Search NASA⌕ Search

SEARCH · Search NASA

Results for “Experimental evolution”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
DOE OSTI2018

Density and magnetic fluctuations in type III-ELM pedestal evolution in JET: experimental and numerical characterization

Density and magnetic fluctuation measurements in low-β type-III ELM discharges are obtained in the Joint European Torus (JET). They are observed during the inter-ELM pedestal evolution, after the LH transition phase, at about 60–70 kHz. Density fluctuations are measured with a correlation reflectometer system installed on the low-field side and they are localized at the pedestal top. Magnetic fluctuations with a spatial scale $k_y\rho_i\sim 0.1$ are measured through a high resolution coil array. The main features and the relations with local plasma parameters are presented. The nature of these fluctuations is discussed along with linear gyrokinetic simulations. Ion temperature gradient (ITG) modes are the dominant instabilities in the frequency range of interest. In terms of radial localization, typical oscillation frequency and qualitative relation with the possible linear drive, ITG modes are consistent with the experimental density fluctuations measurements. Micro-tearing modes (MTMs), found unstable with a lower growth rate, appear a possible explanation for magnetic fluctuations in terms of typical wavenumbers and direction of propagation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2020

3D Experimental Measurements of Evolution of Force Chains in Natural Silica Sand

The mechanisms of force transmission in granular materials is a classic physics problem that has been addressed since the 19th century, when Heinrich Rudolf Hertz investigated the interaction between two similar objects that were in contact under compression. However, the study of force transmission mechanisms in assemblies of more particles has proven to be a formidable problem due to the complex nature of granular materials. In recent years, synchrotron microcomputed tomography (SMT) and three-dimensional X-ray diffraction microscopy (3DXRD) have been employed to study the mechanics of granular materials experimentally. Combining SMT and 3DXRD offers unique three-dimensional (3D) experimental measurements of the internal structure, kinematics (such as rotation and translation), and lattice strains of individual sand particles. In this paper, in situ SMT and 3DXRD scans were acquired at multiple load steps for a specimen composed of 2,705 natural Ottawa sand particles that were subjected to one-dimensional (1D) confined compression. An algorithm was developed to combine SMT images and 3DXRD lattice strain measurements and used to characterize the constitutive behavior of sand particles. The results were used to identify the crystal structure and the evolution of the stresses and lattice strains of individual sand particles. Another algorithm was developed to characterize the force structures within the specimen. Force structures were identified, and their properties (such as length) and evolution through the experiment were examined. The contact number of particles is a particle-scale property that affects the mechanics of granular materials. The effect of the contact number of the sand particles on the onset and evolution of the force structures was also investigated and discussed.

3D x-ray diffraction microscopy↗
DOE OSTI2012

In-situ Monitoring of Dynamic Phenomena during Solidification and Phase Transformation Processing

The purpose of this project is to: (1) Directly observe phase transformations and microstructure evolution using proton (and synchrotron x-ray) radiography and tomography; (2) Constrain phase-field models for microstructure evolution; (3) Experimentally control microstructure evolution during processing to enable co-design; and (4) Advance toward the MaRIE vision. Understand microstructure evolution and chemical segregation during solidification {yields} solid-state transformations in Pu-Ga.

36 MATERIALS SCIENCE↗
DOE OSTI2017

Experimental recreation of the evolution of lignin-degrading enzymes from the Jurassic to date

Floudas et al. (Science 336: 1715) established that lignin-degrading fungi appeared at the end of Carboniferous period associated with the production of the first ligninolytic peroxidases. Here, the subsequent evolution of these enzymes in Polyporales, where most wood-rotting fungi are included, is experimentally recreated using genomic information.

