Search NASA⌕ Search

SEARCH · Search NASA

Results for “Oscillatory”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 523 records · Page 29

Problems inherent in using aircraft for radio oceanography studies

Some of the disadvantages relating to altitude stability and proximity to the ocean are described for radio oceanography studies using aircraft. The random oscillatory motion introduced by the autopilot in maintaining aircraft altitude requires a more sophisticated range tracker for a radar altimeter than would be required in a satellite application. One-dimensional simulations of the sea surface (long-crested waves) are performed using both the JONSWAP spectrum and the Pierson-Moskowitz spectrum. The results of the simulation indicate that care must be taken in trying to experimentally verify instrument measurement accuracy. Because of the relatively few wavelengths examined from an aircraft due to proximity to the ocean and low velocity compared to a satellite, the random variation in the sea surface parameters being measured can far exceed an instrument's ability to measure them.

Walsh, E. J.↗

On aerodynamic coupling between lateral and longitudinal degrees of freedom

An oscillatory technique for routine measurement of all the direct, cross and cross-coupling moment derivatives due to pitching and yawing has been developed and a series of comprehensive results at Mach numbers 0.7 and 0.25 and at angles of attack up to 40 deg has been obtained in a large wind tunnel. It was found that some of the dynamic cross-coupling derivatives, that at low angles of attack were all zero, at higher angles of attack could reach values that rendered the pertinent cross-coupling terms in the equations of motion comparable in magnitude to the well-established damping terms. Large nonlinear variations with angle of attack were observed in many of the measured derivatives including the important damping-in-pitch and damping-in-yaw derivatives. It was concluded that it may be desirable to include some dynamic cross-coupling derivatives, and the functional variation with angle of attack of many derivatives, in the equations of motion, and to consider all these equations simultaneously, rather than in separate longitudinal and lateral groups.

Orlik-Rueckemann, K. J.↗

Wind tunnel test and calibration techniques for the measurement of damping and dynamic cross derivatives due to pitching and yawing

The paper shows how the oscillatory apparatus described previously by Orlik-Rueckemann et al. (1974) for determining cross and cross-coupling moment derivatives due to pitching and yawing oscillation is strengthened, extensively modified, and adapted to permit operation in a large continuous-flow wind tunnel. Particular attention is given to an electromagnetic three-degrees-of-freedom calibrating system developed to verify the validity of the experimental method and the various aspects of data reduction procedure. Typical results from calibration tests and from a series of wind tunnel experiments are presented. The only significant limitation is that the apparatus can only be used for models that are relatively small and have a conically-shaped longitudinal cavity.

Hanff, E. S.↗

State-space formulations for flutter analysis

Two state-space methods for true-damping flutter analysis are presented here. The aerodynamic matrix is assumed to be function of the complex reduced frequency p (off-the-imaginary axis aerodynamics) as the ones provided for instance by the computer code SOUSSA (Steady, Oscillatory and Unsteady, Subsonic and Supersonic Aerodynamics). This matrix is approximated by a third order polynomial or by a Pade's matrix approximant. Then the equations are cast into a suitable state space format including the Laplace transform of the space vector, a frequency-independent matrix, and the flight speed. The solution is then obtained by standard root-locus methods. Results are in good agreement with existing ones in a suitable range of the flutter reduced frequency. A discussion on spurious roots is also included.

Weiss, S. J.↗

Recent developments in the Green's function method

A recent computational development on the Green's function method (the method used in the computer program SOUSSA: Steady, Oscillatory and Unsteady Subsonic and Supersonic Aerodynamics) is presented. A scheme consisting of combined numerical (Gaussian quadrature) and analytical procedures for the evaluation of the source and doublet integrals used in the program is presented. This combination results in 80 to 90% reduction in computer time.

Tseng, K.↗

Basic coaxial mass driver reference design

The reference design for a basic coaxial mass driver is developed to illustrate the principles and optimization procedures on the basis of numerical integration by programmable pocket calculators. The four inch caliber system uses a single-coil bucket and a single-phase propulsion track with discrete coils, separately energized by capacitors. An actual driver would use multiple-coil buckets and an oscillatory multi-phase drive system. Even the basic, table-top demonstration system should in principle be able to achieve accelerations in the 1,000 m/sq sec range. Current densities of the order of 25 ka/sq cm, continuously achievable only in superconductors, are carried by an ordinary aluminum bucket coil for a short period in order to demonstrate the calculated acceleration. Ultimately the system can be lengthened and provided with a magnetically levitated, superconducting bucket to study levitation dynamics under quasi-steady-state conditions, and to approach lunar escape velocity in an evacuated tube.

