Search NASA⌕ Search

SEARCH · Search NASA

Results for “electron source”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 505 records · Page 28
All sourcesNASA NTRSDOE OSTI
NASA NTRS2005

First Results From the Gas Chromatograph Mass Spectrometer (GCMS) Experiment on the Cassini-Huygens Probe

The Huygens Probe of the Cassini Huygens Mission entered the atmosphere of the moon Titan on January 14,2005. The GCMS was part of the instrument complement on the Probe to measure in situ the chemical composition of the atmosphere during the probe descent and to support the Aerosol Collector Pyrolyser (ACP) experiment by serving as detector for the pyrolization products. The GCMS employed a quadrupole mass filter with a secondary electron multiplier detection system and a gas sampling system providing continuous direct atmospheric composition measurements and batch sampling through three gas chromatographic (GC) columns. The mass spectrometer employed five electron impact ion sources with available electron energies of either 70 or 25 eV. Three ion sources served as detectors for the GC columns and two were dedicated to direct atmosphere sampling and ACP gas sampling, respectively. The GCMS gas inlet was heated to prevent condensation, and served to evaporate surface constituents after impact.

Niemann, Hasso B.↗
NASA NTRS1974

Midlatitude electron precipitation: A possible source of contamination of galactic X and gamma-ray measurements

The effect of trapped and precipitated particles in the magnetosphere on the measurement of galactic X-rays and gamma rays is discussed. To minimize contamination caused by electron precipitation, most galactic X-ray and gamma ray measurements are conducted at equatorial or relatively low to middle latitudes where the influence of auroral effects is expected to be small. Substorm-related VLF phase perturbations also affect the measurements. If such perturbation are indicative of electron precipitation at middle to low latitudes, then their relatively high frequency of occurrence, as many as 100 per year, is evidence that electron precipitation at these latitudes may pose a problem to some galactic X-ray and gamma ray measurements. Charts and maps are presented to show: (1) phase recordings from sixteen sub-ionospheric VLF propagation paths, (2) map of great circle propagation paths, (3) ionization rates in the nighttime ionosphere due to several sources, and (4) computer phase variation for the NLK-APL path versus electron flux for different e-folding energies.

Rosenberg, T. J.↗
DOE OSTI2021

Electron generation and multiplication at the initial stage of nanosecond breakdown in water

Electrical breakdown of liquid dielectrics under nanosecond pulsed high voltage has been investigated extensively in the last decade. Prior studies have focused on either experimental characterization of the breakdown process and discharge plasma or formulation/verification of the electrostrictive cavitation mechanism of the breakdown initiation. There remain knowledge gaps toward a clear physical picture of how the first plasma is generated in a region saturated by nanoscale cavities created by electrostrictive forces in inhomogeneous fields at the nanosecond timescale. Initial plasma results from the multiplication of primary electrons that gain energy collisionlessly in the cavities to cause collisional ionization of water molecules on the cavity walls. This paper quantitatively discusses the possible sources of primary electrons that seed the plasma discharge. Electron detachment from hydroxide is shown to be the most probable and sustainable electron source. Using numerical modeling, this study demonstrates the plausibility of an electron multiplication mechanism involving two neighboring cavities. The drift of hydrated electrons from one cavity to the next is the rate-limiting step and sets the minimum electric field requirement. Furthermore, this work will inform subsequent experimental studies and have implications in various applications such as plasma sources in biomedical applications, cavitation study, and insulation of pulsed power equipment.

42 ENGINEERING↗
DOE OSTI2021

JSPEC – An Open Source Program for IBS and Electron Cooling Simulation

The intrabeam scattering can affect the accumulation, the lifetime, and the property of a high-intensity beam. Electron cooling is a method to mitigate the intrabeam scattering effect. JSPEC (JLab Simulation Package on Electron Cooling) is an open-source program developed at Jefferson Lab, which includes various numerical models and friction force formulas for intrabeam scattering and electron cooling simulations. JSPEC has been benchmarked with BETACOOL and experimental data. In this report, we will introduce what features JSPEC provides to the users and how it carries out the computations. Numerical examples are presented to demonstrate the performance and the validity of JSPEC.

