Search NASA⌕ Search

SEARCH · Search NASA

Results for “Sound”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 487 records · Page 27

Sound radiation from a subsonic rotor subjected to turbulence

The broadband sound radiated by a subsonic rotor subjected to turbulence in the approach stream has been analyzed. The power spectral density of the sound intensity has been found to depend on a characteristic time scale-namely, the integral scale of the turbulence divided by the axial flow velocity-as well as several length-scale ratios. These consist of the ratio of the integral scale to the acoustic wavelength, rotor radius, and blade chord. Due to the simplified model chosen, only a limited number of cascade parameters appear. Limited comparisons with experimental data indicate good agreement with predicted values.

Sevik, M.↗

Pressure contact sounding data for NASA's Atmospheric Variability Experiment (AVE 2)

The basic rawinsonde data are described at each pressure contact from the surface to sounding termination for the 54 stations participating in the AVE 2 pilot experiment. Soundings were taken at three-hour intervals from stations within the United States east of about 105 degrees west longitude. Methods of data reduction and estimates of data accuracy are discussed. Examples of the data records produced are shown. The AVE 2 pilot experiment was conducted as part of NASA's program to better understand and establish the extent of applications for meteorological satellite sensor data through correlative ground truth experiments and to provide basic experimental data for use in studies of atmospheric scales-of-motion interrelationships.

Fuelberg, H. E.↗

The 25-MB sounding data and synoptic charts for NASA's AVE 2 pilot experiment

Rawinsonde data were tabulated at 25-mb intervals from the surface to 25 mb for the 54 stations participating in the atmospheric variability experiment 2 Pilot Experiment which began at 12 Greenwich mean time on May 11 and ended at 12 Greenwich mean time on May 12, 1974. Soundings were made at 3 hour intervals. Methods of processing and data accuracy are discussed, and synoptic charts prepared from the data are presented. The area covered by the sounding stations is the eastern United States east of approximately 105 deg west longitude.

Scoggins, J. R.↗

Spinning mode sound propagation in ducts with acoustic treatment and sheared flow

The propagation of spinning mode sound was considered for a cylindrical duct with sheared steady flow. Calculations concentrated on the determination of the wall optimum acoustic impedance and the maximum possible attenuation. Both the least attenuated and higher radial modes for spinning lobe patterns were considered. A parametric study was conducted over a wide range of Mach numbers, spinning lobe numbers, sound frequency, and boundary layer thickness. A correlation equation was developed from theoretical considerations starting with the thin boundary layer approximation of Eversman. This correlation agrees well with the more exact calculations for inlets and provides a single boundary layer refraction parameter which determines the change in optimum wall impedance due to refraction effects.

Rice, E. J.↗

NASA plans for space-processing experiments on sounding rockets

Planning for sounding rocket space processing experiments in the second half of 1975 is reported. Currently operational sounding rocket systems are capable of carrying payloads containing more than 50 kg of experimental apparatus on trajectories including between 5 and 10 min of coasting flight above 100 km altitude. When equipped with stabilization systems to nullify angular velocities in their rotational degrees of freedom, these vehicles can provide an environment in which accelerations are less than 1 mm/sec per 2. The cost of flight operations to implement a rocket experiment program will be of the order of 2000 dollars per kg of discretionary payload, and within the next two years newly operational systems are expected to reduce the cost to about 700 dollars per kg.

Bredt, J. H.↗

An interdisciplinary study of the estuarine and coastal oceanography of Block Island Sound and adjacent New York coastal waters

The author has identified the following significant results. Photo-optical additive color quantitative measurements were made of ERTS-1 reprocessed positives of New York Bight and Block Island Sound. Regression of these data on almost simultaneous ship sample data of water's physical, chemical, biological, and optical properties showed that ERTS bands 5 and 6 can be used to predict the absolute value of the total number of particles and bands 4 and 5 to predict the relative extinction coefficient in New York Bight. Water masses and mixing patterns in Block Island Sound heretofore considered transient were found to be persistent phenomena requiring revision of existing mathematical and hydraulic models.