Kolm, H. H.↗

An experimental and computational investigation of the steady and unsteady transonic flow fields about an airfoil in a solid-wall test channel

An experimental and computational investigation of the steady and unsteady transonic flow field about a thick airfoil is described. An operational computer code for solving the two-dimensional, compressible Navier-Stokes equations for flow over airfoils was modified to include solid-wall, slipflow boundary conditions to properly assess the code and help guide the development of improved turbulence models. Steady and unsteady flow fields about an 18% thick circular arc airfoil at Mach numbers of 0.720, 0.754, and 0.783 and a chord Reynolds number of 11 x 10 to the 6th are predicted and compared with experiment. For the first time, computed results for unsteady turbulent flows with separation caused by a shock wave were obtained which qualitatively reproduce the time-dependent aspects of experiments. Features such as the intensity and reduced frequency of airfoil surface-pressure fluctuations, oscillatory regions of trailing-edge and shock-induced separation, and the Mach number range for unsteady flows were all qualitatively reproduced.

Levy, L. L., Jr.↗

Static inverter with synchronous output waveform synthesized by time-optimal-response feedback

Time-optimal-response 'bang-bang' or 'bang-hang' technique, using four feedback control loops, synthesizes static-inverter sinusoidal output waveform by self-oscillatory but yet synchronous pulse-frequency-modulation (SPFM). A single modular power stage per phase of ac output entails the minimum of circuit complexity while providing by feedback synthesis individual phase voltage regulation, phase position control and inherent compensation simultaneously for line and load disturbances. Clipped sinewave performance is described under off-limit load or input voltage conditions. Also, approaches to high power levels, 3-phase arraying and parallel modular connection are given.

Kernick, A.↗

Active flutter control using generalized unsteady aerodynamic theory

This paper describes the application of generalized unsteady aerodynamic theory to the problem of active flutter control. The controllability of flutter modes is investigated. It is shown that the response of aeroelastic systems is composed of a portion due to a rational transform and a portion due to a nonrational transform. The oscillatory response characteristic of flutter is due to the rational portion, and a theorem is given concerning the construction of a linear, finite-dimensional model of this portion of the system. The resulting rational model is unique and does not require state augmentation. Active flutter control designs using optimal regulator synthesis are presented.

Edwards, J. W.↗

Optimal low-thrust takeoff from an orbit about an oblate planet

Future space missions to the outer planets may depend upon the use of low-thrust propulsion systems. As these planets are decidedly oblate, the question of the effect of that oblateness on a low-thrust trajectory is of some interest. In this paper the problem of optimal energy increase is attacked under the assumption that the coefficients for the second zonal harmonic, and the nondimensional thrust acceleration are the same order of magnitude. By means of a two-variable asymptotic expansion technique, a near optimal control program is generated and the first-order uniformly valid approximation for the corresponding trajectory is obtained. Tangential thrust is shown to be a good near-optimal thrust program even in the presence of oblateness effects. The optimal control program is found to be oscillatory and quite similar to the optimal control for energy increase in an inverse square gravitational field.

Jacobson, R. A.↗

Gasdynamics and shock dynamics of weak shock waves

Experiments in weak-shock dynamics were conducted using a 17-in. diameter shock tube. Weak shocks were generated in air by a compressed nitrogen driver gas; the incident shock waves were brought to a focus by reflecting them from concave cylindrical reflectors at the endwall of the tube. It was found that the behavior of a shock discontinuity at a focus is determined by nonlinear gasdynamic processes. Consideration is also given to nonlinear resonance phenomena, i.e., phenomena associated with oscillatory motion in ducts, with amplitude so large that weak shocks occur. Attention is given to nonlinear resonance in open and closed tubes and to thermal and relaxation effects.

Sturtevant, B.↗

Effect of flight on jet noise from supersonic underexpanded flows

Experiments on underexpanded cold jet flows from a convergent nozzle under simulated flight conditions have shown that a large periodic spinning motion of the jet can occur with greatly enhanced broadband noise production. Shadowgraph pictures indicate that this oscillatory jet motion accompanies the generation of random weak shock waves at the source. These waves appear to be generated at the point downstream of the nozzle exit where the shock cells in the jet begin to disappear. The weak shock waves propagate upstream and have been identified to be the cause of enhanced broadband jet noise production in flight. In addition, the results show that the boundary layer flow conditions over the outside of the primary nozzle (simulating engine cowl flow in flight) have a key role in the production of these random weak shock waves.

