Search NASA⌕ Search

SEARCH · Search NASA

Results for “Stability and Control”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 487 records · Page 27
All sourcesNASA NTRSDOE OSTI
NASA NTRS1959

Effects of Forebody Deflection on the Stability and Control Characteristics of a Canard Airplane Configuration with a High Trapezoidal Wing at a Mach Number of 2.01

An investigation has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel at a Mach number of 2.01 to determine the effects of forebody deflection on the stability and control characteristics of a canard airplane configuration. The configuration had a high trapezoidal aspect-ratio-3 wing, a trapezoidal canard surface, and a single swept vertical tail. Forebody deflection angles of 0 deg, 2 deg and deg were investigated. The results indicated that nose-up deflections of the forebody provided positive increments of pitching moment with little increase in drag and hence would be useful in reducing the pitch-control requirements and the attendant losses in lift-drag ratio due to trimming. Deflection of the forebody, however, aggravated the decrease in directional stability with increasing angle of attack by causing a loss in tail contribution and by increasing the instability of the wing-body combination.

Spearman, M. Leroy↗
NASA NTRS1977

Stability and control characteristics of a monoplannar missile configuration with two low-profile tail arrangements at Mach numbers from 1.70 to 2.86

An experimental wind tunnel investigation has been made to determine the longitudinal and lateral aerodynamic stability and control characteristics of two tail fin arrangements of a monowing missile model. Both a conventional cruciform and a low profile tail arrangement were tested. The results indicate that the tail surfaces of both configurations were effective in producing pitch control. It was also concluded that both are effective in producing roll and yaw control that is accompanied by proverse yaw and roll, respectively. The conventional cruciform tail produces the most roll and yaw control.

Blair, A. B., Jr.↗
NASA NTRS1993

Determination of the stability and control derivatives of the NASA F/A-18 HARV using flight data

This report documents the research conducted for the NASA-Ames Cooperative Agreement No. NCC 2-759 with West Virginia University. A complete set of the stability and control derivatives for varying angles of attack from 10 deg to 60 deg were estimated from flight data of the NASA F/A-18 HARV. The data were analyzed with the use of the pEst software which implements the output-error method of parameter estimation. Discussions of the aircraft equations of motion, parameter estimation process, design of flight test maneuvers, and formulation of the mathematical model are presented. The added effects of the thrust vectoring and single surface excitation systems are also addressed. The results of the longitudinal and lateral directional derivative estimates at varying angles of attack are presented and compared to results from previous analyses. The results indicate a significant improvement due to the independent control surface deflections induced by the single surface excitation system, and at the same time, a need for additional flight data especially at higher angles of attack.

Napolitano, Marcello R.↗
NASA NTRS1955

Longitudinal Stability and Control Characteristics as Determined by the Rocket-Model Technique for an Inline, Cruciform, Canard Missile Configuration with a Low-Aspect-Ratio Wing Having Trailing-Edge Flap Controls for a Mach Number Range of 0.7 to 1.8

Two full-scale models of an inline, cruciform, canard missile configuration having a low-aspect-ratio wing equipped with flap-type controls were flight tested in order to determine the missile's longitudinal aerodynamic characteristics. Stability derivatives and control and drag characteristics are presented for a range of Mach number from 0.7 to 1.8. Nonlinear lift and moment curves were noted for the angle-of-attack range of this test (0 deg to 8 deg ). The aerodynamic-center location for angles of attack near 5 deg remained nearly constant for supersonic speeds at 13.5 percent of the mean aerodynamic chord; whereas for angles of attack near O deg, there was a rapid forward movement of the aerodynamic center as the Mach number increased. At a control deflection of O deg, the missile's response to the longitudinal control was in an essentially fixed space plane which was not coincident with the pitch plane as a result of the missile rolling. As a consequence, stability characteristics were determined from the resultant of pitch and yaw motions. The damping-in-pitch derivatives for the two angle-of-attack ranges of the test are in close agreement and varied only slightly with Mach number. The horn-balanced trailing-edge flap was effective in producing angle of attack over the Mach number range.

Baber, H. T., Jr.↗
NASA NTRS1955

Longitudinal Stability and Control Characteristics as Determined by the Rocket-model Technique for an Inline, Cruciform, Canard Missile Configuration with a Low-aspect-ratio Wing Having Trailing-edge Flap Controls for a Mach Number Range of 0.7 to 1.

