Search NASA⌕ Search

SEARCH · Search NASA

Results for “Operating experience”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 523 records · Page 29
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Skylab Workshop experience in experiment accommodation

This paper examines the experiment support facilities available from the Orbital Workshop (OWS) module of the Skylab. Experiments and associated support provisions have been selected and described to illustrate the various accommodations and degree of complexities involved in the integration of these experiments into the Workshop. The interfaces described start with the simple and proceed to the complex. On the basis of the experience gained in integrating the experiments into the Workshop, conclusions are drawn and suggestions are made on ways to facilitate future experiment operations and at the same time simplify and reduce the cost of integration efforts.

Hanlon, W. H.↗
NASA NTRS1974

Microwave measurement of sea surface temperature

SEASAT-A microwave radiometry is considered for scientific studies related to sea surface temperature measurements. Its limited swath width negates certain studies at angles greater than about 30 deg from nadir. Symmetrical scans appear best for operational experiments. It is recommended that a mode of scan be incorporated which permits data to be collected from nadir up to 11 55-60 deg from nadir, even if a symmetrical scan is necessary.

Sherman, J. W., III↗
NASA NTRS1975

Design aspects of zeppelin operations from case histories

Some widely held beliefs concerning the practicability of rigid airships in air carrier operations are discussed. It is shown by a review of past operational experience, and some basic aerostatic theory, their actual record and the reasons for their demise. Problems of atmospheric density and temperature variations, meteorological factors, aerodynamic stability and control, and mooring difficulties are discussed and related to actual case histories. Structural and flight efficiencies are compared to airplane efficiencies for airplanes contemporary with the zeppelin as well as modern designs. The difficulty of supporting new, commercial airship developments on an economic basis is made clear.

Maiersperger, W. P.↗
NASA NTRS1976

A summary of the Skylab crew/vehicle disturbances experiment T-013

A manned space flight experiment (designated experiment T-013) to assess the characteristics of astronaut crew-motion disturbances was conducted on the second manned Skylab mission. A brief description of the experiment hardware utilized is given, and a comprehensive discussion of the experiment data reduction and analysis is presented. Data obtained from a force-measuring system, an astronaut limb-motion measuring system, motion-picture film, and the Skylab attitude and pointing control system is described. Results show that astronaut crew members can produce significant disturbance inputs to a spacecraft's attitude control system. Total forces of up to 400 N were exerted during vigorous soaring activities, whereas ""restrained'' motions by the experiment subject generated total forces of up to 300 N. A discussion of potential applications of the experiment results is given and appendixes provide additional detail with respect to experiment operations and results.

Conway, B. A.↗
NASA NTRS1976

Microprocessor-based multichannel flutter monitor using dynamic strain gage signals

Two microprocessor-based multichannel monitors for monitoring strain gage signals during aerodynamic instability (flutter) testing in production type turbojet engines were described. One system monitors strain gage signals in the time domain and gives an output indication whenever the signal amplitude of any gage exceeds a pre-set alarm or abort level for that particular gage. The second system monitors the strain gage signals in the frequency domain and therefore is able to use both the amplitude and frequency information. Thus, an alarm signal is given whenever the spectral content of the strain gage signal exceeds, at any point, its corresponding amplitude vs. frequency limit profiles. Each system design is described with details on design trade-offs, hardware, software, and operating experience.

Smalley, R. R.↗
NASA NTRS1975

Status of Marshall Space Flight Center solar house

The Marshall Space Flight Center (MSFC) solar facility is described herein, and test results obtained from late May 1974 to September 1974 are discussed. This facility was assembled to provide operational experience in the utilization of solar energy for heating and cooling buildings. The major subsystems are the solar collector, the energy storage tank, the simulated living space, the air conditioning and heating subsystems, and the controls. These subsystems are described with emphasis placed on major results and conclusions. A cursory evaluation of the system for cooling is given from energy and power consumption viewpoints. This data evaluation indicates the current system is capable of supplying 50 per cent of the thermal energy required to drive the air conditioner. A preliminary evaluation of winter data indicates that more than 90 per cent of the heating required can be provided by the solar system.

Humphries, W. R.↗
NASA NTRS1976

Description and operating performance of a parallel-rail electric-arc system with helium driver gas for the Langley 6-inch expansion tube

A parallel-rail arc-discharge system to heat and pressurize the initial helium driver gas of the Langley 6-inch expansion tube is described. This system was designed for a 2.44-m-long driver vessel rated at 138 MPa, with a distance between rails of 20.3 cm. Electric energy was obtained from a capacitor storage system rated at 12,000 V with a maximum energy of 5 MJ. Tests were performed over a range of energy from 1.74 MJ to the maximum value. The operating experience and system performance are discussed, along with results from a limited number of expansion-tube tests with air and carbon dioxide as test gases.

Moore, J. A.↗
NASA NTRS1976

Operating cost model for local service airlines

Several mathematical models now exist which determine the operating economics for a United States trunk airline. These models are valuable in assessing the impact of new aircraft into an airline's fleet. The use of a trunk airline cost model for the local service airline does not result in representative operating costs. A new model is presented which is representative of the operating conditions and resultant costs for the local service airline. The calculated annual direct and indirect operating costs for two multiequipment airlines are compared with their actual operating experience.