Yost, E. F.↗

Propagation of sound in elliptic ducts

The paper studies the propagation of sound in an elliptic duct, which is of considerable interest in the field of jet-engine noise reduction. The cutoff frequencies of the higher-order circumferential modes in an elliptic duct are calculated for various duct eccentricities. The results indicate that, if equal inlet area is retained, even major deformations of the inlet shape will have virtually no influence on the cutoff conditions of the radiated sound.

Lowson, M. V.↗

Sound propagation in curved ducts

An analysis of the sound field in a circularly curved duct of rectangular cross-section is carried out for both rigid and locally-reacting absorbing walls. The field is excited by a piston source at one end of the duct section, and comparisons of the acoustic field and the net power flow along the duct axis are made with corresponding results for a straight duct section for various frequencies. It is found that in general the curved duct yields a significant increase in sound attenuation along the duct axis as compared to the straight duct.

Myers, M. K.↗

Spinning mode sound propagation in ducts with acoustic treatment and sheared flow

The propagation of spinning mode sound was considered for a cylindrical duct with sheared steady flow. The calculations concentrated on the determination of the wall optimum acoustic impedance and the maximum possible attenuation. Both the least attenuated and higher radial modes for spinning lobe patterns were considered. A parametric study was conducted over a wide range of Mach numbers, spinning lobe numbers, sound frequency, and boundary layer thickness. A correlation equation was developed from theoretical considerations starting with the thin boundary layer approximation of Eversman. This correlation agrees well with the more exact calculations for inlets and provides a single boundary layer refraction parameter which determines the change in optimum wall impedance due to refraction effects.

Rice, E. J.↗

A sounding rocket spectroheliometer for photometric studies at extreme ultraviolet wavelengths

Construction and mode of operation are described for a sounding rocket spectroheliometer used to establish the sensitivity of the EUV spectroheliometer on the Skylab Apollo Telescope Mount (ATM). The sounding rocket instrument was calibrated immediately before and after two flights and the calibration was transferred when the rocket and ATM instruments simultaneously measured the average intensity emitted by a quiet area of the solar disk. Descriptions are presented for the payload assembly and flight sequence, the optical system (telescope, spectrometer, and pointing reference camera), the vacuum pumping system, and the instrument electronics. Results obtained from the two flights in August and December 1973 are discussed, which included unambiguous determinations of the absolute intensity emitted by a region of the quiet solar disk over the wavelength range from 1350 to 300 A on two separate occasions and the establishment of photometric accuracy to that of laboratory calibration procedures.

Timothy, J. G.↗

Pressure Contact Sounding Data for NASA's Atmospheric Variability Experiment (AVE 3)

The basic rawinsonde data are described at each pressure contact from the surface to sounding termination for the 41 stations participating in the AVE III measurement program that began at 0000 GMT on February 6 and ended at 1200 GMT on February 7, 1975. Soundings were taken at 3-hour intervals during a large period of the experiment from most stations within the United States east of about 105 degrees west longitude. Methods of data processing, change in reduction scheme since the AVE II pilot experiment, and data accuracy are briefly discussed. An example of contact data is presented, and microfiche cards of all the contact data are included in the appendix. The AVE III project was conducted to better understand and establish the extent of applications for meteorological satellite sensor data through correlative ground truth experiments and to provide basic experimental data for use in studies of atmospheric scales of-motion interrelationships.

Fuelberg, H. E.↗

Real time analysis of voiced sounds

A power spectrum analysis of the harmonic content of a voiced sound signal is conducted in real time by phase-lock-loop tracking of the fundamental frequency, (f sub 0) of the signal and successive harmonics (h sub 1 through h sub n) of the fundamental frequency. The analysis also includes measuring the quadrature power and phase of each frequency tracked, differentiating the power measurements of the harmonics in adjacent pairs, and analyzing successive differentials to determine peak power points in the power spectrum for display or use in analysis of voiced sound, such as for voice recognition.

