Search NASA⌕ Search

SEARCH · Search NASA

Results for “Argon”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 505 records · Page 28
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Incident shock-wave characteristics in air, argon, carbon dioxide, and helium in a shock tube with unheated helium driver

Incident shock-wave velocities were measured in the Langley 6-inch expansion tube, operated as a shock tube, with air, argon, carbon dioxide, and helium as test gases. Unheated helium was used as the driver gas and most data were obtained at pressures of approximately 34 and 54 MN/sq m. A range of pressure ratio across the diaphragm was obtained by varying the quiescent test-gas pressure, for a given driver pressure, from 0.0276 to 34.5 kN/sq m. Single- and double-diaphragm modes of operation were employed and diaphragms of various materials tested. Shock velocity was determined from microwave interferometer measurements, response of pressure transducers positioned along interferometer measurements, response of pressure transducers positioned along the driven section (time-of-arrival gages), and to a lesser extent, measured tube-wall pressure. Velocities obtained from these methods are compared and limitations of the methods discussed. The present results are compared with theory and the effects of diaphragm mode (single or double diaphragm), diaphragm material, heating of the driver gas upon pressurization of the driver section, diaphragm opening time, interface mixing, and two-dimensional (nonplanar) flow are discussed.

Miller, C. G., III↗
NASA NTRS1976

Plasma core reactor simulations using RF uranium seeded argon discharges

Experimental results are described in which pure uranium hexafluoride was injected into an argon-confined, steady-state, RF-heated plasma to investigate characteristics of plasma core nuclear reactors. The 80 kW (13.56 MHz) and 1.2 MW (5.51 MHz) rf induction heater facilities were used to determine a test chamber flow scheme which offered best uranium confinement with minimum wall coating. The cylindrical fused-silica test chamber walls were 5.7-cm-ID by 10-cm-long. Test conditions included RF powers of 2-85 kW, chamber pressures of 1-12 atm, and uranium hexafluoride mass-flow rates of 0.005-0.13 g/s. Successful techniques were developed for fluid-mechanical confinement of RF-heated plasmas with pure uranium hexafluoride injection.

Roman, W. C.↗
NASA NTRS1976

A 30-cm diameter argon ion source

A 30 cm diameter argon ion source was evaluated. Ion source beam currents up to 4a were extracted with ion energies ranging from 0.2 to 1.5 KeV. An ion optics scaling relation was developed for predicting ion beam extraction capability as a function of total extraction voltage, gas type, and screen grid open area. Ignition and emission characteristics of several hollow cathode geometries were assessed for purposes of defining discharge chamber and neutralizer cathodes. Also presented are ion beam profile characteristics which exhibit broad beam capability well suited for ion beam sputtering applications.

Sovey, J. S.↗
NASA NTRS1976

Argon hollow cathode

An interest in alternate propellants for ion-bombardment thrusters, together with ground applications of this technology, has prompted consideration of argon. Several variations of conventional hollow cathode designs were tried, but the bulk of the testing used a hollow tube with an internal tungsten emitter and an orifice at one end. The optimum cathode tube diameter was found to be in the range of 1.0-2.5 cm, somewhat larger than those used for cesium and mercury. Optimum orifice diameter depended on operating conditions, and varied from 0.5 to 5 mm. Biasing the internal emitter negative relative to the cathode chamber reduced the external coupling voltage and should therefore improve orifice lifetime. The expected effect of this bias on emitter lifetime was less clear. Lifetime tests were not conducted as part of this investigation, but several designs show promise of long lifetime in specific applications.

Rehn, L. A.↗
NASA NTRS1977

Thermodynamic properties of gaseous fluorocarbons and isentropic equilibrium expansions of two binary mixtures of fluorocarbons and argon

Equations and computer code are given for the thermodynamic properties of gaseous fluorocarbons in chemical equilibrium. In addition, isentropic equilibrium expansions of two binary mixtures of fluorocarbons and argon are included. The computer code calculates the equilibrium thermodynamic properties and, in some cases, the transport properties for the following fluorocarbons: CCl2F, CCl2F2, CBrF3, CF4, CHCl2F, CHF3, CCL2F-CCl2F, CCLF2-CClF2, CF3-CF3, and C4F8. Equilibrium thermodynamic properties are tabulated for six of the fluorocarbons(CCl3F, CCL2F2, CBrF3, CF4, CF3-CF3, and C4F8) and pressure-enthalpy diagrams are presented for CBrF3.

