SEARCH · Search NASA

Results for “open loop”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 487 records · Page 27

All sources NASA NTRS DOE OSTI

NASA NTRS1987

Measurement technique of the Giotto radio science experiment

The paper describes the technique used to record time delay and waveform measurements for the Giotto radio science experiment of ESA's mission to comet Halley. The data were taken by using either two-way measurements (during pre- and post-encounter) or one-way measurements (during encounter with comet Halley), the downlink of the radio signal of the Giotto spacecraft being received at 8.4 GHz by the 64 m tracking stations of NASA's Deep Space Network (DSN). The waveform measurements were obtained at a sampling frequency of 50 kHz with an open-loop receiver assembly at DSN station Canberra as recently used for the Voyager/Uranus fly-by. Performance and calibration data are given as relevant to the radio subsystems on the ground and aboard Giotto.

Edenhofer, P.↗

NASA NTRS1987

A new simulation model building process for use in dynamic systems integration research

A framework to build simulation models for aircraft dynamic systems integration is described. The objective of the framework is increased simulation model fidelity and reduced time required to develop and modify these models. The equations of motion for an elastic aircraft and their impact on the framework are discussed in broad terms. A software tool which automatically generates FORTRAN routines for tabular data lookups, the language used to develop a simulation model, and the structures for passing information into a simulation are discussed. A simulation variable nomenclature is presented. The framework has been applied to build an open-loop F/A-18 simulation model. This example model is used to illustrate model reduction issues. Current deficiencies in the framework are identified as areas for future research.

Arbuckle, P. Douglas↗

NASA NTRS1987

Dynamic stability and handling qualities tests on a highly augmented, statically unstable airplane

Novel flight test and analysis techniques in the flight dynamics and handling qualities area are described. These techniques were utilized at NASA Ames-Dryden during the initial flight envelope clearance of the X-29A aircraft. It is shown that the open-loop frequency response of an aircraft with highly relaxed static stability can be successfully computed on the ground from telemetry data. Postflight closed-loop frequency response data were obtained from pilot-generated frequency sweeps and it is found that the current handling quality requirements for high-maneuverability aircraft are generally applicable to the X-29A.

Gera, Joseph↗

NASA NTRS1987

Simulation investigation of the effects of helicopter hovering dynamics on pilot performance

A fixed base simulation has been performed to investigate the handling qualities requirements for the mid-term pitch response of a helicopter at hover and in low-speed flight. Pilot rating results from this simulation were compared with those from previous experiments to develop handling qualities limits on the frequency and damping of the oscillatory mode in the hovering cubic. Pilot performance data obtained during the experiment were used to confirm the pilot rating results. These data show the pilot performance to closely match that predicted by the theory of piloted control. A means of predicting pilot ratings from the open-loop aircraft dynamics is presented.

Aponso, Bimal L.↗

NASA NTRS1987

Modeling XV-15 tilt-rotor aircraft dynamics by frequency and time-domain identification techniques

Models of the open-loop hover dynamics of the XV-15 Tilt-Rotor Aircraft are extracted from flight data using two approaches: frequency domain and time-domain identification. Both approaches are reviewed and the identification results are presented and compared in detail. The extracted models are compared favorably, with the differences associated mostly with the inherent weighing of each technique. Step responses are used to show that the predictive capability of the models from both techniques is excellent. Based on the results of this study, the relative strengths and weaknesses of the frequency and time-domain techniques are summarized and a proposal for a coordinated parameter identification approach is presented.

Tischler, Mark B.↗

NASA NTRS1988

Design for performance enhancement in feedback control systems with multiple saturating nonlinearities

A systematic control design methodology is introduced for multi-input/multi-output systems with multiple saturations. The methodology can be applied to stable and unstable open loop plants with magnitude and/or rate control saturations and to systems in which state limitations are desired. This new methodology is a substantial improvement over previous heuristic single-input/single-output approaches. The idea is to introduce a supervisor loop so that when the references and/or disturbances are sufficiently small, the control system operates linearly as designed. For signals large enough to cause saturations, the control law is modified in such a way to ensure stability and to preserve, to the extent possible, the behavior of the linear control design. Key benefits of this methodology are: the modified compensator never produces saturating control signals, integrators and/or slow dynamics in the compensator never windup, the directional properties of the controls are maintained, and the closed loop system has certain guaranteed stability properties. The advantages of the new design methodology are illustrated by numerous simulations, including the multivariable longitudinal control of modified models of the F-8 (stable) and F-16 (unstable) aircraft.