Zhang, He↗
NASA NTRS1977

Soft electrons as a possible heat source for Jupiter's thermosphere

The 850 K exospheric temperature inferred for Jupiter from the radio-occultation experiments on Pioneers 10 and 11 is shown to imply a heat input of 0.25-0.5 erg/sq cm/sec. One possible source of this energy is precipitation of electrons from a warm plasma (temperature corresponding to energies of the order of 30-500 eV). A mechanism is suggested wherein the presence of this plasma can be accounted for by centrifugal acceleration and adiabatic compression of ionospheric electrons and protons. Present ideas of the source strength of ionospheric plasma, however, give heating rates that are too small by one to two orders of magnitude, although inferences from direct plasma measurements suggest that the required plasma is indeed present.

Hunten, D. M.↗
NASA NTRS2009

Broadband Sources in the 1-3 THz Range

Broadband electronically tunable sources in the terahertz range are a critical technology for enabling space-borne as well as ground-based applications. By power-combining MMIC amplifier and frequency tripler chips, we have recently demonstrated >1 mW of output power at 900 GHz. This source provides a stepping stone to enable sources in the 2-3 THz range than can sufficiently pump multi-pixel imaging arrays.

sources↗
DOE OSTI2019

Various Applications of Precision Low-Energy Nuclear Electron Spectrometry in the KATRIN Tritium Neutrino Project

The energy scale of the main spectrometer in the KATRIN tritium project is required to remain stable within ±60 meV at an electron energy of 18.6 keV for two months in order to reach the intended sensitivity of 0.2 eV for the rest mass of the electron antineutrino. A natural source of reference electrons with an energy of 17824.3 ± 0.5 eV based on K -conversion electrons of the 32-keV nuclear γ-transition in {sup 83m}Kr from the decay of parent {sup 83}Rb was developed for this purpose using precision low-energy nuclear electron spectrometry. The spectroscopic parameters of {sup 83m}Kr/{sup 83}Rb sources fabricated by ion implantation into polycrystalline platinum foils were significantly better than the parameters of vacuum-deposited sources. A large-scale study of the influence of the physicochemical environment of atoms of different radioisotopes in various matrices of vacuum-deposited and implanted radioactive sources on the energy of emitted conversion and Auger electrons and on the structure of the corresponding energy spectra was conducted in the process. The possibility of application of photoelectron sources with a metallic converter as sources of reference electrons for the KATRIN project was also considered.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
NASA NTRS1971

Ion sources for electric propulsion

Ion systems, which accelerate ions of Cs, Hg, or colloid particles by electrostatic fields, are furthest advanced and ready for application. Four kinds of ion sources have been developed: The contact ionization source for Cs as propellants, the electron bombardment source for Cs or Hg, the RF ionization source for Hg, and the hollow needle spray nozzle for colloidal glycerol particles. In each case, the ion beam must be neutralized by injection of electrons shortly behind the exit orifice to avoid adverse space charge effects.

Stuhlinger, E.↗
DOE OSTI2023

Microscopic Origin of Polarization Charges at Ga N / ( Al , Ga ) N Interfaces

Ga⁢N/(Al,Ga)⁢N heterojunctions are at the heart of high-electron-mobility transistors that are being adopted for high-power and high-frequency applications. The strong polarization fields present at this interface significantly enhance the density of the two-dimensional electron gas (2DEG) that is confined on the Ga⁢ N side of the junction. The microscopic origin of these electrons has been debated over the years: after excluding that they would be contributed by bulk donors, a model that identifies surface states on the (Al, Ga)⁢N surface as the source of electrons has become widely adopted. Recently, it has become clear, however, that the measured density of surface states is insufficient to account for the high electron density in the 2DEG. Here we demonstrate, based on state-of-the-art first-principles calculations, that the source of electrons is intrinsic to the overall structure and that the negative charge in the 2DEG is balanced by fixed charge on the surface. We perform a rigorous study of polarization, using our recently developed methodology for quantifying polarization fields within the finite-sized systems that can be addressed with density-functional calculations. The results show that the electrons that appear in the 2DEG originate locally at the interface, and that the net charge at the interface is predominantly compensated by fixed charge on the surface, rather than surface states. We elucidate the source of this fixed charge and associate it with surface reconstructions or the presence of heterovalent impurities (such as oxygen). Our results force a reassessment of the impact of surface states on the density of the 2DEG: rather than serving as a supply of electrons, the surface states mainly act to pin the Fermi level. Our conclusions allow a fresh interpretation of experimental observations and allow devising guidelines for optimizing carrier densities in the 2DEG.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2022

A Laser Frequency Transverse Modulation Might Compensate for the Spectral Broadening Due to Large Electron Energy Spread in Thomson Sources

