Search NASA⌕ Search

SEARCH · Search NASA

Results for “Mapper”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 523 records · Page 29

LANDSAT-D Thematic Mapper image dimensionality reduction and geometric correction accuracy

Principal components transformations was applied to a Walnut Creek, Texas subscene to reduce the dimensionality of the multispectral sensor data. This transformation was also applied to a LANDSAT 3 MSS subscene of the same area acquired in a different season and year. Results of both procedures are tabulated and allow for comparisons between TM and MSS data. The TM correlation matrix shows that visible bands 1 to 3 exhibit a high degree of correlation in the range 0.92 to 0.96. Correlation for bands 5 to 7 is 0.93. Band 4 is not highly correlated with any other band, with corrections in the range 0.13 to 0.52. The thermal band (6) is not highly correlated with other bands in the range 0.13 to 0.46. The MSS correlation matrix shows that bands 4 and 5 are highly correlated (0.96) as are bands 6 and 7 with a correlation of 0.92.

Ford, G. E.↗

Understanding and utilization of Thematic Mapper and other remotely sensed data for vegetation monitoring

The TM Tasseled Cap transformation, which provides both a 50% reduction in data volume with little or no loss of important information and spectral features with direct physical association, is presented and discussed. Using both simulated and actual TM data, some important characteristics of vegetation and soils in this feature space are described, as are the effects of solar elevation angle and atmospheric haze. A preliminary spectral haze diagnostic feature, based on only simulated data, is also examined. The characteristics of the TM thermal band are discussed, as is a demonstration of the use of TM data in energy balance studies. Some characteristics of AVHRR data are described, as are the sensitivities to scene content of several LANDSAT-MSS preprocessing techniques.

Crist, E. P.↗

Evaluation of LANDSAT-D Thematic Mapper performance as applied to hydrocarbon exploration

Work with digital data of Oklahoma, Colorado, Wyoming, Utah and California demonstrate that the increased spectral refinement and spatial resolution of TM over MSS data greatly increase the value of the data to petroleum exploration in roles ranging from logistic planning to direct detection of phenomena related to microseepage of hydrocarbons. The value of the spatial content versus the spectral content of the data increases as soil and vegetation cover increase. The structural detail visible in the imagery can contribute to exploration at the prospect level. Examination of the variance/covariance matrix suggests that a combination of bands 1, 4, and 5 displays the most information for most areas.

Dykstra, J. D.↗

Thematic Mapper Image Processing System (TIPS) Processing Status

Radiometric and geometric correction performance is considered. A one quantum level requirement was met in all spectral bands with an occasional band 7 exception. Initial post launch calibration was accomplished. An absolute radiometric calibration is in progress including an investigation of low impact solution to scan striping. Initial and three downstream updates as well as coordination with LANDSAT D' instrument calibration are planned. Methods and problems in measuring geometric correction performance are examined with an emphasis on temporal registration, geodetic registrtion, and the modeling error budget. Planned efforts include eliminating band 2, band 5 chips; continued performance monitoring; calibration of profile, misalignment angles, and filer parameters; studying the need for seasonal geodetic control points; and improvement of the subpixel correlation technique.

Brooks, J.↗

Pre-launch Absolute Radiometric Calibration of LANDSAT-4 Protoflight Thematic Mapper

From both scientific and applications perspectives, the usefulness of TM digital imagery is significantly determined by its radiometric characteristics. This includes both the accuracy to which the dynamic range is known and its radiometric reproducibility or precision. Results from several pre-launch tests with a 122-cm Integrating Sphere (IS) used as part of the absolute radiometric calibration experiments for the protoflight TM sensor carried on the LANDSAT-4 satellite are summarized and analyzed. Topics covered include TM radiometric calibration and sensitivity; the TM internal calibrator; and the dynamic range after calibration.