Kapasouris, Petros↗

NASA NTRS1988

Design of feedback control systems for stable plants with saturating actuators

A systematic control design methodology is introduced for multi-input/multi-output stable open loop plants with multiple saturations. This new methodology is a substantial improvement over previous heuristic single-input/single-output approaches. The idea is to introduce a supervisor loop so that when the references and/or disturbances are sufficiently small, the control system operates linearly as designed. For signals large enough to cause saturations, the control law is modified in such a way as to ensure stability and to preserve, to the extent possible, the behavior of the linear control design. Key benefits of the methodology are: the modified compensator never produces saturating control signals, integrators and/or slow dynamics in the compensator never windup, the directional properties of the controls are maintained, and the closed loop system has certain guaranteed stability properties. The advantages of the new design methodology are illustrated in the simulation of an academic example and the simulation of the multivariable longitudinal control of a modified model of the F-8 aircraft.

Kapasouris, Petros↗

NASA NTRS1988

Modelling and Control of an Annular Momentum Control Device

The results of a modelling and control study for an advanced momentum storage device supported on magnetic bearings are documented. The control challenge posed by this device lies in its dynamics being such a strong function of flywheel rotational speed. At high rotational speed, this can lead to open loop instabilities, resulting in requirements for minimum and maximum control bandwidths and gains for the stabilizing controllers. Using recently developed analysis tools for systems described by complex coefficient differential equations, the closed properties of the controllers were analyzed and stability properties established. Various feedback controllers are investigated and discussed. Both translational and angular dynamics compensators are developed, and measures of system stability and robustness to plant and operational speed variations are presented.

Downer, James R.↗

NASA NTRS1988

A microprocessor-based real-time simulator of a turbofan engine

A real-time digital simulator of a Pratt and Whitney F 100 engine is discussed. This self-contained unit can operate in an open-loop stand-alone mode or as part of a closed-loop control system. It can also be used in control system design and development. It accepts five analog control inputs and its sixteen outputs are returned as analog signals.

Litt, Jonathan S.↗

NASA NTRS1986

Integrated Application of Active Controls (IAAC) technology to an advanced subsonic transport project: Program review

This report summarizes the Integrated Application of Active Controls (IAAC) Technology to an Advanced Subsonic Transport Project, established as one element of the NASA/Boeing Energy Efficient Transport Technology Program. The performance assessment showed that incorporating ACT into an airplane designed to fly approximately 200 passengers approximately 2,000 nmi could yield block fuel savings from 6 to 10 percent at the design range. The principal risks associated with incorporating these active control functions into a commercial airplane are those involved with the ACT system implementation. The Test and Evaluation phase of the IAAC Project focused on the design, fabrication, and test of a system that implemented pitch axis fly-by-wire, pitch axis augmentation, and wing load alleviation. The system was built to be flight worthy, and was planned to be experimentally flown on the 757. The system was installed in the Boeing Digital Avionics Flight Controls Laboratory (DAFCL), where open loop hardware and software tests, and a brief examination of a direct drive valve (DDV) actuation concept were accomplished. The IAAC Project has shown that ACT can be beneficially incorporated into a commercial transport airplane. Based on the results achieved during the testing phase, there appears to be no fundamental reason(s) that would preclude the commercial application of ACT, assuming an appropriate development effort is included.

Source record↗

NASA NTRS1987

Development of a generic combustion stability code for liquid propellant rocket engines

The mathematical framework for a combustion stability analysis code is outlined. The goal for the code is to be general enough in problem treatment so that its validity and accuracy extend over a wide range of problem applications and that it lends the convenience for any future model improvement if necessary. An approach for modeling the combustion dynamics is devised to meet both requirements. An open-loop numerical procedure is also developed to mechanistically model various combustion processes for determining the stability parameters.