Compact laser plasma accelerators generate high-energy electron beams with increasing quality. When used in inverse Compton backscattering, however, the relatively large electron energy spread jeopardizes potential applications requiring small bandwidths. We present here a novel interaction scheme that allows us to compensate for the negative effects of the electron energy spread on the spectrum, by introducing a transverse spatial frequency modulation in the laser pulse. Such a laser chirp, together with a properly dispersed electron beam, can substantially reduce the broadening of the Compton bandwidth due to the electron energy spread. We show theoretical analysis and numerical simulations for hard X-ray Thomson sources based on laser plasma accelerators.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗
NASA NTRS1996

40 HP Electro-Mechanical Actuator

This report summarizes the work performed on the 40 BP electro-mechanical actuator (EMA) system developed on NASA contract NAS3-25799 for the NASA National Launch System and Electrical Actuation (ELA) Technology Bridging Programs. The system was designed to demonstrate the capability of large, high power linear ELA's for applications such as Thrust Vector Control (TVC) on rocket engines. It consists of a motor controller, high frequency power source, drive electronics and a linear actuator. The power source is a 25kVA 20 kHz Mapham inverter. The drive electronics are based on the pulse population modulation concept and operate at a nominal frequency of 40 kHz. The induction motor is a specially designed high speed, low inertia motor capable of a 68 peak HP. The actuator was originally designed by MOOG Aerospace under an internal R & D program to meet Space Shuttle Main Engine (SSME) TVC requirements. The design was modified to meet this programs linear rate specification of 7.4 inches/second. The motor and driver were tested on a dynamometer at the Martin Marietta Space Systems facility. System frequency response and step response tests were conducted at the Marshall Space Flight Center facility. A complete description of the system and all test results can be found in the body of the report.

Fulmer, Chris↗
DOE OSTI2017

Current transmission and nonlinear effects in un-gated thermionic cathode RF guns

Un-gated thermionic cathode RF guns are well known as a robust source of electrons for many accelerator applications. These sources are in principle scalable to high currents without degradation of the transverse emittance due to control grids but they are also known for being limited by back-bombardment. While back-bombardment presents a significant limitation, there is still a lack of general understanding on how emission over the whole RF period will affect the nature of the beams produced from these guns. In order to improve our understanding of how these guns can be used in general we develop analytical models that predict the transmission efficiency as a function of the design parameters, study how bunch compression and emission enhancement caused by Schottky barrier lowering affect the output current profile in the gun, and study the onset of space-charge limited effects and the resultant virtual cathode formation leading to a modulation in the output current distribution.

43 PARTICLE ACCELERATORS↗
NASA NTRS1974

Physics of compact nonthermal sources. III - Energetic considerations

The energy content of the compact incoherent electron-synchrotron sources 3C 84, 3C 120, 3C 273, 3C 279, 3C 454.3, CTA 102, 3C 446, PKS 2134+004, VRO 42.22.01 and OJ 287 is calculated on the assumption that the low-frequency turnovers in the radio spectrum are due to self-absorption and that the electron distribution is isotropic. The dependence of the source parameters on various modifications of the standard assumptions is determined. These involve relativistic motions, alternate explanations for the low-frequency turnover, proton-synchrotron radiation, and distance to the source. The canonical interpretation is found to be accurate in many respects; some of the difficulties and ways of dealing with them are discussed in detail.

Burbidge, G. R.↗
DOE OSTI2021

Strong effect of scandium source purity on chemical and electronic properties of epitaxial Sc x Al 1–x N/GaN heterostructures

Epitaxial multilayer heterostructures of Sc x Al 1–x N/GaN with Sc contents x = 0.11–0.45 are found to exhibit significant differences in structural quality, chemical impurity levels, and electronic properties depending on the starting Sc source impurity levels. A higher purity source leads to a 2–3 orders of magnitude reduction in the carbon, oxygen, and fluorine unintentional doping densities in MBE-grown Sc x Al 1–x N/GaN multilayers. Electrical measurements of Sc x Al 1–x N/n + GaN single heterostructure barriers show a 5–7 orders of magnitude reduction in the electrical leakage for films grown with a higher purity Sc source at most Sc contents. The measured chemical and electrical properties of epitaxial Sc x Al 1–x N highlight the importance of the starting Sc source material purity for epitaxial device applications that need these highly piezoelectric and/or ferroelectric transition-metal nitride alloys.

36 MATERIALS SCIENCE↗