Search NASA⌕ Search

SEARCH · Search NASA

Results for “Flight data”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 505 records · Page 28
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Test-engine and inlet performance of an aircraft used for investigating flight effects on fan noise

As part of the NASA Flight Effects on Fan Noise Program, a Grumman OV-1B Mohawk aircraft was modified to carry a modified and instrumented Pratt & Whitney JT15D-1 turbofan engine. Onboard flight data, together with simultaneously measured farfield acoustic data, comprise a flight data base to which JT15D-1 static and wind-tunnel data are compared. The overall objective is to improve the ability to use ground-based facilities for the prediction of flight inlet radiated noise. This report describes the hardware and presents performance results for the research engine.

Golub, R. A.↗
NASA NTRS2000

Identification of Low Order Equivalent System Models From Flight Test Data

Identification of low order equivalent system dynamic models from flight test data was studied. Inputs were pilot control deflections, and outputs were aircraft responses, so the models characterized the total aircraft response including bare airframe and flight control system. Theoretical investigations were conducted and related to results found in the literature. Low order equivalent system modeling techniques using output error and equation error parameter estimation in the frequency domain were developed and validated on simulation data. It was found that some common difficulties encountered in identifying closed loop low order equivalent system models from flight test data could be overcome using the developed techniques. Implications for data requirements and experiment design were discussed. The developed methods were demonstrated using realistic simulation cases, then applied to closed loop flight test data from the NASA F-18 High Alpha Research Vehicle.

Morelli, Eugene A.↗
NASA NTRS1997

Wavelet Analyses of F/A-18 Aeroelastic and Aeroservoelastic Flight Test Data

Time-frequency signal representations combined with subspace identification methods were used to analyze aeroelastic flight data from the F/A-18 Systems Research Aircraft (SRA) and aeroservoelastic data from the F/A-18 High Alpha Research Vehicle (HARV). The F/A-18 SRA data were produced from a wingtip excitation system that generated linear frequency chirps and logarithmic sweeps. HARV data were acquired from digital Schroeder-phased and sinc pulse excitation signals to actuator commands. Nondilated continuous Morlet wavelets implemented as a filter bank were chosen for the time-frequency analysis to eliminate phase distortion as it occurs with sliding window discrete Fourier transform techniques. Wavelet coefficients were filtered to reduce effects of noise and nonlinear distortions identically in all inputs and outputs. Cleaned reconstructed time domain signals were used to compute improved transfer functions. Time and frequency domain subspace identification methods were applied to enhanced reconstructed time domain data and improved transfer functions, respectively. Time domain subspace performed poorly, even with the enhanced data, compared with frequency domain techniques. A frequency domain subspace method is shown to produce better results with the data processed using the Morlet time-frequency technique.

Martin J Brenner↗
DOE OSTI2026

Flight Arrival Data for Each Airport

This dataset contains flight arrival data for each airport, which serves as the input for generating load profiles and estimating energy needs and fleet and charger requirements. ![image](distribution-flight-arrivals.png) Distribution of annual flight arrivals across different airport categories.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗
NASA NTRS1997

SimGraph: A Flight Simulation Data Visualization Workstation

Today's modern flight simulation research produces vast amounts of time sensitive data, making a qualitative analysis of the data difficult while it remains in a numerical representation. Therefore, a method of merging related data together and presenting it to the user in a more comprehensible format is necessary. Simulation Graphics (SimGraph) is an object-oriented data visualization software package that presents simulation data in animated graphical displays for easy interpretation. Data produced from a flight simulation is presented by SimGraph in several different formats, including: 3-Dimensional Views, Cockpit Control Views, Heads-Up Displays, Strip Charts, and Status Indicators. SimGraph can accommodate the addition of new graphical displays to allow the software to be customized to each user s particular environment. A new display can be developed and added to SimGraph without having to design a new application, allowing the graphics programmer to focus on the development of the graphical display. The SimGraph framework can be reused for a wide variety of visualization tasks. Although it was created for the flight simulation facilities at NASA Langley Research Center, SimGraph can be reconfigured to almost any data visualization environment. This paper describes the capabilities and operations of SimGraph.

Kaplan, Joseph A.↗
NASA NTRS1982

Correlation and assessment of structural airplane crash data with flight parameters at impact

Crash deceleration pulse data from a crash dynamics program on general aviation airplanes and from transport crash data were analyzed. Structural airplane crash data and flight parameters at impact were correlated. Uncoupled equations for the normal and longitudinal floor impulses in the cabin area of the airplane were derived, and analytical expressions for structural crushing during impact and horizontal slide out were also determined. Agreement was found between experimental and analytical data for general aviation and transport airplanes over a relatively wide range of impact parameter. Two possible applications of the impulse data are presented: a postcrash evaluation of crash test parameters and an assumed crash scenario.

Carden, H. D.↗
NASA NTRS1983

Comparison of measured and predicted flight effects on high-bypass coaxial jet exhaust noise

A semi-empirical model for predicting the noise generated by conventional-velocity profile coaxial jets is compared with full scale flight data and model scale simulated flight data for high bypass nozzles. The prediction model was shown to agree with small scale static data for primary jet velocities from 215 to 795 m/s for a wide range of area, temperature, and velocity ratios between streams. However, there were insufficient model nozzle, simulated flight data available at that time to permit validation of the flight effects prediction. The comparisons presented demonstrate that the prediction method is also valid in flight.