Hong, J. P.↗

Application of parametric and non-parametric statistics to sounding rocket dispersion including large sample and small sample theory

Analytical methods for obtaining large and small samples to be used in sounding rocket dispersion statistics are described. When the distribution of the parent population is assumed known, a method is called parametric. When no assumption is made about the parent population, the method is called nonparametric. Parametric and nonparametric methods are given for both large and small samples. The assumed distribution for the parametric case will be normal and it is shown that sample nonparametric theory is easier to apply in many cases, giving essentially the same results as parametric theory. The method is applied to the dispersion of NASA sounding rockets from 1959 to 1974.

James F. McGarvey↗

Stage separation study of Nike-Black Brant V Sounding Rocket System

A new Sounding Rocket System has been developed. It consists of a Nike Booster and a Black Brant V Sustainer with slanted fins which extend beyond its nozzle exit plane. A cursory look was taken at different factors which must be considered when studying a passive separation system. That is, one separation system without mechanical constraints in the axial direction and which will allow separation due to drag differential accelerations between the Booster and the Sustainer. The equations of motion were derived for rigid body motions and exact solutions were obtained. The analysis developed could be applied to any other staging problem of a Sounding Rocket System.

Ferragut, N. J.↗

Development of the Hawk/Nike Hawk sounding rocket vehicles

A new sounding rocket family, the Hawk and Nike-Hawk Vehicles, have been developed, flight tested and added to the NASA Sounding Rocket Vehicle Stable. The Hawk is a single-stage vehicle that will carry 35.6 cm diameter payloads weighing 45.5 kg to 91 kg to altitudes of 78 km to 56 km, respectively. The two-stage Nike-Hawk will carry payloads weighing 68 kg to 136 kg to altitudes of 118 km to 113 km, respectively. Both vehicles utilize the XM22E8 Hawk rocket motor which is available in large numbers as a surplus item from the U.S. Army. The Hawk fin and tail can hardware were designed in-house. The Nike tail can and fin hardware are surplus Nike-Ajax booster hardware. Development objectives were to provide a vehicle family with a larger diameter, larger volume payload capability than the Nike-Apache and Nike-Tomahawk vehicles at comparable cost. Both vehicles performed nominally in flight tests.

Flowers, B. J.↗

On sound transmission into a stiffened cylindrical shell under flight conditions

In the context of airborne-noise transmission through an aircraft fuselage, a mathematical model is presented for sound transmission into a stiffened cylindrical shell. The stiffening effect of the ring frames and stringers is approximated by a 'smeared'-stiffener theory which includes the eccentricity of the stiffeners. Numerical results are presented for a typical narrow-bodied jet in cruising flight. A comparison is made between noise transmission into a monococque shell and into a stiffened shell. The stiffeners are shown to greatly increase TL for small incidence angles, so that the effective 'window' for noise transmission is restricted to the neighborhood of normal incidence. Flow is shown to increase TL for sound waves propagating 'upstream' against the flow. Stiffeners are also shown to raise the ring frequency at which a dip in cylinder TL occurs. Limitations of the 'smeared'-stiffener theory are also discussed.

Koval, L. R.↗

Effect of slot width on transition and noise attenuation of a sound shield panel for supersonic wind tunnels

The effect of slot width on transition and noise attenuation of a planar rod wall sound shield has been investigated at Mach 6. Boundary layer laminarization was obtained by induced suction through adjustable slots or gaps between the rods. Transition Reynolds numbers increased significantly with increasing gap width. The local mean flow field above the suction panel rod array was uniform. Important factors for design and performance of a supersonic wind-tunnel sound shield are rod diameter, gap-to-rod diameter ratio, surface finish of the rods, and leading-edge configuration.

Harvey, W. D.↗