Barker, J. L.↗

Evaluation of the Radiometric Integrity of LANDSAT-4 Thematic Mapper Band 6 Data

An approach for experimentally evaluating the radiometric calibration of the LANDSAT-4 band 6 data is described which draws on a method used to radiometrically calibrate the HCMR data which involved underflying the satellite with an infrared line scanner. By extending this technology to higher altitudes experimental radiance data suitable for radiometric calibration of the TM band 6 sensor can be generated. Repetition of this experiment can permit evaluation of long term drift in the sensor and provide a data base for evaluating atmospheric propagation models for radiation transfer. To date, efforts were concentrated on modifying the infrared line scanner to match the spectral response of the TM band 6 sensor. In addition, the LOWTRAN code corresponding to a satellite overpass of September 1982 was run to yield a plot of transmission and path radiance as a function of altitude.

Schott, J. R.↗

Thermal Band Characterization of LANDSAT-4 Thematic Mapper

A quick look monitor in the spacecraft control center was used to measure the TM Band 6 shutter background and the 34.7 C internal blackbody signal on over 50 dates. Comparison of relative internal gains between the four channels to prelaunch values showed changes over 9 months of up to 5%, while 512 x 512 subsections of the original 10 daytime scenes showed scene counts that ranged from 135 down to 62. A night scene of the Buffalo area was used to determine channel gain relative to the mean and to discern a systematic along scan pattern in a difference between forward and reverse scan counts of up to 0.5. A corrected digital image was produced and individual gains and offsets were calculated for the four channels. At satellite radiance was determine and noise equivalent temperature difference was calculated. The calibration data and the Buffalo scene, with the corrections and estimates of the atmospheric transmission and radiance, were used to make a temperature estimate for an area of Lake Erie of 21 C to 27 C. Local records of the temperature showed 21 C.

Lansing, J. C.↗

Geodetic Accuracy of LANDSAT-4 Multispectral Scanner and Thematic Mapper Data

The geodetic accuracy of an MSS or TM scene is assessed using a minicomputer and appropriate software, a digitizer, and an image display device. The calculated image location of a selected feature is compared with the actual image location obtained though visual inspection of the image on the display. Measurements of 15 to 20 features evenly distributed throughout the image provide an estimate of the geodetic accuracy of the scene. Tests of two system-corrected MSS scenes measured geodetic registration root-mean-square (RMS) errors of approximately 3,200 m or 57 pixels. Tests of two TM system-corrected scenes measured RMS errors of approximately 1,250 and 1,000 m, or 44 and 35 pixels, respectively. All errors were primarily translational, implying good internal scene registration of both MSS and TM data. The one MSS GCP-corrected scene which was evaluated had an RMS error of approximately 325 m or 6 pixels.

Thormodsgard, J. M.↗

Impact of Thematic Mapper Sensor Characteristics on Classification Accuracy

A three factor (spectral, spatial, and radiometric resolution), two level (TM and MSS) analysis of variance (ANOVA) approach allowed evaluation of the effects of each factor individually and in all possible combinations. Digital classification accuracy was used as the figure of merit. Nine study sites in Washington, D.C. each of approximately 256 x 256 TM pixels, were randomly selected from the full scene for analysis. These results strongly suggest that the quantization level improvements and the addition of new spectral bands in the visible and middle IR regions (both afforded by the TM sensor design) can result in improved capabilities to accurately delineate land cover categories using a per point Gaussian maximum likelihood classifier. On the other hand, results indicate that the increase in spatial resolution to 30m does not significantly enhance classification accuracy. The spatial result points to an inherent limitation of a per point classifier and to the need to improve data analysis techniques to handle high spatial resolution data.

Williams, D. L.↗

Evaluation of LANDSAT-4 Thematic Mapper Data as Applied to Geologic Exploration: Summary of Results

As with any tool applied to geologic exploration, maximum value results from the innovative integration of optimally processed LANDSAT-4 data with existing pertinent information and perceptive geologic thinking. The synoptic view of the satellite images and the relatively high resolution of the data permits recognization of regional tectonic patterns and their detailed mapping. The refined spatial and spectral characteristics and digital nature surface alterations associated with hydrothermal activity and microseepage of hydrocarbons. In general, as vegetation and soil cover increase, the value of spectral components of TM data decreases with respect to the value of the spatial component of the data. This observation reinforces the experience from working with MSS data that digital processing must be optimized both for the area and for the application.