Talcott, N. A., Jr.↗
NASA NTRS1977

The relation between isotopic composition of argon and carbon in natural gases

The methods and results of determination of the argon and carbon isotope compositions of hydrocarbon gases of Mezozoic complexes of Western Siberia are presented. Based on the Ar-36, Ar-40, C-12, C-13 content of the various deposits and on the presumed mechanisms of entry of these isotopes into the deposits, it is concluded that formation of natural gas in some deposits included vertical migration from a lower complex.

Gavrilov, Y. Y.↗
NASA NTRS1976

A 30-cm diameter argon ion source

A 30-cm diameter argon ion source was evaluated. Ion source beam currents up to 4A were extracted with ion energies ranging from 0.2 to 1.5 KeV. An ion optics scaling relation was developed for predicting ion beam extraction capability as a function of total extraction voltage, gas type and screen grid open area. Ignition and emission characteristics of several hollow cathode geometries were assessed for purposes of defining discharge chamber and neutralizer cathodes. Also presented are ion beam profile characteristics which exhibit broad beam capability well suited for ion beam sputtering applications.

Sovey, J. S.↗
NASA NTRS1976

Resolution of electron emission mechanisms in an argon arc with a hot tungsten cathode

The regenerative nature of the interaction between the electron emission processes at the cathode surface and the ion-, excited-atom-, and photon-production processes in the plasma was examined. Semiquantitative estimates of the thickness of the species production layer, the current partition, and the time constants were made. These results were used to interpret experimental measurements of the current decay of an argon arc at 46.7 kPa, 3.2-7.9 A, and 28-18 V, with a self-sustained hot tungsten cathode. After the discharge is suddenly connected to a voltage clamp, the disparity of decay rates for different emission processes permits the separation of thermionic emission from the faster-decaying components. The observed thermionic current constitutes about 30% of the total emission. The high nonthermionic portions of the current could not be explained in terms of the present understanding of the emission processes.

Chen, M. M.↗
NASA NTRS1977

Vacuum ultraviolet radiometry. III - The argon mini-arc as a new secondary standard of spectral radiance

A miniature argon arc has been designed and tested as a new transfer standard of spectral radiance for the wavelength range from 114 nm to 330 nm. Calibration has been performed using two primary standard sources: the hydrogen arc from 130 nm to 330 nm and the blackbody line radiator from 114 nm to 130 nm. The mini-arc provides an intense, stable, and reproducible UV continuum with dc power requirements of less than 1.5 kW. The arc characteristics have been investigated, and the sensitivity of the radiant power output to various operating parameters has been measured. The rms uncertainty in the spectral radiance is estimated to be 5.3% above 140 nm and 10.1% between 114 nm and 140 nm, due primarily to uncertainties in the primary standard sources.

Bridges, J. M.↗
NASA NTRS1977

Adsorption of argon on sintered tin dioxide analyzed by several methods

Argon adsorption measurements are presented over a wide range of temperature and coverage on a series of three progressively sintered SnO2 surfaces. These data are analyzed by mercury porosimetry, the BET method, the CAEDMON distribution analysis, and the Singleton-Halsey equation. Isosteric heats are computed, and the high-temperature virial expansion of the data presented. The advantages and disadvantages of each method are discussed with particular attention to the ability of physical adsorption to discriminate among surfaces beyond the measurement of surface area.

Hinman, D. C.↗
NASA NTRS1978

Metamorphism, argon depletion, heat flow and stress on the Alpine fault

The Alpine fault of New Zealand is a major continental transform fault which was uplifted on its southeast side 4 to 11 km within the last 5 m.y. This uplift has exposed the Haast schists, which were metamorphosed from the adjacent Torlesse graywackes. The Haast schists increase in metamorphic grade from prehnite-pumpellyite facies 9-12 km from the fault through the chlorite and biotite zones of the greenschist facies to the garnet-oligoclase zone amphibolite facies within 4 km of the fault. These metamorphic zone boundaries are subparallel to the fault for 350 km along the strike. The K-Ar and Rb-Sr ages of the schists increase with distance from the fault: from 4 m.y. within 3 km of the fault to approximately 110 m.y. 20 km from the fault. Field relations show that the source of heat that produced the argon depletion aureole was the fault itself.