Fang, J. J.↗

NASA NTRS1988

MSAT-X phased array antenna adaptions to airborne applications

The Mobile Satellite Experiment (MSAT-X) phased array antenna is being modified to meet future requirements. The proposed system consists of two high gain antennas mounted on each side of a fuselage, and a low gain antenna mounted on top of the fuselage. Each antenna is an electronically steered phased array based on the design of the MSAT-X antenna. A beamforming network is connected to the array elements via coaxial cables. It is essential that the proposed antenna system be able to provide an adequate communication link over the required space coverage, which is 360 degrees in azimuth and from 20 degrees below the horizon to the zenith in elevation. Alternative design concepts are suggested. Both open loop and closed loop backup capabilities are discussed. Typical antenna performance data are also included.

Sparks, C.↗

NASA NTRS1986

Variable structure control of nonlinear systems through simplified uncertain models

A variable structure control approach is presented for the robust stabilization of feedback equivalent nonlinear systems whose proposed model lies in the same structural orbit of a linear system in Brunovsky's canonical form. An attempt to linearize exactly the nonlinear plant on the basis of the feedback control law derived for the available model results in a nonlinearly perturbed canonical system for the expanded class of possible equivalent control functions. Conservatism tends to grow as modeling errors become larger. In order to preserve the internal controllability structure of the plant, it is proposed that model simplification be carried out on the open-loop-transformed system. As an example, a controller is developed for a single link manipulator with an elastic joint.

Sira-Ramirez, Hebertt↗

NASA NTRS1988

Techniques for assessment of flexible space structure control performance

Several multivariable concepts are presently applied to both the open-loop and closed-loop analysis of a wrap-rib antenna space structure. After evaluating the alternative placements of sensors and actuators by means of controllability, observability, and transmission-zero concepts, the linear quadratic gaussian/loop transfer recovery method is used to synthesize a control law for suppression of the transient vibrations that are typically encountered during maneuvers. The integration of these techniques and associated computer programs into a larger spacecraft design system is also discussed.

Rowell, Lawrence F.↗

NASA NTRS1987

Design of feedforward controllers for multivariable plants

Simple methods for the design of feedforward controllers to achieve steady-state disturbance rejection and command tracking in stable multivariable plants are developed in this paper. The controllers are represented by simple and low-order transfer functions and are not based on reconstruction of the states of the commands and disturbances. For unstable plants, it is shown that the present method can be applied directly when an additional feedback controller is employed to stabilize the plant. The feedback and feedforward controllers do not affect each other and can be designed independently based on the open-loop plant to achieve stability, disturbance rejection and command tracking, respectivley. Numerical examples are given for illustration.

Seraji, H.↗

NASA NTRS1988

Active control of helicopter air resonance in hover and forward flight

A coupled rotor/fuselage helicopter analysis is presented. The accuracy of the model is illustrated by comparing it with experimental data. The sensitivity of the open loop damping of the unstable resonance mode to such modeling effects as blade torsional flexibility, unsteady aerodynamics, forward flight, periodic terms, and trim solution is illustrated by numerous examples. Subsequently, the model is used in conjunction with linear optimal control theory to stabilize the air resonance mode. The influence of the modeling effects mentioned before on active resonance control is then investigated.

Takahashi, M. D.↗

NASA NTRS1987

Output control using feedforward and cascade controllers

An open-loop solution to the output control problem in SISO (single-input, single-output) systems by means of feedforward and cascade controllers is investigated. A simple characterization of feedforward controllers, which achieve steady-state disturbance rejection, is given in a transfer-function setting. Cascade controllers which cause steady-state command tracking are characterized. Disturbance decoupling and command matching controllers are identified. Conditions for existence of feedforward and cascade controllers are given. For unstable systems, it is shown that a stabilizing feedback controller can be used without affecting the feedforward and cascade controllers used for output control; hence, the three controllers can be designed independently. Output control by a combination of feedforward and feedback is discussed.

Seraji, H.↗

NASA NTRS1988

Sequential design of linear quadratic state regulators via the optimal root-locus techniques

The use of well-known root-locus techniques for sequentially finding the weighting matrices and the linear quadratic state regulators of multivariable control systems in the frequency domain is considered. This sequential design method permits the retention of some stable open-loop poles and the associated eigenvectors in the closed-loop system; it also allows some optimal closed-loop poles to be placed in a specific region of the complex plane. In addition, it provides a design procedure for determining the weighting matrices and linear quadratic state regulators for the optimal control of multivariable systems in the frequency domain.

Shieh, L. S.↗