Search NASA⌕ Search

SEARCH · Search NASA

Results for “Power Generation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 505 records · Page 28

Proton Exchange Membrane Fuel Cells for Electrical Power Generation On-Board Commercial Airplanes

Deployed on a commercial airplane, proton exchange membrane fuel cells may offer emissions reductions, thermal efficiency gains, and enable locating the power near the point of use. This work seeks to understand whether on-board fuel cell systems are technically feasible, and, if so, if they offer a performance advantage for the airplane as a whole. Through hardware analysis and thermodynamic and electrical simulation, we found that while adding a fuel cell system using today’s technology for the PEM fuel cell and hydrogen storage is technically feasible, it will not likely give the airplane a performance benefit. However, when we re-did the analysis using DOE-target technology for the PEM fuel cell and hydrogen storage, we found that the fuel cell system would provide a performance benefit to the airplane (i.e., it can save the airplane some fuel), depending on the way it is configured.

08 HYDROGEN↗

Solar thermal power generation. A bibliography with abstracts

Bibliographies and abstracts are cited under the following topics: (1) energy overviews; (2) solar overviews; (3) conservation; (4) economics, law; (5) thermal power; (6) thermionic, thermoelectric; (7) ocean; (8) wind power; (9) biomass and photochemical; and (10) large photovoltaics.

Source record↗

Evaluation of a wind turbine electric power generator

A technical assessment of the aerodynamic performance of the wind wheel turbine (WWT) is reported. The potential of the WWT in utilizing wind as an alternate power source was evaluated. Scaling parameters were developed to predict the aerodynamic performance of WWT prototype sized to produce 3, 9, 30, and 100 kw outputs in a 6.7 m/sec wind.

Swim, W. B.↗

High Temperature Electrochemical Sensors for In-Situ Corrosion Monitoring in Coal-Based Power Generation Boilers

In this project, we successfully achieved the goals we proposed: 1. optimization and development of electrochemical sensor, 2. sensor construction and package, 3. sensor testing @Longview Power Plant and data analysis, 4. lab-scale sensor optimization and corrosion database development, 5. electrochemical and corrosion monitoring validation and 6. TEA.

01 COAL, LIGNITE, AND PEAT↗

A computational framework for uncertainty quantification and stochastic optimization in unit commitment with wind power generation.

We present a computational framework for integrating a state-of-the-art numerical weather prediction (NWP) model in stochastic unit commitment/economic dispatch formulations that account for wind power uncertainty. We first enhance the NWP model with an ensemble-based uncertainty quantification strategy implemented in a distributed-memory parallel computing architecture. We discuss computational issues arising in the implementation of the framework and validate the model using real wind-speed data obtained from a set of meteorological stations. We build a simulated power system to demonstrate the developments.

17 WIND ENERGY↗

Tunnel injection transit-time diodes for W-band power generation

GaAs p(+ +)n(+)n(-)n(+) single-drift tunnel injection transit-time (TUNNETT) diodes for W-band operation have been successfully designed and tested. An output power of 32 mW at 93.5 GHz with a dc to RF conversion efficiency of 2.6 percent was obtained. The oscillations have a clean spectrum in a conventional waveguide cavity.

Kidner, C.↗

Impact of future climate variability on ERCOT thermoelectric power generation

This report summarizes a study to determine the medium‐term (through the year 2030) impacts of future climate and drought scenarios on electricity generation by the Electric Reliability Council of Texas (ERCOT). Because water in reservoirs is used to cool many steam cycle‐based power plants, significantly low water levels can reduce the ability to cool power plants. This reduced cooling ability can come from physical supply limitations or environmental constraints (power plant effluent temperatures exceeding permitted limits).

Yan, Y. Eugene↗

Comparison of Long-Term Bioenergy with Carbon Capture and Storage to Reference Power Generation Technologies Using CO2 Avoidance Cost in the U.S.