Scholz, C. H.↗
NASA NTRS1981

Performance of a magnetic multipole line-cusp argon ion thruster

A 17 cm diameter line cusp ion thruster was evaluated with inert gases which are candidate propellants for on orbit and orbit transfer propulsion functions for Large Space Systems. A semiempirical relationship was generated to predict thruster beam current in terms of plasma parameters which would allow initial thruster optimization without ion extraction and the associated large vacuum facilities. The sensitivity of performance to changes in discharge electrode configurations and magnetic circuit was evaluated and is presented. After final optimization a propellant utilization efficiency of 0.9 at a discharge chamber power expenditure of about 260 w per beam ampere was obtained. These performance parameters are the highest yet achieved with argon propellant.

Sovey, J. S.↗
NASA NTRS1981

The abundances of neon, sulfur, and argon in planetary nebulae

New infrared observations of Ne II, Ar III, and S IV are used in optical observations of other ionization states of the considered elements to evaluate the abundances of neon, argon, and sulfur in 18 planetary nebulae. Attention is also given to one or more of the infrared lines in 18 other nebulae. It is pointed out that S IV was detected in approximately 90% of the observed objects, while Ar III was found in about 80%, and Ne II in roughly one-third. It is noted that optical observations typically include only a limited region of the nebula, while the infrared measurements frequently involve integration over the entire nebular image.

Beck, S. C.↗
NASA NTRS1982

Laboratory observation of a very low frequency instability in an argon plasma

Very low frequency (50 to 500 Hz) self-excited electrostatic waves are detected in a cylindrical argon plasma column with a weak axial magnetic field (10 to 100 G). The waves propagate azimuthally with a phase velocity in the electron diamagnetic drift direction, but with a speed at least an order of magnitude less than the ion acoustic speed. A number of known plasma instabilities are considered as possible explanations, though most of them do not seem to account for the observed characteristics of the waves.

Reinleitner, L.↗
NASA NTRS1984

Correlations between plasma variables and the deposition process of Si films from chlorosilanes in low pressure RF plasma of argon and hydrogen

The dissociation of chlorosilanes to silicon and its deposition on a solid substrate in a RF plasma of mixtures of argon and hydrogen were investigated as a function of the macrovariables of the plasma. The dissociation mechanism of chlorosilanes and HCl as well as the formation of Si in the plasma state were studied by sampling the plasma with a quadrupole mass spectrometer. Macrovariables such as pressure, net RF power input and locations in the plasma reactor strongly influence the kinetics of dissociation. The deposition process of microcrystalline silicon films and its chlorine contamination were correlated to the dissociation mechanism of chlorosilanes and HCl.

Avni, R.↗
NASA NTRS1984

The anode mechanism of a thermal argon arc

In order to clarify the anode mechanism in freely burning argon arcs, the anode drop was determined by probe measurements in the current intensity range of 10 to 200 A and arc lengths between 2 and 10 mm. Simultaneously, the power input at the anode was determined by measuring the temperature increase in the cooling water, using a thermoelement, and compared to the electrical output at the arc and in the anodic drop area. An anodic contraction was observed in the arc, at low current intensities. The results can be explained in terms of the effects of a cathodic plasma current, and in the contracted arc, in terms of an additional anodic plasma current.

Busz-Peuckert, G.↗
NASA NTRS1985

Ignition delay times of benzene and toluene with oxygen in argon mixtures

The ignition delay times of benzene and toluene with oxygen diluted in argon were investigated over a wide range of conditions. For benzene the concentration ranges were 0.42 to 1.69 percent fuel and 3.78 to 20.3 percent oxygen. The temperature range was 1212 to 1748 K and the reflected shock pressures were 1.7 to 7.89 atm. Statistical evaluation of the benzene experiments provided an overall equation which is given. For toluene the concentration ranges were 0.5 to 1.5 percent fuel and 4.48 to 13.45 percent oxygen. The temperature range was 1339 to 1797 K and the reflected shock pressures were 1.95 to 8.85 atm. The overall ignition delay equation for toluene after a statistical evaluation is also given. Detailed experimental information is provided.

Burcat, A.↗
NASA NTRS1986

Dendritic microstructure in argon atomized superalloy powders

The dendritic microstructure of atomized nickel base superalloy powders (Ni-20 pct Cr, NIMONIC-80A, ASTROALOY, and ZHS6-K) was studied. Prealloyed vacuum induction melted ingots were argon-atomized, the powders were cooled to room temperature, and various powder-size fractions were examined by optical metallography. Linear correlations were obtained for the powder size dependence of the secondary dendrite arm spacing, following the expected d-alpha (R) to the m power dependence on the particle size for all four superalloy compositions. However, the Ni-20 pct Cr alloy, which had much coarser arm spacing as compared to the other three alloys, had a much larger value of m.

Tewari, S. N.↗