Search NASA⌕ Search

SEARCH · Search NASA

Results for “AERODYNAMIC COEFFICIENT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

The interference of the model support mast with measurements of the longitudinal and lateral aerodynamic coefficients

The effects the single-bottom support masts used in the ONERA S1 and S4 wind tunnels have on aerodynamic data collected with scale model aircraft were examined experimentally and analytically. Systematic studies were performed on the flow characteristics around different diameters for the mounts. Scaling methods used to make data from one wind tunnel correspond to data from the other are described. Airbus 320 models were introduced into the tests and mast-body flow interactions were observed. A summary is presented of restrictions on the mast diameters, relative to cylindrical model diameters, which will minimize the effects the masts have on longitudinal and lateral aerodynamic stability data.

Vandekreeke, C.↗
NASA NTRS1972

Extraction of longitudinal aerodynamic coefficients from forward-flight conditions of a tilt-wing V/STOL airplane

A parameter-estimation algorithm was used to extract the longitudinal aerodynamic derivatives from flight data for the XC-142A airplane in a cruise condition. The flight data were the response to a tail-plane doublet input. Results of this study showed that a set of derivatives were determined which yielded a calculated aircraft response in close agreement with the measured response. This calculated response was in much closer agreement with the flight data than the response obtained by using derivatives which were calculated from empirical methods. There were large differences between some of the important derivatives extracted from flight data and those calculated from empirical methods. The reasons for these differences were not identified.

Williams, J. L.↗
NASA NTRS1995

Using the HARV simulation aerodynamic model to determine forebody strake aerodynamic coefficients from flight data

The method described in this report is intended to present an overview of a process developed to extract the forebody aerodynamic increments from flight tests. The process to determine the aerodynamic increments (rolling pitching, and yawing moments, Cl, Cm, Cn, respectively) for the forebody strake controllers added to the F/A - 18 High Alpha Research Vehicle (HARV) aircraft was developed to validate the forebody strake aerodynamic model used in simulation.

Messina, Michael D.↗
NASA NTRS1973

Generalize aerodynamic coefficient table storage, checkout and interpolation for aircraft simulation

The set of programs described has been used for rapidly introducing, checking out and very efficiently using aerodynamic tables in complex aircraft simulations on the IBM 360. The preprocessor program reads in tables with different names and dimensions and stores then on disc storage according to the specified dimensions. The tables are read in from IBM cards in a format which is convenient to reduce the data from the original graphs. During table processing, new auxiliary tables are generated which are required for table cataloging and for efficient interpolation. In addition, DIMENSION statements for the tables as well as READ statements are punched so that they may be used in other programs for readout of the data from disc without chance of programming errors. A quick data checking graphical output for all tables is provided in a separate program.

Neuman, F.↗
NASA NTRS1989

Measured and predicted aerodynamic coefficients and shock shapes for Aeroassist Flight Experiment (AFE) configuration

Two scaled models of the Aeroassist Flight Experiment (AFE) vehicle were tested in two air wind tunnels and one CF4 tunnel. The tests were to determine the static longitudinal aerodynamic characteristics, and shock shapes for the configuration in hypersonic continuum flow. The tests were conducted with a range of angle of attack to evaluate the effects of Mach number, Reynolds numbers, and normal shock density ratio.

Wells, William L.↗
NASA NTRS1991

Local and overall aerodynamic coefficients for bodies in hypersonic, rarefied flow

A computational method is given for the prediction of local pressure and viscous shear stress on windward surfaces of bluff, convex, axisymmetric or quasi-axisymmetric, hypersonic bodies in the transitional, rarefied flow regime. Overall aerodynamic forces and moments are computed by integration of the local quantities. The method is based upon a correlation of local pressure and shear stress computed by the direct simulation Monte Carlo (DSMC) numerical technique for cold wall, real gas conditions and some supplemental data from low-density, hypersonic wind tunnels. The relative simplicity of the method makes it feasible to do the necessary calculations with a personal computer. Two-dimensional shapes and leeward surfaces are not included in the scope of the method as it is presented here. Results are compared with DSMC computations for both local and overall coefficients. The latter includes sphere and blunt cone drag as well as lift and pitching moment coefficients for the NASA AFE vehicle at various angles of attack. Very satisfactory agreement is shown.

Potter, J. Leith↗
NASA NTRS1986

Analysis of aerodynamic coefficients using gradient data: Spanwise turbulence effects on airplane response

The influence of spanwise turbulence on airplane dynamic behavior is determined. Calculations are based on data collected from test flights with the NASA B-57 research aircraft. The approach is to first compute aerodynamic forces and moments due to a spanwise distribution of angle of attack and airspeed. Secondly, these quantities are incorporated into the equations of motion. Simulation of flights done with the effects of spanwise turbulence included are compared to simulations without any spanwise turbulence. The findings of the study are that the moments developed by turbulence along the span are significant and that more realistic flight simulation can be achieved by including the spanwise turbulence terms.

Ringnes, E. A.↗
NASA NTRS1974

The influence of wind shear on aerodynamic coefficients

The purpose of this study is to investigate the influence of wind shear on the lift, drag, roll and yaw moments of a wing in a horizontal wind gradient at various elevations and roll angles. The models of wind shear considered are those proposed by Leurs (1973) for atmospheric flow over horizontally homogeneous and uniform terrain. A general series solution for the distribution of lift along the wing span following the method of Houghton and Brock (1970) is employed to compute the loads and moments on the airfoil. Results of the computations indicate that wind shear can have a significant effect on the rolling and yawing moments of the wing of an aircraft flying with one wing low in the atmospheric boundary layer. These moments are directly influenced by the magnitude of the wind gradient in the neutral atmosphere reflected by the magnitude of the friction velocity. The effect of wind shear on lift and drag is negligible. Stability of the atmosphere tends to increase the magnitude of the rolling moment while decreasing its variation with elevation.

Frost, W.↗
NASA NTRS1986

Vortex systems on slender rotating bodies and their effect on the aerodynamic coefficients

The turbulent flow of rotational bodies up to a length of 20 diameters with various head shapes and cylindrical tails was examined in the subsonic wind tunnel with the Mach number of M = 0.1. At angles of incidence lower than 30 degrees, a pair of symmetrical eddies rests stationary from head to tail on the trailing side, very close to the body. At angles between 30 and 60 degrees, the stationary eddies are asymmetrically pushed off. Between 60 and 90 degrees, the eddies detach themselves in an instationary manner. This includes, for example, the turbulent flow at the start-up of flying bodies in the presence of lateral winds. The results of measurments obtained by Mello at M = 2, an impulse method, and the cross flow theory according to Allen are used for comparison.

Fiechter, M.↗
NASA NTRS1987

Hypersonic aerodynamic coefficients and convection flow estimation in a HERMES type project

An analysis of all the experimental and computation requirements of the HERMES project is presented. The discussion includes the influence of the upper atmosphere composition and possible chemical reactions, the information collected in Orbiter experiments, the possibility of utilizing plasma generators and CF4 in wind tunnel tests, the development of parabolized Navier-Stokes models and solutions, and the computing capacity requirements.

Pollak, C.↗