Bioenergy with carbon capture and storage (BECCS) can sequester atmospheric CO2, while producing electricity. The CO2 avoidance cost (CAC) is used to calculate the marginal cost of avoided CO2 emissions for BECCS as compared to other established energy technologies. A comparative analysis using four different reference-case power plants for CAC calculations is performed here to evaluate the CO2 avoidance cost of BECCS implementation. Results from this work demonstrate that BECCS can generate electricity at costs competitive with other neutral emissions technologies, while simultaneously removing CO2 from the atmosphere. Approximately 73% of current coal power plants are approaching retirement by the year 2035 in the U.S. After considering CO2 sequestered from the atmosphere and coal power plant CO2 emissions displaced by BECCS, CO2 emissions can be reduced by 1.4 billion tonnes per year in the U.S. alone at a cost of $88 to $116 per tonne of CO2 removed from the atmosphere, for 10% to 90% of available biomass used, respectively. CAC calculations in this paper indicate that BECCS can help the U.S. and other countries transition to a decarbonized electricity grid, as simulations presented in this paper predict that BECCS power plants operate at lower CACs than coal plants with CCS.

25 ENERGY STORAGE↗

Mars Surface Power Generation Challenges and Considerations

Once the challenges of reaching and landing safely on Mars have been met, the first human explorers will be faced with the challenge of finding sufficient energy to power the systems they will need for a healthy and productive stay on the surface and for their ascent back to orbit.

Moon↗

Demonstrated Low Pressure Loss Inlet and Low Equivalence Ratio Operation of a Rotating Detonation Engine (RDE) for Power Generation

Presentation. An Aerojet Rocketdyne (AR) program was funded by the National Energy Technology Laboratory (NETL), part of the U.S. Department of Energy, to evaluate the benefits of an RDE in a turbine power plant system. Aerojet Rocketdyne subcontracted a variety of support for the program with efforts in modeling, diagnostic techniques, and test campaigns. Over the span of the program more than 700 hot fire tests were conducted at 4 facilities with 7 RDE assemblies. This presentation will cover results from the final test campaign conducted by Aerojet Rocketdyne.

03 NATURAL GAS↗

Hydrogen Based Energy Storage System for Integration with Dispatchable Power Generator (Phase I Feasibility Study)

This project examined the feasibility of integrating hydrogen generation, storage, and use as a means to decarbonize campus activities while retaining the ability to utilize the existing natural gas fired combined heat and power system installed at the campus of the University of California @ Irvine. Analysis of specific potential sites for the integrated system identified a location adjacent to the existing central plant which resulted in minimization of interconnections. A strategy based on use of commercial electrolyzers and gas storage was identified. Primary technology advancements are required for the gas turbine to accommodate higher levels of hydrogen and the integrated controls. The project indicated challenges for adopting the proposed strategy with the present rates and constraints. The availability of a relatively low-cost biogas resource by the campus already decarbonizes the gas turbine to some extent. In the absence of this resource, procurement of electricity directly from large scale renewable operations could facilitate lower electricity costs. Additional solar resources on campus could also help in this regard. The gas turbine cannot be operated below 50% capacity due to air permit constraints. Using the otherwise curtailed gas turbine operation to generate hydrogen via electrolysis by consuming natural gas is not highly efficient and therefore leads to relatively high costs of electricity returned. Several scenarios demonstrate potential for effective decarbonization, yet most involve lower and lower capacity factor for the legacy gas turbine which is not a good use of the asset. A small gas turbine output with higher efficiency operation would help. As would ability to export electricity to the grid. Certainly current rate structures and operational scenarios are less attractive than other possible future structures which should be pushed for in the future.