Stone, J. R.↗
NASA NTRS1975

Flight transition data for angles of attack at Mach 22 with correlations of the data

Boundary-layer transition data for angles of attack from 2.5 to 47 deg from a flight experiment with a cone that reentered at angles of attack up to 75 deg were analyzed and their local flow conditions are presented. The transition data were obtained from both acoustic and electrostatic sensors. The data from the acoustic and electrostatic sensors were correlated by use of three different sets of correlating parameters. For each set of correlating parameters, the transitional and turbulent data from the acoustic and electrostatic sensors were plotted separately. Each of the correlations was compared with a linear curve fit of previous cone-flight data at near zero angle of attack. Results indicate that the data from acoustic sensors falls below the linear curve fits to the flight data and indicates the sensitivity of the sensors. It is shown that the transition data from the electrostatic sensors tends to scatter much more than the data from the acoustic sensors. However, the data from the electrostatic sensors tends to scatter about the linear curve fits based on previous flight data.

Johnson, C. B.↗
NASA NTRS1981

Development of a simple, self-contained flight test data acquisition system

This paper describes a simple, self-contained flight test data acquisition system. The system makes use of the latest sensor and microprocessor technology available, to reduce overall system costs. Coupled with this is the use of modern control theory techniques allowing minimization of data requirements, as well as flight time requirements. Capability of the system includes primarily stability and performance analysis of general aviation airplanes, although system versatility has been designed into the package. Presented are details of the prototype system constructed, as well as details of the data reduction technique utilized. Preliminary results of the flight test program have also been included which demonstrate the capability of this system.

Renz, R. R. L.↗
NASA NTRS1972

Discriminant analyses of Bendix scanner data

Flights over Weslaco, Texas are discussed, using the 9-channel Bendix scanner, providing calibrated data in the 380 to 1000 nm wavelength interval. These flights were at 2000 ft. These data gave seasonal coverage from the time signals, representing mainly the soil background. The ground truth data are provided; signature processing studies relating scanner data to ground truth were also carried out.

Richardson, A. J.↗
NASA NTRS1972

Longitudinal stability and control derivatives of a jet fighter airplane extracted from flight test data by utilizing maximum likelihood estimation

A method of parameter extraction for stability and control derivatives of aircraft from flight test data, implementing maximum likelihood estimation, was developed and successfully applied to actual longitudinal flight test data from a modern sophisticated jet fighter. The results of this application establish the merits of the estimation technique and its computer implementation(allowing full analyst interaction with the program) as well as provide data for the validation of a portion of the differential maneuvering simulator (DMS). The results are presented for all flight test runs in tabular form and as time history comparisons between the estimated states and the actual flight test data. Comparisons between extracted and manufacturer's values for five major derivatives are presented and reveal good agreement for these principal derivatives with one exception. This particular derivative is extensively investigated by utilizing the interactive capabilities of the computer program. The results of this investigation verify the numbers extracted by maximum likelihood estimation.

Steinmetz, G. G.↗
NASA NTRS1998

Aerodynamic Parameters of High Performance Aircraft Estimated from Wind Tunnel and Flight Test Data

A concept of system identification applied to high performance aircraft is introduced followed by a discussion on the identification methodology. Special emphasis is given to model postulation using time invariant and time dependent aerodynamic parameters, model structure determination and parameter estimation using ordinary least squares an mixed estimation methods, At the same time problems of data collinearity detection and its assessment are discussed. These parts of methodology are demonstrated in examples using flight data of the X-29A and X-31A aircraft. In the third example wind tunnel oscillatory data of the F-16XL model are used. A strong dependence of these data on frequency led to the development of models with unsteady aerodynamic terms in the form of indicial functions. The paper is completed by concluding remarks.

Klein, Vladislav↗
NASA NTRS1999

Aerodynamic Parameters of High Performance Aircraft Estimated from Wind Tunnel and Flight Test Data

A concept of system identification applied to high performance aircraft is introduced followed by a discussion on the identification methodology. Special emphasis is given to model postulation using time invariant and time dependent aerodynamic parameters, model structure determination and parameter estimation using ordinary least squares and mixed estimation methods. At the same time problems of data collinearity detection and its assessment are discussed. These parts of methodology are demonstrated in examples using flight data of the X-29A and X-31A aircraft. In the third example wind tunnel oscillatory data of the F-16XL model are used. A strong dependence of these data on frequency led to the development of models with unsteady aerodynamic terms in the form of indicial functions. The paper is completed by concluding remarks.

Klein, Vladislav↗
NASA NTRS1972

Lateral stability and control derivatives of a jet fighter airplane extracted from flight test data by utilizing maximum likelihood estimation

A method of parameter extraction for stability and control derivatives of aircraft from flight test data, implementing maximum likelihood estimation, has been developed and successfully applied to actual lateral flight test data from a modern sophisticated jet fighter. This application demonstrates the important role played by the analyst in combining engineering judgment and estimator statistics to yield meaningful results. During the analysis, the problems of uniqueness of the extracted set of parameters and of longitudinal coupling effects were encountered and resolved. The results for all flight runs are presented in tabular form and as time history comparisons between the estimated states and the actual flight test data.

Parrish, R. V.↗