Two full-scale models of an inline, cruciform, canard missile configuration having a low-aspect-ratio wing equipped with flap-type controls were flight tested in order to determine the missile's longitudinal aerodynamic characteristics. Stability derivatives and control and drag characteristics are presented for a range of Mach number from 0.7 to 1.8. Nonlinear lift and moment curves were noted for the angle - of-attack range of this test (0 deg to 8 deg). The aerodynamic-center location for angles of attack near 50 remained nearly constant for supersonic speeds at 13.5 percent of the mean aerodynamic chord; whereas for angles of attack near 0 deg, there was a rapid forward movement of the aerodynamic center as the Mach number increased. At a control deflection of 0 deg, the missile's response to the longitudinal control was in an essentially fixed space plane which was not coincident with the pitch plane as a result of the missile rolling. As a consequence, stability characteristics were determined from the resultant of pitch and yaw motions. The damping-in-pitch derivatives for the two angle -of-attack ranges of the test are in close agreement and varied only slightly with Mach number. The horn-balanced trailing-edge flap was effective in producing angle of attack over the Mach number range.

Baber, Hal T , Jr↗
NASA NTRS1972

Space shuttle: Static stability and control investigation of NR/GD delta wing booster (B-20) and delta wing orbiter (134D), volume 1

Experimental aerodynamic investigations have been made on a .0035 scale model North American Rockwell/General Dynamics version of the space shuttle. Static stability and control data were obtained on the delta wing booster alone (B-20) and with the delta wing orbiter (134D) mounted in various positions on the booster. Six component aerodynamic force and moment data were recorded over an angle of attack range from -10 deg to 24 deg at 0 deg and 6 deg sideslip angles and from -10 deg to +10 deg sideslip at 0 deg angle of attack. Mach number ranged from 0.6 to 4.96.

Allen, E. C.↗
NASA NTRS1979

Longitudinal and lateral static stability and control characteristics of a 1/6-scale model of a remotely piloted research vehicle with a supercritical wing

An investigation was conducted in the Langley 8-foot transonic pressure tunnel to determine the longitudinal and lateral-directional static stability and control characteristics of a 1/6-scale force model of a remotely piloted research vehicle. The model was equipped with a supercritical wing and employed elevons for pitch and roll control. Test conditions were as follows: Reynolds number of about 6.6 x 10 to the 6th power per meter, variations of sideslip from -6 deg to 6 deg, elevon deflection angle (symmetrically and asymmetrically) from -9 deg to 3 deg, and rudder deflection angle from 0 deg to -10 deg. The model was longitudinally statically stable at angles of attack up to about 7 deg, which is significantly greater than the angle of attack for the cruise condition (approximately 4 deg). In the range of test Mach numbers, the model was directionally stable and had positive effective dihedral, sufficient pitch control, and positive effectiveness of roll and yaw control.

Byrdsong, T. A.↗
NASA NTRS2006

A Theoretical Solid Oxide Fuel Cell Model for System Controls and Stability Design

As the aviation industry moves towards higher efficiency electrical power generation, all electric aircraft, or zero emissions and more quiet aircraft, fuel cells are sought as the technology that can deliver on these high expectations. The Hybrid Solid Oxide Fuel Cell system combines the fuel cell with a microturbine to obtain up to 70 percent cycle efficiency, and then distributes the electrical power to the loads via a power distribution system. The challenge is to understand the dynamics of this complex multi-discipline system, and design distributed controls that take the system through its operating conditions in a stable and safe manner while maintaining the system performance. This particular system is a power generation and distribution system and the fuel cell and microturbine model fidelity should be compatible with the dynamics of the power distribution system in order to allow proper stability and distributed controls design. A novel modeling approach is proposed for the fuel cell that will allow the fuel cell and the power system to be integrated and designed for stability, distributed controls, and other interface specifications. This investigation shows that for the fuel cell, the voltage characteristic should be modeled, but in addition, conservation equation dynamics, ion diffusion, charge transfer kinetics, and the electron flow inherent impedance should also be included.

Kopasakis, George↗
NASA NTRS1976

Practical aspects of a maximum likelihood estimation method to extract stability and control derivatives from flight data

A maximum likelihood estimation method was applied to flight data and procedures to facilitate the routine analysis of a large amount of flight data were described. Techniques that can be used to obtain stability and control derivatives from aircraft maneuvers that are less than ideal for this purpose are described. The techniques involve detecting and correcting the effects of dependent or nearly dependent variables, structural vibration, data drift, inadequate instrumentation, and difficulties with the data acquisition system and the mathematical model. The use of uncertainty levels and multiple maneuver analysis also proved to be useful in improving the quality of the estimated coefficients. The procedures used for editing the data and for overall analysis are also discussed.

