Search NASA⌕ Search

SEARCH · Search NASA

Results for “DME”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3

HEAO 1 observations of X-ray emission from flares on dMe stars

The paper reports the detection of two X-ray flares from each of the nearby dMe stars, AT Mic and AD Leo, with the A-2 experiment on board HEAO 1. A spectrum obtained during the brighter AT Mic flare, the first X-ray spectrum of a stellar flare, is well matched by a thermal model with a temperature 3 x 10 to the 7 K and an iron K-alpha emission line. The X-ray luminosities derived are in the range 1.3-16 x 10 to the 30th ergs/s, while emission measures are in the range 1.1-14 x 10 to the 53rd/cu cm. The estimated Lx/Lopt ratios exceed unity and are inconsistent with Mullan's flare model. Several scenarios to explain this discrepancy are proposed.

Kahn, S. M.↗

The Mg 2 h and k lines in a sample of dMe and dM stars

Both Mg II h and k line fluxes are presented for a sample of 4 dMe and 3 dM stars obtained with the IUE satellite in the long wavelength, low dispersion mode. The observed fluxes are converted to stellar surface flux units and the importance of chromospheric non radiative heating in this sample of M dwarf stars is intercompared. In addition, the net chromospheric radiative losses due to the Ca II H and K lines in those stars in the sample for which calibrated Ca II H and K line data exist are compared. Active region filling factors which likely give rise to the observed optical and ultraviolet chromospheric emission are estimated. The implications of the results for homogeneous, single component stellar model chromospheres analyses are discussed.

Giampapa, M. S.↗

X-ray and optical observations of a dMe flare star in the T Tauri field

Observations of a newly discovered dMe flare star within 20 pc of the sun are presented. An EXOSAT observation of this source shows an almost complete X-ray flare light curve with rise time about 600 s, decay time about 1500 s, and peak luminosity 6.1 x 10 to the 29th erg/s, a 40-fold increase in brightness over the quiescent level. The total energy in the flare is between 2.7 x 10 to the 32nd and 3.3 x 10 to the 33rd erg. Results of two Einstein IPC observations are also presented; the source is quiescent in the first and shows evidence for a luminosity enhancement, possibly the tail of another flare, in the second. The source is identified with a hitherto unsteadied nearby star with magnitude V about 13 and spectral type roughly dM5e, at a distnce of about 13 pc. For the flare, a variety of different physical assumptions about the cooling mechanism is explored and possible values for loop lengths and electron densities are derived.

Smale, A. P.↗

Direct numerical simulation of an auto-ignitive turbulent flame in a stratified dimethyl-ether (DME)/air mixture

Direct numerical simulations (DNS) of a turbulent premixed flame in an auto-ignitive dimethyl-ether (DME)/air mixture exhibiting two-staged ignition were conducted at elevated pressure and temperature using a statistically stationary planar configuration. Three sets of conditions with an identical turbulence intensity, but different stratification/turbulence length scales and correlations between temperature (T) and equivalence ratio (f) fields were simulated to study the dynamics of turbulent premixed flame propagation at auto-ignitive conditions. The influence of different stratification length scales and T-f correlations on turbulent flame speed was examined by comparing the flame statistics obtained from 2D simulations against laminar 1D solution. A global analysis of the front propagation speed was carried out for determining the effect of turbulent wrinkling and the role of upstream auto-ignition on the overall burning rate.

Desai, Swapnil S.↗

High-Efficiency Mixing Controlled Compression Ignition Combustion of Propane DME Blends

The program is a multi-institutional effort led by the University of Wisconsin-Madison Engine Research Center, partnered with WM International and the University of Central Florida, aiming to revolutionize combustion technology for medium-duty commercial vehicles. The project’s primary objective is to develop a high-efficiency mixing controlled compression ignition (MCCI) combustion strategy utilizing propane and propane/DME blends. This development is crucial because current propane-fueled spark-ignited (SI) engines operate at substantially lower efficiencies (BTE of 31.5%) than comparable modern diesel engines (37.1%).

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Effects of Applied Interfacial Pressure on Li-Metal Cycling Performance and Morphology in 4 M LiFSI in DME

Lithium-metal anodes can theoretically enable 10x higher gravimetric capacity than conventional graphite anodes. However, Li-metal anode cycling has proven difficult due to porous and dendritic morphologies, extensive parasitic solid electrolyte interphase reactions, and formation of dead Li. We systematically investigate the effects of applied interfacial pressure on Li-metal anode cycling performance and morphology in the recently developed and highly efficient 4 M lithium bis(fluorosulfonyl)imide in 1,2-dimethoxyethane electrolyte. We present cycling, morphology, and impedance data at a current density of 0.5 mA/cm 2 and a capacity of 2 mAh/cm 2 at applied interfacial pressures of 0, 0.01, 0.1, 1, and 10 MPa. Cryo-focused ion beam milling and cryo-scanning electron microscopy imaging in cross section reveal that increasing the applied pressure during Li deposition from 0 to 10 MPa leads to greater than a fivefold reduction in thickness (and therefore volume) of the deposited Li. This suggests that pressure during cycling can have a profound impact on the practical volumetric energy density for Li-metal anodes. A “goldilocks zone” of cell performance is observed at intermediate pressures of 0.1–1 MPa. Increasing pressure from 0 to 1 MPa generally improves cell-to-cell reproducibility, cycling stability, and Coulombic efficiency. However, the highest pressure (10 MPa) results in high cell overpotential and evidence of soft short circuits, which likely result from transport limitations associated with increased pressure causing local pore closure in the separator. All cells exhibit at least some signs of cycling instability after 50 cycles when cycled to 2 mAh/cm 2 with thin 50 μm Li counter electrodes, though instability decreases with increasing pressure. In contrast, cells cycled to only 1 mAh/cm 2 perform well for 50 cycles, indicating that capacity plays an important role in cycling stability.

