from the plage into the surrounding network.
The development of the flour beetle, Tribolium confusum, was studied through all stages of its life cycle. The results show that for each environmental factor there is a limited range of values within which the organisms are able best to survive and that this optimum range of survival becomes smaller when additional stresses are imposed upon the organism. This has been shown for external temperature, oxygen content of the atmosphere, gravity compensation, and radiation. On Biosatellite II it was shown that Tribolium pupae irradiated in spaceflight exhibited more wing abnormalities than ground controls. Later it was shown that gravity compensation, when combined with irradiation, can induce a similar effect at ground level.
The creep strength of 17 ternary columbium (Nb)-base alloys was determined using an abbreviated measuring technique, and the results were analyzed to identify the contributions of solute interactions to creep strength. Isostrength creep diagrams and an interaction strengthening parameter, ST, were used to present and analyze data. It was shown that the isostrength creep diagram can be used to estimate the creep strength of untested alloys and to identify compositions with the most economical use of alloy elements. Positive values of ST were found for most alloys, showing that interaction strengthening makes an important contribution to the creep strength of these ternary alloys.
Particle creation due to field interactions in an expanding Robertson-Walker universe is investigated. A model in which pseudoscalar mesons and photons are created as a result of their mutual interaction is considered, and the energy density of created particles is calculated in model universes which undergo a bounce at some maximum curvature. The free-field creation of non-conformally coupled scalar particles and of gravitons is calculated in the same space-times. It is found that if the bounce occurs at a sufficiently early time the interacting particle creation will dominate. This result may be traced to the fact that the model interaction chosen introduces a length scale which is much larger than the Planck length.
This paper questions the validity of modulation theories that ignore the presence of large regions of enhanced magnetic field in the heliosphere. The scatter-free and diffusive motion of relativistic cosmic rays is simulated in models of the heliospheric magnetic field, which include compressed field structures representing the corotating interaction regions that are believed to be present in the interplanetary medium throughout most of the solar cycle. It is found that the strong field gradients associated with these regions greatly perturb the drift pattern anticipated for simple Parkerian fields, and thus the expected streaming of cosmic rays from over the poles or along the current sheet, during consecutive solar cycles, no longer holds.
Jets of low temperature air are introduced into the aft sections of gas turbine combustors for the purpose of cooling the high temperature gases and quenching the combustion reactions. Research studies, motivated by this complex flow field, have been executed by introducing a heated jet into the cross stream of a wind tunnel. The investigation by Kamotani and Greber stands as a prime example of such investigations and it serves as the principal reference for the present study. The low disturbance level of the cross stream, in their study and in similar research investigations, is compatible with an interest in identifying the basic features of this flow field. The influence of the prototypes' strongly disturbed cross flow is not, however, made apparent in these prior investigations.
Results are presented from one- and two-dimensional modeling of climate perturbations induced by interactive cloud/radiation feedback phenomena. The one-dimensional simulation generated a vertical temperature profile caused by CO2 doubling in the atmosphere, with and without implementation of a cumulus parameterization scheme. The simulation showed that the surface temperature sensitivity in the tropics is higher in the presence of cumulus convection than in its absence. The two-dimensional model accounted for the latitudinal dependence of heating rates caused by cumulus convection and the interactions between the mean circulation and horizontal eddy transport of sensible and latent heat fluxes.
Time-of-flight spectra for Maxwell-Boltzman (MB) distributions of antiprotons initially held in an ion trap and detected after being launched through a 50-cm-long shielding drift tube have been calculated. The distributions used are of temperature 0.4-40 K, cubic length 0.003-3.0 cm, and number 10-100 particles. The mutual Coulomb repulsion of the particles causes a reduction in the number of late arrival particles expected from the MB velocity distribution. The Coulomb energy is not equally divided among the particles during the expansion. The energy is transferred preferentially to the outer particles so that the reduction in the number of slow particles is not necessarily large. The reduction factor is found to be greater than unity when the potential energy of the trapped ions is greater than about 5 percent of the ions' kinetic energy and is about 2 for the launch parameters of the Los Alamos antiproton gravity experiment.
In this paper, trajectory optimization is used as a tool to better understand the performance characteristics of hypersonic Single-Stage-To-Orbit(SSTO) vehicle exhibiting significant aeropropulsive interactions. The energy state approximation is used to determine a straightforward method of determining the scramjet-powered phase of the mission. The energy state method is then used to generate fuel-optimal trajectory results over this portion of the mission for a vehicle configuration of this class. The fuel-optimal unconstrained trajectory is marked by low-altitude acceleration, while a dynamic pressure-constrained trajectory is seen to ride the dynamic pressure constraint for the entire scramjet mission phase. The significance of aeropropulsive interactions in affecting vehicle performance is also investigated.