Dykstra, J. D.↗

Preliminary Geologic/spectral Analysis of LANDSAT-4 Thematic Mapper Data, Wind River/bighorn Basin Area, Wyoming

A LIDQA evaluation for geologic applications of a LANDSAT TM scene covering the Wind River/Bighorn Basin area, Wyoming, is examined. This involves a quantitative assessment of data quality including spatial and spectral characteristics. Analysis is concentrated on the 6 visible, near infrared, and short wavelength infrared bands. Preliminary analysis demonstrates that: (1) principal component images derived from the correlation matrix provide the most useful geologic information. To extract surface spectral reflectance, the TM radiance data must be calibrated. Scatterplots demonstrate that TM data can be calibrated and sensor response is essentially linear. Low instrumental offset and gain settings result in spectral data that do not utilize the full dynamic range of the TM system.

Lang, H. R.↗

Thematic Mapper Data Quality and Performance Assessment in Renewable Resources/agriculture Remote Sensing

It is believed that the increased spatial resolution will provide solutions to proportion estimation error due to mixed pixels, and the increased spectral resolution will provide for the identification of important agricultural features such as crop stage, and condition. The results of analyses conducted relative to these hypothesis from sample segments extracted from the 4-band Detroit scene and the 7-band Mississippi County, Arkansas engineering test scene are described. Several studies were conducted to evaluate the geometric and radiometric performance of the TM to determine data viability for the more pertinent investigations of TM utility. In most cases this requirement was more than sufficiently satisfied. This allowed the opportunity to take advantage of detailed ground observations for several of the sample segments to assess class separability and detection of other important features with TM. The results presented regarding these TM characteristics show that not only is the increased definition of the within scene variance captured by the increased spatial and spectral resolution, but that the mid-IR bands (5 and 7) are necessary for optimum crop type classification. Both qualitative and quantitative results are presented that describe the improvements gained with the TM both relative to the MSS and on its own merit.

Bizzell, R. M.↗

Prelaunch absolute radiometric calibration of LANDSAT-4 protoflight Thematic Mapper

Results are summarized and analyzed from several prelaunch tests with a 122 cm integrating sphere used as part of the absolute radiometric calibration experiments for the protoflight TM sensor carried on the LANDSAT-4 satellite. The calibration procedure is presented and the radiometric sensitivity of the TM is assessed. The internal calibrator and dynamic range after calibration are considered. Tables show dynamic range after ground processing, spectral radiance to digital number and digital number to spectral radiance values for TM bands 1, 2, 3, 4, 5, 7 and for channel 4 of band 6.

Barker, J. L.↗

Investigation of LANDSAT D Thematic Mapper geometric performance: Line to line and band to band registration

The geometric accuray of LANDSAT TM raw data of Toulouse (France) raw data of Mississippi, and preprocessed data of Mississippi was examined using a CDC computer. Analog images were restituted on the VIZIR SEP device. The methods used for line to line and band to band registration are based on automatic correlation techniques and are widely used in automated image to image registration at CNES. Causes of intraband and interband misregistration are identified and statistics are given for both line to line and band to band misregistration.

Begni, G.↗

LANDSAT-4 Thematic Mapper Modulation Transfer Function (MTF) evaluation

Results of MTF analysis of imagery of the San Mateo Bridge are consistent on two TM image dates for bands 4,5, and 7. There are indications that bands 1, 2, and 3 suffer from low image contrast, and consequently low signal to noise in the derived MTFs. The two image analysis produced reasonable results along +45 deg and -45 deg azimuths in the 2-D MTF, but poor results along the 0 deg and 90 deg azimuths. The effective instantaneous field of view is given for each band, and the image contrast for water and the bridge are compared. Graphs show overall TM system MTFs.

Schowengerdt, R.↗

Radiative cryogenic cooler for Thematic Mapper

This paper reports on the development of a two-stage radiative cooler for infrared detectors designed to operate in polar, sun-synchronous, low-earth orbit. Novelty is evident in three areas of the design; radiator/shield geometry, contamination protection, and provision for detector cooling in ambient air. An overview of the design is presented along with the results of thermal, structural and contamination control tests.

Cafferty, T. T.↗