Iliff, K. W.↗
NASA NTRS1958

Low-speed stability and control and spinning characteristics of dynamic models of the X-15 airplane

Paper summarizes the results of low-speed dynamic-model studies of the X-15 aircraft. The investigation included flight tests of a 1/7-scale model in the Langley full-scale tunnel and also in free-gliding flight using a recently developed radio-control technique. In order to interpret and evaluate some of the flight test results, static and dynamic force tests were conducted to determine the low-speed stability and control parameters for angles of attack from 0 degree to as high as 90 degrees. Preliminary tests also have been made in the Langley 20-foot free-spinning tunnel to determine the developed spin and recovery characteristics. Inasmuch as the lower rudder will be jettisoned sometime during the subsonic glide, the investigation has included tests with the lower rudder both on and off.

Hewes, Donald E↗
NASA NTRS1974

Identification of M2/F3 stability and control derivatives from flight data containing gust effects

The application of the maximum likelihood identification technique to M2/F3 lifting body flight data containing wind gust effects is discussed. With the objective of this effort being the identification of the stability and control derivatives, it is shown first that the output error technique (or modified Newton-Raphson) fails to fit the recorded data accurately. The means of applying the maximum likelihood technique to this problem are then discussed and the results given which indicate an accurate fit to the data. The question of derivative signs opposite to the wind tunnel values is then addressed and the results of three techniques for dealing with this problem are presented. These techniques are a priori weighting, fixing parameter values, and rank deficient inverses.

Stepner, D. E.↗
NASA NTRSDate not supplied

Experimental Testing of Advanced Generalized Predictive Control for Stability Augmentation and Vibration Reduction of Tiltrotor Aircraft

Generalized Predictive Control (GPC) is an advanced form of an adaptive control algorithm that uses experimentally acquired data to determine the input-output relationship of complex systems through a process called system identification (system ID). GPC has historically been applied to wind tunnel tests of dynamically-scaled tiltrotor aircraft for stability augmentation and vibration reduction since the complex nature of these dynamic systems does not lend itself well to traditional control theory. Advanced GPC (AGPC) improves upon traditional GPC by enabling self-adaptation as conditions change from those used to acquire the system ID and controller performance would normally erode. The present research expands upon previous analytical development and demonstration of AGPC with experimental demonstration. To support AGPC, this present work also identifies and describes figures of merit that define a good working controller and quantifies the uniqueness of the control inputs and quality of the system ID parameters. The present research demonstrates that AGPC consistently performs better than traditional GPC and can successfully adapt to changing conditions.

Active Controls↗
NASA NTRSDate not supplied

Experimental Testing of Advanced Generalized Predictive Control for Stability Augmentation and Vibration Reduction of Tiltrotor Aircraft

Generalized Predictive Control (GPC) is an advanced form of an adaptive control algorithm that uses experimentally acquired data to determine the input-output relationship of complex systems through a process called system identification (system ID). GPC has historically been applied to wind tunnel tests of dynamically-scaled tiltrotor aircraft for stability augmentation and vibration reduction since the complex nature of these dynamic systems does not lend itself well to traditional control theory. Advanced GPC (AGPC) improves upon traditional GPC by enabling self-adaptation as conditions change from those used to acquire the system ID and controller performance would normally erode. The present research expands upon previous analytical development and demonstration of AGPC with experimental demonstration. To support AGPC, this present work also identifies and describes figures of merit that define a good working controller and quantifies the uniqueness of the control inputs and quality of the system ID parameters. The present research demonstrates that AGPC consistently performs better than traditional GPC and can successfully adapt to changing conditions.

Active Controls↗
NASA NTRS1980

Wind-tunnel investigation of longitudinal and lateral-directional stability and control characteristics of a 0.237-scale model of a remotely piloted research vehicle with a thick, high-aspect-ratio supercritical wing

A 0.237-scale model of a remotely piloted research vehicle equipped with a thick, high-aspect-ratio supercritical wing was tested in the Langley 8-foot transonic tunnel to provide experimental data for a prediction of the static stability and control characteristics of the research vehicle as well as to provide an estimate of vehicle flight characteristics for a computer simulation program used in the planning and execution of specific flight-research mission. Data were obtained at a Reynolds number of 16.5 x 10 to the 6th power per meter for Mach numbers up to 0.92. The results indicate regions of longitudinal instability; however, an adequate margin of longitudinal stability exists at a selected cruise condition. Satisfactory effectiveness of pitch, roll, and yaw control was also demonstrated.

Byrdsong, T. A.↗