Anderson, J. L.↗
NASA NTRS1977

Extreme ultraviolet photometer for observations of helium in interplanetary space

A four-channel photometer sensitive to two solar EUV lines which are resonantly scattered by helium gas was developed for flight on the Apollo-Soyuz Test Project. Two channels observed the 58.4-nm line of He I and used helium gas resonant absorption cells to determine the intensities of the center and wings of that line. The other two channels observed the 30.4-nm line of He II. The instrument surveyed much of the celestial sphere during a series of slow rolling maneuvers by the Apollo spacecraft. The experiment operated properly, and usable data were obtained. Study of the distributions of flux seen, and of the ratio 58.4-nm fluxes seen with gas cells full and empty, will refine current understanding of several poorly known properties of the local interstellar medium. Study of the 30.4-nm flux distribution will refine present knowledge of the structure of the earth's plasmasphere.

Bowyer, S.↗
NASA NTRS1976

Microprocessor-based multichannel flutter monitor using dynamic strain gage signals

Two microprocessor-based multichannel monitors are described for monitoring strain gage signals during aerodynamic instability (flutter) testing in production type turbojet engines. One system monitors strain gage signals in the time domain and gives an output indication whenever the signal amplitude of any gage exceeds a pre-set alarm or abort level for that particular gage. The second system monitors the strain gage signals in the frequency domain and therefore is able to use both the amplitude and frequency information. Thus, an alarm signal is given whenever the spectral content of the strain gage signal exceeds, at any point, its corresponding amplitude vs frequency limit profile. Each system design is described with details on design trade-offs, hardware, software, and operating experience.

Smalley, R. R.↗
NASA NTRS1977

Technology of civil usage of composites

The paper deals with the use of advanced composites in structural components of commercial aircraft. The need for testing the response of a material system to service environment is discussed along with methods for evaluating design and manufacturing aspects of a built-up structure under environmental conditions and fail-safe (damage-tolerance) evaluation of structures. Crashworthiness aspects, the fire-hazard potential, and electrical damage of composite structures are considered. Practical operational experience with commercial aircraft is reviewed for boron/epoxy foreflaps, Kevlar/epoxy fillets and fairings, graphite/epoxy spoilers, graphite/polysulfone spoilers, graphite/epoxy floor posts, boron/aluminum aft pylon skin panels, graphite/epoxy engine nose cowl outer barrels, and graphite/epoxy upper aft rudder segments.

Kemp, D. E.↗
NASA NTRS1977

Skylab simulator visual displays and training for joint observing programs

The complexity of the Skylab Apollo Telescope Mount (ATM) experiment operations necessitated the use of high fidelity simulations of the onboard visual displays and pointing system for crew training. The displays which were simulated included the H-alpha displays, XUV monitor display, XUV/slit/white light display, X-ray image display, and the white light coronagraph display. The pointing simulation was achieved by projecting film sequences which were subsequently viewed by TV cameras. An optical system in front of the vidicons simulated the pointing, roll, and zoom capabilities of the ATM and sensing systems. The simulation enabled the Skylab crewmen to obtain valuable integrated training combining such tasks as target recognition and status assessment, complex and the time dependent pointing operations, malfunction analyses, and rapid responses to flare and other transient events.

Holt, A. C.↗
NASA NTRS1977

Proceedings of the conference on Coal Feeding Systems

Development of coal feed systems for coal gasification, fluidized bed combustion, and magnetohydrodynamic applications is discussed. Process operations experience, energy conversion efficiency, and environment effects are among the factors considered.

Source record↗
NASA NTRS1976

Third Conference on Fibrous Composites in Flight Vehicle Design, part 1

The use of fibrous composite materials in the design of aircraft and space vehicle structures and their impact on future vehicle systems are discussed. The topics covered include: flight test work on composite components, design concepts and hardware, specialized applications, operational experience, certification and design criteria. Contributions to the design technology base include data concerning material properties, design procedures, environmental exposure effects, manufacturing procedures, and flight service reliability. By including composites as baseline design materials, significant payoffs are expected in terms of reduced structural weight fractions, longer structural life, reduced fuel consumption, reduced structural complexity, and reduced manufacturing cost.

Source record↗
NASA NTRS1978

Description and status of NASA-LeRC/DOE photovoltaic applications systems

Designed, fabricated and installed were 16 geographically dispersed photovoltaic systems. These systems are powering a refrigerator, highway warning sign, forest lookout towers, remote weather stations, a water chiller at a visitor center, and insect survey traps. Each of these systems is described in terms of load requirements, solar array and battery size, and instrumentation and controls. Operational experience is described and present status is given for each system. The P/V power systems have proven to be highly reliable with almost no problems with modules and very few problems overall.

Ratajczak, A. F.↗
NASA NTRS1977

Shuttle Avionics Integration Laboratory

The SAIL (Shuttle Avionics Integration Laboratory) has been established to provide direct in-line support to the space shuttle program. The SAIL provides a central facility where the avionics and related flight hardware, flight software, and flight procedures will be brought together for integration and verification testing. The basic approach is to utilize qualifiable avionics flight hardware to the greatest extent possible. Where this is not feasible, flight hardware simulators are developed that provide the electrical/electronic termination, stimulation, and signal interface to the flight hardware that it would actually encounter in the shuttle vehicle. This paper discusses the existing laboratory configuration supporting the approach and landing test phase of the shuttle program, the operational experience gained to date, and the design of the laboratory elements to support the orbital flight test phase.

Chambers, T. V.↗
NASA NTRS1975

Radio-controlled model design and testing techniques for stall/spin evaluation of general-aviation aircraft

A relatively inexpensive radio-controlled model stall/spin test technique was developed. Operational experiences using the technique are presented. A discussion of model construction techniques, spin-recovery parachute system, data recording system, and movie camera tracking system is included. Also discussed are a method of measuring moments of inertia, scaling of engine thrust, cost and time required to conduct a program, and examples of the results obtained from the flight tests.

Burk, S. M., Jr.↗