The phenomenal growth of the satellite communications industry has created a large demand for traveling wave-tubes (TWTs) operating with unprecedented specifications requiring design and production of many novel devices in record time. To achieve this, the TWT industry heavily relies upon computational modeling. However, there is a need for improvement in the TWT industry's computational modeling capabilities as there are often discrepancies between measured TWT data and that predicted by conventional two-dimensional helical TWT interaction codes. This severely limits the analysis and design of novel devices or TWTs with parameters differing from what is conventionally manufactured. In addition, the inaccuracy of current computational tools limits achievable TWT performance because optimized designs require highly accurate models. In particular, collector efficiency, which significantly affects overall TWT efficiency, is difficult to optimize unless extremely accurate spent beam data is predicted by the interaction code.
Theory and experiments involving single droplet combustion date back to 1953, with the first microgravity work appearing in 1956. The problem of a spherical droplet burning in an infinite, quiescent microgravity environment is a classical problem in combustion research with the classical solution appearing in nearly every textbook on combustion. The microgravity environment offered by ground-based facilities such as drop towers and space-based facilities is ideal for studying the problem experimentally. A recent review by Choi and Dryer shows significant advances in droplet combustion have been made by studying the problem experimentally in microgravity and comparing the results to one dimensional theoretical and numerical treatments of the problem. Studying small numbers of interacting droplets in a well-controlled geometry represents a logical step in extending single droplet investigations to more practical spray configurations. Studies of droplet interactions date back to Rex and co-workers, and were recently summarized by Annamalai and Ryan. All previous studies determined the change in the burning rate constant, k, or the flame characteristics as a result of interactions. There exists almost no information on how droplet interactions a effect extinction limits, and if the extinction limits change if the array is in the diffusive or the radiative extinction regime. Thus, this study examined experimentally the effect that droplet interactions have on the extinction process by investigating the simplest array configuration, a binary droplet array. The studies were both in normal gravity, reduced pressure ambients and microgravity facilities. The microgravity facilities were the 2.2 and 5.2 second drop towers at the NASA Glenn Research Center and the 10 second drop tower at the Japan Microgravity Center. The experimental apparatus and the data analysis techniques are discussed in detail elsewhere.
Adaptive Mesh Refinement (AMR) promises a much more computationally efficient meansto obtain a discrete approximation to a continuous boundary value problem of a specifiedaccuracy than classic isotropic grid refinement. The AMR capability of OVERFLOW is utilizedto provide estimates of the exact analytical solutions to problems of interest to turbulencemodeling. Predictions of surface pressure and skin friction, essentially the state of stress at thesurface, shows little difference with grids believed to be "grid resolved." Velocity profiles, on theother hand, show marked differences in flows with shocks. The AMR method, as implementedin OVERFLOW2.2k, appears to provide the ability to produce arbitrarily accurate solutionsat a predictable cost much smaller than classic uniform mesh refinement.
Galaxy interactions and mergers are thought to play an important role in the evolution of galaxies. Studies in the nearby universe show a higher fraction of active galactic nuclei(AGNs)in interacting and merging galaxies than in their isolated counterparts, indicating that such interactions are important contributors to black hole growth. To investigate the evolution of this role at higher redshifts, we have compiled the largest known sample of major spectroscopic galaxy pairs(2381 withΔV<5000 km s−1)at 0.5<z<3.0 from observations in the COSMOS and CANDELS surveys. We identify X-ray and IR AGNs among this kinematic pair sample, a visually identified sample of mergers and interactions, and a mass-, redshift-, and environment-matched control sample for each in order to calculate AGN fractions and the level of AGN enhancement as a function of relative velocity, redshift, and X-ray luminosity. While we see a slight increase in AGN fraction with decreasing projected separation, overall, we find no significant enhancement relative to the control sample at any separation. In the closest projected separation bin(<25 kpc,ΔV<1000 km s−1),we find enhancements of a factor of-+0.940.160.21and-+1.000.310.58for X-ray and IR-selected AGNs, respectively. While we conclude that galaxy interactions do not significantly enhance AGN activity on average over 0.5<z<3.0 at these separations, given the errors and the small sample size at the closest projected separations, our results would be consistent with the presence of low-level AGN enhancement
The effect of finite span on the jet-surface interaction noise source and the jet mixing noise shielding and reflection effects is considered using recently acquired experimental data. First, the experimental setup and resulting data are presented with particular attention to the role of surface span on far-field noise. These effects are then included in existing empirical models that have previously assumed that all surfaces are semi-infinite. This extended abstract briefly describes the experimental setup and data leaving the empirical modeling aspects for the final paper.
The effect of finite span on the jet-surface interaction noise source and the jet mixing noise shielding and reflection effects is considered using recently acquired experimental data. First, the experimental setup and resulting data are presented with particular attention to the role of surface span on far-field noise. These effects are then included in existing empirical models that have previously assumed that all surfaces are semi-infinite. This extended abstract briefly describes the experimental setup and data leaving the empirical modeling aspects for the final paper.