03 NATURAL GAS↗

A Polywell Fusion Reactor Designed for Net Power Generation

A brief history of Polywell progress is recounted. The present PIC simulation explains why the most recent Polywell fusion reactor failed to produce fusion energy. Synchronized variations of multiple parameters would require DC power supplies, not available in historic model testing. Even with DC power, the simulation showed that the trapping of cold electrons would ruin plasma stability during start-up. A theoretical solution to this trapping problem was found in Russian literature describing diocotron-pumping of electrons out of a plasma trap at Kharkov Institute. In Polywell, diocotron-pumping required matching the depth of the potential-well to the electron-beam current falling on a special aperture installed in one of the electromagnets. With diocotron-pumping the reactor was simulated to reach steady-state, maximum-power operation in a few milliseconds of simulated time. These improvements, validated in simulating small-scale DD reactors, were scaled up by a factor of 30 to simulate a large, net-power reactor burning p + {sup 11}B fuel. Power-balance was estimated from a textbook formula for fusion power density by numerically integrating the power density. Unity power-balance required the size of the p + {sup 11}B reactor to be somewhat larger than ITER.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Current and Future Technologies for Power Generation with Post-Combustion Carbon Capture

The objective of this study is to support DOE’s Carbon Capture and Advanced Combustion R&D Programs by completing an 'R&D Pathway” study for PC power plants that employ post-combustion carbon capture. The pathway begins with representation of today's technology and extends to include emerging carbon capture, advanced steam conditions, and advanced CO 2 compression with corresponding performance/cost estimates to illustrate routes to achieving the DOE goal of = 35% increase in cost of electricity relative to a PC plant without CO 2 capture.

20 FOSSIL-FUELED POWER PLANTS↗

Life Cycle Analysis of Natural Gas Extraction and Power Generation

Natural gas is considered a cleaner burning and more flexible alternative to other fossil fuels today. It is used in residential, commercial, industrial, and transportation applications in addition to having an expanding role in power production. However, the primary component of natural gas is methane, which is also a powerful greenhouse gas (GHG). Methane losses from natural gas extraction vary geographically and by extraction technology. This analysis inventories the GHG emissions from extraction, processing, and transmission of natural gas to large end users, and the combustion of that natural gas to produce electricity. In addition to GHG emissions, this analysis inventories other air emissions, water quality, water use, land use, and resource energy metrics.

03 NATURAL GAS↗

GaAs Schottky barrier varactor diodes for submillimeter wavelength power generation

The development of GaAs Schottky barrier diodes for frequencies well into the submillimeter wavelength range is discussed. These devices have the highest cutoff frequencies yet obtained for varactor diodes and have produced sufficient output power to drive Schottky mixers at frequencies as high as 640 GHz. The fundamental design tradeoff between cutoff frequency and capacitance modulation is explored. As the doping density is increased and the anode diameter is reduced, the dynamic cutoff frequency increases, reaching a maximum of roughly 5 THz. It is concluded that the maximum output frequency from harmonic multipliers based on standard GaAs varactor diodes will be about 1 THz.

Crowe, T. W.↗

Multicolor, time-gated, soft x-ray pinhole imaging of wire array and gas puff Z pinches on the Z and Saturn pulsed power generators

A multicolor, time-gated, soft x-ray pinhole imaging instrument is fielded as part of the core diagnostic set on the 25 MA Z machine [M. E. Savage et al., in Proceedings of the Pulsed Power Plasma Sciences Conference (IEEE, New York, 2007), p. 979] for studying intense wire array and gas puff Z-pinch soft x-ray sources. Pinhole images are reflected from a planar multilayer mirror, passing 277 eV photons with <10 eV bandwidth. An adjacent pinhole camera uses filtration alone to view 1-10 keV photons simultaneously. Overlaying these data provides composite images that contain both spectral as well as spatial information, allowing for the study of radiation production in dense Z-pinch plasmas. Cu wire arrays at 20 MA on Z show the implosion of a colder cloud of material onto a hot dense core where K-shell photons are excited. A 528 eV imaging configuration has been developed on the 8 MA Saturn generator [R. B. Spielman et al., and A. I. P. Conf, Proc. 195, 3 (1989)] for imaging a bright Li-like Ar L-shell line. Ar gas puff Z pinches show an intense K-shell emission from a zippering stagnation front with L-shell emission dominating as the plasma cools.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