25 ENERGY STORAGE↗

Evaluation of Technical Feasibility of Homogeneous Charge Compression Ignition (HCCI) Engine Fueled with Hydrogen, Natural Gas, and DME

The objective of the proposed project was to confirm the feasibility of using blends of hydrogen and natural gas to improve the performance, efficiency, controllability and emissions of a homogeneous charge compression ignition (HCCI) engine. The project team utilized both engine simulation and laboratory testing to evaluate and optimize how blends of hydrogen and natural gas fuel might improve control of HCCI combustion.

33 ADVANCED PROPULSION SYSTEMS↗

Long-term variability of dMe stars

Photographic B magnitudes of the four spot stars BY Dra (dM0e), CC Eri (K7 Ve), AU Mic (dM2.5e), and YZ CMi (dM4.5e) are reported which considerably extend the time baseline of the photoelectric data on these stars. The long-term variation of the stars in yearly mean light is investigated. It is found that both BY Dra and CC Eri exhibit long-term B-magnitude variations with amplitudes of about 0.3 to 0.4 magnitude and times between maximum and minimum light near 30 yr. No apparent variability is observed for AU Mic and YZ CMi. The possibility is discussed that the variability of BY Dra and CC Eri is connected with a starspot cycle, for which the period would be around 60 yr.

Phillips, M. J.↗

Observing stellar coronae with the Goddard High Resolution Spectrograph. 1: The dMe star AU microscopoii

We report on an observation of AU Mic taken with the Goddard High Resolution Spectrograph (GHRS) aboard the Hubble Space Telescope. The data consist of a rapid sequence of spectra covering the wavelength range 1345-1375 A with a spectral resolution of 10,000. The observations were originally intended to search for spectral variations during flares. No flares were detected during the 3.5 hr of monitoring. A method of reducing the noise while combining the individual spectra in the time series is described which resulted in the elimination of half of the noise while rejecting only a small fraction of the stellar signal. The resultant spectrum was of sufficient quality to allow the detection of emission lines with an integrated flux of 10(exp -15) ergs/sq cm(sec) or greater. Lines of C I, O I, O V, Cl I, and Fe XXI were detected. This is the first indisputable detection of the 1354 A Fe XXI line, formed at T approximately = 10(exp 7) K, on a star other than the Sun. The line was well resolved and displayed no significant bulk motions or profile asymmetry. From the upper limit on the observed line width, we derive an upper limit of 38 km/s for the turbulent velocity in the 10(exp 7) K plasma. An upper limit is derived for the flux of the 1349 A Fe XII line, formed at T approximately = 1.3 x 10(exp 6) K. These data are combined with contemporaneous GHRS and International Ultraviolet Explorer (IUE) data to derive the volume emission measure distribution of AU Mic over the temperature range 10(exp 4)-10(exp 7) K. Models of coronal loops in hydrostatic equilibrium are consistent with the observed volume emission measures of the coronal lines. The fraction of the stellar surface covered by the footprints of the loops depends upon the loop length and is less than 14% for lengths smaller than the stellar radius. From the upper limit to the estimated width of the Fe XXI line prfile we find that the we cannot rule out Alfven wave dissipation as a possible contributor to the required quiescent loop heating rate.

Maran, S. P.↗

Parameterizations of Chromospheric Condensations in dG and dMe Model Flare Atmospheres

The origin of the near-ultraviolet and optical continuum radiation in flares is critical for understanding particle acceleration and impulsive heating in stellar atmospheres. Radiative-hydrodynamic (RHD) simulations in 1D have shown that high energy deposition rates from electron beams produce two flaring layers at T approximately 10 (exp 4) K that develop in the chromosphere: a cooling condensation (downflowing compression) and heated non-moving (stationary) flare layers just below the condensation. These atmospheres reproduce several observed phenomena in flare spectra, such as the red-wing asymmetry of the emission lines in solar flares and a small Balmer jump ratio in M dwarf flares. The high beam flux simulations are computationally expensive in 1D, and the (human) timescales for completing NLTE models with adaptive grids in 3D will likely be unwieldy for some time to come. We have developed a prescription for predicting the approximate evolved states, continuum optical depth, and emergent continuum flux spectra of RHD model flare atmospheres. These approximate prescriptions are based on an important atmospheric parameter: the column mass (m(sub ref)) at which hydrogen becomes nearly completely ionized at the depths that are approximately in steady state with the electron beam heating. Using this new modeling approach, we find that high energy flux density (>F11) electron beams are needed to reproduce the brightest observed continuum intensity in IRIS data of the 2014 March 29 X1 solar flare, and that variation in m(sub ref) from 0.001 to 0.02 g cm (exp -2) reproduces most of the observed range of the optical continuum flux ratios at the peak of M dwarf flares.

Kowalski, Adam F.↗