Sarohia, V.↗

Two-dimensional wind tunnel test of an oscillating rotor airfoil, volume 1

A two dimensional wind tunnel test was conducted to obtain the quasisteady and unsteady characteristics of an advanced airfoil designed for helicopter rotor applications. Differential pressures were measured at 17 locations along the chord of the airfoil model. The airfoil motions were sinusoidal forced-pitch oscillations about the quarter chord at amplitudes varying from 2.5 to 10.0 degrees and at frequencies from 23 Hz to 90 Hz. The quasisteady tests were conducted at Mach numbers from 0.2 to 0.9, and the oscillatory tests between M = 0.2 and M = 0.7. At quasisteady conditions a limited number of drag measurements were made with a wake-traversing probe.

Dadone, L. U.↗

Solid propellant rocket motor internal ballistics performance variation analysis, phase 3

Results of research aimed at improving the predictability of off nominal internal ballistics performance of solid propellant rocket motors (SRMs) including thrust imbalance between two SRMs firing in parallel are reported. The potential effects of nozzle throat erosion on internal ballistic performance were studied and a propellant burning rate low postulated. The propellant burning rate model when coupled with the grain deformation model permits an excellent match between theoretical results and test data for the Titan IIIC, TU455.02, and the first Space Shuttle SRM (DM-1). Analysis of star grain deformation using an experimental model and a finite element model shows the star grain deformation effects for the Space Shuttle to be small in comparison to those of the circular perforated grain. An alternative technique was developed for predicting thrust imbalance without recourse to the Monte Carlo computer program. A scaling relationship used to relate theoretical results to test results may be applied to the alternative technique of predicting thrust imbalance or to the Monte Carlo evaluation. Extended investigation into the effect of strain rate on propellant burning rate leads to the conclusion that the thermoelastic effect is generally negligible for both steadily increasing pressure loads and oscillatory loads.

Sforzini, R. H.↗

Recent turbulent drag reduction research at Langley Research Center

Three areas are discussed: oscillatory longitudinal curvature, large eddy breakup devices, and small longitudinal surface striations. The first two concepts produced sizable local turbulent skin friction reductions, but further research is required to optimize the effect, reduce parasitic device drag, and provide a net increase in vehicle performance. The surface striations, due to large wetted area increased for a given planform, have not yet yielded a planform-averaged skin friction reduction. Heat transfer data indicated such surfaces may have useful application in heat exchangers.

Bushnell, D. M.↗

An approach to the determination of aircraft handling qualities using pilot transfer functions

It was shown that a correlation exists between pilot-aircraft system closed-loop characteristics, determined by using analytical expressions for pilot response along with the analytical expression for the aircraft response, and pilot ratings obtained in many previous flight and simulation studies. Two different levels of preferred pilot response were used. These levels were: (1) a static gain and a second-order lag function with a lag time constant of 0.2 second; and (2) a static gain, a lead time constant of 1 second, and a 0.2-second lag time constant. If a system response with a pitch-angle time constant of 2.6 seconds and a stable oscillatory mode of motion with a period of 2.5 seconds could be achieved with the first-level pilot model, it was shown that the pilot rating will be satisfactory for that vehicle.

Adams, J. J.↗

Stability of constant gain systems with vector feedback

The state space, the controllability, and the observability concepts are discussed in connection with the proposed stability analysis which permits drastic dimensional reductions for a vector feedback problem. Any constant gain system's stability can thus be analyzed in the frequency domain with a single Nyquist plot. The analysis considers the total system with all loops closed, a disturbance vector as input, and the feedback vector as output. All constant gain systems are shown to be decomposable into stable subsystems where the degree of the decomposition determines the dimensions. The maximum decomposition results in the state-space approach which is the limit case. The method is demonstrated with the stability analysis of the pogo phenomenon, an oscillatory interaction between the propulsion and the structure of a space vehicle. This problem, with eigenvalues over a hundred, was drastically but rigorously reduced to a stability analysis of a 4x4 matrix.

Vonpragenau, G. L.↗