Ancestral sequence reconstruction↗
DOE OSTI2014

Nonlinear acoustics experimental characterization of microstructure evolution in Inconel 617

Inconel 617 is a candidate material for the intermediate heat exchanger in a very high temperature reactor for the next generation nuclear power plant. This application will require the material to withstand fatigue-ratcheting interaction at temperatures up to 950°C. Therefore nondestructive evaluation and structural health monitoring are important capabilities. Acoustic nonlinearity (which is quantified in terms of a material parameter, the acoustic nonlinearity parameter, β) has been proven to be sensitive to microstructural changes in material. This research develops a robust experimental procedure to track the evolution of damage precursors in laboratory tested Inconel 617 specimens using ultrasonic bulk waves. The results from the acoustic non-linear tests are compared with stereoscope surface damage results. Therefore, the relationship between acoustic nonlinearity and microstructural evaluation can be clearly demonstrated for the specimens tested.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
DOE OSTI2011

Experimental Support for the Evolution of Symmetric Protein Architecture from a Simple Peptide Motif

The majority of protein architectures exhibit elements of structural symmetry, and 'gene duplication and fusion' is the evolutionary mechanism generally hypothesized to be responsible for their emergence from simple peptide motifs. Despite the central importance of the gene duplication and fusion hypothesis, experimental support for a plausible evolutionary pathway for a specific protein architecture has yet to be effectively demonstrated. To address this question, a unique 'top-down symmetric deconstruction' strategy was utilized to successfully identify a simple peptide motif capable of recapitulating, via gene duplication and fusion processes, a symmetric protein architecture (the threefold symmetric {beta}-trefoil fold). The folding properties of intermediary forms in this deconstruction agree precisely with a previously proposed 'conserved architecture' model for symmetric protein evolution. Furthermore, a route through foldable sequence-space between the simple peptide motif and extant protein fold is demonstrated. These results provide compelling experimental support for a plausible evolutionary pathway of symmetric protein architecture via gene duplication and fusion processes.

59 BASIC BIOLOGICAL SCIENCES↗
DOE OSTI2016

The effect of a dominant initial single mode on the Kelvin–Helmholtz instability evolution: New insights on previous experimental results

This paper brings new insights on an experiment, measuring the Kelvin–Helmholtz (KH) instability evolution, performed on the OMEGA-60 laser facility. Experimental radiographs show that the initial seed perturbations in the experiment are of multimode spectrum with a dominant single-mode of 16 μm wavelength. In single-mode-dominated KH instability flows, the mixing zone (MZ) width saturates to a constant value comparable to the wavelength. However, the experimental MZ width at late times has exceeded 100 μm, an order of magnitude larger. In this work, we use numerical simulations and a statistical model in order to investigate the vortex dynamics of the KH instability for the experimental initial spectrum. Here, we conclude that the KH instability evolution in the experiment is dominated by multimode, vortex-merger dynamics, overcoming the dominant initial mode.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
DOE OSTI2011

Simulation and experimental study on compositional evolution of Li-Co in LiCoO{sub 2} thin films during sputter deposition

The compositional evolution in sputter deposited LiCoO{sub 2} thin films is influenced by process parameters involved during deposition. The electrochemical performance of these films strongly depends on their microstructure, preferential orientation and stoichiometry. The transport process of sputtered Li and Co atoms from the LiCoO{sub 2} target to the substrate, through Ar plasma in a planar magnetron configuration, was investigated based on the Monte Carlo technique. The effect of sputtering gas pressure and the substrate-target distance (d{sub st}) on Li/Co ratio, as well as, energy and angular distribution of sputtered atoms on the substrate were examined. Stable Li/Co ratios have been obtained at 5 Pa pressure and d{sub st} in the range 5-11 cm. The kinetic energy and incident angular distribution of Li and Co atoms reaching the substrate have been found to be dependent on sputtering pressure. Simulations were extended to predict compositional variations in films prepared at various process conditions. These results were compared with the composition of films determined experimentally using x-ray photoelectron spectroscopy (XPS). Li/Co ratio calculated using XPS was in moderate agreement with that of the simulated value. The measured film thickness followed the same trend as predicted by simulation. These studies are shown to be useful in understanding the complexities in multicomponent sputtering.

36 MATERIALS SCIENCE↗
DOE OSTI2011

Experimental investigation of anisotropy evolution of AZ31 magnesium alloy sheets under tensile loading

Increasing demand for lighter final products has created new opportunities for the application of new light weight materials. Due to high strength to density ratio and good magnetic resistance properties, magnesium alloys are good candidates to replace steel and aluminum for same application. However, limited numbers of active slip deformation mechanisms, result in a decreased formability at room temperature. Furthermore, wrought magnesium alloys have an initial crystallographic texture, remained from the prior rolling operations, which makes them highly anisotropic. In this paper, tensile tests are performed at room temperature and 200 deg. C at different strain rates and orientations relative to the rolling direction, including rolling, 30 deg., 45 deg., 60 deg. and transverse orientation. The strain rates adopted for these experiments varied from 0.001 to 1.0. The testing results show the effect of temperature on the strain rate sensitivity of AZ31 sheets. The extent of deformation is continuously recorded using two separate high temperature extensometers. The results of testing show an increase in the r-values with the plastic deformation. The strain rate sensitivity of AZ31 increased as the temperature was elevated. At higher strain rates the measured r-values are larger and the slope of its evolution with the plastic strain is steeper.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Virtual Tokamak for Test and Development of Plasma Control Applied to NSTX-U

Safe and efficient operation of tokamak experiments depends on shot preparation prior to the experiment to maximize performance and avoid issues that are predictable consequences of known physics. The General Atomics TokSys toolbox is used to test and develop the plasma control system (PCS) on numerous tokamaks around the world. Tokamaks that use a version of the DIII-D PCS can connect it to a TokSys simulation and control a virtual version of the tokamak with the real PCS. Recent upgrades to the simulation include more detailed profile and transport modeling to support design and implementation of optimized scenarios. The simulation combines a module called “Profiles” that simulates the 1D profiles of density, pressure, and current and a module called “GSevolve'' that evolves the 2D Grad-Shafranov equilibrium. The “Profiles'' module primarily uses simplified models for fueling, heating, and current. The TRANSP code provides precomputed diffusion coefficients and heating/current drive profiles from radio-frequency and neutral beam sources for the scenarios being simulated. The fidelity of a simulation can be enhanced by analyzing it with TRANSP and making corrections to the precomputed values and iterating until convergence. Simulations of the National Spherical Torus Upgrade (NSTX-U) are presented. It is shown that the simulation reproduces the experimental profile evolution. Here, the simulation has also been upgraded to reproduce the experimental outcome at points of bifurcation. This is demonstrated with a simulation of vertical displacement in NSTX-U.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2012

QCD EVOLUTION AND TMD/SPIN EXPERIMENTS

Transverse Spin and Transverse Momemtum Dependent (TMD) distribution study has been one of the main focuses of hadron physics in recent years. The initial exploratory Semi-Incluisve Deep-Inelastic-Scattering (SIDIS) experiments with transversely polarized proton and deuteron from HERMES and COMPASS attracted great attention and lead to very active efforts in both experiments and theory. QCD factorization has been carefully studied. A SIDIS experiment on the neutron with a polarized 3He target was performed at JLab. Recently published results will be shown. Precision TMD experiments are planned at JLab after the 12 GeV energy upgrade. The approved experiments with a new SoLID spectrometer on both the proton and neutron will be presented. Proper QCD evolution treatments beyond collinear cases become crucial for the precision study of the TMDs. Experimentally, Q2 evolution and higher-twist effects are often closely related. The experience of study higher-twist effects in the cases of moments of the spin structure functions will be discussed.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗
DOE OSTI2014

Monoxides of small terbium clusters: A density functional theory investigation

To investigate the effect of oxygen atom on the geometrical structures, electronic, and magnetic properties of small terbium clusters, we carried out the first-principles calculations on Tb{sub n}O (n = 1-14) clusters. The capping of an oxygen atom on one trigonal-facet of Tb{sub n} structures is always favored energetically, which can significantly improve the structural stability. The far-infrared vibrational spectroscopies are found to be different from those of corresponding bare clusters, providing a distinct signal to detect the characteristic structures of Tb{sub n}O clusters. The primary effect of oxygen atom on magnetic properties is to change the magnetic orderings among Tb atoms and to reduce small of local magnetic moments of the O-coordinated Tb atoms, both of which serve as the key reasons for the experimental magnetic evolution of an oscillating behavior. These calculations are consistent with, and help to account for, the experimentally observed magnetic properties of monoxide Tb{sub n}O clusters [C. N. Van Dijk et al., J. Appl. Phys. 107, 09B526 (2010)].

74 ATOMIC AND MOLECULAR PHYSICS↗